Peugeot 407 2007 Manual Online

5
77
LIGHTS
Front and rear lights (ring A)
 Turn ring A to the position re-quired.
Lights on
With the ignition off, on opening the driver’s door a buzzer sounds to indi-cate that you have left your lights on although you are leaving the vehicle.
 Switch the lights off.
Direction indicators (flashers)
Lights off
Side lights
Dipped/Main beam headlamps
Dipped/main beam change
 Pull the stalk fully towards you.
Front and rear fog lamps (ring B)
 Turn ring B forwards to switch on and rearwards to switch off.The status is confirmed by the light on the instrument panel.
Front fog lamps (one press)
Left: downwards. The direction arrow indica-tor light flashes on the instrument panel.
Right: upwards. The direction arrow indica-tor light flashes on the instrument panel.
Note: If you forget to return the direction indicator to its normal position, the volume of the audible signal will in-crease, if you are driving at a speed greater than 40 mph (60 km/h) or if the control is maintained for more than 20 seconds.
These operate with the side lightsand the dipped or main beam headlamps.
Rear fog lamps (two presses)
These operate when the front fog lamps are already on.

5
78
Automatic switching on of the lights
The dipped beam headlamps switch on automatically if the light is poor and when the windscreen wipers operate continuously. They switch off when the light is bright enough or the wind-screen wipers stop.
Warning: in foggy weather, the bright-ness sensor can detect sufficient light. As a consequence, the lights will not come on automatically.
ActivationManual "Follow-me-home" lighting
When you leave your vehicle, the side lights and dipped headlamps can be left on for a few seconds.When the function is activated, the indicator light comes on on the 5-dial instrument panel display.
To disarm or activate the function, pass via the "Per-sonalisation-configura-tion" menu on your multi-function display.
For safety reasons, activation/deactivation of the "Automat-ic switching on of the lights" function via the menu must be carried out when stationary.
To deactivate or activate the "Automatic follow-me-home lighting" function, pass via the "Person-alisation-configuration"menu on your multifunction screen.
The duration of timing can be set via the "Personalisa-tion-configuration" menu of your multifunction display.
Automatic "Follow-me-home" lighting
When you leave your vehicle with the automatic switching on of the lightsactivated, the side lights and dipped headlamps remain on for the duration selected after the ignition is switched off.
Disarming
When the function is disarmed, the indicator light comes on on the 5-dial instrument panel display.
Do not cover the sunshine/brightness sensor, located in the centre of the windscreen. It is used to regulate the air conditioning and for the automatic switching on of the lights.
If the sunshine/brightness sensor does not function correctly, the side lights and dipped headlamps come on.
Contact a PEUGEOT dealer.
Activation:
 switch off the engine,
 "flash" the headlamps,
 get out of the vehicle and lock it.

5
78
Automatic switching on of the lights
The dipped beam headlamps switch on automatically if the light is poor and when the windscreen wipers operate continuously. They switch off when the light is bright enough or the wind-screen wipers stop.
Warning: in foggy weather, the bright-ness sensor can detect sufficient light. As a consequence, the lights will not come on automatically.
ActivationManual "Follow-me-home" lighting
When you leave your vehicle, the side lights and dipped headlamps can be left on for a few seconds.When the function is activated, the indicator light comes on on the 5-dial instrument panel display.
To disarm or activate the function, pass via the "Per-sonalisation-configura-tion" menu on your multi-function display.
For safety reasons, activation/deactivation of the "Automat-ic switching on of the lights" function via the menu must be carried out when stationary.
To deactivate or activate the "Automatic follow-me-home lighting" function, pass via the "Person-alisation-configuration"menu on your multifunction screen.
The duration of timing can be set via the "Personalisa-tion-configuration" menu of your multifunction display.
Automatic "Follow-me-home" lighting
When you leave your vehicle with the automatic switching on of the lightsactivated, the side lights and dipped headlamps remain on for the duration selected after the ignition is switched off.
Disarming
When the function is disarmed, the indicator light comes on on the 5-dial instrument panel display.
Do not cover the sunshine/brightness sensor, located in the centre of the windscreen. It is used to regulate the air conditioning and for the automatic switching on of the lights.
If the sunshine/brightness sensor does not function correctly, the side lights and dipped headlamps come on.
Contact a PEUGEOT dealer.
Activation:
 switch off the engine,
 "flash" the headlamps,
 get out of the vehicle and lock it.

5
79
MANUAL ADJUSTMENT OF
THE HEADLAMPSAUTOMATIC HEADLAMP
ADJUSTMENT
In cases of malfunction, the warning light comes on on the instrument panel display, ac-companied by an audible sig-nal and a message on the multifunction display. The system places your head-lamps to the low position.
Do not touch the xenon bulbs. Contact a PEUGEOT dealer.
Daytime lights*
On vehicles which are equipped with daytime lights, the dipped headlamps come on when the vehicle is started.
This warning light comes on on the instrument panel screen.
The instruments and controls (instrument panel, multifunc-tion display, air conditioning control panel, ...) are only lit on switching to the automatic switch-ing on of the lights mode or when the lights are switched on manually.
* According to country.
For vehicles fitted with halogen bulbs, depending on the load in your vehicle, adjusting the beam of your headlamps is recommended.
0. 1 or 2 people in the front seats.
-. 3 people.
1. 5 people.
2. 5 people + maximum authorised loads.
3. Driver + maximum authorised loads.
Initial setting is position 0.
On vehicles with xenon bulbs: when stationary,the system automatically corrects the height of the beam, what-ever the load of the vehicle. The driver is then assured of having optimum lighting and not causing a nuisance to other road users.

5
80
WINDSCREEN WIPER STALK
Front windscreen wiper with intermittent wipe Front windscreen wiper with automatic wipe
Automatic windscreen wipers
An indicator light comes on on the instrument panel display.
Activation
Move the control to position 0 then re-turn it to the AUTO position.
It is accompanied by a message on the multifunction display.
In the AUTO position, the windscreen wipers operate automatically and adapt their speed to the intensity of the rainfall.
The windscreen wiping must be reactivated if the ignition has been switched off for more than one minute.
Disarming
Manual operation of the wiper stalk interrupts the AUTO position, the de-activation indicator light comes on on the 5-dial instrument panel display, ac-companied by a message on the mul-tifunction display.
In the event of malfunction, the windscreen wipers will operate in in-termittent mode.
Contact a PEUGEOT dealer to have the system checked.
2 Fast wipe (heavy rain).
1 Normal wipe (moderate rain).
l Intermittent wipe.
0 Off.
 Single wipe (press downwards).
In the Intermittent position, the wiping speed is in proportion to the vehicle speed.
2 Fast wipe (heavy rain).
1 Normal wipe (moderate rain).
AUTO Automatic wipe.
0 Off.
 Single wipe (press downwards).
In the AUTO position, no action on your part is necessary.

5
81
REAR WIPER CONTROL
(407 SW)Rear wash-wipeDo not cover the rain sensor located on the windscreen be-hind the interior mirror.
When using an automatic car wash to wash your vehicle, switch off the ignition or check that the wiper stalk is not in the automatic position.
In winter, it is advisable to wait for the windscreen to completely clear of ice before operating the automatic wipe.
Automatic rear wiper
If the windscreen wipers control is ac-tivated and you engage reverse gear, the rear wiper operates in intermittent mode.
Note: if a bicycle carrier is used, deactivate this function by going to the "personali-sation-configuration" menu on the multifunction display or install a special bicycle carrier approved by PEUGEOT.
Note: the rear wiper and rear wash-wipe functions are deac-tivated automatically when the rear screen is opened.
Turn the ring to the first notch for inter-mittent wiping.
The control must be reactivated if the ignition has been switched off. To do this, move the control to any position then return it to the required position.
Turn the ring beyond the first notch, the wash-wipe then the wiper operate for a set period of time.

5
82
Windscreen and headlamp wash
Pull the windscreen wiper stalk to-wards you. The windscreen wash then the windscreen wipers operate for a fixed period.
The headlamp wash is also activated, if the headlamps are on.
When the minimum level of the reservoir is reached, this warning light comes on, ac-companied by an audible signal and a message on the multifunction display.
Next time you stop, fill the screen-wash/headlamp wash reservoir.
The warning light comes on each time the stalk is operated, until the reser-voir is filled.
FRONT COURTESY LIGHTThe courtesy light can be deactivated by pressing switch 1 with the door open. The map reading lights are not affected by this and may be switched on.
 To re-activate the lights, press the switch, with the door open.
Screenwash/headlamp wash low
1 - Courtesy light
2 - Map reading lights
With the key in the ignition on or start-ing position, operate the relevant switch.
The front courtesy light comes on when the ignition key is removed, on unlocking the vehicle or on opening one of the doors.
It gradually goes off after the ignition has been switched on or when the ve-hicle is locked.
 Pressing switch 1 turns on the front courtesy light.

5
80
WINDSCREEN WIPER STALK
Front windscreen wiper with intermittent wipe Front windscreen wiper with automatic wipe
Automatic windscreen wipers
An indicator light comes on on the instrument panel display.
Activation
Move the control to position 0 then re-turn it to the AUTO position.
It is accompanied by a message on the multifunction display.
In the AUTO position, the windscreen wipers operate automatically and adapt their speed to the intensity of the rainfall.
The windscreen wiping must be reactivated if the ignition has been switched off for more than one minute.
Disarming
Manual operation of the wiper stalk interrupts the AUTO position, the de-activation indicator light comes on on the 5-dial instrument panel display, ac-companied by a message on the mul-tifunction display.
In the event of malfunction, the windscreen wipers will operate in in-termittent mode.
Contact a PEUGEOT dealer to have the system checked.
2 Fast wipe (heavy rain).
1 Normal wipe (moderate rain).
l Intermittent wipe.
0 Off.
 Single wipe (press downwards).
In the Intermittent position, the wiping speed is in proportion to the vehicle speed.
2 Fast wipe (heavy rain).
1 Normal wipe (moderate rain).
AUTO Automatic wipe.
0 Off.
 Single wipe (press downwards).
In the AUTO position, no action on your part is necessary.

5
81
REAR WIPER CONTROL
(407 SW)Rear wash-wipeDo not cover the rain sensor located on the windscreen be-hind the interior mirror.
When using an automatic car wash to wash your vehicle, switch off the ignition or check that the wiper stalk is not in the automatic position.
In winter, it is advisable to wait for the windscreen to completely clear of ice before operating the automatic wipe.
Automatic rear wiper
If the windscreen wipers control is ac-tivated and you engage reverse gear, the rear wiper operates in intermittent mode.
Note: if a bicycle carrier is used, deactivate this function by going to the "personali-sation-configuration" menu on the multifunction display or install a special bicycle carrier approved by PEUGEOT.
Note: the rear wiper and rear wash-wipe functions are deac-tivated automatically when the rear screen is opened.
Turn the ring to the first notch for inter-mittent wiping.
The control must be reactivated if the ignition has been switched off. To do this, move the control to any position then return it to the required position.
Turn the ring beyond the first notch, the wash-wipe then the wiper operate for a set period of time.

5
81
REAR WIPER CONTROL
(407 SW)Rear wash-wipeDo not cover the rain sensor located on the windscreen be-hind the interior mirror.
When using an automatic car wash to wash your vehicle, switch off the ignition or check that the wiper stalk is not in the automatic position.
In winter, it is advisable to wait for the windscreen to completely clear of ice before operating the automatic wipe.
Automatic rear wiper
If the windscreen wipers control is ac-tivated and you engage reverse gear, the rear wiper operates in intermittent mode.
Note: if a bicycle carrier is used, deactivate this function by going to the "personali-sation-configuration" menu on the multifunction display or install a special bicycle carrier approved by PEUGEOT.
Note: the rear wiper and rear wash-wipe functions are deac-tivated automatically when the rear screen is opened.
Turn the ring to the first notch for inter-mittent wiping.
The control must be reactivated if the ignition has been switched off. To do this, move the control to any position then return it to the required position.
Turn the ring beyond the first notch, the wash-wipe then the wiper operate for a set period of time.