sensor Peugeot 307 SW 2007.5 Owner's Manual

Page 85 of 199

75
VISIBILITY
Automatic switching on of the
lights
Side lights and dipped beam head-
lamps switch on automatically if the
light is poor, or during operation of the
windscreen wipers. They switch off
as soon as the light becomes bright
enough or the windscreen wipers
stop.

Note: in foggy weather or in snow,
the brightness sensor can detect
sufi cient light. As a consequence, the
lights will not come on automatically.
Deactivation

 Turn ring A to a position other
than "AUTO" . Switching off is
accompanied by a message on
the multifunction display.

If the brightness sensor does not
function correctly, the lights come
on accompanied by the service
warning light, an audible signal and
a message on the multifunction dis-
play.
Contact a PEUGEOT dealer.
Manual "Follow-me-home" lighting

When the automatic switching on of
the lights function is deactivated , the
side lights and dipped headlamps re-
main on for the duration selected for the
automatic "follow-me-home" lighting.

If the vehicle is not i tted with the
automatic switching on of the lights
function , when you leave your vehicle,
the side lights and dipped headlamps
remain on for thirty seconds.
Direction indicators (l ashers)

Left: downwards.

Right: upwards.

Note: if you forget to cancel the di-
rection indicator, the volume of the
audible signal will increase, if you
are driving at a speed greater than
50 mph (80 km/h).
Automatic "Follow me home"
lighting
With the ignition off, when you leave
your vehicle with the automatic
switching on of the lights function
activated , the side lights and dipped
headlamps remain on for the selected
duration. Activation:

 switch off the engine,

 "l ash" the headlamps,

 get out of the vehicle and lock it.
Deactivation:

 "l ash" the headlamps again,

 get out of the vehicle and lock it.
To deactivate or activate
this function, go to the mul-
tifunction display coni gura-
tion menu.
The duration of the timed
period must also be set (15, 30,
60 seconds), via the multifunction
display coni guration menu, except
in the case of the monochrome
screen A for which it is pre-set.
Cancelling:

 "l ash" the headlamps,

 get out of the vehicle and lock it. Activation

 Turn ring A to the "AUTO"
position. The automatic lighting
is accompanied by a message on
the multifunction display.
Do not cover the brightness
sensor, coupled with the rain
sensor, located in the centre
of the windscreen, behind
the interior mirror. It is used for the
automatic switching on of the lights.

Page 87 of 199

75
VISIBILITY
Automatic switching on of the
lights
Side lights and dipped beam head-
lamps switch on automatically if the
light is poor, or during operation of the
windscreen wipers. They switch off
as soon as the light becomes bright
enough or the windscreen wipers
stop.

Note: in foggy weather or in snow,
the brightness sensor can detect
sufi cient light. As a consequence, the
lights will not come on automatically.
Deactivation

 Turn ring A to a position other
than "AUTO" . Switching off is
accompanied by a message on
the multifunction display.

If the brightness sensor does not
function correctly, the lights come
on accompanied by the service
warning light, an audible signal and
a message on the multifunction dis-
play.
Contact a PEUGEOT dealer.
Manual "Follow-me-home" lighting

When the automatic switching on of
the lights function is deactivated , the
side lights and dipped headlamps re-
main on for the duration selected for the
automatic "follow-me-home" lighting.

If the vehicle is not i tted with the
automatic switching on of the lights
function , when you leave your vehicle,
the side lights and dipped headlamps
remain on for thirty seconds.
Direction indicators (l ashers)

Left: downwards.

Right: upwards.

Note: if you forget to cancel the di-
rection indicator, the volume of the
audible signal will increase, if you
are driving at a speed greater than
50 mph (80 km/h).
Automatic "Follow me home"
lighting
With the ignition off, when you leave
your vehicle with the automatic
switching on of the lights function
activated , the side lights and dipped
headlamps remain on for the selected
duration. Activation:

 switch off the engine,

 "l ash" the headlamps,

 get out of the vehicle and lock it.
Deactivation:

 "l ash" the headlamps again,

 get out of the vehicle and lock it.
To deactivate or activate
this function, go to the mul-
tifunction display coni gura-
tion menu.
The duration of the timed
period must also be set (15, 30,
60 seconds), via the multifunction
display coni guration menu, except
in the case of the monochrome
screen A for which it is pre-set.
Cancelling:

 "l ash" the headlamps,

 get out of the vehicle and lock it. Activation

 Turn ring A to the "AUTO"
position. The automatic lighting
is accompanied by a message on
the multifunction display.
Do not cover the brightness
sensor, coupled with the rain
sensor, located in the centre
of the windscreen, behind
the interior mirror. It is used for the
automatic switching on of the lights.

Page 90 of 199

78
VISIBILITY
Do not cover the rain sensor
located on the windscreen
behind the interior mirror.
When using an automatic car
wash, switch off the ignition.
In winter, it is advisable to wait for the
windscreen to completely clear of ice
before operating the automatic wipe.
Activation
Activation of the function is
accompanied by a message on the
multifunction display.
Turn ring A to the i rst notch
for intermittent wiping.
When reverse gear is
engaged, if the windscreen
wipers are in operation, the
rear wiper will start wiping.
To activate or deactivate this
function, go to the multi-func-
tion display coni guration
menu.
If there is a signii cant ac-
cumulation of snow or ice and when
using a bicycle carrier on the tailgate,
deactivate the automatic rear wiping
by going to the multifunction display
coni guration menu.
Turn ring A past the i rst
notch; the windscreen wash
then the windscreen wiper
operate for a i xed period.
Deactivation
Deactivation of the function is
accompanied by a message on the
multifunction display.
The function is deactivated when the
windscreen wipers stalk is moved to
position
I , 1 or 2 .

In the event of malfunction of the
automatic windscreen wipers, the
windscreen wipers will operate in
intermittent mode.
Contact a PEUGEOT dealer to have
the system checked.
Rear windscreen wash 1. Front courtesy light
In this position, the courtesy
light comes on automatically:
-
when the vehicle is unlocked, - when the key is removed from the ignition, - when a door is opened, - when the vehicle location function is used.
Permanently off.
It switches off gradually:
- when the vehicle is locked,
- when the ignition is switched on,
- with the ignition off, 30 seconds
after the last door is closed.
COURTESY LIGHTS Rear windscreen wiper

The automatic windscreen
wipers function must be
reactivated if the ignition
has been switched off for
more than one minute, by pressing
the stalk downwards.

Page 91 of 199

78
VISIBILITY
Do not cover the rain sensor
located on the windscreen
behind the interior mirror.
When using an automatic car
wash, switch off the ignition.
In winter, it is advisable to wait for the
windscreen to completely clear of ice
before operating the automatic wipe.
Activation
Activation of the function is
accompanied by a message on the
multifunction display.
Turn ring A to the i rst notch
for intermittent wiping.
When reverse gear is
engaged, if the windscreen
wipers are in operation, the
rear wiper will start wiping.
To activate or deactivate this
function, go to the multi-func-
tion display coni guration
menu.
If there is a signii cant ac-
cumulation of snow or ice and when
using a bicycle carrier on the tailgate,
deactivate the automatic rear wiping
by going to the multifunction display
coni guration menu.
Turn ring A past the i rst
notch; the windscreen wash
then the windscreen wiper
operate for a i xed period.
Deactivation
Deactivation of the function is
accompanied by a message on the
multifunction display.
The function is deactivated when the
windscreen wipers stalk is moved to
position
I , 1 or 2 .

In the event of malfunction of the
automatic windscreen wipers, the
windscreen wipers will operate in
intermittent mode.
Contact a PEUGEOT dealer to have
the system checked.
Rear windscreen wash 1. Front courtesy light
In this position, the courtesy
light comes on automatically:
-
when the vehicle is unlocked, - when the key is removed from the ignition, - when a door is opened, - when the vehicle location function is used.
Permanently off.
It switches off gradually:
- when the vehicle is locked,
- when the ignition is switched on,
- with the ignition off, 30 seconds
after the last door is closed.
COURTESY LIGHTS Rear windscreen wiper

The automatic windscreen
wipers function must be
reactivated if the ignition
has been switched off for
more than one minute, by pressing
the stalk downwards.

Page 100 of 199

87
SAFETY
Sensors i tted in each valve check
the tyre pressure during driving and
trigger a warning in the event of
malfunction (speed above 12 mph
(20 km/h)). The service warning light
comes on on the instrument
panel, accompanied by an
audible signal and a mes-
sage on the multifunction
display locating the wheel
concerned.
Check the tyre pressures as soon as
possible. This check must be carried
out when the tyres are cold. Puncture
The
STOP warning light comes on on
the instrument panel, accompanied
by an audible signal and a message
on the multi-function display locating
the wheel concerned.
Stop immediately, avoiding any sud-
den movement of the steering wheel
and the brakes.
Change the damaged wheel (punc-
tured or very del ated tyre), and have
the tyre pressure checked as soon
as possible.
The service warning light
comes on on the instrument
panel, accompanied by an
audible signal and a mes-
sage on the multifunction
display locating the wheel or wheels
which are not detected or indicating a
fault in the system.
Contact a PEUGEOT dealer to re-
place the faulty sensor(s). All repairs and changing of
tyres on a wheel i tted with
this system must be carried
out by a PEUGEOT dealer.
If, when changing a tyre, you
install a wheel which is not detect-
ed by your vehicle (example: i tting
of snow tyres), you must have the
system reinitialised by a PEUGEOT
dealer.
The tyre under-inl ation detection
system is an aid to driving which does
not replace the need for the driver to
be vigilant or to drive responsibly.
This system does not eliminate
the need to have the tyre pressure
checked regularly (see manufactur-
er’s label on the door pillar) to ensure
that the optimum dynamic perfor-
mance of the vehicle is maintained
and prevent premature wear of the
tyres, particularly in arduous driving
conditions (heavy load, high speed).
The tyre pressures must be checked
cold, at least once a month. Re-
member to check the pressure of the
spare wheel.
The tyre under-inl ation detection
system may experience temporary
interference due to radioelectric
emissions on a frequency close to
that used by the system.
Flat tyre Sensor(s) not detected or faulty

Notes:
This message is also displayed when
one of the wheels is away from the
vehicle (being repaired) or when one
or more wheels without a sensor are
i tted.
The spare wheel is not i tted with a
sensor.
TYRE UNDER-INFLATION
DETECTION

Page 138 of 199

10
122
PRACTICAL INFORMATION
CHANGING A FUSE
The fuse boxes are placed in the low-
er part of the fascia (passenger side)
and in the engine compartment (left-
hand side). Correct Incorrect
 Open the glove box lid to gain
access to the fuses.
Replacing a fuse
Before replacing a fuse, the cause of
the incident must be found and recti-
i ed. The fuse numbers are indicated
on the fuse box.
Always replace a faulty fuse with a
fuse of the same rating (same co-
lour).
Use the special pliers located on the
inside of the fascia fuse box cover,
this support also contains the re-
placement fuses.
Fascia fuses

Fuse N° Rating Functions

F1 15 A Rear wiper.

F2 30 A Locking and deadlocking.

F3 5 A Air bags and pre-tensioners unit.

F4 10 A Brake and clutch pedals switch, engine coolant
level switch, steering wheel angle sensor,
diagnostic socket, ESP sensor, electrochromatic
mirror, particle emission i lter pump.

F5 30 A Front electric windows and panoramic roof
concealing shutter supply, heated mirrors.

Page 139 of 199

10
122
PRACTICAL INFORMATION
CHANGING A FUSE
The fuse boxes are placed in the low-
er part of the fascia (passenger side)
and in the engine compartment (left-
hand side). Correct Incorrect
 Open the glove box lid to gain
access to the fuses.
Replacing a fuse
Before replacing a fuse, the cause of
the incident must be found and recti-
i ed. The fuse numbers are indicated
on the fuse box.
Always replace a faulty fuse with a
fuse of the same rating (same co-
lour).
Use the special pliers located on the
inside of the fascia fuse box cover,
this support also contains the re-
placement fuses.
Fascia fuses

Fuse N° Rating Functions

F1 15 A Rear wiper.

F2 30 A Locking and deadlocking.

F3 5 A Air bags and pre-tensioners unit.

F4 10 A Brake and clutch pedals switch, engine coolant
level switch, steering wheel angle sensor,
diagnostic socket, ESP sensor, electrochromatic
mirror, particle emission i lter pump.

F5 30 A Front electric windows and panoramic roof
concealing shutter supply, heated mirrors.