Peugeot 407 2006 Workshop Manual

3COMFORT
50
MANUAL STEERING WHEEL
HEIGHT AND DEPTH
ADJUSTMENTELECTRIC ADJUSTMENT OF
THE HEIGHT AND DEPTH OF
THE STEERING WHEEL*WELCOME FUNCTION*
You can activate or
deactivate this function
via the "personalisation-
configuration" menu on the
multifunction display.
* During the year.
When the vehicle is stationary, unlock
the steering wheel by pushing the
control forwards.
Adjust the height and depth of the
steering wheel then lock by pulling the
control fully.
When stationary, adjust the height or
depth of the steering wheel by moving
the control:

forwards or backwards to adjust the
depth.
 up or down to adjust the height. When the driver’s door is opened with
the ignition off, the steering wheel
rises to make access to or exit from
the vehicle easier.

3COMFORT
51
FRONT SEATS
Manual mode
Longitudinal adjustment
Lift the control bar and slide the seat
forwards or backwards.Driver’s seat cushion height and
angle adjustment
Pump up or down to the required
position.Seat back angle adjustment
Operate the lever for your comfort.

3COMFORT
52
Electric mode
Longitudinal adjustment
Push the control fowards or backwards
to slide the seat.Driver’s seat cushion height and
angle adjustment
Height
: tilt the rear of the control up
or down.
Tilt : tilt the front of the control up or
down. Seat back angle adjustment
Tilt the control forwards or backwards
for your comfort.
The electrical functions of the driver’s seat are deactivated o ne minute after the ignition is switched off.
To reactivate them, open the door or switch on the ignition .

3COMFORT
53
Head restraint height and angle
adjustmentFront seat active head restraint
This system prevents "whiplash".
In the event of a rear impact, the
action of the body on the seat back
moves the head restraint forwards and
upwards preventing the head from
being thrown back.
Front armrest
Driver’s seat lumbar adjustment
Heated seats adjustment
0
: Off.
1 : Low. 2
: Medium.
3 : High. The adjustment is correct
when the top of the head
restraint is aligned with the top
of the head of the occupant of
the seat.
Never drive with the head
restraints removed and
stored in the vehicle. This is
dangerous and they may be
thrown in the event of sharp braking.
They must be in place and adjusted
correctly. To change the position of the armrest:

Lift the handle 1.
The armrest folds forwards and
upwards.
To return to the initial position, push
the armrest backwards and press it to
engage.
Operate the lever to obtain the correct
position.
To raise or lower the head restraint,
pull it forwards then slide it.
To tilt the head restraint, tilt the lower
part forwards or backwards.
To remove the head restraint, move it
almost to the highest position, lift the
tab using a coin and pull it forwards
and upwards at the same time.
To refit the head restraint, engage the
stalks in the holes keeping in line with
the seat back.
With the engine running, turn the
dial. The temperature of the seat is
regulated automatically.

3COMFORT
54
Memorising driving positions*Memorising using the controls on
the driver’s door
To memorise:
 Place the key in the ignition on
position,
 Adjust your seat and mirrors,
 Press button M, then button 1
"first driving position" or button 2
"second driving position" within four
seconds.
An audible signal confirms that a
position has been memorised.
Memorising a new position cancels
the previous one. Recalling a memorised driving
position
Engine off

Briefly press button 1 or 2 to recall
the corresponding memorised
position. The end of the setting is
indicated by a bleep.
After recalling a memorised position a
few times in succession, the function
will be cancelled until the engine is
started.
* During the year.
Engine running

Keep button 1 or 2 pressed down
until the bleep indicates that setting
of the corresponding memorised
position is complete.
The electrical adjustments of the seat
and exterior mirrors are memorised.
Two driving positions can be
memorised using
buttons M/1 and
M/2 .

3COMFORT
55
REAR SEATS (SALOON)
Note: the seat cushion 1 can be
removed with care to increase the
volume of the load space.
Squeeze the seat cushion fixings to
detach them from their fastenings.
When repositioning:
 fold up the seat back 2 and lock it
(the red marker of control 3 should
no longer be visible),
 fold up the seat 1,
 refit the head restraints if they were
removed. Locking/unlocking the access to
the boot via the rear seats
Your vehicle’s boot can be isolated
from the passenger compartment.
The red indicator on the control
3
should no longer be visible. If it is,
push the seat fully.
Insert the ignition key in the lock 4.
Take care not to trap the seat
belt and to position the buckle
of each strap correctly in its
respective clasp before folding
down the seat back. This will enable
you to reposition the seat backs with
their seat belts and clasps ready to
accommodate your rear passengers.
To fold down the rear left seat or the
rear right seat, always start with the
seat, never with the seat back (risk of
damage):

move the front seat(s) forward if
necessary,
 place the head restraints in the
low position or remove them if
necessary,
Check that the seat belt strap is
positioned correctly at the side of the
seat back,
Ensure that the side seat belt straps
are fastened in their clasp (the centre
seat belt must not be fastened),
 lift the front of the seat cushion 1,
 tilt the seat cushion 1 against the
front seat(s),
 pull control 3 forwards to unlock the
seat back 2,
 fold down the seat back 2.

3COMFORT
56
REAR SEATS (407 SW)
Note: the seat cushion 1 can be
removed with care to increase the
volume of the load space.
Squeeze the seat cushion fixings to
detach them from their fastenings.
When repositioning:
 fold up the seat back 2 and lock it
(the red marker of control 3 should
no longer be visible),
 fold up the seat 1,
 refit the head restraints if they were
removed. Take care not to trap the seat
belt and to position the buckle
of each strap correctly in its
respective clasp before folding
down the seat back. This will enable
you to reposition the seat backs with
their seat belts and clasps ready to
accommodate your rear passengers.
To fold down the rear left seat or the
rear right seat, always start with the
seat, never with the seat back (risk of
damage):

move the front seat(s) forward if
necessary,
 place the head restraints in the
low position or remove them if
necessary,
Check that the seat belt strap is
positioned correctly at the side of the
seat back,
Ensure that side seat belt straps are
fastened in their clasp (the centre seat
belt must not be fastened),
 lift the front of the seat cushion 1,
 tilt the seat cushion 1 against the
front seat(s),
 pull control 3 forwards to unlock the
seat back 2,
 fold down the seat back 2.

3COMFORT
57
TRANSPORTING LONG
OBJECTS (407 SW)
Rear seat
(see corresponding paragraph):
 Tilt the seat cushion,
 Remove the head restraints,
 Tilt the seat back. Note:
when repositioning,
ensure that the front and
rear seat backs are secured
correctly.
Precautions
- The long object must be placed on the end of the
front seat back and on the
rear seat cushion.
- Do not place a load in excess of 30 kg on the front of the seat back.
- Do not load blunt objects, this could damage the rear of the front seat
back (storage pocket).
Front passenger seat:

Tilt the seat back approximately
25° towards the rear (in relation to
the vertical position) using the seat
back angle adjustment control (see
corresponding paragraph).
 Lift control A upwards to release
the seat back.
 Without releasing control A, press
on the top of the seat back and
move with it until it is folded.

3COMFORT
58
"Forwards-facing"
INSTALLING A CHILD SEAT
USING A THREE POINT SEAT
BELT
GENERAL POINTS RELATING
TO CHILD SEATS
Although one of PEUGEOT’s main
criteria when designing your vehicle,
the safety of your children also
depends on you.
* According to current legislation in the country.
** According to model. Intermediate longitudinal
position
When a "rearwards-facing"
child seat is installed on the
front passenger seat
, it is
essential that the passenger
air bag** is disarmed. Otherwise, the
child would risk being seriously
injured or killed if the air bag were
to inflate . When a "forwards-facing" child seat
is installed on the
front passenger
seat , adjust the vehicle’s seat to the
intermediate longitudinal position with
the seat back upright and leave the
passenger air bag armed**.
For maximum safety, please
follow these precautions:
- since 1992, and in accordance with Directive 2000/3, all children
under the age of 12 must travel
in approved child seats* suited to
their weight , on seats fitted with a
seat belt or ISOFIX mountings**,
- statistically, the safest seats in
your vehicle for the transportation
of children are the rear seats,
- a child weighing less than 9 kg
must travel in the "rearwards-
facing" position both in the front
and in the rear.
PEUGEOT recommends that children
should travel in the rear seats of your
vehicle:
- "rearwards-facing" up to the age
of 2,
- "forwards-facing" over the age
of 2. "Rearwards-facing"

3COMFORT
59
Group 0: from birth to 10kg
Group 0+: from birth to 13 kg
L1
"BRITAX
Babysure"
(E11 0344117) Installed in
the rear-facing position. L2
"RÖMER
Baby-Safe"
(E1 03301146) Installed in
the rear-facing position.
Groups 1, 2 and 3: from 9 to 36 kg L3
"KIDDY Life"
(E1 03301135)
For the safety of young children (from 9 to 18 kg), PEUGEOT recommends use of
the restraining cushion.
Groups 2 and 3: from 15 to 36 kg
L4
"RECARO Start" (E1 03301108). L5
"KLIPPAN Optima" (E17 030007)From the age of 6 years
(approximately
22 kg), the booster is used on its own.
CHILD SEATS RECOMMENDED BY PEUGEOT
PEUGEOT offers a complete range of recommended child seats which are
secured using a three point seat belt :
** According to version.Passenger air bag OFF**