ignition Peugeot 407 2008 User Guide

Page 69 of 204

4ACCESS
67
LOCKING/UNLOCKING FROM THE INSIDE
Using the remote control

 Pressing button B locks the vehicle
(the direction indicators come on
for approximately two seconds).

 A second press within fi ve seconds
deadlocks the vehicle (the direction
indicators come on for approxima-
tely two seconds).
MANUAL LOCKING (EMERGENCY MODE)
Automatic central locking of the
doors
The doors can lock automatically while
driving (speed above 6 mph [10 km/h]).
Press and hold the button to activate
or deactivate this function. Key in ignition
A buzzer sounds on opening the
driver’s door, if the key has been left
in the ignition.
LOCATING YOUR VEHICLE
To locate your vehicle, if you have
locked or deadlocked it, in a car park:

 press button B on the remote
control, the courtesy lights come
on and the direction indicators
fl ash for a few seconds.

Note: driving with the doors
locked may make access to
the passenger compartment by
the emergency services more
diffi cult in an emergency.
If the vehicle is deadlocked,
the button is not active. In this
case, use the key or the re-
mote control to unlock.

 Press the button.
This allows the doors and the boot to
be locked or unlocked. Driver’s door
Insert the key in the lock to lock or
unlock the door.
Passenger doors
To lock, insert the key in the control
located on the edge of the door then
turn to the right.

Page 70 of 204

4ACCESS
68
CHANGING THE REMOTE CONTROL BATTERY
Battery ref.: CR1620/3 volts.
To change the battery, unclip the casing
using a coin at the notch.
REPROGRAMMING THE REMOTE CONTROL

 Switch off the ignition.

 Switch the ignition on again.


Press the remote control locking but-
ton immediately for a few seconds.

 Switch off the ignition and remove
the remote control key from the ig-
nition lock. The remote control is
now working again.
If the remote control does not work
after the battery has been changed,
re-programme the remote control.
ELECTRONIC ENGINE IMMOBILISER
Service indicator
light
Electronic engine
immobiliser
indicator light
or It is accompanied by a message on
the multi-function display.
Your vehicle will not start.
Consult a PEUGEOT dealer.
Do not discard the batteries,
they contain metals which are
harmful to the environment.
Take them to an approved col-
lection point.
This locks the engine control system as
soon as the ignition has been switched
off and therefore prevents starting of the
vehicle by anyone who does not have
the key.
The ignition key has an electronic chip
which has a special code. When the
ignition is switched on, the code must be
recognised for starting to be possible.

If the system does not function correctly,
the following indicator light comes on:
If the keys are lost
Visit a PEUGEOT dealer with the ve-
hicle's V5 registration certifi cate and
your personal identifi cation.
The PEUGEOT network will be able
to retrieve the key code and the trans-
ponder code to order a replacement
key.

Make a careful note of the
number on each key. The
key number is coded on the
label attached to the key.

If the keys are lost, a PEUGEOT
dealer can rapidly supply you with
new keys.

The high frequency remote control is
a sensitive system; do not operate it
while it is in your pocket as there is a
possibility that it may unlock your ve-
hicle, without you being aware of it.

The remote control does not ope-
rate when the key is in the ignition,
even when the ignition is switched
off, except for reprogramming.

Do not operate the deadlocking
function if there is anyone inside
the vehicle.

Page 71 of 204

4ACCESS
68
CHANGING THE REMOTE CONTROL BATTERY
Battery ref.: CR1620/3 volts.
To change the battery, unclip the casing
using a coin at the notch.
REPROGRAMMING THE REMOTE CONTROL

 Switch off the ignition.

 Switch the ignition on again.


Press the remote control locking but-
ton immediately for a few seconds.

 Switch off the ignition and remove
the remote control key from the ig-
nition lock. The remote control is
now working again.
If the remote control does not work
after the battery has been changed,
re-programme the remote control.
ELECTRONIC ENGINE IMMOBILISER
Service indicator
light
Electronic engine
immobiliser
indicator light
or It is accompanied by a message on
the multi-function display.
Your vehicle will not start.
Consult a PEUGEOT dealer.
Do not discard the batteries,
they contain metals which are
harmful to the environment.
Take them to an approved col-
lection point.
This locks the engine control system as
soon as the ignition has been switched
off and therefore prevents starting of the
vehicle by anyone who does not have
the key.
The ignition key has an electronic chip
which has a special code. When the
ignition is switched on, the code must be
recognised for starting to be possible.

If the system does not function correctly,
the following indicator light comes on:
If the keys are lost
Visit a PEUGEOT dealer with the ve-
hicle's V5 registration certifi cate and
your personal identifi cation.
The PEUGEOT network will be able
to retrieve the key code and the trans-
ponder code to order a replacement
key.

Make a careful note of the
number on each key. The
key number is coded on the
label attached to the key.

If the keys are lost, a PEUGEOT
dealer can rapidly supply you with
new keys.

The high frequency remote control is
a sensitive system; do not operate it
while it is in your pocket as there is a
possibility that it may unlock your ve-
hicle, without you being aware of it.

The remote control does not ope-
rate when the key is in the ignition,
even when the ignition is switched
off, except for reprogramming.

Do not operate the deadlocking
function if there is anyone inside
the vehicle.

Page 72 of 204

4ACCESS
69

Driving with the doors locked
may make access to the pas-
senger compartment by the
emergency services more
diffi cult in an emergency.

As a safety precaution (with chil-
dren on board), remove the ignition
key when you leave the vehicle,
even for a short time.

Do not repeatedly press the button
of your remote control out of range
and out of sight of your vehicle. You
run the risk of stopping it from wor-
king and the remote control would
have to be reprogrammed.

When purchasing a second-hand ve-
hicle, have the key codes memorised
by a PEUGEOT dealer to ensure that
the keys in your possession are the
only ones which can start the vehicle.

Do not make any modifi cations to
the electronic engine immobiliser
system.
CHILD LOCK
Electric mode
Always remove the ignition
key when leaving the vehicle,
even for a short time.
It is advisable to check that
the child lock is active each time the
ignition is switched on.
In the event of a serious impact, the
electric child lock is deactivated auto-
matically to permit the exit of the rear
passengers.
This prevents opening of both of the
rear doors from the inside.
With the ignition on, press the button.
A message appears on the multi-func-
tion display.
This system is independent and does not,
in any circumstances, take the place of the
central locking control.

Page 73 of 204

4ACCESS
69

Driving with the doors locked
may make access to the pas-
senger compartment by the
emergency services more
diffi cult in an emergency.

As a safety precaution (with chil-
dren on board), remove the ignition
key when you leave the vehicle,
even for a short time.

Do not repeatedly press the button
of your remote control out of range
and out of sight of your vehicle. You
run the risk of stopping it from wor-
king and the remote control would
have to be reprogrammed.

When purchasing a second-hand ve-
hicle, have the key codes memorised
by a PEUGEOT dealer to ensure that
the keys in your possession are the
only ones which can start the vehicle.

Do not make any modifi cations to
the electronic engine immobiliser
system.
CHILD LOCK
Electric mode
Always remove the ignition
key when leaving the vehicle,
even for a short time.
It is advisable to check that
the child lock is active each time the
ignition is switched on.
In the event of a serious impact, the
electric child lock is deactivated auto-
matically to permit the exit of the rear
passengers.
This prevents opening of both of the
rear doors from the inside.
With the ignition on, press the button.
A message appears on the multi-func-
tion display.
This system is independent and does not,
in any circumstances, take the place of the
central locking control.

Page 85 of 204

5VISIBILITY
79
MANUAL ADJUSTMENT OF THE HEADLAMPS AUTOMATIC HEADLAMP ADJUSTMENT

In cases of malfunction , the
warning light comes on on the
instrument panel display, ac-
companied by an audible signal
and a message on the multifunction dis-
play. The system places your headlamps
to the low position.
Do not touch the xenon bulbs.
Consult a PEUGEOT dealer.
Daytime lights *
On vehicles which are equipped with
daytime lights, the dipped headlamps
come on when the vehicle is started.
This indicator light comes on on
the instrument panel screen.
The instruments and controls
(instrument panel, multifunc-
tion display, air conditioning
control panel, ...) are only lit
on switching to the automatic switch-
ing on of the lights mode or when the
lights are switched on manually.
* According to country. For vehicles fi tted with halogen bulbs,
depending on the load in your vehicle,
adjusting the beam of your headlamps
is recommended.

0. 1 or 2 people in the front seats.

-. 3 people.

1. 5 people.

2. 5 people + maximum
authorised loads.

3. Driver + maximum
authorised loads.

Initial setting is position 0. On vehicles with xenon bulbs:
when
stationary with the ignition on , the
system automatically corrects the
height of the beam, whatever the load
of the vehicle. The driver is then as-
sured of having optimum lighting and
not causing a nuisance to other road
users.

Page 87 of 204

5VISIBILITY
81
REAR WIPER CONTROL(407 SW) Rear wash-wipe
Do not cover the rain sensor
located on the windscreen be-
hind the interior mirror.
When using an automatic car wash to
wash your vehicle, switch off the igni-
tion or check that the wiper stalk is not
in the automatic position.
In winter, it is advisable to wait for the
windscreen to completely clear of ice
before operating the automatic wipe.
Automatic rear wiper
If the windscreen wipers control is ac-
tivated and you engage reverse gear,
the rear wiper operates in intermittent
mode.
Note: if a bicycle carrier is
used, deactivate this function
by going to the "personalisa-
tion - confi guration" menu on
the multifunction display or install a
special bicycle carrier approved by
PEUGEOT .
Note: the rear wiper and rear
wash-wipe functions are de-
activated automatically when
the rear screen is opened.
Turn the ring to the fi rst notch for inter-
mittent wiping.

The control must be reactivated if
the ignition has been switched off.
To do this, move the control to any
position then return it to the required
position. Turn the ring beyond the fi rst notch,
the wash-wipe then the wiper operate
for a set period of time.

Page 88 of 204

5VISIBILITY
82
Windscreen and headlamp wash
Pull the windscreen wiper stalk to-
wards you. The windscreen wash then
the windscreen wipers operate for a
fi xed period.
The headlamp wash is also activated,

if the headlamps are on .
When the minimum level of
the reservoir is reached, this
warning light comes on, ac-
companied by an audible
signal and a message on the
multi-function display.
Next time you stop, fi ll the screen-
wash/headlamp wash reservoir.
The warning light comes on each time
the stalk is operated, until the reser-
voir is fi lled. FRONT COURTESY LIGHT The courtesy light can be deactivated
by pressing switch 1 with the door open.
The map reading lights are not affected
by this and may be switched on.

 To re-activate the lights, press the
switch, with the door open.
Screenwash/headlamp wash low

1. Courtesy light

2. Map reading lights
With the key in the ignition on or start-
ing position, operate the relevant
switch.
The front courtesy light comes on
when the ignition key is removed, on
unlocking the vehicle or on opening
one of the doors.
It gradually goes off after the ignition
has been switched on or when the ve-
hicle is locked.

 Pressing switch 1 turns on the front
courtesy light.

Page 90 of 204

5VISIBILITY
81
REAR WIPER CONTROL(407 SW) Rear wash-wipe
Do not cover the rain sensor
located on the windscreen be-
hind the interior mirror.
When using an automatic car wash to
wash your vehicle, switch off the igni-
tion or check that the wiper stalk is not
in the automatic position.
In winter, it is advisable to wait for the
windscreen to completely clear of ice
before operating the automatic wipe.
Automatic rear wiper
If the windscreen wipers control is ac-
tivated and you engage reverse gear,
the rear wiper operates in intermittent
mode.
Note: if a bicycle carrier is
used, deactivate this function
by going to the "personalisa-
tion - confi guration" menu on
the multifunction display or install a
special bicycle carrier approved by
PEUGEOT .
Note: the rear wiper and rear
wash-wipe functions are de-
activated automatically when
the rear screen is opened.
Turn the ring to the fi rst notch for inter-
mittent wiping.

The control must be reactivated if
the ignition has been switched off.
To do this, move the control to any
position then return it to the required
position. Turn the ring beyond the fi rst notch,
the wash-wipe then the wiper operate
for a set period of time.

Page 91 of 204

5VISIBILITY
81
REAR WIPER CONTROL(407 SW) Rear wash-wipe
Do not cover the rain sensor
located on the windscreen be-
hind the interior mirror.
When using an automatic car wash to
wash your vehicle, switch off the igni-
tion or check that the wiper stalk is not
in the automatic position.
In winter, it is advisable to wait for the
windscreen to completely clear of ice
before operating the automatic wipe.
Automatic rear wiper
If the windscreen wipers control is ac-
tivated and you engage reverse gear,
the rear wiper operates in intermittent
mode.
Note: if a bicycle carrier is
used, deactivate this function
by going to the "personalisa-
tion - confi guration" menu on
the multifunction display or install a
special bicycle carrier approved by
PEUGEOT .
Note: the rear wiper and rear
wash-wipe functions are de-
activated automatically when
the rear screen is opened.
Turn the ring to the fi rst notch for inter-
mittent wiping.

The control must be reactivated if
the ignition has been switched off.
To do this, move the control to any
position then return it to the required
position. Turn the ring beyond the fi rst notch,
the wash-wipe then the wiper operate
for a set period of time.

Page:   < prev 1-10 11-20 21-30 next >