PEUGEOT 308 2007 Manual Online

!
i
75
GLASS PANORAMIC ROOF
Component which has a tinted glass panoramic surface to increase the light and visibility in the passenger compart-ment. Fitted with an electric shutter in several sections to improve tempera-ture and noise related comfort.
- manual mode Pull or press control A gently.
The shutter stops when you release the control.
- automatic mode Pull or press control A firmly.
One press opens or closes the shut-ter completely.
Pressing the control again stops the shutter.
Safety auto-reverse
In automatic mode and at the end of its travel, if the shutter meets an obstacle while closing it stops and moves back slightly.
One-touch electric shutter
There are two options for opening and closing:

i
76
FUEL TANK
Capacity of the tank: approximately 60 litres.
To fill the tank safely:
it is essential that the engine is switched off,
 open the fuel filler flap,
 insert the key in the cap, then turn it to the left,
When filling is complete:
 put the cap back in place,
 turn the key to the right, then remove it from the cap,
 close the flap.
 remove the cap and secure it on the hook, located on the inside of the flap,
 fill the tank, but do not continue af-ter the 3rd cut-off of the nozzle; this could cause malfunctions.
Low fuel level
Filling
A label affixed to the inside of the flap reminds you of the type of fuel to be used according to your engine.
Operating fault
A fuel gauge malfunction is indicated by the return of the fuel level indicator needle to zero.
Contact a PEUGEOT dealer.
When the fuel tank minimum level is reached, this warning light comes on on the instru-ment panel, accompanied by an audible signal and a message on the multifunction display.
You have enough fuel left to drive ap-proximately 30 miles (50 km).
If you run out of fuel, refer to the "Practi-cal information" section also.

77
LIGHTING CONTROLS
System for selection and control of the various front and rear lights providing the vehicle’s lighting.
Main lighting
The various front and rear lights of the vehicle are designed to adapt the driver’s visibility progressively in rela-tion to the climatic conditions:
- side lights, to be seen,- dipped headlamps to see without dazzling other drivers,- main beam headlamps to see clearly when the road is clear,- directional headlamps for improved visibility when cornering.
Additional lighting
Other lights are installed to fulfil the re-quirements of particular driving condi-tions:
- rear fog lamps to be seen from a distance,- front fog lamps for even better vis-ibility,- daytime lights to be seen during the day.
Programming
Various automatic lighting control modes are also available according to the following options:
- follow-me-home lighting,- automatic lighting,- directional lighting.
Model without AUTO lighting
Model with AUTO lighting
automatic switching on of the lights,
Manual controls
The lighting commands are issued di-rectly by the driver by means of the ring A and the lever B.
A. main lighting mode selection ring, with:
lights off,
side lights only,
B. lever for inversion of the lights by pulling: dipped headlamps/main beam headlamps.
In the lights off and side lights modes, the driver can switch on the main beam headlamps directly ("headlamp flash") for as long as he pulls the lever.
dipped headlamps or main beam headlamps.
Displays
Lighting of the corresponding indicator light on the instrument panel confirms the selective switching on of the lighting selected.

!
i
78
Model with rear fog lamp only
rear fog lamp
 To switch on the fog lamp, turn the ring C forwards.
When the lights are switched off auto-matically (with AUTO model), the fog lamp and the dipped headlamps will re-main on.
 To switch off all of the lights, turn the ring C rearwards.
Model with front and rear fog lampsfront and rear fog lamps
 To switch on the fog lamps, turn the ring C forwards.
 To switch off the rear fog lamp, turn the ring C rearwards twice in succes-sion.
When the lights are switched off auto-matically (with AUTO model) or when the dipped headlamps are switched off manually, the fog lamps and the side lights will remain on.
 Turn the ring rearwards to switch off the fog lamps, the side lights will then switch off.
C. fog lamps selection ring.
The fog lamps operate with the dipped and main beam headlamps.

i
i
79
Follow-me-home lighting
The temporary maintaining of the dipped headlamps lighting after the vehicle’s ignition has been switched off makes the driver’s exit easier when the light is poor.
Switching on
 With the ignition off, "flash" the head-lamps using the lever B.
 A second "headlamp flash" switches the function off again.
Switching off
The follow-me-home lighting switches off automatically after a set time.
Daytime lights
On vehicles fitted with daytime lights, the corresponding lights comes on when the vehicle is started*.
* According to country.
The instruments and controls (instru-ment panel, multifunction display, air conditioning control panel, ...) are not lit, except on switching to the automatic switching on of the lights mode or when the lights are switched on manually.
Exterior welcome lighting
The remote switching on of the lights makes your approach to the vehicle easier in poor light when in automatic switching on of the lights mode.
Switching on
 Press the open padlock on the re-mote control.
The dipped headlamps and the side lights come on; your vehicle is also unlocked.
Switching off
The exterior welcome lighting switches off automatically after a set time, when the ignition is switched on or on locking the vehicle.
Programming
The function is activated or deactivated via the multi-function display configura-tion menu.
Programming
The duration of maintaining of the lighting is selected via the multifunction dis-play configuration menu.
In countries in which this function is imposed by regulations*, it is activated by default.
The side lights and the number plate lights are also switched on.

!
i
80
Coupling with the "Follow-me-home" lighting
Association with the automatic lighting provides the "follow-me-home" lighting with the following additional options:
- selection of the duration of maintaining of the lighting for 15, 30 or 60 seconds in the vehicle parameters on the multi-function display configuration menu,- automatic activation of "follow-me-home" lighting when automatic light-ing is in operation.
Automatic lighting
The side lights and dipped headlamps are switched on automatically, without any action on the part of the driver, when a low level of external light is de-tected or in certain cases of activation of the windscreen wipers.
As soon as the brightness returns to a sufficient level or after the windscreen wipers are switched off, the lights are switched off automatically.
Activation
 Turn ring A to the "AUTO" position. The automatic lighting is accompa-nied by a message on the multifunc-tion display.
Deactivation
 Turn ring A to a position other than "AUTO". Deactivation is accompa-nied by a message on the multifunc-tion display.
Operating fault
In the event of a malfunction of the brightness sensor, the lights come on, this warning light is displayed on the instrument panel and/or a message appears on the multifunction display, accompanied by an audible signal.
In this case, contact a PEUGEOT dealer.
MANUAL HEADLAMP
ADJUSTMENT
To avoid causing a nuisance to other road users, the height of the halogen headlamps should be adjusted in rela-tion to the load in the vehicle.
0. 1 or 2 people in the front seats.
-. 3 people.
1. 5 people.
2. 5 people + maximum authorised load.
3. Driver + maximum authorised load.

i
i
79
Follow-me-home lighting
The temporary maintaining of the dipped headlamps lighting after the vehicle’s ignition has been switched off makes the driver’s exit easier when the light is poor.
Switching on
 With the ignition off, "flash" the head-lamps using the lever B.
 A second "headlamp flash" switches the function off again.
Switching off
The follow-me-home lighting switches off automatically after a set time.
Daytime lights
On vehicles fitted with daytime lights, the corresponding lights comes on when the vehicle is started*.
* According to country.
The instruments and controls (instru-ment panel, multifunction display, air conditioning control panel, ...) are not lit, except on switching to the automatic switching on of the lights mode or when the lights are switched on manually.
Exterior welcome lighting
The remote switching on of the lights makes your approach to the vehicle easier in poor light when in automatic switching on of the lights mode.
Switching on
 Press the open padlock on the re-mote control.
The dipped headlamps and the side lights come on; your vehicle is also unlocked.
Switching off
The exterior welcome lighting switches off automatically after a set time, when the ignition is switched on or on locking the vehicle.
Programming
The function is activated or deactivated via the multi-function display configura-tion menu.
Programming
The duration of maintaining of the lighting is selected via the multifunction dis-play configuration menu.
In countries in which this function is imposed by regulations*, it is activated by default.
The side lights and the number plate lights are also switched on.

!
i
80
Coupling with the "Follow-me-home" lighting
Association with the automatic lighting provides the "follow-me-home" lighting with the following additional options:
- selection of the duration of maintaining of the lighting for 15, 30 or 60 seconds in the vehicle parameters on the multi-function display configuration menu,- automatic activation of "follow-me-home" lighting when automatic light-ing is in operation.
Automatic lighting
The side lights and dipped headlamps are switched on automatically, without any action on the part of the driver, when a low level of external light is de-tected or in certain cases of activation of the windscreen wipers.
As soon as the brightness returns to a sufficient level or after the windscreen wipers are switched off, the lights are switched off automatically.
Activation
 Turn ring A to the "AUTO" position. The automatic lighting is accompa-nied by a message on the multifunc-tion display.
Deactivation
 Turn ring A to a position other than "AUTO". Deactivation is accompa-nied by a message on the multifunc-tion display.
Operating fault
In the event of a malfunction of the brightness sensor, the lights come on, this warning light is displayed on the instrument panel and/or a message appears on the multifunction display, accompanied by an audible signal.
In this case, contact a PEUGEOT dealer.
MANUAL HEADLAMP
ADJUSTMENT
To avoid causing a nuisance to other road users, the height of the halogen headlamps should be adjusted in rela-tion to the load in the vehicle.
0. 1 or 2 people in the front seats.
-. 3 people.
1. 5 people.
2. 5 people + maximum authorised load.
3. Driver + maximum authorised load.

!
i
80
Coupling with the "Follow-me-home" lighting
Association with the automatic lighting provides the "follow-me-home" lighting with the following additional options:
- selection of the duration of maintaining of the lighting for 15, 30 or 60 seconds in the vehicle parameters on the multi-function display configuration menu,- automatic activation of "follow-me-home" lighting when automatic light-ing is in operation.
Automatic lighting
The side lights and dipped headlamps are switched on automatically, without any action on the part of the driver, when a low level of external light is de-tected or in certain cases of activation of the windscreen wipers.
As soon as the brightness returns to a sufficient level or after the windscreen wipers are switched off, the lights are switched off automatically.
Activation
 Turn ring A to the "AUTO" position. The automatic lighting is accompa-nied by a message on the multifunc-tion display.
Deactivation
 Turn ring A to a position other than "AUTO". Deactivation is accompa-nied by a message on the multifunc-tion display.
Operating fault
In the event of a malfunction of the brightness sensor, the lights come on, this warning light is displayed on the instrument panel and/or a message appears on the multifunction display, accompanied by an audible signal.
In this case, contact a PEUGEOT dealer.
MANUAL HEADLAMP
ADJUSTMENT
To avoid causing a nuisance to other road users, the height of the halogen headlamps should be adjusted in rela-tion to the load in the vehicle.
0. 1 or 2 people in the front seats.
-. 3 people.
1. 5 people.
2. 5 people + maximum authorised load.
3. Driver + maximum authorised load.

!
i
81
DIRECTIONAL LIGHTING
When the dipped or main beam head-lamps are on, this function enables the light beam to follow the direction of the road.
The use of this function, coupled with the xenon headlamps only, consider-ably improves the quality of your light-ing when cornering.
with directional lighting
without directional lighting
Programming
Operating fault
The function is activated or deactivated via the multi-function display configura-tion menu.
If a malfunction occurs, this warning light flashes on the in-strument panel, accompanied by a message on the multifunc-tion display.
Contact a PEUGEOT dealer.
AUTOMATIC ADJUSTMENT
OF THE DIRECTIONAL
HEADLAMPS
In order to avoid causing a nuisance to other road users, this system corrects the height of the xenon headlamps beam automatically and when stationary, in re-lation to the load in the vehicle.
If a malfunction occurs, this warning light and/or the service warning light is displayed on the instrument panel, accompanied by an audible signal and a message on the multifunction display.
The system then places your headlamps inb the lowest position.