tailgate Peugeot 407 2010 Owner's Manual

FAMILIARISATION


Press the button and raise the boot lid.

 68
 68
With the rear screen closed, to open the

boot , pull the handle A then raise the
tailgate.
Boot (SW) Rear screen (SW) Panoramic roof (SW)

 71

1. Opening of the shutter.

2. Closing of the shutter.
Boot (Saloon)
With the tailgate closed, to open the

rear screen , pull the handle B then
raise the rear screen.

The tailgate and the rear
screen cannot both be open
at the same time.

4ACCESS
68
BOOT (SALOON) TAILGATE AND REAR SCREEN (407SW) Partial opening of the rear screen
Opening the tailgate and rear
screen

The tailgate and rear screen cannot
be opened at the same time.
With the rear screen closed, to open
the tailgate , operate the handle A ,
then lift the tailgate.
With the tailgate closed, to open the

rear screen , operate the handle B ,
then lift the rear screen.
The boot lighting is controlled by open-
ing the tailgate or the rear screen.
If the permanent locking of the
boot is activated, opening is
only possible by pressing the
remote control button.

Notes: the tailgate and rear
screen lock automatically when
driving at 6 mph (10 km/h) and
unlock when one of the doors
is opened.
When the rear wiper is in a wiping
position, the rear screen cannot be
opened until the end of the cycle.
Close the rear screen using the wiper
arm or by pressing the centre of the
glass.
To open the boot, press the push button
and raise the tailgate.
The locking or unlocking of the tailgate
and rear screen is simultaneous with
that of the doors. With the tailgate closed, to partially
open the
rear screen , press and hold
the unlocking button C on the remote
control.

4ACCESS
68
BOOT (SALOON) TAILGATE AND REAR SCREEN (407SW) Partial opening of the rear screen
Opening the tailgate and rear
screen

The tailgate and rear screen cannot
be opened at the same time.
With the rear screen closed, to open
the tailgate , operate the handle A ,
then lift the tailgate.
With the tailgate closed, to open the

rear screen , operate the handle B ,
then lift the rear screen.
The boot lighting is controlled by open-
ing the tailgate or the rear screen.
If the permanent locking of the
boot is activated, opening is
only possible by pressing the
remote control button.

Notes: the tailgate and rear
screen lock automatically when
driving at 6 mph (10 km/h) and
unlock when one of the doors
is opened.
When the rear wiper is in a wiping
position, the rear screen cannot be
opened until the end of the cycle.
Close the rear screen using the wiper
arm or by pressing the centre of the
glass.
To open the boot, press the push button
and raise the tailgate.
The locking or unlocking of the tailgate
and rear screen is simultaneous with
that of the doors. With the tailgate closed, to partially
open the
rear screen , press and hold
the unlocking button C on the remote
control.

4ACCESS
69
"Rear screen open" warning

When the engine is running , if the
rear screen is not fully closed, you are
warned by a message on the multi-
function screen.

When the vehicle is moving (speed
greater than 6 mph (10 km/h)), if the
rear screen is not fully closed, you are
warned by an audible signal, a mes-
sage on the multifunction screen and
lighting of the service warning lamp. Tailgate release
This enables the tailgate to be un-
locked in the event of a central locking
fault.
- Fold back the rear seats to gain
access to the lock from inside the
boot.
- Insert a small screwdriver into hole A
of the lock to unlock the tailgate.

1010PRACTICAL INFORMATION
118
CHANGING A REAR BULB (407SW)
Left and right foglamps: P21W.

 Carefully unclip the tailgate interior
trim.

 Detach the sealing fi lm located be-
hind the lamp in question.

 Remove the bulb holder turning it a
quarter of a turn.

 Change the faulty bulb.
When refi tting, ensure that the bulb is
positioned correctly in the bulb holder.

 Unclip the lamp (2 clips).

 Disconnect the connector and re-
move the lamp.

 Unclip the bulb holder moving
aside the 4 tabs.

 Unscrew the bulb and change it.

 Reconnect the connector.

 Refi t the bulb holder. When refi tting
it, ensure that the lamp is correctly
positioned and secured, reclipping
the rear part then the front part.

Number plate lamps: W5W.

 Insert a thin screwdriver in one of
the exterior holes of the transpar-
ent cover.


Push it towards the outside to unclip it.

 Remove the transparent cover.

 Change the faulty bulb. Third brake lamp (diodes)
All work on the diode lamps must be
carried out by a PEUGEOT dealer.
Wing lamps

1. Brake lamps/sidelamps: P21/5W.

2. Reversing lamps: P21W.

3. Direction indicators: P21W.
These three bulbs are changed by re-
moving the lamp.

 Remove the corresponding boot
side fl ap to gain access to the
lamp.

 Remove the lamp fi xing nut inside
the boot.
Note: if necessary, use the wheelbrace
to remove the nuts. In some climatic conditions
(e.g. low temperature or hu-
midity), the presence of misting
on the internal surface of the
glass of the headlamps and rear lamps
is normal; it disappears after the lamps
have been on for a few minutes.