driver seat adjustment Peugeot 407 2008 Owner's Manual

Page 7 of 204

FAMILIARISATION

 53
Forwards-backwards Height and angle of the driver'
s seat
cushion Seat back angle
Front seat adjustments

Page 52 of 204

3COMFORT
53
FRONT SEATS
Manual mode
Longitudinal adjustment
Lift the control bar and slide the seat
forwards or backwards. Driver’s seat cushion height and
angle adjustment
Pump up or down to the required posi-
tion. Seat back angle adjustment
Operate the lever for your comfort.

Page 53 of 204

3COMFORT
54
Electric mode
Longitudinal adjustment
Push the control forwards or back-
wards to slide the seat. Driver’s seat cushion height and
angle adjustment

Height: tilt the rear of the control up
or down.

Tilt: tilt the front of the control up or
down. Seat back angle adjustment
Tilt the control forwards or backwards
for your comfort.
The electrical functions of the driver’s seat are deactivated one minute after the ignition is switched off.
To reactivate them, open the door or switch on the ignitio n.

Page 54 of 204

3COMFORT
55
Head restraint height and angle
adjustment Front seat active head restraint
This system prevents "whiplash".
In the event of a rear impact, the action
of the body on the seat back moves
the head restraint forwards and up-
wards preventing the head from being
thrown back.
Front armrest
Driver’s seat lumbar adjustment
Heated seats adjustment

0: Off.

1: Low.
2: Medium.

3: High. The adjustment is correct when
the top of the head restraint is
aligned with the top of the head
of the occupant of the seat.
Never drive with the head re-
straints removed and stored in
the vehicle. This is dangerous
and they may be thrown in the
event of sharp braking. They must be
in place and adjusted correctly. To change the position of the armrest:

 Lift the handle 1 .
The armrest folds forwards and up-
wards.
To return to the initial position, push
the armrest backwards and press it to
engage.
Operate the lever to obtain the correct
position.
To raise or lower the head restraint,
pull it forwards then slide it.
To tilt the head restraint, tilt the lower
part forwards or backwards.
To remove the head restraint, move it
almost to the highest position, lift the
tab using a coin and pull it forwards
and upwards at the same time.
To refi t the head restraint, engage the
stalks in the holes keeping in line with
the seat back.
With the engine running, turn the dial.
The temperature of the seat is regu-
lated automatically.