check engine Peugeot 307 SW 2007.5 Owner's Manual

90
SAFETY
To adjust the height in the front:

 To lower the attachment point,
squeeze control 1 and slide it
downwards.

 To raise the attachment point,
slide control 1 upwards.
Fastening the seat belts

 Pull the strap, then insert the
buckle into the stalk.

 Check that the seat belt is
fastened by pulling the strap. Unfastening the seat belts
When the ignition is switched
on, the warning light comes
on on the instrument panel
if the driver has not fastened
his seat belt.
With the engine running and the
doors closed, the light switches off
automatically after 30 seconds.
 for children or people of a short
stature, pass the seat belt under
the strap guide 2 ,

 for other passengers, pass the
seat belt over the strap guide.
This strap guide prevents the seat
belt from passing over the neck of
these passengers.
SEAT BELTS
Front and 2 nd row rear side
seat belts
The front seats are i tted with pre-ten-
sioners and force limiters while the
rear seats have force limiters only.
Seat belt unfastened/not fastened
warning light

 Press the red button on the stalk
then remove the buckle. If the seat belt is unfastened:
- below 12 mph (20 km/h), the light
comes on constantly,
- above 12 mph (20 km/h) and for two minutes, the warning
light l ashes accompanied by
an audible signal of increasing
volume. Once these two minutes
have elapsed, the warning light
remains on until the driver fastens
his seat belt.
Routing the 2 nd row rear side
seat belt:

108
CHECKS
Tilt the handle on the left-hand side
under the fascia to the right.
Lift the catch and raise the bonnet.
Bonnet strut
RUNNING OUT OF FUEL
(DIESEL)
If you should run out of fuel, it is nec-
essary to re-prime the circuit.
The repriming pump, the degas
screw and the transparent pipe are
located under the bonnet (see corre-
sponding drawing):
1.6 litre HDI 16V engine
- i ll the fuel tank with at least i ve litres of diesel,
- unclip the style cover to access the repriming pump,
- squeeze and release the manual repriming pump until fuel appears
in the transparent pipe with the
green connector,
- operate the starter until the engine starts.
2 litre HDI 16V engine
- i ll the fuel tank with at least i ve litres of diesel,
- unclip the style cover to access the repriming pump,
- unscrew the degas screw,
- squeeze and release the manual repriming pump until diesel is
seen escaping via the degas
screw,
- retighten the degas screw,
- operate the starter until the engine starts.
OPENING THE BONNET
From outside Secure the strut
to hold the bonnet
open.
Before closing the
bonnet, replace
the strut in its
housing.
To close
Lower the bonnet and release it at
the end of its travel.
Check that the bonnet is properly
locked.
From inside

109
CHECKS

1. Power steering reservoir.

2. Windscreen/headlamp wash
reservoir.

3. Coolant reservoir.
4. Brake l uid reservoir.

5. Battery.

6. Fuse box.
7. Air i lter.

8. Dipstick.

9. Engine oil reservoir.
1.6 LITRE 16V PETROL AND 1.6 LITRE 16V BIOFLEX ENGINE

110
CHECKS

1. Power steering reservoir.

2. Windscreen/headlamp wash
reservoir.

3. Coolant reservoir.
4. Brake l uid reservoir.

5. Brake l uid reservoir.

6. Fuse box.
7. Air i lter.

8. Dipstick.

9. Engine oil reservoir.
2 LITRE 16V PETROL ENGINE

111
CHECKS

1. Power steering reservoir.

2. Windscreen /headlamp wash
reservoir.

3. Coolant reservoir.
4. Brake l uid reservoir.

5. Battery.

6. Fuse box.
7. Dipstick.

8. Engine oil reservoir.

9. Priming pump.
1.6 LITRE 16V TURBO DIESEL HDI ENGINE (90 BHP/110 BHP)

112
CHECKS

1. Power steering reservoir.

2. Windscreen/headlamp wash
reservoir.

3. Coolant reservoir.
4. Brake l uid reservoir.

5. Battery.

6. Fuse box.

7. Air i lter.
8. Engine oil reservoir.

9. Dipstick.

10. Priming pump.

11. Degas screw.
2 LITRE 16V TURBO DIESEL HDI ENGINE (136 BHP)

113
CHECKS
CHECKING THE LEVELS
There are two marks on
the dipstick:

A = maximum
Never i ll past this mark.

B = minimum
To maintain the reliability of
engines and emission control
systems, the use of additives
in engine oil is prohibited.
Viscosity selection
In all cases, the oil selected must
meet the manufacturer’s require-
ments.
Note: the coolant does not need to
be changed.
Dipstick
Cooling system
Use the l uid recommended by the
manufacturer.
When the engine is warm, the tem-
perature of the coolant is controlled
by the engine fan. This fan can oper-
ate with the ignition off.

In the case of vehicles i tted with
a particle emission i lter, the fan
can operate after the vehicle has
stopped, even when the engine is
cold.
In addition, as the cooling system is
pressurised, wait for at least one hour
after the engine has stopped before
carrying out any work.
Slacken the cap by two turns to re-
lease the pressure to prevent any
risk of scalding. When the pressure
has dropped, remove the cap and
top up the level.
Windscreen and headlamp
wash level
Diesel additive level (Diesel
with particle emission filter)
If the service warning light comes on,
accompanied by a message and an
audible signal, this indicates a low
diesel additive level.
This additive must be topped up.
Contact a PEUGEOT dealer as soon
as possible.
Brake fluid level
Oil level
Oil change
According to the information given in
the servicing booklet. The level should always be
above the MIN mark and
close to the MAX mark.
Power steering reservoir
Remove the style trim * (see §
"Changing a bulb - Front lights").
Open the reservoir, with the engine
at ambient temperature. The level
should always be above the MIN.
mark and close to the MAX. mark.
For best quality cleaning and
for your safety, we would
advise that you use products
recommended by PEUGEOT.
Replacement must be car-
ried out according to the
manufacturer’s servicing
schedule.
Use l uids recommended by
the manufacturer, which fuli l DOT4
standards.
Check the level regularly
and top up between chang-
es. The maximum consump-
tion is 0.5 l per 600 miles
(1 000 km).
Check the level with the vehicle level,
engine cold, using the oil level gauge
on the instrument panel or the dip-
stick.
* According to engine.

114
CHECKS
CHECKS
Where the handbrake travel
is too great or there is a re-
duction in the performance
of the system, the hand-
brake should be adjusted,
even between services.

Have the system checked by a PEUGEOT
dealer.
Air filter and passenger
compartment filter
Particle emission filter (Diesel)
It is imperative that the particle emis-
sion i lter is maintained in accordance
with the manufacturer’s servicing
schedule, by a PEUGEOT dealer. Brake pad wear depends
on the style of driving, in
particular for vehicles which
are used in town, over short
distances.
Disc and drum wear status
For any information relating to the wear
status of the surfaces of the discs and
drums, contact a PEUGEOT dealer.
Only use products recom-
mended by PEUGEOT or
products of equivalent qual-
ity and characteristics.
To ensure best performance from
components as important as the
power steering and the braking sys-
tem, PEUGEOT selects and offers
quite specii c products.
To prevent damage to the electrical
units, high pressure washing to clean
the engine compartment is strictly

prohibited .
Oil filter
Used products
Avoid all prolonged contact of the
used oil with the skin.
Brake l uid is harmful to health and
very corrosive.
Note: following prolonged operation
of the vehicle at very low speed or at
idle, you may, in exceptional cases,
notice discharges of water vapour
at the exhaust on acceleration. This
has no effect on the behaviour of the
vehicle or on the environment.
Do not dispose of used oil,
brake l uid or coolant into
drains or onto the ground.
Empty the used oil into the
containers provided for this purpose
in the PEUGEOT network.
Battery
At the start of winter, have
your battery checked by a
PEUGEOT dealer.
Have the i lter elements
replaced regularly. If you
drive in dusty conditions,
change them twice as of-
ten.
Brake pads
It may be necessary to
check the thickness of the
pads, even between ser-
vices.
Handbrake
Change the i lter regularly,
in accordance with the ser-
vicing schedule.
Manual gearbox

To check the main levels
and certain components,
in accordance with the
manufacturer’s servic-
ing schedule, refer to the
pages of the servicing booklet
which correspond to your vehi-
cle’s engine.
This does not require an oil
change. Have the level checked
in accordance with the manu-
facturer’s servicing schedule.

114
CHECKS
CHECKS
Where the handbrake travel
is too great or there is a re-
duction in the performance
of the system, the hand-
brake should be adjusted,
even between services.

Have the system checked by a PEUGEOT
dealer.
Air filter and passenger
compartment filter
Particle emission filter (Diesel)
It is imperative that the particle emis-
sion i lter is maintained in accordance
with the manufacturer’s servicing
schedule, by a PEUGEOT dealer. Brake pad wear depends
on the style of driving, in
particular for vehicles which
are used in town, over short
distances.
Disc and drum wear status
For any information relating to the wear
status of the surfaces of the discs and
drums, contact a PEUGEOT dealer.
Only use products recom-
mended by PEUGEOT or
products of equivalent qual-
ity and characteristics.
To ensure best performance from
components as important as the
power steering and the braking sys-
tem, PEUGEOT selects and offers
quite specii c products.
To prevent damage to the electrical
units, high pressure washing to clean
the engine compartment is strictly

prohibited .
Oil filter
Used products
Avoid all prolonged contact of the
used oil with the skin.
Brake l uid is harmful to health and
very corrosive.
Note: following prolonged operation
of the vehicle at very low speed or at
idle, you may, in exceptional cases,
notice discharges of water vapour
at the exhaust on acceleration. This
has no effect on the behaviour of the
vehicle or on the environment.
Do not dispose of used oil,
brake l uid or coolant into
drains or onto the ground.
Empty the used oil into the
containers provided for this purpose
in the PEUGEOT network.
Battery
At the start of winter, have
your battery checked by a
PEUGEOT dealer.
Have the i lter elements
replaced regularly. If you
drive in dusty conditions,
change them twice as of-
ten.
Brake pads
It may be necessary to
check the thickness of the
pads, even between ser-
vices.
Handbrake
Change the i lter regularly,
in accordance with the ser-
vicing schedule.
Manual gearbox

To check the main levels
and certain components,
in accordance with the
manufacturer’s servic-
ing schedule, refer to the
pages of the servicing booklet
which correspond to your vehi-
cle’s engine.
This does not require an oil
change. Have the level checked
in accordance with the manu-
facturer’s servicing schedule.

182
QUESTIONSOLUTION
RESPONSE
The stored stations do
not function (no sound,
87.5 Mhz is displayed...) An incorrect waveband is selected.
Press the BAND AST button to return to the
waveband (AM, FM1, FM2, FMAST) on which the
stations are stored.
The trafic announcement
(TA) is displayed. I do
not receive any trafic
information. Tune to a radio station which broadcasts trafic
information.
The radio station is not part of the regional trafi
c information network.
The quality of reception
of the radio station
listened to gradually
deteriorates or the
stored stations do
not function (no
sound, 87.5 Mhz is
displayed...). The vehicle is too far from the transmitter used by
the station listened to or
there is no transmitter in the geographical area th rough which the vehicle
is travelling.
The environment (hills, buildings, tunnels, basemen t car parks...) block
reception, including in RDS mode.
The aerial is absent or has been damaged (for examp le when going
through a car wash or into an underground car park) .Activate the RDS function to enable the system
to check whether there is a more powerful
transmitter in the geographical area.
This phenomenon is normal and does not
indicate a failure of the audio equipment.
Have the aerial checked by a PEUGEOT dealer.
Sound cut-outs of 1
to 2 seconds in radio
mode. During this brief sound cut-out, the RDS searches f
or any frequency
permitting better reception of the station. Deactivate the RDS function if the phenomenon
is too frequent and always on the same route.
With the engine off,
the audio equipment
switches off after a few
minutes of use. When the engine is switched off, the audio equipmen
t operating time
depends on the battery charge.
The switch-off is normal: the audio equipment switc hes to economy mode
and switches off to prevent discharging of the vehi cle’s battery.Start the vehicle’s engine to increase the battery
charge.
The message "the audio
system is overheated"
appears on the display. Switch the audio system off for a few minutes to
allow the system to cool.
In order to protect the installation if the surroun
ding temperature is too
high, the audio equipment switches to an automatic thermal protection
mode leading to a reduction of the volume or stoppi ng of the playing of the
CD.