Peugeot 407 2006 Manual PDF

4ACCESSES
67
CONFIDENTIAL CARD
This is given to you on delivery of your
vehicle with the duplicate keys.
It contains the identification code
necessary for any work carried out by
a PEUGEOT dealer on the electronic
immobiliser system. This code is
hidden by a film, which should be
removed only if necessary.
Keep your card in a safe place,
never inside the vehicle.
When undertaking a long trip or journey,
however, it is advisable to take it with
you along with your personal papers.
ELECTRONIC ENGINE
IMMOBILISER
This locks the engine control system
as soon as the ignition has been
switched off and therefore prevents
starting of the vehicle by anyone who
does not have the key.
The ignition key has an electronic
chip which has a special code. When
the ignition is switched on, the code
must be recognised for starting to be
possible.
If the system does not function
correctly, the following indicator light
comes on:
Service indicator
light
Electronic engine
immobiliser
indicator light
or
It is accompanied by a message on
the multi-function display.
Your vehicle will not start.
Contact a PEUGEOT dealer.

4ACCESSES
68
Make a careful note of the
number on each key. The
key number is coded on the
label attached to the key.
If the keys are lost, your PEUGEOT
dealer can rapidly supply you with
new keys.
The high frequency remote control
is a sensitive system; do not
operate it while it is in your pocket
as there is a possibility that it may
unlock your vehicle, without you
being aware of it.
The remote control does not operate
when the key is in the ignition, even
when the ignition is switched off,
except for reprogramming.
Do not operate the deadlocking
function if there is anyone inside
the vehicle. Driving with the doors locked may
make access to the passenger
compartment by the emergency
services more difficult in an
emergency.
As a safety precaution (with children
on board), remove the ignition key
when you leave the vehicle, even
for a short time.
Do not repeatedly press the button
of your remote control out of range
and out of sight of your vehicle.
You run the risk of stopping it from
working and the remote control
would have to be reprogrammed.
When purchasing a second-hand
vehicle:
- ensure that you are given the
confidential card;
- have the key codes memorised by a PEUGEOT dealer, to ensure that
the keys in your possession are
the only ones which can start the
vehicle.
Do not make any modifications to
the electronic engine immobiliser
system.

4ACCESSES
69
CHILD LOCK
Electric modeAlways remove the ignition
key when leaving the vehicle,
even for a short time.
It is advisable to check that
the child lock is active each time the
ignition is switched on.
This prevents opening of both of the
rear doors from the inside.
With the ignition on, press the button.
A message appears on the multi-
function display.
Warning: this system is independent
of the central locking control.

4ACCESSES
70
THE ALARMWhen the alarm is triggered, the siren
sounds and the direction indicator
lights flash for approximately thirty
seconds.
After triggering, the alarm remains set,
ten times in succession.
On the eleventh time it will become
inactive again, until the next cycle of
disarming then setting of the alarm.
Warning: if button A indicator light
flashes rapidly, the alarm has been
triggered while you were away from
your vehicle.
Note: if the alarm has been triggered
in your absence, this flashing stops
when the ignition is switched on.Remote control failure,
alarm set
 Unlock the doors with the key
and open the door. The alarm is
triggered.
 Switch on the ignition. The alarm is
disarmed.
* According to country.
Setting the alarm
 Switch off the ignition and get out of
the vehicle.
 Set the alarm, by locking or
deadlocking using the remote
control (button A indicator light
flashes once per second).
If you wish to lock or deadlock your
vehicle without setting the alarm, lock
it (one turn of the key) or deadlock
it (a second turn within five seconds
maximum) using the lock.
Disarming
Unlock the vehicle with the remote
control key.
The alarm is disarmed, indicator
light A goes out when the ignition is
switched on (unless the alarm has
been triggered).
To set the alarm with exterior
protection only
If, while you are away from the vehicle,
you wish to leave a window partially
open or a pet inside the vehicle, you
should choose exterior protection
only.
 Switch off the ignition,
 In the next ten seconds, press
button A until the indicator light is
on continuously,
 Get out of the vehicle,
 Set the alarm by locking or
deadlocking using the remote
control (button A indicator light
flashes once a second).
Incorrect operation
When the ignition is switched on, if
button A lights for ten seconds, there
is a fault in the siren connection.
Contact a PEUGEOT dealer to have
the system checked.
Automatic activation*
The alarm is activated automatically
two minutes after the last closure of a
door or the boot.
In order to avoid accidental triggering
of the alarm when a door or the boot
is opened, it is essential to press the
unlocking button on the remote control
again.
When the alarm is set, if
a door, the tailgate or the
bonnet is not closed correctly,
the siren is triggered briefly. If
the vehicle is closed correctly within
the next 45 seconds, the alarm is
set. In all cases, the alarm is set after
45 seconds.
This provides two types of
surveillance:
-
exterior protection: it sounds if
a door, the boot or the bonnet is
opened.
- interior protection: it sounds if
the volume inside the passenger
compartment changes (breaking of
a window or a movement inside the
vehicle).

4ACCESSES
71
ELECTRIC WINDOWSAutomatic operation:
To open or close the window, press or
pull switch fully: the window opens or
closes completely when the switch is
released. Pressing the switch again
stops the movement of the window.
The electric window switches remain
operational for approximately one
minute after the key has been removed
from the ignition.
Once this time has elapsed, the electric
windows will not operate. To reactivate
them, switch the ignition on again.Always remove the key from
the ignition when leaving the
vehicle, even for a short time.
In the event of contact
during operation of the windows, you
must reverse the movement of the
window. To do this, press the switch
concerned.
When the driver operates the
passenger electric window switches, he
must ensure that no one is preventing
correct closing of the windows.
The driver must ensure that the
passengers use the electric windows
correctly.
Be aware of children when operating
the windows.REINITIALISATION OF THE
WINDOWS
Following reconnection of the battery,
the safety auto-reverse function
must be reinitialised: the safety auto-
reverse function is not active during
these operations.
- lower the window completely, then raise it, it will rise in steps of a few
centimetres each time the switch is
pressed. Repeat the operation until
the window closes completely,
- continue to press the switch for at least one second after reaching this
position, window closed.
Safety auto-reverse
When the window rises and meets
an obstacle, it stops and immediately
partially lowers again.
In the event of unwanted opening of
the window on closing, press the switch
until the window opens completely,
then pull the switch immediately until
the window closes. Continue to hold
the switch for approximately one
second after the window has closed.
The safety auto-reverse function is not
active during this operation.
Disarming the rear window
controls
For the safety of your children, press
switch 5 to prevent operation of the
rear windows irrespective of their
position.
When the button is pressed down,
the switches are disarmed. When
the button is raised, the switches are
active.
Manual operation:
To open or close the window, press or
pull the switch gently. The window stops
as soon as the switch is released.
1 - Driver’s electric window
switch.
2 - Passenger’s electric window switch.
3 - Rear right electric window switch.
4 - Rear left electric window switch.
5 - Disarming of the rear electric window switches (child lock).

4ACCESSES
72
BOOT (SALOON) TAILGATE AND REAR SCREEN (407SW)Partial opening of the rear screen
Opening the tailgate and rear
screen
The tailgate and rear screen cannot
be opened at the same time.
With the rear screen closed, to open
the tailgate , operate the handle A,
then lift the tailgate.
With the tailgate closed, to open the
rear screen , operate the handle C,
then lift the rear screen.
The lighting is controlled by opening
the tailgate or the rear screen.
If the permanent locking of the
boot is activated, opening is
only possible by pressing the
remote control button.
Notes:
the tailgate and rear
screen lock automatically
when driving at 6 mph
(10 km/h) and unlock when
one of the doors is opened.
When the rear wiper is in a wiping
position, the rear screen cannot be
opened until the end of the cycle.
Close the rear screen using the wiper
arm or by pressing the centre of the
glass.
To open the boot, press the push
button and raise the tailgate.
The locking or unlocking of the tailgate
and rear screen is simultaneous with
that of the doors.With the tailgate closed, to partially
open the
rear screen , press the
unlocking button B on the remote
control.

4ACCESSES
72
BOOT (SALOON) TAILGATE AND REAR SCREEN (407SW)Partial opening of the rear screen
Opening the tailgate and rear
screen
The tailgate and rear screen cannot
be opened at the same time.
With the rear screen closed, to open
the tailgate , operate the handle A,
then lift the tailgate.
With the tailgate closed, to open the
rear screen , operate the handle C,
then lift the rear screen.
The lighting is controlled by opening
the tailgate or the rear screen.
If the permanent locking of the
boot is activated, opening is
only possible by pressing the
remote control button.
Notes:
the tailgate and rear
screen lock automatically
when driving at 6 mph
(10 km/h) and unlock when
one of the doors is opened.
When the rear wiper is in a wiping
position, the rear screen cannot be
opened until the end of the cycle.
Close the rear screen using the wiper
arm or by pressing the centre of the
glass.
To open the boot, press the push
button and raise the tailgate.
The locking or unlocking of the tailgate
and rear screen is simultaneous with
that of the doors.With the tailgate closed, to partially
open the
rear screen , press the
unlocking button B on the remote
control.

4ACCESSES
73
"Rear screen open" warning
When the engine is running, if the
rear screen is not fully closed, you
are warned by a message on the
multifunction display.
When the vehicle is moving (speed
greater than 6 mph (10 km/h)), if the
rear screen is not fully closed, you
are warned by an audible signal, a
message on the multifunction display
and lighting of the service warning
light.Tailgate release
This enables the tailgate to be unlocked
in the event of a central locking fault.
- Fold back the rear seats to gain access to the lock from inside the
boot,
- Insert a small screwdriver into hole A
of the lock to unlock the tailgate.

4ACCESSES
74
Notes:
After reconnecting the battery, you
must reinitialise the safety auto-
reverse:
- place the control in the maximum partial opening position (3rd notch to
the right),
- wait until the roof is in the maximum partially open position,
- press the control for at least one second.
In the event of unwanted opening of
the roof on closing (for example, in
the presence of ice), and immediately
after the roof stops:
- move the control to the "O" position
and press the control immediately,
- continue to press the control until the roof is fully closed.SUNROOF (SALOON)Always remove the key from
the ignition when leaving the
vehicle, even for a short time.
In the event of contact during
operation of the roof, you must reverse
the movement of the roof. To do this,
press the switch concerned.
When the driver operates the roof
switch, he must ensure that no one is
preventing correct closing of the roof.
The driver must ensure that the
passengers use the sunroof correctly.
Be aware of children when operating
the roof.
- To partially open the roof: Turn the
switch to the right (three possible
settings).
- To open the roof completely: Turn
the switch to the left (six possible
settings).
- To close it completely: Turn the
switch back to position "O".
- Safety auto-reverse: When the
sunroof is closing and meets an
obstacle, it stops then partially opens
again.
The sunroof shutter is manual.

4ACCESSES
75
Safety auto-reverse
If the shutter encounters an obstacle
during closing, it stops and partially
opens again.
You must reinitialise the safety auto-
reverse within a maximum of five
seconds after the concealing shutter
has stopped:
- press part A of the control until the
shutter is completely closed (closing
in stages of a few centimetres).PANORAMIC ROOF (407 SW)In the event of contact during
operation of the shutter, you
must reverse its movement.
To do this, press the control
concerned.
When the driver operates the shutter
control, he must ensure that no one
is preventing the shutter from closing
correctly.
The driver must ensure that the
passengers use the concealing shutter
correctly.
Pay attention to children during
operation of the shutter.
Notes
Following reconnection of the battery,
in the event of a shutter malfunction
while it is moving or immediately after
it has stopped, you must reinitialise
the safety auto-reverse:
- place the control in the fully open position (position "0"),
- wait until the shutter is in the fully open position,
- press section A of the control for at
least three seconds.
In the event of unwanted opening of
the shutter on closing, and immediately
after the shutter has stopped:
- move the control to the fully closed position (9th setting to the left) then
press part A of the control straight
away,
- continue to press the control until the shutter is fully closed.
The safety auto-reverse function is
not active during these operations.
Your vehicle is fitted with a tinted glass
panoramic roof which increases the
light and visibility in the passenger
compartment. Its electric concealing
shutter improves temperature
conditions.
The concealing shutter
is controlled
electrically by a dial with nine opening
positions.
To close: turn the dial to the left (nine
possible settings).
To open: return the dial to the initial
position "0".