PEUGEOT 407 C 2005 Service Manual

Comfort46 -
04-11-2005
47Comfort-
04-11-2005
MANUAL FRONT SEATS
Longitudinal adjustment
Lift the control bar and slide the seat
forwards or backwards.Driver and passenger seat
cushion height and angle
adjustment
Pump up or down to the required
position. Seat back angle adjustment
Without resting your back against the
seat, turn the control to adjust the
angle of the seat back.

Comfort
48 -
04-11-2005
49
Comfort
-
04-11-2005
Heated seat adjustment
With the engine running, turn the knob.
The temperature of the seat is regu-
lated automatically.
0: Off.
1 : Low. 2
: Medium.
3 : High.
Driver and passenger seat lumbar
adjustment*
Operate the lever to obtain the
required position. Access to the rear seats
If necessary, detach the seat belt
from the handle and position it along
the door pillar.
Pull the handle
A upwards and
forwards to fold the seat back, then
move the seat forward pushing the
seat back.
The driver has a courtesy handle B
to enable him to move the passenger
seat from his seat.
When it is put back in place, the seat
returns to its initial position.
No person or object must pre-
vent the seat from returning
to its initial longitudinal and
angle position.
Depending on your seat's settings, it
is possible that the access to the rear
seats manoeuvre may be limited. In
this case, the seat settings must be
altered irst.
The seat must return to this position
for correct locking of the seat back.
Ensure that the seat back returns to
its position correctly and never drive
with the seat back disengaged (free
of any movement).
If the seat back jams on repositioning,
operate the handle A again to release
it and return it to its initial position.
* With electric seat only.
Do not use the seat back an-
gle adjustment control when
using the access to the rear
seats (risk of disengaging of
the seat back with loss of the angle
adjustment function).

Comfort50 -
04-11-2005
51Comfort-
04-11-2005
Head restraint height and angle
adjustment
To raise or lower the head restraint,
pull it forwards then slide it.
To tilt the head restraint, tilt the lower
part forwards or backwards.
To remove the head restraint, move
it almost to the highest position, lift
the tab using a coin and pull the head
restraint forwards and upwards at the
same time.
To reit the head restraint, engage
the stalks in the holes keeping in line
with the seat back.Front seat active head restraint
This system prevents whiplash.
In the event of a rear impact, the
action of the body on the seat back
moves the head restraint forwards
and upwards preventing the head
from being thrown backwards.
Front armrest
To change the position of the armrest:
F
Lift the handle 1.
The armrest folds forwards and
upwards.
To return to the initial position, push
the armrest backwards and press it
to engage.
The adjustment is correct
when the top of the head re-
straint is level with the top of
the head. Never drive with the head re-
straints removed; they must
be in place and adjusted
correctly.

Comfort48 -
04-11-2005
49Comfort-
04-11-2005
ELECTRIC FRONT SEATS
Longitudinal adjustment
Push the control forwards or back-
wards to slide the seat.Driver and passenger seat
cushion height and angle
adjustment
Height:
tilt the rear of the control up
or down.
Angle: tilt the front of the control up
or down. Seat back angle adjustment
Tilt the control forwards or backwards
to adjust the angle of the seat back.
The electrical functions of the
driver's seat (with the exception of
the access to the rear seats) are
deactivated approximately one
minute after the ignition is switched off.
To reactivate them, open the door or
switch on the ignition.

Comfort
48 -
04-11-2005
49
Comfort
-
04-11-2005
Heated seat adjustment
With the engine running, turn the knob.
The temperature of the seat is regu-
lated automatically.
0: Off.
1 : Low. 2
: Medium.
3 : High.
Driver and passenger seat lumbar
adjustment*
Operate the lever to obtain the
required position. Access to the rear seats
If necessary, detach the seat belt
from the handle and position it along
the door pillar.
Pull the handle
A upwards and
forwards to fold the seat back, then
move the seat forward pushing the
seat back.
The driver has a courtesy handle B
to enable him to move the passenger
seat from his seat.
When it is put back in place, the seat
returns to its initial position.
No person or object must pre-
vent the seat from returning
to its initial longitudinal and
angle position.
Depending on your seat's settings, it
is possible that the access to the rear
seats manoeuvre may be limited. In
this case, the seat settings must be
altered irst.
The seat must return to this position
for correct locking of the seat back.
Ensure that the seat back returns to
its position correctly and never drive
with the seat back disengaged (free
of any movement).
If the seat back jams on repositioning,
operate the handle A again to release
it and return it to its initial position.
* With electric seat only.
Do not use the seat back an-
gle adjustment control when
using the access to the rear
seats (risk of disengaging of
the seat back with loss of the angle
adjustment function).

Comfort50 -
04-11-2005
51Comfort-
04-11-2005
Head restraint height and angle
adjustment
To raise or lower the head restraint,
pull it forwards then slide it.
To tilt the head restraint, tilt the lower
part forwards or backwards.
To remove the head restraint, move
it almost to the highest position, lift
the tab using a coin and pull the head
restraint forwards and upwards at the
same time.
To reit the head restraint, engage
the stalks in the holes keeping in line
with the seat back.Front seat active head restraint
This system prevents whiplash.
In the event of a rear impact, the
action of the body on the seat back
moves the head restraint forwards
and upwards preventing the head
from being thrown backwards.
Front armrest
To change the position of the armrest:
F
Lift the handle 1.
The armrest folds forwards and
upwards.
To return to the initial position, push
the armrest backwards and press it
to engage.
The adjustment is correct
when the top of the head re-
straint is level with the top of
the head. Never drive with the head re-
straints removed; they must
be in place and adjusted
correctly.

Comfort50 -
04-11-2005
51Comfort-
04-11-2005
Memorising driving positions
The electrical adjustments of the
driver's seat, steering wheel* and
exterior mirrors are memorised.
Two driving positions can be memo-
rised using buttons M/1 and M/2 . An audible signal conirms that a
position has been memorised.
Memorising a new position cancels
the previous one.
Recalling a memorised driving
position
Ignition on, vehicle stationary
F
Briely press button 1 or 2 to recall
the corresponding memorised
position. The end of the setting is
indicated by a bleep.
After recalling a memorised position
a few times in succession, the func-
tion will be cancelled until the engine
is started.
* During the year.
During access to the rear
seats, the memorising and
recalling of the driving posi-
tions are deactivated.
Vehicle moving
F
Keep button 1 or 2 pressed down
until the bleep indicates that setting
of the corresponding memorised
position is complete.
REAR HEAD RESTRAINTS
The rear head restraints have a high
position for use and a low position for
storing.
They can also be removed.
To remove them, pull upwards fully
and press the lug.
Never drive with the head
restraints removed; they
must be in place and
adjusted correctly.
Memorising using the controls on
the driver's door
To memorise:
F
Place the key in the ignition on
position,
F Adjust your seat, steering wheel*
and mirrors,
F Press button M, then button 1
"irst driving position" or button 2
"second driving position" within
four seconds.

Comfort52 -
04-11-2005
53Comfort-
04-11-2005
REAR SEATS
To fold down the rear left seat or the
rear right seat, always start with the
seat, never with the seat back (risk
of damage): F move the front seat(s) forward if
necessary,
F place the head restraints in the
low position or remove them if
necessary,
Check that the seat belt strap is
positioned correctly at the side of the
seat back,
F release the front of the seat cushion
1 by passing your hands underneath
and lifting at each end A,
F lift the front of the seat cushion 1,
F tilt the seat cushion 1 against the
front seat(s),
F pull control 3 forwards to unlock
the seat back 2,
F fold down the seat back 2 (left or
right). Note:
the seat cushion 1 can be
removed with care to increase the
volume of the load space.
Squeeze the seat cushion ixings to
detach them from their fastenings.
When repositioning:F fold up the seat back 2 and lock
it (the red marker of control 3
should no longer be visible),
F fold up the seat 1,
F reit the head restraints if they
were removed. Locking/unlocking the access to
the boot via the rear seats
Your vehicle's boot can be isolated
from the passenger compartment.
The red indicator on the control
3
should no longer be visible. If it is,
push the seat fully.
Insert the ignition key in the lock 4.
Transporting long objects
In exceptional circumstances , a
rear seat back can be folded without
folding the seat cushion 1 in order to
transport long, light objects (risk of
damage to the seat cushion).
When putting the seat backs
and the seat cushion back in
place, ensure that they are se-
cured correctly to guarantee
your safety and take care not to trap
the seat belts.
When transporting long ob-
jects, do not place a load
weighing more than 30 kg on
the rear of the seat back.
Do not place blunt objects on the
rear of the seat back as this could
damage it.

Comfort52 -
04-11-2005
53Comfort-
04-11-2005
Although one of PEUGEOT's main
criteria when designing your vehicle,
the safety of your children also de-
pends on you.
INSTALLING A CHILD SEAT USING A THREE POINT SEAT BELT
Intermediate longitudinal position
* According to current legislation in the country.
** According to model.
GENERAL POINTS RELATING
TO CHILD SEATS
"Forwards-facing"
"Rearwards-facing"
For maximum safety, please
follow these precautions:
When a "rearwards-facing"
child seat is installed on the
front passenger seat, it is
essential that the passenger
air bag** is disarmed. Otherwise, the
child would risk being seriously
injured or killed if the air bag were
to inlate .
- since 1992, and in accordance with
Directive 2000/3, all children under
the age of 12 must travel in ap-
proved child seats* suited to their
weight , on seats itted with a seat
belt or ISOFIX mountings**,
- statistically, the safest seats in
your vehicle for the transportation
of children are the rear seats,
- a child weighing less than 9 kg must travel in the "rearwards-
facing" position both in the front
and in the rear.
PEUGEOT recommends that chil-
dren should travel in the rear seats
of your vehicle:
- "rearwards-facing" up to the age
of 2,
- "forwards-facing" over the age of 2.
When a "forwards-facing" child seat
is installed on the front passenger
seat , adjust the vehicle's seat to the
intermediate longitudinal position
with the seat back upright and leave
the passenger air bag armed**.

Comfort58 -
04-11-2005
59Comfort-
04-11-2005
ADVICE ON CHILD
SEATSChildren under the age of 10 must
not travel in the "forward facing"
position on the front passenger seat,
unless the rear seats are already oc-
cupied by other children, cannot be
used or are absent.
Disarm the passenger air bag* when
a "rear facing" child seat is installed
on the front seat. Otherwise, the child
would risk being seriously injured or
killed if the air bag were to inlate.As a safety precaution, do not leave:
- one or more children alone and
unsupervised in a vehicle,
- a child or an animal in a vehicle which is exposed to the sun, with
the windows closed,
- the keys within reach of children inside the vehicle.
To protect young children from the
rays of the sun, it side blinds on the
rear windows.
* According to country.
The incorrect installation of a child
seat in a vehicle compromises the
child's protection in the event of an
accident.
Remember to fasten the seat belts or
the child seat harness
keeping the
slack in relation to the child's body to
a minimum, even for short journeys.
For optimum installation of the
"forward facing" child seat, ensure
that the back of the child seat is in
contact with the back of the vehicle's
seat and that the head restraint does
not cause any discomfort.
If the head restraint has to be re-
moved, ensure that it is stored or
attached securely to prevent it from
being thrown around the vehicle in
the event of sharp braking. Installing a booster seat
The chest part of the seat belt must
be positioned on the child's shoulder
without touching the neck.
Ensure that the lap part of the seat
belt passes correctly over the child's
thighs.
PEUGEOT recommends the use of a
booster seat which has a back, itted
with a seat belt guide at shoulder
level.