light PEUGEOT 4008 2012 Owner's Manual

87
3
Comfort





Rear view mirror
Adjustable mirror providing a central rear ward view.
Equipped with an anti-dazzle system, which darkens the mirror glass and reduces the nuisance to
the driver caused by the sun, headlamps from other vehicles...


Manual day/night model

Ad
justment
)
Adjust the mirror so that the glass is directed correctly in the "day" position.


As a safety measure, the mirrors should be adjusted to reduce the "blind spot".


In order to ensure optimum visibilityduring your manoeuvres, the mirror lightens automatically when reverse gear is engaged.



Day / night position
)
Pull the lever to change to the "night"
anti-dazzle position.) Push the lever to change to the normal
"day" position.
Automatic day/night model
By means of a sensor, which measures the
light from the rear of the vehicle, this system automatically and progressively changes
between the day and night uses.








Steering wheel adjustment
)When stationary, lower the control lever yto release the steering wheel adjustment mechanism. )
Adjust the height and reach to suit your
driving position.) Pull the control lever to lock the steering
wheel adjustment mechanism.

As a safety precaution, these operations should only be carried out while the vehicle is stationary.

98
Comfort























Front fi ttings

Sun visor. 2.
Glove box.3.
Portable ashtray.
4.
Cigarette lighter
12 V socket (120 W max).5. Armrest with storage compar tments.
6.Cup holder.
7. Bottle holder.

100
Comfort





Portable ashtray
)Pull the cover to open the ashtray. )To e m p ty it, remove the ashtray by pulling it upwards.









Cigarette lighter /
12 V accessory
socket
) To use the cigarette lighter, press it in
and wait a few seconds until it pops out
automatically.) To connect a 12 V accessory (max power:
120 W), remove the cigarette lighter and
connect a suitable adaptor.
You can use this socket to connect a telephone
charger, a bottle warmer...
After use, put the cigarette lighter back into
place straight away.

105
3
Comfort
Stowing rings
There are four stowing rings in the boot for
securing luggage:
- two rings are located on the boot floor,
- two rings are located on the rear side
pillars.
T
o remove the shelf: )unhook the two cords, )raise the shelf slightly, then remove it.
There are several options
for storing the shelf:


- either upright behind the front seats,

- or flat at the base of the boot.

106
Driving








Starting - stopping the engine with the key
- Position 1: LOCKThe steering is locked.
- Position 2: ACCThe accessories (radio, 12 V socket...) can be used. - Position 3: ONIgnition on.
- P
osition 4: STARTStarting the engine.
Ignition switch


If you use the accessories for aprolonged period (with the key in position 2 (ACC)), you risk dischargingthe battery. Starting your vehicle will then no longer be possible. Be aware. See the "Automatic power cut-off toaccessories" section.

Key in ignition
A buzzer sounds on opening the driver'sdoor, if the key has been left in the ignition.
)
Inser t the key in the ignition switch.)
Turn the key to position 2 (ACC)
and unlock the steering column, by turning
wheel slightly. ) Press and hold the brake pedal.)
Fully depress the clutch pedal (vehicles fitted with a manual gearbox). )
Put the gear lever into neutral (vehicles fitted with a manual gearbox), or in position P(vehicles fitted with a CVT
gearbox). ) Operate the star ter by turning the key to
position 4 (START).) Once the engine is running, release the key.
The key returns automatically to
position 3 (ON).

Starting using the key
Stopping
)Immobilise the vehicle. )Put the gear lever into neutral (vehiclesfitted with a manual gearbox), or inposition P
(vehicles fitted with a CVT gearbox).)While pressing the key, turn it to position 1 (LOCK).)Remove the key from the ignition switch.)Lock the steering.


Do not attach any heavy objects to the key as this could weigh down on it whenin the ignition switch and cause a fault.
For Diesel vehicles, when the engineis cold wait with the ignition switchin position 3 (ON)
until the preheater warning lamp goes off, before turningthe key to position 4 (START)
. The warning lamp does not come on when the engine is hot.

108
Driving

For Diesel vehicles, when the engine is cold star ting does not take place until thepre-heater warning lamp has gone off.


If one of the star ting conditions is not met, a reminder message appears inthe instrument panel screen. In somecircumstances, it is necessary toturn the steering wheel slightly whilepressing the "START/STOP" buttonto assist unlocking of the steering; a message warns you when this isneeded.
The presence of the electronic keyin the defined zone is essential. For
reasons of safety, do not leave this area when the engine is running.


Switching off using the
electronic key


If the vehicle is not immobilised, theengine will not stop.
This messa
ge is displayed
when the driver's door isopened and the vehicle is not
in "OFF" mode.
)Press the "START/STOP" button again to change to "OFF" mode.
)Immobilise the vehicle.
)Place the gear lever in neutral for vehicles fitted with a manual gearbox, or on P
for
vehicles fitted with a CVT gearbox
. )With the electronic key inside the vehicle, press the " START/STOP
" button.
The engine stops.
The steering locks when a door is opened or on
locking the vehicle. Each attempt at star tin
g takes around
15 seconds. If the en
gine does not star t, press
the "START/STOP
" button once more to tryagain.
The presence of the electronic key inthe vehicle is essential for switching on the ignition and star ting only. Once theengine has started, make sure that the electronic key remains with the vehicle until the end of the journey: other wiseyou would not be able to lock the vehicle.

119
4
Driving








Stop & Start (Auto Stop & Go) function


Operation


Going into engine STOP mode
The "AS &G "
warning lamp comes on in
the instrument panel or the instrument panel screen and the engine goes intostandby after a few seconds:


- with a manual
gearbox
, with the vehicle stationary and your foot on the brake, whenyou put the gear lever into neutral andrelease the clutch pedal.

Never refuel with the engine in STOPmode; you must switch off the ignition with the key or the START/STOP button.
When the engine is stopped automatically, the operation of certainvehicle systems, such as for example,braking, power steering... are modified. Take care.


Special cases: STOP mode notavailable
STOP mode is not invoked when:


- the driver's seat belt is not fastened,

- the bonnet is open,

- the vehicle has not exceeded 3 mph (5 km/h) since the last engine start,

- the vehicle has restarted less than10 seconds ago,

- the engine is needed to maintain acomfor table temperature in the passenger compartment,

- demisting is active,

- some special conditions (battery charge, engine temperature, braking assistance,
ambient temperature...) where the engine isneeded to assure control of a system.

- th
e "AS&G"warning lamp is
flashing in the instrument panel.
This operation is perfectl
y normal.

The Stop & Star t (Auto Stop & Go) function puts the engine temporarily into standby during stops in the traffic (red lights, traffic jams, or other...). Theengine restarts automatically as soon as you want to move off. The restart takes place instantly, quickly and silently.
Per fect for urban use, the Stop & Star t (Auto Stop & Go) function reduces fuel consumption and exhaust emissions as well as the noise level whenstationary.

131
5
Visibility





Lighting controls
Stalk for selecting and switching the vehicle's
front and rear exterior lamps. Main lighting
The various front and rear lamps of the vehicle are designed to adapt the lighting progressively in relation to the climatic conditions and soensure the best visibility for the driver:
- sidelamps, to be seen,
-
dipped beam headlamps to see withoutdazzling other drivers,
- main beam headlamps to see clearly when
the road is clear.

Additional lighting
Other lamps are provided to fulfil the
requirements of par ticular driving conditions:


- a rear foglamp to be seen from a distance,

- front foglamps for even better visibility,

- daytime running lamps to be seen during
the day.
In some weather conditions (e.g. low temperature or humidity), the presence of misting on the internal sur face of theglass of the headlamps and rear lampsis normal; it disappears after the lamps have been on for a few minutes.

Other lighting functions are also available: - automatic illumination of headlamps,- guide-me-home lighting, - welcome lighting.


When using your vehicle in a countrythat drives on the other side of theroad, the headlamps must be adjusted to avoid dazzling on-coming drivers. Contact a PEUGEOT dealer or a qualified workshop.

132
Visibility
Model without AUTO lighting
Model with AUTO lighting

Manual controls
The lighting is controlled directly by the driver by means of the ring A
and the stalk B
.
Lamps off.
Automatic illumination of headlamps.
Sidelamps.
Dipped headlamps or main beam headlamps.


Displays

Illumination of the corresponding indicator
lamp in the instrument panel confirms that the
lighting selected is on.
A. Main lighting mode selection ring: turn it
to position the symbol required facing the
mark.
B. Stalk for switching headlamps: pull the stalk
towards you to switch the lighting between dipped and main beam headlamps.
In the lamps o
ff and sidelamps modes, thedriver can switch on the main beam headlamps
temporarily ("headlamp flash") by maintaining a pull on the stalk.

133
5
Visibility
rear foglamp
Rotate and release the rin
g C:) forwards a first time to switch on the front foglamps,)
forwards a second time to switch on the rear foglamp,)
rearwards a first time to switch off the rear foglamp,)
rearwards a second time to switch of thefront foglamps.
In good or rainy weather, both dayand night, the front foglamps and the rear foglamps are prohibited. In these situations, the power of their beams
may dazzle other drivers.
Do not forget to switch off the front foglamps and the rear foglamps when they are no longer necessary.
Model with front foglamps and a rear foglamp
Foglamp selection ring
.
The
y operate if at least the sidelamps are on.
) To switch on the rear foglamp, turn the ring C
forwards. )
To switch off the rear foglamp, turn thering C
rearwards.


front and rear fo
glamps

Lighting on reminder

An audible signal when the driver's door is opened warns the driver if the vehiclelighting is on, with the ignition off.
Switching off the lighting stops theaudible signal.