trip recorder zero reset button Peugeot 307 SW 2007.5 Owner's Manual

Page 24 of 199

27
INSTRUMENTS, CONTROLS and DISPLAYS
With the lights on, press the button
to vary the intensity of the lighting of
the instruments and controls. When
the lighting reaches the minimum (or
maximum) setting, release the button
then press it again to increase (or re-
duce) the brightness.
As soon as the lighting is of the re-
quired brightness, release the but-
ton.
With the ignition on, press the button
until the zeros appear.
Pressing the button enables you to
alternate between the distance re-
corder and cruise control or speed
limiter displays, when either of these
is activated.
Engine oil level indicator
When the ignition is switched on, the
engine oil level is indicated for a few
seconds, after the service informa-
tion.
Oil level correct
Oil level gauge fault
Flashing of "OIL --"
indicates a malfunc-
tion of the engine oil
level gauge.
Contact a
PEUGEOT dealer.

The level read will only be correct
if the vehicle is on level ground
and the engine has been off for
more than 15 minutes.
Flashing of
"OIL" ,
linked with the ser-
vice warning light,
accompanied by
an audible signal
and a message on
the multifunction display, indicates a
lack of oil which could damage the
engine.
If the lack of oil is coni rmed by a
check using the dipstick, it is essential
that the level is topped up.
Lack of oil Dipstick
There are 2 marks on the
dipstick:
- never exceed level A,
- in position B, top up the level via the oil i ller
cap, using the type of oil
suited to your engine.

A = max.

B = min.
Trip recorder zero reset
button Lighting rheostat

Page 29 of 199

27
INSTRUMENTS, CONTROLS and DISPLAYS
With the lights on, press the button
to vary the intensity of the lighting of
the instruments and controls. When
the lighting reaches the minimum (or
maximum) setting, release the button
then press it again to increase (or re-
duce) the brightness.
As soon as the lighting is of the re-
quired brightness, release the but-
ton.
With the ignition on, press the button
until the zeros appear.
Pressing the button enables you to
alternate between the distance re-
corder and cruise control or speed
limiter displays, when either of these
is activated.
Engine oil level indicator
When the ignition is switched on, the
engine oil level is indicated for a few
seconds, after the service informa-
tion.
Oil level correct
Oil level gauge fault
Flashing of "OIL --"
indicates a malfunc-
tion of the engine oil
level gauge.
Contact a
PEUGEOT dealer.

The level read will only be correct
if the vehicle is on level ground
and the engine has been off for
more than 15 minutes.
Flashing of
"OIL" ,
linked with the ser-
vice warning light,
accompanied by
an audible signal
and a message on
the multifunction display, indicates a
lack of oil which could damage the
engine.
If the lack of oil is coni rmed by a
check using the dipstick, it is essential
that the level is topped up.
Lack of oil Dipstick
There are 2 marks on the
dipstick:
- never exceed level A,
- in position B, top up the level via the oil i ller
cap, using the type of oil
suited to your engine.

A = max.

B = min.
Trip recorder zero reset
button Lighting rheostat