belt PEUGEOT 4008 2012 Owners Manual

Contents
Direction indicators 145
Hazard warning lamps 145
Horn 145
Braking assistance systems 146
Tr ajectory control systems 148
Front seat belts 150
Airbags 154
Child seats 159
ISOFIX child seats 164
Child lock 169
Safety
Te m p o r a ry puncture repair kit 170
Changing a wheel 174
Changing a bulb 180
Changing a fuse 186
12 V battery 192
Automatic power cut-off to accessories 195
Changing a wiper blade 195
Recovering the vehicle 196
To w i ng a trailer 199
Fitting roof bars 201
Accessories 202
Practical information
Bonnet 205
Petrol engines 206
Diesel engines 207
Fuel tank 208
Running out of fuel (Diesel) 210
Checking levels 211
Checks 214
Checks
Petrol engines 217
Petrol weights 218
Diesel engines 219
Diesel weights 220
Dimensions 221
Identifi cation markings 222
Technical data
AUDIO-TELEMATIC system 223
AUDIO- CD system 283
Audio equipment and telematics
Alphabetical index
Visual search

14
Familiarisation
Sitting comfortably
A.
Selection of the mirror to adjust. B.Adjusting the position of the mirror glass in
four directions. C.Folding / Unfolding.
85-86

Rear view mirror


Manual day/night model
1.Selection of the "day" position of the mirror.
2. Adjustment of the mirror.


Automatic day/night model
87 A
. Brightness detection in automatic day/night
mode. B. Adjustment of the mirror.
1.
Fastening the buckle.2.Height adjustment.


Front seat belts
150

.
17
Familiarisation
Monitoring
A.Speedometer dial.B.Instrument panel screen.C.Rev counter dial.D.Lighting dimmer.E.
INFO button.
Used to cycle through the different
information in the instrument panel screen.


Instrument panel
A.Passenger's airbag deactivation warning
lamp.


Central switch panel
155 1
.With the ignition on, the orange and red
warning lamps come on.
2. With the engine running, these warning lamps should go off.
If warning lamps remain on, refer to the page concerned.
25
24
Warning lamps
145
151
B. Hazard warning lamps.
C.
Front passenger's seat belt not fastened or unfastened.

1
27
Instruments and controls
Warning lampis onCauseAction / Observations
Battery charge*fixed.The battery charging circuit has afault (dir ty or loose terminals, slack or cut alternator belt, ...). The warnin
g lamp should go off when the engine is started.
If it does not go off, contact a PEUGEOT dealer or a
qualified workshop.
Anti-lockBraking System(ABS)
fixed.The anti-lock braking system has afault. The vehicle retains conventional braking.
Drive carefully at reduced speed and contact a
PEUGEOT dealer or a qualified workshop without
delay.
Front seat beltnot fastened /
unfastenedfixed, then flashin
g,accompanied by an
audible signal. Th
e driver has not fastened or has unfastened their seat belt. Pull the strap, then inser t the tongue in the buckle.

*

According to destination country.
Airbags andpretensionerstemporarily. When you switch on the ignition, this
warning lamp comes on for a few
seconds, then goes off. I
f it does not go off, contact a PEUGEOT dealer or a
qualified workshop.
fixed.Fault with one of the airbag or seat
belt pretensioner s
ystems.Have it checked b
y a PEUGEOT dealer or a qualified
workshop.

1
37
Instruments and controls
Screen 1Screen 2CauseSolution - ActionObservations
Fault in the steering column. You must stop as soon as it is safe
to do so. Contact a PEUGEOT dealer or aqualified workshop.
Fault with the electrical s
ystem. Stop the vehicle and contact aPEUGEOT dealer or a qualified workshop.
The cooling system temperature is
too hi
gh. Wait for the engine to cool downbefore topping up, if necessary.
If the problem persists, contact a
PEUGEOT dealer or a qualified workshop. You must sto
p as soon as it is safe
to do so.
The temperature o
f the CVT
transmission fluid is too high. Stop the vehicle and contact aPEUGEOT dealer or a qualified workshop.
Th
e driver has not fastened or has unfastened their seat belt. Fasten your seat belt. There is a continuous audible signal
if you drive without fastening your seat belt.
Mal
function of the fuel system. Contact a PEUGEOT dealer or a qualified workshop.

119
4
Driving








Stop & Start (Auto Stop & Go) function


Operation


Going into engine STOP mode
The "AS &G "
warning lamp comes on in
the instrument panel or the instrument panel screen and the engine goes intostandby after a few seconds:


- with a manual
gearbox
, with the vehicle stationary and your foot on the brake, whenyou put the gear lever into neutral andrelease the clutch pedal.

Never refuel with the engine in STOPmode; you must switch off the ignition with the key or the START/STOP button.
When the engine is stopped automatically, the operation of certainvehicle systems, such as for example,braking, power steering... are modified. Take care.


Special cases: STOP mode notavailable
STOP mode is not invoked when:


- the driver's seat belt is not fastened,

- the bonnet is open,

- the vehicle has not exceeded 3 mph (5 km/h) since the last engine start,

- the vehicle has restarted less than10 seconds ago,

- the engine is needed to maintain acomfor table temperature in the passenger compartment,

- demisting is active,

- some special conditions (battery charge, engine temperature, braking assistance,
ambient temperature...) where the engine isneeded to assure control of a system.

- th
e "AS&G"warning lamp is
flashing in the instrument panel.
This operation is perfectl
y normal.

The Stop & Star t (Auto Stop & Go) function puts the engine temporarily into standby during stops in the traffic (red lights, traffic jams, or other...). Theengine restarts automatically as soon as you want to move off. The restart takes place instantly, quickly and silently.
Per fect for urban use, the Stop & Star t (Auto Stop & Go) function reduces fuel consumption and exhaust emissions as well as the noise level whenstationary.

150
Safety
Seat belts
The front seat belts are fitted with a
pretensioning and force limiting system.
This system improves safety in the frontseats in the event of a front or side impact.
Depending on the severity of the impact, thepretensioning system instantly tightens the seat
belts a
gainst the body of the occupants.The pretensioning seat belts are active when
the ignition is on.
The force limiter reduces the pressure of the seat belt on the chest of the occupant, so improving their protection.Fastening
) Pull the strap, then inser t the tongue in the buckle A.)
Check that the seat belt is fastened correctly by pulling the strap.


Unfastening
)
Press the red button on the buckle A.


Height adjustment
)To lower the attachment point, press thecontrol B
and slide the fixing Cdown.)To raise the attachment point, press thecontrol B
and slide the fixing Cup.

151
6
Safety
If the driver does not fasten their seat beltwithin one minute after switching on theignition, the warning lamp flashes accompanied by an intermittent audible signal and a display
on the instrument panel screen. The warning lamp, the audible signal and the
display stop after approximately 90 secondsand return until the driver fastens their seatbelt.
If the seat belt is unfastened while the vehicleis moving
, you are aler ted by the samewarnings.
When the ignition is switched
on, t
his warning lamp comes onaccompanied by an audible signal for a few seconds if the driver has not
fastened their seat belt.

Front seat belt not fastened /
unfastened warning lamp

Front passenger's seat belt
Driver's seat belt
When the ignition is switched on, this
warning lamp comes on the centre console panel.
It is accompanied b
y an audible signal for a few seconds if the passenger has not fastened their seat belt.
If the seat belt is unfastened while the vehicle is moving
, you are aler ted by the same
warnings.

152
Safety
The seat belt for the centre rear seat is fitted in
the roof.
It has three anchora
ge points and a reel.
Fitting the belt
)Pull out the belt and pass it through the beltguide A . )Pull on the strap and inser t the tongue Binto the left hand buckle. )Inser t the tongue C
into the right-hand buckle.)Check that each buckle has engaged bypulling on the strap.


Removing and stowing the belt
)
Press the red button on buckle C
, and then on the red button on buckle B.)
Guide the belt as it reels in, passing it
through the belt guide A.) Stow the tongue Cin the upper slot D
and
the tongue Bin the lower slot E.
Outer rear seat belts
Each outer rear seat is fitted with a three-point
in
ertia reel seat belt.

Fastening
)Pull the strap, then inser t the tongue in thebuckle.)Check that the seat belt is fastenedcorrectly by pulling the strap.



Unfastening
)Press the red button on the buckle.

153
6
Safety
The driver must ensure that passengers usethe seat belts correctly and that they are allrestrained securely before setting off.
Wherever you are seated in the vehicle, always fasten your seat belt, even for short journeys. Do not interchange the seat belt buckles asthey will not fulfil their role fully.
The seat belts are fitted with an inertia reel permitting automatic adjustment of the length of the strap to your size. The seat belt isstowed automatically when not in use.
Before and after use, ensure that the seatbelt is reeled in correctly.
The lower par t of the strap must bepositioned as low as possible on the pelvis.
The upper par t must be positioned in the hollow of the shoulder.
The inertia reels are fitted with an automatic locking device which comes into operation inthe event of a collision, emergency braking or if the vehicle rolls over. You can releasethe device by pulling firmly on the strap and releasing it so that it reels in slightly.
Recommendations for children
Use a suitable child seat if the passenger isless than 12 years old or shor ter than one
and a half metres. Never use the same seat belt to secure morethan one person. Never allow a child to travel on your lap.

In order to be effective, a seat belt must:


- be tightened as close to the body as possible,


- be pulled in front of you with a smooth movement, checking that it does nottwist,

- be used to restrain only one person,

- not bear any trace of cuts or fraying,

- not be converted or modified to avoid affecting its per formance.
In the event of an impact
Depending on the nature and seriousness of the impact
, thepretensioning device may be deployedbefore and independently of the airbags.Deployment of the pretensioners isaccompanied by a slight discharge of harmless smoke and a noise, due to theactivation of the pyrotechnic cartridgeincorporated in the system.In all cases, the airbag warning lamp comes on.Following an impact, have the seat belts system checked, and if necessary replaced,by a PEUGEOT dealer or a qualified workshop.

In accordance with current safety regulations, for all repairs on your vehicle, go to a qualified workshop with the skills and equipment needed, which a PEUGEOT dealer is able to provide. Have your seat belts checked regularly by aPEUGEOT dealer or a qualified workshop,particularly if the straps show signs of damage.Clean the seat belt straps with soapy water or a textile cleaning product, sold byPEUGEOT dealers.
After folding or moving a seat or rear bench seat, ensure that the seat belt is positioned and reeled in correctly.