battery PEUGEOT 4007 2012 Owners Manual

Page 5 of 236

7
89
1011
CONTENTS
3
Parking brake 112
Manual gearbox 112
CVT gearbox 113
DCS gearbox 115
Four wheel drive system 119
Cruise control 121
Audible rear parking sensors 123
Reversing camera 124







DRIVING 112 Î 124
Bonnet 126
Running out of fuel 126
Petrol engine 127
Diesel engine 128
Checking levels 129
Checks 130





CHECKS 125 Î 131
Changing a wheel 132
Changing a bulb 137
Changing a fuse 144
Battery 149
Changing a wiper blade 151
Towing 152
Towing a trailer 154
Fitting roof bars 155
Accessories 156








PRACTICAL
INFORMATION 132 Î 156
Engines 157
Weights 158
Dimensions 159
Identifi cation markings 160



TECHNICAL
DATA 157 Î 161
Audio CD system 162
CD changer 173
Error messages 175
Audio-Telematic System 176
Navigation 178
DVD mode 206
Hands-free telephone 214






AUDIO EQUIPMENT and
TELEMATICS 162 Î 221
VISUAL
SEARCH 222 Î 228
ALPHABETICAL
INDEX 229 Î 232

Page 25 of 236

1
INSTRUMENTS and CONTROLS


Warning lamp



is on



Cause



Actions/Observations







Diesel
preheating
Fixed This comes on when the
ignition switch is in the
ON position. Wait until this goes off before starting.
The duration for which this is on is determined by
the exterior climatic conditions.




Parking brake/
Brake fl uid level
Fixed This comes on for a
few seconds when the
ignition is turned to "ON"
then goes off. It is accompanied by a message on the
instrument panel screen.
The parking brake is
applied or has not been
released fully. It is accompanied by a message on the
instrument panel screen. Release the parking
brake to switch off the warning lamp.
The brake fl uid level is
too low. It is accompanied by a message on the
instrument panel screen. Top up with brake fl uid
and contact a PEUGEOT dealer or a qualifi ed
workshop.




Emission
control system
Fixed or
fl ashing This comes on or
fl ashes in the event of a
fault with the system. Contact a PEUGEOT dealer or a qualifi ed
workshop.
It should go off a few seconds after starting the
engine.




Battery charge
Fixed This comes on if a
charging circuit fault
occurs. It should go off when the engine is started.
It is accompanied by a message on the
instrument panel screen. Check the battery
terminals (refer to the "Battery" section).

Page 30 of 236

1
INSTRUMENTS and CONTROLS


Message



is on



Cause



Solution - action



Observations








Dynamic
stability
control system
(ASC)
Fixed Dynamic stability control
system (ASC) fault. Contact a PEUGEOT
dealer or a qualifi ed
workshop.






Four wheel
drive system
Fixed Four wheel drive
transmission system
fault. Contact a PEUGEOT
dealer or a qualifi ed
workshop.





Four wheel
drive system
temperature
Fixed The temperature of
the four wheel drive
transmission system is
too high. Stop the vehicle and
contact a PEUGEOT
dealer or a qualifi ed
workshop. The vehicle switches to
front wheel drive (2 WD)
mode automatically.





Automatic
headlamp
adjustment
system
Fixed The automatic headlamp
adjustment is faulty. Contact a PEUGEOT
dealer or a qualifi ed
workshop. Only on vehicle fi tted
with xenon bulbs.




Battery charge
Fixed Battery charge fault. Stop the vehicle and
contact a PEUGEOT
dealer or a qualifi ed
workshop.





Ambient
temperature
Fixed The ambient
temperature is 3 °C
(37 °F) or below. Road icy.
Take care and drive
slowly. Caution: The road may
be icy even when this
screen is not displayed.

Page 34 of 236

1
INSTRUMENTS and CONTROLS
The total distance is dis-
played in zone 1
of the
screen and the trip dis-
tance in zone 2
.
DISTANCE RECORDERS (A/B)

System for measuring the total distance
travelled by the vehicle during its ser-
vice life and the distance travelled in
a day or other period until it is reset to
zero by the driver.

Zero reset

With the ignition on, press the INFO
button for more than 2 seconds until
zeros appear.

When the engine is run-
ning, this indicates the tem-
perature of the coolant.
COOLANT TEMPERATURE
If the bar is close to the critical
position
located on the right, the temperature is
too high.
The symbol fl ashes when your engine
is overheating.

You must stop your vehicle as soon
as it is safe to do so.


Wait a few minutes before switching
off the engine.

Wait for the engine to cool be-
fore topping up the level. The
cooling system is pressurised.
When the engine is
running
, this indicates
the distance which can
still be travelled with
the fuel remaining in the
tank based on the aver-
age fuel consumption
over the last few miles/
kilometres travelled.
RANGEGE
When the range is less than 30 miles
(50 km)
, dashes are displayed.
Refuel as soon as possible. The display
of the range is updated.
To avoid any risk of scalding,
unscrew the cap by two turns to
allow the pressure to drop.
When the pressure has dropped, remove the cap and top up the
level, if necessary.
Contact a PEUGEOT dealer or
a qualifi ed workshop. This fi gure may increase fol-
lowing a change in the style of
driving or the relief, resulting in
a reduction in the current fuel
consumption.
If you only add a few litres, the
value displayed will be incorrect.
Therefore, you must fi ll the tank
whenever possible.
When you disconnect the bat-
tery, the previous fuel consump-
tion data is lost and the value
displayed will be different from
that displayed before the battery was disconnected. The distance
displayed must be considered
an approximate indication.

Page 38 of 236

1
INSTRUMENTS and CONTROLS

Choice of the fuel consumption
units
You can choose between different units
for displaying fuel consumption. On the menus screen:


)
press the INFO
button to select
"UNIT"
.

)
press and hold the INFO
button for
a few seconds to display the "UNIT"

screen.

)
press the INFO
button to scroll the
units (km/L, L/100 km, mpg (US),
mpg (UK) and PREVIOUS) in suc-
cession.

)
press and hold the INFO
button for
a few seconds to confi rm your se-
lection. In this case, the distance, speed and
quantity of fuel units will also be changed
in accordance with your choice of fuel
consumption unit. If the battery is disconnected,
the settings memory is cleared
and the default unit (km/L) is re-
stored automatically.


Choice of the temperature
display unit
You can choose between different units
for displaying the temperature.
On the menu screen:


)
press the INFO
button to se-
lect the temperature unit set-
ting symbol (thermometer).

)
press and hold the INFO
button for
a few seconds to scroll the units
(°C and °F) in succession.
The mode selected is confi rmed.
If the battery is disconnected,
the settings memory is cleared
and the default unit (°C) is re-
stored automatically.


Choice of the reinitialisation of
the average consumption and
average speed
You can choose between two average
fuel consumption and average speed
reinitialisation modes:


- automatic reinitialisation (
choice 1)
,

- manual reinitialisation (choice 2)
.
On the menu screen:


)
press the INFO
button to select:

)
press and hold the INFO
button for
a few seconds to switch in succes-
sion from reinitialisation mode 1



(au-
tomatic)
to reinitialisation mode 2
(manual)
.
The mode selected is confi rmed.

Page 39 of 236

1
INSTRUMENTS and CONTROLS

Choice of the display language

On the menu screen:


)
press the INFO
button to select
"LANGUAGE"
.


)
press and hold the INFO
button
for a few seconds to display the
"LANGUAGE"
screen.

)
press the INFO
button to scroll
the languages (Japonais, English,
Deutsch, Français, Espanol, Italiano,
"---" and PREVIOUS) in succes-
sion.

)
press and hold the INFO
button for
a few seconds to confi rm your se-
lection.
If you select the "---" setting, no
message will be displayed in
message display situations. If the battery is disconnected, the
settings memory is cleared and
the default language (ENGLISH)
is restored automatically.


Activation/deactivation of the
"INFO" button sound
You can activate or deactivate the INFO
button sound.
On the menu screen:


)
press the INFO
button to se-
lect the INFO
button sound
activation/deactivation sym-
bol (located on menu 2/3)
.

)
press and hold the INFO
button for
a few seconds to scroll the choices
(ON, OFF) in succession.
The mode selected is confi rmed.
If the battery is disconnected,
the settings memory is cleared
and the default choice (ON) is
restored automatically.


Changing the display interval
of the "BREAK REMINDER"
message
On the menu screen:


)
press the INFO
button to select
"ALERT" (located on menu 2/3)
.

)
press and hold the INFO
button
for a few seconds to display the
"ALERT"
screen.


)
press the INFO
button to select
the display interval of the "BREAK
REMINDER"
message.

)
press and hold the INFO
button for
a few seconds to confi rm.
If the battery is disconnected,
the settings memory is cleared
and the default value (OFF) is
restored automatically.

You can choose between different lan-
guages for the display. You can change the display interval of
the "BREAK REMINDER"
message.

Page 53 of 236

2
COMFORT

Electric mode (driver's seat only)


Forwards-backwards adjustment

Push the control forwards or rearwards to
move the seat to the position required.


Driver's seat cushion height and
angle adjustment
Pull or push the front of the control to raise
or lower the front of the seat cushion.
Pull or push the rear of the control to raise
or lower the rear of the seat cushion.
Pull or push the entire control to raise or
lower the entire seat cushion.
Seat back angle adjustment
Tilt the control forwards or rearwards to
straighten or tilt the seat back.
ONT SEATSFRONT SEATS
To avoid discharging the battery,
use the electric mode with the
engine running.

Page 68 of 236

2
COMFORT

Upper storage compartment
Pull the right-hand lever to open the
storage compartment lid, which serves
as an armrest.
To close, fold down the lid until it locks.
Lower storage compartment









12 V socket (120 W max)









Armrest with storage compartments
12 V socket (120 W max)
This is operational when the ignition
switch is in the "LOCK", "ON" or "ACC"
position.
Check that the electrical equipment op-
erates on 12 volts and that its electrical
power is 120 W maximum.
The prolonged use of electrical
equipment without running the en-
gine may discharge the battery.
Pull the left-hand lever to open the lid.
To close, fold down the lid until it locks.

Page 69 of 236

2
COMFORT







Removable ashtray
Pull the cover to open the ashtray.
To empty, remove the ashtray by pulling
it upwards.







12 V socket (120 W max)
This operates when the ignition switch is
in the "LOCK", "ACC" or "ON" position.
Open the cover to gain access to the
socket. Check that the electrical equip-
ment operates on 12 V and that
its maximum electrical power is
120 W.
When you use the two sockets
at the same time, ensure that
the two items of equipment to-
gether operate on 12 V and that
their combined electrical power
is 120 W maximum.
The prolonged use of electrical
equipment without running the en-
gine may discharge the battery.

Page 77 of 236

3
ACCESS









Starting the vehicle



)
Insert the key in the ignition switch.

)
Operate the starter by turning the
key to position 4 (START)
.

)
When the engine turns over, release
the key. The ignition switch is placed
in position 3 (ON)
automatically.



Switching the vehicle off



)
Park the vehicle.

)
While pressing the key, turn it to-
wards you to position 1 (LOCK)
.

)
Remove the key from the ignition
switch.


Changing the battery
Battery reference: CR1616/3 volts.


)
Unclip the casing using a coin at the
notch.

)
Slide the fl at battery out of its housing.

)
Slide the new battery into its housing
observing the original direction.

)
Clip the casing.









Key in ignition

A buzzer sounds on opening the
driver's door, if the key has been
left in the ignition.

Page:   1-10 11-20 21-30 next >