headlamp Peugeot 406 2002.5 Owner's Guide

29072002
Amber bulbs must be
replaced by bulbs of iden
tical specification and
colour.
In certain weather conditions (low
temperatures, humidity), the
presence of condensation on
the inside of the headlamp
glass is normal; it disappears a
few minutes after the lights have
been switched on.
CHANGING A BULB
1 Dipped beam headlamps
2 Main beam headlamps
2 bulbs (H755W)
Press the tab and remove the protective cover corresponding to the faulty bulb.
Disconnect the connector.
Press the end of the securing clip to remove it. Change the b ulb.
When fitting, ensure that the direction notches are positi oned correctly and that
the securing clip is corrrectly fixed.
Reconnect the connector.
Refit the protective cover.
3 Side lights (W 5 W)
Turn the socket using the lever and remove it. Change the bul b.
4 Direction indicators (P 21 W)
Turn the bulb holder a quarter turn and remove it. Change t he bulb.
Note: only handle H7 bulbs using a dry cloth.
To replace the lefthand bulbs, remove the protective battery co ver.Direction indicator (WY 5 W)
Pull the rear section of the trans
parent cover and release the
assembly.
Turn the connector a quarter turn and remove it.
Change the bulb.
MAINTENANCE OF YOUR 406
37

29072002
Engine compartment fuses
Fuse box
To access the fuse box in the engine
compartment (beside the battery),
unclip the cover.
Carefully close the cover when
you have finished.The electrical system of
your vehicle is designed
to operate with standard
or optional equipment.
Before installing other electrical
equipment or accessories on your
vehicle, contact a PEUGEOT
dealer.
Some electrical accessories or
the way in which they are fitted
can have damaging effects on the
operation of your vehicle; the
electronic control circuits, the
audio circuit and the battery
charging circuit.
PEUGEOT will not accept respon
sibility for the cost incurred in
repairing your vehicle or for recti
fying the malfunctions resulting
from the installation of acces
sories not supplied and not rec
ommended by PEUGEOT and not
installed in accordance with its
instructions, in particular where
the equipment in question con
sumes more than 10 mil
liamperes. *The maxifuses provide addition
al protection for the electrical sys
tems. All work must be carried out
by a PEUGEOT dealer.
Fuse N° Rating Functions
1* 10 A Reversing lights– Double injection relay Oil
temperature Oil level Air conditioning compressor.
2* 15 AFuel pump, canister solenoid valve.
3* 10 AControl unit.
4* 10 AEngine control unit and automatic gearbox.
5 10 A Particulate Emission Filter control unit Rear
windscreen relay.
6 15 AFront fog lamps.
7 20 AHeadlamp wash.
8* 20 A Direct petrol injection engine control unit Clutch pedal.
9* 15 ALefthand dipped beam lights.
10* 15 A Righthand dipped beam lights
MAINTENANCE OF YOUR 406
44