Screen Peugeot 407 2008 Owner's Guide

Page 138 of 204

1010PRACTICAL INFORMATION
122

Fuse N° Rating
Functions

F9 30 A Lighter, telematics (according to country), rear 12 V accessories socket (100 W max).

F10 15 A Tyre under-infl ation detection unit.

F11 15 A Diagnostic socket, ignition switch.

F12 30 A Hands-free kit, trailer socket, trailer fuse box, audible rear pa
rking assistance, passenger's
electric seat, rain and brightness sensor, alarm.

F13 5 A Engine fuse box, windscreen wipers relay control.

F14 15 A Driver's seat memory unit or driver's electric seat, instrument panel,
air conditioning control
panel, air bags control unit.

F15 15 A Electric child lock, rear doors deadlocking.

F17 40 A Heated rear screen.

FS1 - PARC shunt.

Page 140 of 204

1010PRACTICAL INFORMATION
125
The electrical system of your
vehicle is designed to ope-
rate with standard or optional
equipment.
Before installing other electrical equip-
ment or accessories on your vehicle,
contact a PEUGEOT dealer.
PEUGEOT will not accept responsi-
bility for the cost incurred in repairing
your vehicle or for rectifying the mal-
functions resulting from the installation
of accessories not supplied and not
recommended by PEUGEOT and not
installed in accordance with its instruc-
tions, in particular where the equip-
ment in question consumes more than
10 milliamperes.
The maxi-fuses provide additional
protection for the electrical systems.
All work must be carried out by a
PEUGEOT dealer. CHANGING A WINDSCREEN WIPER BLADE ECONOMY MODE FUNCTION
After the engine has stopped, certain
functions (audio equipment, wind-
screen wiper, electric windows, sun-
roof, electric seats, telephone, video,
etc) are only supplied with power for
approximately thirty minutes, to prevent
complete discharging of the battery.
Once the thirty minutes are over, a
message appears on the multi-func-
tion display and the active functions
are put on standby.
These functions are automatically re-
activated when the vehicle is started.
A fl at battery prevents the en-
gine from starting.
As winter approaches, have
your battery checked by a
PEUGEOT dealer.
If the telephone is being used
when economy mode starts,
it will still be possible to fi nish
the call.
Placing the wiper blades in the
maintenance position


Less than one minute after switching
off the ignition, press the windscreen
wiper stalk down once to position the
blades at the top of the windscreen
(maintenance position).
Replacing a blade

 Lift the arm, then unclip the blade
and remove it.

 Fit the new blade and fold down
the arm.
To reposition the blades, switch on the
ignition and operate the windscreen
wiper stalk.

Page 142 of 204

1010PRACTICAL INFORMATION
125
The electrical system of your
vehicle is designed to ope-
rate with standard or optional
equipment.
Before installing other electrical equip-
ment or accessories on your vehicle,
contact a PEUGEOT dealer.
PEUGEOT will not accept responsi-
bility for the cost incurred in repairing
your vehicle or for rectifying the mal-
functions resulting from the installation
of accessories not supplied and not
recommended by PEUGEOT and not
installed in accordance with its instruc-
tions, in particular where the equip-
ment in question consumes more than
10 milliamperes.
The maxi-fuses provide additional
protection for the electrical systems.
All work must be carried out by a
PEUGEOT dealer. CHANGING A WINDSCREEN WIPER BLADE ECONOMY MODE FUNCTION
After the engine has stopped, certain
functions (audio equipment, wind-
screen wiper, electric windows, sun-
roof, electric seats, telephone, video,
etc) are only supplied with power for
approximately thirty minutes, to prevent
complete discharging of the battery.
Once the thirty minutes are over, a
message appears on the multi-func-
tion display and the active functions
are put on standby.
These functions are automatically re-
activated when the vehicle is started.
A fl at battery prevents the en-
gine from starting.
As winter approaches, have
your battery checked by a
PEUGEOT dealer.
If the telephone is being used
when economy mode starts,
it will still be possible to fi nish
the call.
Placing the wiper blades in the
maintenance position


Less than one minute after switching
off the ignition, press the windscreen
wiper stalk down once to position the
blades at the top of the windscreen
(maintenance position).
Replacing a blade

 Lift the arm, then unclip the blade
and remove it.

 Fit the new blade and fold down
the arm.
To reposition the blades, switch on the
ignition and operate the windscreen
wiper stalk.

Page 143 of 204

1010PRACTICAL INFORMATION
125
The electrical system of your
vehicle is designed to ope-
rate with standard or optional
equipment.
Before installing other electrical equip-
ment or accessories on your vehicle,
contact a PEUGEOT dealer.
PEUGEOT will not accept responsi-
bility for the cost incurred in repairing
your vehicle or for rectifying the mal-
functions resulting from the installation
of accessories not supplied and not
recommended by PEUGEOT and not
installed in accordance with its instruc-
tions, in particular where the equip-
ment in question consumes more than
10 milliamperes.
The maxi-fuses provide additional
protection for the electrical systems.
All work must be carried out by a
PEUGEOT dealer. CHANGING A WINDSCREEN WIPER BLADE ECONOMY MODE FUNCTION
After the engine has stopped, certain
functions (audio equipment, wind-
screen wiper, electric windows, sun-
roof, electric seats, telephone, video,
etc) are only supplied with power for
approximately thirty minutes, to prevent
complete discharging of the battery.
Once the thirty minutes are over, a
message appears on the multi-func-
tion display and the active functions
are put on standby.
These functions are automatically re-
activated when the vehicle is started.
A fl at battery prevents the en-
gine from starting.
As winter approaches, have
your battery checked by a
PEUGEOT dealer.
If the telephone is being used
when economy mode starts,
it will still be possible to fi nish
the call.
Placing the wiper blades in the
maintenance position


Less than one minute after switching
off the ignition, press the windscreen
wiper stalk down once to position the
blades at the top of the windscreen
(maintenance position).
Replacing a blade

 Lift the arm, then unclip the blade
and remove it.

 Fit the new blade and fold down
the arm.
To reposition the blades, switch on the
ignition and operate the windscreen
wiper stalk.

Page 171 of 204

11
22
33
44
55
66
77
03
153
Press the MENU button.
Press the dial to confi rm the selection.
Turn the dial and select the MAP function.
Turn the dial and select the MAP IN WINDOW or FULL SCREEN MAP tab.
Select OK and press the dial to confi rm.
Press the dial to confi rm the selection.
Turn the dial and select the DISPLAY MAP function.
DISPLAYING THE MAP IN A WINDOW
OR IN FULL SCREEN MODE
GPS
DISPLAY MAP
FULL SCREEN
OK
MAP IN WINDOW

Page 188 of 204

4
4
4
4
4
4
4
4
3
4
4
4
4
3
3
4
4
1
2
3
4
4
4
3
4
4
4
4
4
1
2
3
3
3
3
3
3
3
3
2
3
2
2
3
3
3
3
22
4
4
2
4
4
3
3
4
4
4
3
3
22
170
business centres
supermarkets, shopping
culture, tourism and shows
tourism
culture and museums
casinos and nightlife
cinemas and theatres
shows and exhibitions
sports and open air centres
sports centres
golf courses
skating rinks, bowling alleys
winter sports resorts
parks, gardens
theme parks
transport and automobile
airports, ports
stations, bus stations
vehicle rental
lay-bys, car parks
service stations, garages
DISPLAY MAP
full screen map
map in window
CONFIGURE MESSAGE ANNOUNCEMENT
read messages
new message display
TRAFFIC INFORMATION
AUDIO FUNCTIONS
MOVE THE MAP
READ MESSAGES
FILTER TRAFFIC INFORMATION
geographic fi lter
around the vehicle
around location
on the route
road information
traffi c information
road closure
size limit
road condition
weather and visibility
urban/city information
parking
public transport
demonstrations
SELECT TMC STATION
automatic TMC
manual TMC
list of TMC stations
RADIO FAVOURITES
enter a frequency
activate/deactivate RDS mode
activate/deactivate regional mode
display/hide radio text
CD, JUKEBOX FAVOURITES
activate/deactivate Introscan (SCN)
activate/deactivate Random mode (RDM)
activate/deactivate Repeat (RPT)
activate/deactivate display of CD info
STOP THE COPY
COPY CD TO JUKEBOX
copy complete CD

Page 195 of 204

11
223344
55
6677
1010
1111
1212131314141515
88
99
01
174
FIRST STEPS
1. On/Off and volume adjustment.
2. Selection of the display on the screen from the modes: AUDIO, trip computer (TRIP), air conditioning (CLIM) and hands-free kit (TEL). The TEL button is not active if the hands-free kit option is not fi tted.
3. Selection of the source: radio, CD and CD changer.
4. Displaying of the general menu.
5. Cancellation of the current operation/return to the previous screen.
6. Confi rmation.
7. Automatic search for a lower/higher frequency. Selection of previous/next CD or MP3 track.
8. TA (Traffi c Announcement) function on/off. Long press: access to the PTY (radio Programme TYpe s) mode.
9. Displaying of the list of local stations, of the tracks on the CD or of the MP3 directories.
10. CD eject.
11. Buttons 1 to 6: Selection of a stored radio station. Selection of a CD in the CD changer. Long press: storing of a station.
12. Selection of the FM1, FM2, FMast and AM wavebands .
13. Selection of a lower/higher radio frequency. Selection of the previous/next CD. Selection of the previous/next MP3 directory.
14. Setting the audio options: front/rear balance, left/right balance, loudness, sound ambiences.
15. The DARK button changes the screen display for gre ater driving comfort at night. 1st press: lighting of the upper banner only. 2nd press: black screen display. 3rd press: return to the standard display.

Page:   < prev 1-10 11-20 21-30 31-40