display Peugeot 308 SW BL 2013 Owner's Manual

20
FAMILIARISATION

Stop & Start

Going into engine STOP mode
Going into engine START mode
Deactivation / Activation DRIVING
SAFELY




161
You can deactivate the system at any
time by pressing "ECO OFF"
; the warn-
ing lamp in the button comes on.
The "ECO"
warning lamp comes on
in the instrument panel and the en-
gine automatically goes into standby: The "ECO"
warning lamp goes
off and the engine restarts au-
tomatically:


- with a manual gearbox
; when you
fully
depress the clutch pedal,

- with a 6-speed electronic gear
control gearbox;



●
gear lever in position A
or M
, when
you release the brake pedal,

●
or gear lever in position N
and the
brake pedal release, when you
move to position A
or M
,

●
or when you engage reverse.


- with a manual gearbox
; at speeds
below 12 mph (20 km/h), put the
gear lever into neutral, then release
the clutch pedal,

- with a 6-speed electronic gear
control gearbox
; at speeds below
5 mph (8 km/h), when you press
the brake pedal or move the gear
lever to position N
.
In certain circumstances, STOP mode
may not be available; the "ECO" warn-
ing lamp fl ashes for a few seconds,
then goes off.



160
If you change gear without com-
pletely declutching, the engine will
not restart automatically. An alert
message is displayed to encour-
age you to fully depress the clutch
pedal.



161
The system is reactivated auto-
matically at every new start using
the key.
Before refuelling or doing anything
under the bonnet, you must switch
off the ignition with the key. In certain circumstances, START mode
may be invoked automatically; the
"ECO"
warning lamp fl ashes for a few
seconds, then goes off.

21
FAMILIARISATION
DRIVING SAFELY

Speed limiter "LIMIT"
Display in the instrument panel



1.
Limiter mode Selection / Off.

2.
Decreasing of the programmed
value.

3.
Increasing of the programmed
value.

4.
Speed limiter On / Off.
The cruise control or speed limiter mode
appears in the instrument panel when it
is selected.

1.
Cruise control mode Selection / Off.

2.
Programming a speed / Decreasing
of the programmed value.

3.
Programming a speed / Increasing
of the programmed value.

4.
Cruise control Off / Resume.


Cruise control "CRUISE"


Cruise control

Speed limiter




165




163
In order to be programmed or activated,
the vehicle speed must be higher than
25 mph (40 km/h), with at least fourth gear
engaged on the manual gearbox (second
gear for the 6-speed electronic gear con-
trol gearbox or automatic gearbox). The values must be set with the engine
running.

22
FAMILIARISATION
DRIVING SAFELY

This 6-speed gearbox offers a choice
between the comfort of fully automatic
operation or the pleasure of manual
gear changing.


1.
Gear lever.

2.
Button "S" (sport)
.

3.
Steering wheel "-"
paddle.

4.
Steering wheel "+"
paddle.
The gear or the driving mode select-
ed appears in the instrument panel
screen.

N:
neutral.

R:
reverse gear.

1 2 3 4 5 6:
gears engaged.

AUTO:
automatic mode.

S:
Sport driving style.


Display in the instrument panel



)
Select position N
and press the
brake pedal fi rmly while starting the
engine.

)
Engage fi rst gear (position A
or M
)
or reverse (position R
) using the
gear lever 1
.

)
Release the parking brake.

)
Take your foot off the brake pedal
then accelerate.


Moving off




153



6-speed electronic gear control
gearbox

23
ECO-DRIVING
Eco-driving is a range of everyday practices that allow the motorist to optimise their fuel consumption and CO2 emissions.


Optimise the use of your
gearbox

With a manual gearbox, move off gen-
tly, change up without waiting and
drive by changing up quite soon. If
your vehicle has the system, the gear
shift indicator invites you to change up;
it is displayed in the instrument panel,
follow its instructions.

With an automatic or electronic gear-
box, stay in Drive "D"
or Auto "A"
, ac-
cording to the type of gearbox, without
pressing the accelerator pedal heavily
or suddenly.



Drive smoothly


Maintain a safe distance between ve-
hicles, use engine braking rather than
the brake pedal, and press the accel-
erator progressively. These practices
contribute towards a reduction in fuel
consumption and CO
2 emissions and
also helps reduce the background traf-
fi c noise.

If your vehicle has cruise control, make
use of the system at speeds above
25 mph (40 km/h) when the traffi c is
fl owing well.



Control the use of your
electrical equipment

Before moving off, if the passenger
compartment is too warm, ventilate it by
opening the windows and air vents be-
fore using the air conditioning.
Above 30 mph (50 km/h), close the win-
dows and leave the air vents open.
Remember to make use of equipment
that can help keep the temperature in
the passenger compartment down (sun-
roof and window blinds...).
Switch off the air conditioning, unless
it has automatic digital regulation, as
soon as the desired temperature is at-
tained.
Switch off the demisting and defrosting
controls, if not automatic.
Switch off the heated seat as soon as
possible.

Switch off the headlamps and front fo-
glamps when the level of light does not
require their use.
Avoid running the engine before moving
off, particularly in winter; your vehicle will
warm up much faster while driving.

As a passenger, if you avoid connecting
your multimedia devices (fi lm, music,
video game...), you will contribute to-
wards limiting the consumption of elec-
trical energy, and so of fuel.
Disconnect your portable devices be-
fore leaving the vehicle.

1
25
INSTRUMENTS and CONTROLS
TYPE 1 INSTRUMENT PANEL

Dials


5.
Screen.


6.
Control button.

Recalls the service information.
Resets the function to zero (trip
distance recorder or service
indicator).

7.
Instrument panel lighting button.

Adjusts the brightness of the lighting
of the instruments and controls.

1.
Rev counter.

Indicates the speed of rotation of
the engine (x 1000 rpm).

2.
Coolant temperature.

Indicates the temperature of the
engine coolant (° Celsius).

3.
Fuel level.

Indicates the quantity of fuel
remaining in the tank.

4.
Vehicle speed.

Indicates the current speed of the
moving vehicle (mph or km/h).

A.
Speed limiter

(mph or km/h) or
Cruise control.


B.
Gear shift indicator.


C.
6-speed electronic gear control
or automatic gearbox.


D.
Trip distance recorder.

(miles or km)

E.
Service indicator

(miles or km) then,
engine oil level indicator

then
distance recorder.

(miles or km)
These three functions are displayed
in succession when the ignition is
switched on.


Displays
For more information, refer to the
section on the button or function
and its associated display.

1INSTRUMENTS and CONTROLS












TYPE 2 INSTRUMENT PANEL

Dials


6.
Central screen.


7.
Control button.

Starts a manual CHECK and
recalls the service information.
Resets the function to zero (trip
distance recorder or service
indicator).

8.
Instrument panel lighting button.

Adjusts the brightness of the lighting
of the instruments and controls.

1.
Rev counter.

Indicates the speed of rotation of
the engine (x 1000 rpm).

2.
Coolant temperature.

Indicates the temperature of the
engine coolant (° Celsius).

3.
Fuel level.

Indicates the quantity of fuel
remaining in the tank.

4.
Vehicle speed.

Indicates the current speed of the
moving vehicle (mph or km/h).

5.
Small screen.


A.
Trip distance recorder.

(miles or km)

B.
Distance recorder.

(miles or km)

C.
Engine oil level indicator,

service indicator.

(miles or km)
These two functions are displayed
when the ignition is switched on,
then disappear after a few seconds.
Displays
For more information, refer to the
section on the button or function
and its associated display. The following functions are displayed
depending on the selection.


- Warning lamps / CHECK.



- Tyre under-infl ation detection.


- Speed limiter / Cruise control.


- Gear shift indicator.


- 6-speed electronic gear control
or automatic gearbox.


- Navigation - Guidance / Trip
computer.


- Alert messages symbol.

1INSTRUMENTS and CONTROLS












TYPE 3 INSTRUMENT PANEL WITH PEUGEOT CONNECT MEDIA
NAVIGATION (NG4 3D)


1.
Rev counter.

Indicates the speed of rotation of
the engine (x 1000 rpm).

2.
Coolant temperature.

Indicates the temperature of the
engine coolant (° Celsius).

3.
Fuel level.

Indicates the quantity of fuel
remaining in the tank.

4.
Vehicle speed.

Indicates the current speed of the
moving vehicle (km/h or mph).

5.
Small screen.


A.
Trip distance recorder.

(miles or km)

B.
Distance recorder.

(miles or km).

C.
Engine oil level indicator,

service indicator.

(miles or km)
These two functions are displayed
when the ignition is switched on,
then disappear after a few seconds.
The following functions are displayed
depending on the selection.


- Warning lamps / CHECK.


- Tyre under-infl ation detection.


- Speed limiter / Cruise control.


- Gear shift indicator.


- 6-speed electronic gear control
or automatic gearbox.


- Navigation - Guidance / Trip
computer.


- Vehicle and screen parameter
settings menus.


- Alert messages.






Dials


Displays

6.
Central screen.


7.
Control button.

Starts a manual CHECK and
recalls the service information.
Resets the function to zero (trip
distance recorder or service
indicator).

8.
Instrument panel lighting button.

Adjusts the brightness of the lighting
of the instruments and controls.
For more information, refer to the
section on the button or function
and its associated display.

1INSTRUMENTS and CONTROLS

*
According to country.









Instrument panel navigator associated
with the Peugeot Connect Media

Controls
There are four buttons to control the
large central instrument panel screen:


1.
access the main menu, confi rm the
selection,

2.
move up through the menu,

3.
move down through the menu,

4.
return to the previous screen, exit
from the menu.
Main menu


)
Press button 1
for access to the
main menu and select one of the
following functions:


- "Vehicle parameters",

- "Choice of language",

- "Choice of units".

)
Press button 2
or 3
to move on the
screen.

)
Press button 1
again to confi rm the
selection.
The main menu and its associated
functions can only be accessed
when stationary, via buttons 1
to 4
.
A message appears on the cen-
tral screen above a certain speed
threshold, indicating that the main
menu cannot be displayed.
The trip computer displays can
only be accessed while driving, via
buttons 2
and 3
(refer to the "Trip
computer" section). This group of buttons permits:


- when stationary
, confi guration of
the vehicle's equipment and of the
parameters of the central screen
(languages, units...),

- while driving
, scrolling of the
active functions (trip computer,
navigation...).


Vehicle parameters
This menu allows you to activate or
deactivate certain driving and comfort
equipment:


- wiper linked with reverse gear
(refer to the "Visibility" section),

- guide-me-home and welcome lighting
(refer to the "Visibility" section),

- interior mood lighting (refer to the
"Visibility" section),

- daytime running lamps (refer to the
"Visibility" section),

- directional headlamps (refer to the
"Visibility" section),

- rear parking sensors (refer to the
"Driving" section).


Choice of language
This menu allows you to select the lan-
guage used by the display: Deutsch,
English, Espanol, Français, Italiano,
Nederlands, Portugues, Türkçe * .

Choice of units
This menu allows you to select the
units: temperature (°Celsius or °Fahr-
enheit) and consumption (l/100 km,
mpg or km/l).

1
31
INSTRUMENTS and CONTROLS




Service


temporarily,
accompanied
by a message. Minor faults have occurred
for which there is no
specifi c warning lamp. Identify the fault by reading the message
displayed in the screen, such as:


- doors, boot or bonnet open,

- low engine oil level,

- low screenwash/headlamp wash reservoir
level,

- remote control battery fl at,

- low tyre pressures,

- saturation of the particle emission fi lter on
Diesel vehicles (see Checks - checking
levels / particle emissions fi lter).
For any other faults, contact a PEUGEOT dealer
or a qualifi ed workshop.

fi xed,
accompanied
by a message
and an audible
signal. Major faults have occurred
for which there is no
specifi c warning lamp. Identify the fault by reading the message shown
in the screen and you must then contact
a
PEUGEOT dealer or a qualifi ed workshop.

Warning lamp



is on



Cause



Action / Observations




Engine
autodiagnosis
system


fl ashing. The engine management
system has a fault. Risk of destruction of the catalytic converter.
Have it checked by a PEUGEOT dealer or a
qualifi ed workshop.

fi xed. The emission control
system has a fault. The warning lamp should go off when the engine
is started.
If it does not go off, contact a PEUGEOT dealer
or qualifi ed workshop without delay.

1INSTRUMENTS and CONTROLS








The other warning lamps appear only in this instrument panel.
The illumination of certain warning lamps may be accompanied by an audible sig-
nal; an additional message is still displayed in the multifunction screen, to help you
identify the fault.


Warning lamp



is on



Cause



Action / Observations






Door(s) open


fi xed if the
speed is
below 6 mph
(10 km/h).
A door or the boot is still
open. Close the door or boot.
fi xed and
accompanied
by an audible
signal if the
speed is
above 6 mph
(10 km/h).




Engine oil
pressure


fi xed. There is a fault with the
engine lubrication system. You must stop as soon it is safe to do so.
Park, switch off the ignition and contact a
PEUGEOT dealer or a qualifi ed workshop.




Battery
charge

*

fi xed. The battery charging circuit
has a fault (dirty or loose
terminals, slack or cut
alternator belt, ...). The warning lamp should go off when the engine
is started.
If it does not go off, contact a PEUGEOT dealer
or a qualifi ed workshop. If they are associated with the STOP
warning lamp, you must stop the vehicle
as soon as it is safe to do so!

*
According to destination country.