bulb PEUGEOT 4007 2010.5 Owners Manual

Page 2 of 215

1
INSTRUMENTS and CONTROLS
INSTRUMENT PANEL WARNING LAMPS

Warning lamp is on Cause Actions/
Observations
Left-hand
direction
indicator Flashing
with
audible
warning This fl ashes when you
press the lighting stalk
down. If this indicator lamp fl ashes abnormally quickly,
this could indicate that the bulb of one of the
direction indicators has blown. Change the bulb
or contact a PEUGEOT dealer.
Right-hand
direction
indicator Flashing
with
audible
warning This fl ashes when you
push the lighting stalk up. If this indicator lamp fl ashes abnormally quickly,
this could indicate that the bulb of one of the
direction indicators has blown. Change the bulb
or contact a PEUGEOT dealer.
Main beam
headlamps Fixed This comes on when
you pull the lighting stalk
towards you. Pull the stalk to return to dipped beam
headlamps.
Sidelamps Fixed This comes on when the
lighting stalk is in the
"Sidelamps" or "Dipped
beam headlamps"
position. Turn the stalk to the desired position.
Front foglamps Fixed This comes on when you
use the front foglamps. Turn the ring on the stalk forwards to switch on
the foglamps.
Rear foglamps Fixed This comes on when you
use the rear foglamps. Turn the ring on the stalk forwards to switch on
the foglamps.
Cruise control Fixed This comes on when the
mode is active. Press the "ON/OFF" button to activate/deactivate
the mode.

Page 8 of 215

1
INSTRUMENTS and CONTROLS

Message is on Cause Solution - action Observations
Dynamic
stability control system (ASC) Fixed
Dynamic stability control
system (ASC) fault. Consult a PEUGEOT
dealer.

Four wheel
drive system Fixed Four wheel drive
transmission system
fault. Consult a PEUGEOT
dealer.

Four wheel
drive system temperature Fixed The temperature of the
four wheel drive
transmission system is
too high. Stop the vehicle and
contact a PEUGEOT
dealer.
The vehicle switches to
front wheel drive (2 WD)
mode automatically.

Automatic
headlamp
adjustment system Fixed
The automatic headlamp
adjustment is faulty. Consult a PEUGEOT
dealer. Only on vehicle fi tted
with xenon bulbs.
Battery charge Fixed Battery charge fault. Stop the vehicle and
contact a PEUGEOT
dealer.

Ambient
temperature Fixed The ambient
temperature is 3 °C
(37 °F) or below. Road icy.
Take care and drive
slowly. Caution: The road may
be icy even when this
screen is not displayed.

Page 130 of 215

9
PRACTICAL INFORMATION
CHANGING CHANGING A BULB
Handle the bulbs using a dry
cloth.

Do not clean the headlamps
using a dry or abrasive cloth,
or using detergent or solvent
products, use a sponge and
soapy water. In some weather conditions (e.g.
low temperature or humidity),
the presence of misting on the
internal surface of the glass of
the headlamps and rear lamps
is normal; it disappears after the
lamps have been on for a few
minutes.
Front lamps

1. Direction indicators

(PY21W - 21 W).

2. Dipped
beam
headlamps
(H11 - 55 W)

or xenon bulb (D2S - 35 W).

3. Sidelamps
(W5W - 5 W).

4. Main beam headlamps (H7 - 55 W).

5. Front
foglamps

(H11 - 55 W). WARNING: RISK OF
ELECTROCUTION
Xenon bulbs must be replaced by a
PEUGEOT dealer.

Page 131 of 215

9
PRACTICAL INFORMATION
Direction indicators (1) Coloured bulbs must be re-
placed with bulbs of identical
specifi cation and colour.

 Turn the bulb holder A to the left
and remove it.

 Pull the bulb and change it.
To refi t, carry out these operations in
reverse order. Access to the bulbs on the left-hand
side
When you change a bulb on the left-
hand side, remove the relay box fi xing
nut
B and move the relay box towards
the rear. Access to the bulbs on
the right-hand side
When you change a bulb on the right-
hand side:

 Remove the screenwash reservoir
fi xing C and move the reservoir to-
wards the rear.

 Remove the coolant reservoir fi xing
nut D .

 Remove the clip E and raise the re-
servoir moving it towards the front.

Page 132 of 215

9
PRACTICAL INFORMATION
Changing sidelamp bulbs (3)

 Unscrew the cover H .

 Disconnect the connector.

 Turn the bulb holder I a quarter of a
turn and remove it.

 Pull the bulb and change it.
To refi t, carry out these operations in
reverse order.

 Unscrew the cover F .

 Disconnect the connector.

 Turn the bulb G to the left and re-
move it.
To refi t, carry out these operations in
reverse order.
Changing dipped beam headlamp
bulbs (2)
Changing main beam headlamp
bulbs (4)

 Unscrew the cover J .

 Disconnect the connector.

 Move aside the spring K to release
the bulb and remove it.
To refi t, carry out these operations in
reverse order.

Page 133 of 215

9
PRACTICAL INFORMATION

 Push the repeater A towards the
rear and detach it.

 Unclip the repeater.

 Disconnect the repeater connector
and change the repeater.
To refi t, carry out these operations in
reverse order.
To obtain repeaters, contact a PEUGEOT
dealer.
Changing integrated direction
indicator side repeaters

 Remove the protective cover B by
pulling it towards the front.
Changing foglamp bulbs (5)

 Remove the three screws C then
pull the lamp holder towards you.
 Disconnect the connector D .

 Turn the bulb E to the left and re-
move it.
To refi t, carry out these operations in
reverse order.

Page 134 of 215

9
PRACTICAL INFORMATION
Rear lamps

1. Third brake
lamp
(
LEDs
).

2. Brake
lamps
/
Sidelamps

(21/5 - W21W - 5 W).

3. Direction indicators
(WY21W - 21 W).

4. Reversing
lamps
(W21W - 21 W).

5. Number plate
lamps
(W5W - 5W).

6. Foglamps
(W21W - 21 W). Changing brake lamp/sidelamp and
direction indicator bulbs
These two bulbs are changed from out-
side with the tailgate open:

 Open the tailgate (refer to the
"Access" section),

 Remove the two lamp fi xing bolts A ,

 Extract the lamp unit from outside,

Turn the pin C to the left and remove it.

 Pull the bulb D out and change it.
To refi t, carry out these operations in
reverse order.

 Turn the pin B to the left and remove it.

 Pull the bulb out and change it. When refi tting the lamp unit, align the
two pins
E with the openings on the ve-
hicle.
Amber coloured bulbs, such as
the direction indicators, must be
replaced with bulbs of identical
specifi cation and colour.
Changing the third brake lamp
(LEDs)
All work on the LED lamps must be car-
ried out by a PEUGEOT dealer.

Page 135 of 215

9
PRACTICAL INFORMATION
Changing reversing lamp bulbs

 Open the tailgate (refer to the
"Access" section),

 From the inside of the tailgate, in-
sert a screwdriver in the opening on
the cover A to use it as a lever to
open the cover. Changing number plate lamp bulbs

 Open the tailgate (refer to the
"Access" section) to gain access to
the number plate lamps D ,

 Remove the lamp unit D while
pressing it to the left.


Turn the pin B to the left and remove it.

 Pull the bulb C out and change it.
To refi t, carry out these operations in
reverse order.
 Insert a thin screwdriver in the open-
ing on the lens to press the tab E .

 Remove the lens.

 Pull the bulb out and change it.
To refi t, carry out these operations in
reverse order.

 To refi t the lamp unit, insert the end of
the tab F fi rst, then align the tab G .

Page 136 of 215

9
PRACTICAL INFORMATION
Changing foglamp bulbs

 Open the tailgate and the lower tail-
gate (refer to the "Access" section)
and fold down the cover A .

 Remove the 4 clips B using a screw-
driver to detach the lamp cover.

 Remove the bolts C and remove the
lamp unit.
 Turn the pin and bulb assembly D to
the left.

 Remove the bulb.
To refi t, carry out these operations in
reverse order.

 When refi tting the lamp unit, align
the clips E with the openings on the
bodywork.

Page 148 of 215

9
PRACTICAL INFORMATION
The fi tting of electrical equip-
ment or accessories which are
not recommended by PEUGEOT
may result in a failure of your
vehicle's electronic system.
Please note this specifi c warn-
ing. You are advised to contact
a your dealer to be shown the
range of recommended equip-
ment and accessories.
ACCESSORIES ACCESSORIES
"Protection": "Touring":
"In-car technology":
"Styling":
"Universal":
* To prevent any risk of jamming of the pedals:
- ensure that the mat is positioned and secured correctly,
- never fi t one mat on top of another. Depending on the country in
which the vehicle is sold, it is
compulsory to have a high vis-
ibility jacket, warning triangle
and spare bulbs available in the
vehicle.
anti-theft alarm, window etch-
ing, wheel security bolts, fi rst
aid kit, warning triangle, high
visibility jacket, stolen vehicle
tracking system, anti-skid cov-
ers, tyre under-infl ation detec-
tion, rear parking sensors. mats * , boot tray, dog guard,
PVC door sills, cool box.
For leisure pursuits: roof bars,
bicycle carrier on roof bars,
ski carrier, roof box, booster
seats and child seats, side
blinds.
Trailer towbar which must be fi tted by
the PEUGEOT network.
MP3/USB audio systems,
audio-telephone, amplifi ers,
satellite navigation systems,
hands-free kit, speakers, DVD
player, connection kit for MP3
player or portable CD player,
rear parking sensors, alarm. door defl ectors, rear styling
strips, 18 inch alloy wheels,
chromed exterior mirror shells,
chromed door handle shells,
diffuser on rear bumper, side
protection mouldings, aluminium
boot sill.
screenwash, interior and ex-
terior maintenance and clean-
ing products.
It is advisable to contact a
PEUGEOT dealer before install-
ing accessory radio communica-
tion transmitters with an external
aerial on your vehicle.
The PEUGEOT network will pro-
vide the specifi cations (frequency
band, maximum output power,
aerial position, special installa-
tion conditions) of the transmitters
which can be fi tted, in accordance
with the Motor Vehicle Electro-
magnetic Compatibility Directive
(2004/104/EC).
You can obtain a wide range of
accessories and original parts from the
PEUGEOT network.
These accessories and parts have
been tested and approved for reliability
and safety.
They are all adapted to your vehicle
and benefi t from PEUGEOT's recom-
mendation and warranty.
The product range offered by PEUGEOTAccessories is structured around 5 categories: PROTECTION - TOURING - IN-CAR TECHNOLOGY - STYLING -
UNIVERSAL.