Peugeot 307 SW 2007 Owners Manual

78
3. 2nd row rear reading lights
Permanently off.
The reading light comes on:
- when the vehicle is unlocked,- when the key is removed from the ignition,- when a door is opened,- when the vehicle location function is used.
It switches off gradually:
- when the vehicle is locked,- when the ignition is switched on,- with the ignition off, 30 seconds after the last door is closed.
With the ignition on (function not avail-able in economy mode), press the switch to obtain permanent lighting.
Press the switch again to switch the reading light off.
In this position, the courtesy light comes on automatically:
4. 3rd row rear courtesy light
Permanently on when the ignition is on (function not available in economy mode).
- when the vehicle is unlocked,- when the key is removed from the ignition,- when a door is opened,- when the vehicle location function is used.
It switches off gradually:
- when the vehicle is locked,- when the ignition is switched on,- with the ignition off, 30 seconds after the last door is closed.
Permanently on.
2. Front map reading lights
Different lighting times are available:
- with the ignition off or on, approximately 10 minutes,- in economy mode, approximately 30 seconds,- when the engine is running, no limit.
With the ignition on, press the corresponding switch.

79
With the ignition on, the mirror is automatically lit up when the flap is opened.
The athermic windscreen has two non-reflective zones located either side of the base of the interior mirror.
They are intended for affixing toll cards and/or car park tickets.
SUN VISOR WITH ILLUMINATED
COURTESY MIRRORAREAS FOR TOLL CARDS/CAR PARK TICKETS

80
INTERIOR LAYOUT
2. Front ashtray
Pull the lid to open the ashtray.
To empty it after opening, press the tab and remove the ashtray.
3. Storage
4. 12 volt socket (100 W max)
This is a lighter type socket, fitted with a cap. It is supplied with current from the running position.
5. Door tray
6. Storage/Can holder
7. Waste container
To empty, open it fully (past the point of resistance) then pull on the recep-tacle to remove it.
To refit, lock it in place on the cover.
It contains three sockets* B for con-necting video equipment.
The layout allows storage of a water bottle, a pen, the vehicle handbook, a pair of spectacles, tokens, etc.
* Colour screen only.
1. Glove box with cooling facility
This is fitted with a lock.
To open the glove box, lift the handle.
The glove box lights when the lid is opened.
It has a ventilation nozzle that can be closed A, distributing the same cooled air as the vents of the pas-senger compartment.

81
When fitting the mat for the first time, use only the fixings supplied in the wallet attached.
When removing the mat on the driv-er’s side:
- push the seat as far back as pos-sible,- unscrew the fixings fully,- remove the fixings, then the mat.
FITTING/REMOVING THE MAT
When refitting, position the mat correctly and replace the fixings by pressing them in.
Ensure that the mat is secured correctly.
To prevent the mat from becoming caught under the pedals:
- only use mats which are suited to the fixings already present in the vehicle. It is imperative that these fixings are used.- never fit one mat on top of another.
For further details, refer to the operating manuals "Video kitoperation" and "VMA8582 7 inch LCD colour monitor".
ENTERTAINMENT SCREEN KIT
This video assembly will enable the rear passengers to pass the time pleasant-ly while watching their favourite film or playing their favourite game, by means, in particular, of the connection of a DVD player or games console to the central support, fitted between the front seats.
The entertainment screen kit consists of:
- a 16/9ths, 7 inch, LCD colour monitor with direction adjustment in the three axes,- two high frequency, wireless, stereo headphones,- a removable support,- three audio/video sockets on the fixed base and in the glove compartment.The monitor and the support can be removed and stored, each in their own protective cover.
The entertainment screen kit accepts all types of audio/video source, PAL/NTSC compatible, such as: DVD player, cam-corder, games console, ...
These sources are connected to the three audio/video sockets, AV1 in the glove compartment or AV2 on the fixed base.

82

83
BOOT LAYOUT
4. Rear armrests with grab handle
5. Storage nets
One of them contains the luggage re-taining net.
6. Luggage retaining net fastenings ("hammock" version) in the tailgate
Fold the net in two.
Secure the two centre hooks in the stowing rings on the floor.
Secure the net’s remaining four hooks on the boot pillars.
7. Load space cover
To install it:
- position one end of the cover roller in the 2nd row,- compress the opposite end of the roller and position it,- release it to allow it to engage,- unroll the cover as far as the boot pillars,- insert the cover guides in the rails in the pillars,
To remove it:
- remove the cover guides from the pillar rails,- return the cover into its roller,- compress it and remove it from its support at the 2nd row,To store it, pull it back and place it with the two storage nets, already lowered.
Note: the roller has two hooks for se-curing the luggage retaining net de-pending on where it is installed.
8. High load retaining net
9. Luggage retaining net
Secure the net’s seven hooks in the stowing rings and the fastenings on the floor.
See configuration of the nets (next page)
1. Grab handles and coat hooks
2. High load retaining net fastenings
The high load retaining net can be fit-ted in the 2nd or 3rd row.
Open the covers of the correspond-ing upper fastenings.
Fit the ends of the metal bar in these fastenings.
Secure the two opaque material strap hooks in the stowing rings on the floor.
The rings are located directly below the corresponding upper fastenings.
Pull the two straps taut.
Secure the two hooks on the elastic parts of the opaque material in these rings.
Note: the net must be positioned so that the label can be seen from the boot. This ensures that the central seat belt is routed correctly.
3. 12 volt socket
This is a 12 volt socket (lighter type), installed on the load space cover left support.
It is supplied from the "Running" po-sition.

84
Example of installation of the nets:
Luggage retaining net, "folded" version
Luggage retaining net, "L" version
Luggage retaining net, "hammock" version, in the tailgate
Luggage retaining net, "hammock" version at the roller
High load retaining net in the 2nd row
Load space cover stored with the two storage nets

85
Press the button, the direction indica-tors flash.
They can operate with the ignition off.Press one of the spokes of the steering wheel.
Automatic lighting of hazard warning lights*
When braking in an emergency, depending on the deceleration, the hazard warning lights come on auto-matically. They switch off automati-cally the first time you accelerate.
It is also possible to switch them off by pressing the button.
* According to country.
HAZARD WARNING LIGHTS
HORN

86
Sensors fitted in each valve check the tyre pressure during driving and trigger a warning in the event of malfunction (speed above 12 mph (20 km/h)).
The service warning light comes on on the instrument panel, accompanied by an audible signal and a message on the multifunction display lo-cating the wheel concerned.
Check the tyre pressures as soon as possible. This check must be carried out when the tyres are cold.
Puncture
The STOP warning light comes on on the instrument panel, accompanied by an audible signal and a message on the multi-function display locating the wheel concerned.
Stop immediately, avoiding any sud-den movement of the steering wheel and the brakes.
Change the damaged wheel (punc-tured or very deflated tyre), and have the tyre pressure checked as soon as possible.
The service warning light comes on on the instrument panel, accompanied by an audible signal and a mes-sage on the multifunction display locating the wheel or wheels which are not detected or indicating a fault in the system.
Contact a PEUGEOT dealer to re-place the faulty sensor(s).
All repairs and changing of tyres on a wheel fitted with this system must be carried out by a PEUGEOT dealer.
If, when changing a tyre, you install a wheel which is not detect-ed by your vehicle (example: fitting of snow tyres), you must have the system reinitialised by a PEUGEOT dealer.
The tyre under-inflation detection system is an aid to driving which does not replace the need for the driver to be vigilant or to drive responsibly.
This system does not eliminate the need to have the tyre pressure checked regularly (see manufactur-er’s label on the door pillar) to ensure that the optimum dynamic perform-ance of the vehicle is maintained and prevent premature wear of the tyres, particularly in arduous driving condi-tions (heavy load, high speed).
The tyre pressures must be checked cold, at least once a month. Remember to check the pressure of the spare wheel.
The tyre under-inflation detection system may experience temporary interference due to radioelectric emissions on a frequency close to that used by the system.
Flat tyre
Sensor(s) not detected or faulty
Notes:
This message is also displayed when one of the wheels is away from the vehicle (being repaired) or when one or more wheels without a sensor are fitted.
The spare wheel is not fitted with a sensor.
TYRE UNDER-INFLATION
DETECTION

87
ANTI-LOCK BRAKING
SYSTEM (ABS) AND
ELECTRONIC BRAKE FORCE
DISTRIBUTION (EBFD)
The ABS, in conjunction with the electronic brake force distribution, increases the stability and manoeu-vrability of your vehicle on braking, in particular on poor or slippery road surfaces.
Note: when changing wheels (tyres and rims), make sure that these are approved.
The anti-lock braking system comes into operation automatically when there is a risk of wheel lock.
EMERGENCY BRAKING ASSISTANCE SYSTEM
In an emergency, this system enables the optimum braking pressure to be reached more quickly, thus reducing the stopping distance.
It is triggered by the speed at which the brake pedal is activated. The effect of this is a reduction in the re-sistance of the pedal and an increase in braking efficiency.
When this warning light comes on, accompanied by a buzzer and a mes-sage, it indicates that there is a malfunction of the ABS, which can cause a loss of control of the vehicle when braking.
When this warning light comes on, connected to the STOP and ABS warn-ing lights, accompanied by a buzzer and a message, it indicates that there is a mal-function of the electronic brake force distribution, which can cause a loss of control of the vehicle when braking.
Stop immediately.In both cases, consult a PEUGEOT dealer.
Normal operation of the ABS may make itself felt by slight vibrations of the brake pedal.
In emergency braking, press very firmly without releasing the pressure.