Peugeot 407 2007 Manual PDF

4
68
Make a careful note of the number on each key. The key number is coded on the label attached to the key.
If the keys are lost, your PEUGEOT dealer can rapidly supply you with new keys.
The high frequency remote control is a sensitive system; do not operate it while it is in your pocket as there is a possibility that it may unlock your vehicle, without you being aware of it.
The remote control does not operate when the key is in the ignition, even when the ignition is switched off, except for reprogramming.
Do not operate the deadlocking function if there is anyone inside the vehicle.
Driving with the doors locked may make access to the passenger compartment by the emergency services more difficult in an emergency.
As a safety precaution (with children on board), remove the ignition key when you leave the vehicle, even for a short time.
Do not repeatedly press the button of your remote control out of range and out of sight of your vehicle. You run the risk of stopping it from working and the remote control would have to be reprogrammed.
When purchasing a second-hand vehicle:
- ensure that you are given the confidential card;
- have the key codes memorised by a PEUGEOT dealer, to ensure that the keys in your possession are the only ones which can start the vehicle.
Do not make any modifications to the electronic engine immobiliser system.

4
69
CHILD LOCK
Always remove the ignition key when leaving the vehicle, even for a short time.
It is advisable to check that the child lock is active each time the ignition is switched on.
This prevents opening of both of the rear doors from the inside.
With the ignition on, press the button.
A message appears on the multi-function display.
Warning: this system is independent of the central locking control.
Electric mode

4
70
THE ALARMWhen the alarm is triggered, the si-ren sounds and the direction indica-tor lights flash for approximately thirty seconds.After triggering, the alarm remains set, ten times in succession.On the eleventh time it will become inactive again, until the next cycle of disarming then setting of the alarm.Warning: if button A indicator light flashes rapidly, the alarm has been triggered while you were away from your vehicle.Note: if the alarm has been triggered in your absence, this flashing stops when the ignition is switched on.
Remote control failure, alarm set
 Unlock the doors with the key and open the door. The alarm is trig-gered.
 Switch on the ignition. The alarm is disarmed.
* According to country.
Setting the alarm
 Switch off the ignition and get out of the vehicle. Set the alarm, by locking or dead-locking using the remote control (button A indicator light flashes once per second).
If you wish to lock or deadlock your ve-hicle without setting the alarm, lock it (one turn of the key) or deadlock it (a second turn within five seconds maxi-mum) using the lock.
Disarming
Unlock the vehicle with the remote control key.The alarm is disarmed, indicator light Agoes out when the ignition is switched on (unless the alarm has been triggered).
To set the alarm with exterior protection only
If, while you are away from the vehi-cle, you wish to leave a window par-tially open or a pet inside the vehicle, you should choose exterior protection only.
 Switch off the ignition, In the next ten seconds, press but-ton A until the indicator light is on continuously, Get out of the vehicle, Set the alarm by locking or dead-locking using the remote control (button A indicator light flashes once a second).
Incorrect operation
When the ignition is switched on, if button A lights for ten seconds, there is a fault in the siren connection.
Contact a PEUGEOT dealer to have the system checked.
Automatic activation*
The alarm is activated automatically two minutes after the last closure of a door or the boot.
In order to avoid accidental triggering of the alarm when a door or the boot is opened, it is essential to press the unlocking button on the remote control again.
When the alarm is set, if a door, the tailgate or the bon-net is not closed correctly, the siren is triggered briefly. If the vehicle is closed correctly with-in the next 45 seconds, the alarm is set. In all cases, the alarm is set after 45 seconds.
This provides two types of surveillance:
- exterior protection: it sounds if a door, the boot or the bonnet is opened.- interior protection: it sounds if the volume inside the passenger compart-ment changes (breaking of a window or a movement inside the vehicle).

4
71
ELECTRIC WINDOWSAutomatic operation:
To open or close the window, press or pull switch fully: the window opens or closes completely when the switch is released. Pressing the switch again stops the movement of the window.
The electric window switches remain operational for approximately one minute after the key has been re-moved from the ignition.
Once this time has elapsed, the elec-tric windows will not operate. To re-activate them, switch the ignition on again.
Always remove the key from the ignition when leaving the vehicle, even for a short time.
In the event of contact during operation of the windows, you must re-verse the movement of the window. To do this, press the switch concerned.
When the driver operates the passen-ger electric window switches, he must ensure that no one is preventing cor-rect closing of the windows.
The driver must ensure that the pas-sengers use the electric windows correctly.
Be aware of children when operating the windows.
REINITIALISATION OF THE
WINDOWS
Following reconnection of the bat-tery, the safety auto-reverse function must be reinitialised: the safety auto-reverse function is not active during these operations.
- lower the window completely, then raise it, it will rise in steps of a few centimetres each time the switch is pressed. Repeat the operation until the window closes completely,- continue to press the switch for at least one second after reaching this position, window closed.Safety auto-reverse
When the window rises and meets an obstacle, it stops and immediately par-tially lowers again.
In the event of unwanted opening of the window on closing, press the switch until the window opens com-pletely, then pull the switch immediate-ly until the window closes. Continue to hold the switch for approximately one second after the window has closed.
The safety auto-reverse function is not active during this operation.
Disarming the rear window controls
For the safety of your children, press switch 5 to prevent operation of the rear windows irrespective of their po-sition.
When the button is pressed down, the switches are disarmed. When the but-ton is raised, the switches are active.
Manual operation:
To open or close the window, press or pull the switch gently. The window stops as soon as the switch is re-leased.
1 - Driver’s electric window switch.
2 - Passenger’selectric window switch.
3 - Rear right electric window switch.
4 - Rear leftelectric window switch.
5 - Disarming of the rear electric window switches (child lock).

4
72
BOOT (SALOON) TAILGATE AND REAR SCREEN (407 SW)Partial opening of the rear screen
Opening the tailgate and rear screen
The tailgate and rear screen cannot be opened at the same time.
With the rear screen closed, to open the tailgate, operate the handle A, then lift the tailgate.
With the tailgate closed, to open the rear screen, operate the handle B, then lift the rear screen.
The lighting is controlled by opening the tailgate or the rear screen.
If the permanent locking of the boot is activated, opening is only possible by pressing the remote control button.Notes: the tailgate and rear screen lock automatically when driving at 6 mph (10 km/h) and unlock when one of the doors is opened.
When the rear wiper is in a wiping position, the rear screen cannot be opened until the end of the cycle.
Close the rear screen using the wiper arm or by pressing the centre of the glass.
To open the boot, press the push but-ton and raise the tailgate.The locking or unlocking of the tailgate and rear screen is simultaneous with that of the doors.
With the tailgate closed, to partially open the rear screen, press and hold the unlocking button C on the remote control.

4
72
BOOT (SALOON) TAILGATE AND REAR SCREEN (407 SW)Partial opening of the rear screen
Opening the tailgate and rear screen
The tailgate and rear screen cannot be opened at the same time.
With the rear screen closed, to open the tailgate, operate the handle A, then lift the tailgate.
With the tailgate closed, to open the rear screen, operate the handle B, then lift the rear screen.
The lighting is controlled by opening the tailgate or the rear screen.
If the permanent locking of the boot is activated, opening is only possible by pressing the remote control button.Notes: the tailgate and rear screen lock automatically when driving at 6 mph (10 km/h) and unlock when one of the doors is opened.
When the rear wiper is in a wiping position, the rear screen cannot be opened until the end of the cycle.
Close the rear screen using the wiper arm or by pressing the centre of the glass.
To open the boot, press the push but-ton and raise the tailgate.The locking or unlocking of the tailgate and rear screen is simultaneous with that of the doors.
With the tailgate closed, to partially open the rear screen, press and hold the unlocking button C on the remote control.

4
73
"Rear screen open" warning
When the engine is running, if the rear screen is not fully closed, you are warned by a message on the multi-function display.
When the vehicle is moving (speed greater than 6 mph (10 km/h)), if the rear screen is not fully closed, you are warned by an audible signal, a mes-sage on the multifunction display and lighting of the service warning light.
Tailgate release
This enables the tailgate to be unlocked in the event of a central locking fault.
- Fold back the rear seats to gain access to the lockfrom inside the boot,- Insert a small screwdriver into hole Aof the lock to unlock the tailgate.

4
74
Notes:
After reconnecting the battery, you must reinitialise the safety auto-re-verse:
- place the control in the maximum partial opening position (3rd notch to the right),- wait until the roof is in the maximum partially open position,- press the control for at least one second.In the event of unwanted opening of the roof on closing (for example, in the presence of ice), and immediately af-ter the roof stops:
- move the control to the "O" position and press the control immediately,- continue to press the control until the roof is fully closed.
SUNROOF (SALOON)Always remove the key from the ignition when leaving the vehicle, even for a short time.
In the event of contact during operation of the roof, you must reverse the movement of the roof. To do this, press the switch concerned.
When the driver operates the roof switch, he must ensure that no one is preventing correct closing of the roof.
The driver must ensure that the pas-sengers use the sunroof correctly.
Be aware of children when operating the roof.
-To partially open the roof: Turn the switch to the right (three possible settings).- To open the roof completely:Turn the switch to the left (six possible settings).- To close it completely:Turn the switch back to position "O".- Safety auto-reverse:When the sun-roof is closing and meets an ob-stacle, it stops then partially opens again.The sunroof shutter is manual.

4
75
Safety auto-reverse
If the shutter encounters an obstacle during closing, it stops and partially opens again.
You must reinitialise the safety auto-reverse within a maximum of five sec-onds after the concealing shutter has stopped:
- press part A of the control until the shutter is completely closed (closing in stages of a few centimetres).
PANORAMIC ROOF (407 SW)In the event of contact during operation of the shutter, you must reverse its movement. To do this, press the control concerned.
When the driver operates the shutter control, he must ensure that no one is preventing the shutter from closing correctly.
The driver must ensure that the pas-sengers use the concealing shutter correctly.
Pay attention to children during opera-tion of the shutter.Notes
Following reconnection of the battery, in the event of a shutter malfunction while it is moving or immediately after it has stopped, you must reinitialise the safety auto-reverse:
- place the control in the fully open po-sition (position "0"),- wait until the shutter is in the fully open position,- press section A of the control for at least three seconds.In the event of unwanted opening of the shutter on closing, and immediate-ly after the shutter has stopped:
- move the control to the fully closed position (9th setting to the left) then press part A of the control straight away,- continue to press the control until the shutter is fully closed.The safety auto-reverse function is not active during these operations.
Your vehicle is fitted with a tinted glass panoramic roof which increases the light and visibility in the passenger compartment. Its electric concealing shutter improves temperature condi-tions.
The concealing shutter is controlled electrically by a dial with nine opening positions.
To close: turn the dial to the left (nine possible settings).
To open: return the dial to the initial position "0".

4
76
FILLING WITH FUELThe ignition must be switched off and the vehicle must be unlocked when filling with fuel.
When this warning light comes on in certain driving conditions and depending on the engine, the distance which can be travelled with the fuel remaining may be less than 30 miles (50 kilometres).
Note: should you run out of fuel, you must add at least 6 litres.
Operating fault
A fuel gauge fault is indicated by the fuel level indicator needle returning to zero.
Contact a PEUGEOT dealer.
Fuel warning
 Open the fuel filler flap.
 Turn the cap to the left.
 Remove the cap and hang the end on the hook located on the inside of the flap.
A label affixed to the inside of the fuel filler flap indicates which type of fuel to use.
When you fill your tank, do not continue after the third cut-off of the pump. This could cause your vehicle to malfunction.
The capacity of the tank is approximately 67 litres.
 After filling the tank, screw on the cap and close the fuel filler flap.