Peugeot 407 C 2010.5 Owner's Manual

1010
116

Fuse N°
Rating

A
Functions

F1 - Not used.

F2 30 Locking and deadlocking.

F3 5 Airbags and pretensioners control unit.

F4 10 Automatic gearbox switch, diagnostic socket, electrochromatic mirror.

F5 30 Driver and passenger electric windows.

F6 30 Sunroof.

F7 5 Glove box lamp, map reading lamps, courtesy lamps, courtesy mirrors.

F8 20 Multifunction screen, audio equipment, top-of-column, trailer
fusebox (accessory),
alarm, alarm siren.

F9 30 Front cigar lighter, 12 V rear socket, glove box lamp, map readi
ng lamps, courtesy lamps,
courtesy mirrors.

F10 15 Tyre under-infl ation detection, CD changer.

F11 15 Diagnostic socket, ignition switch.

F12 15 Trailer fusebox (accessory), parking sensors control unit supply,
passenger seat memory unit, rain and sunshine sensor.

F13 5 Windscreen wipers relay control, engine fusebox.

F14 15 Driver’s seat memory unit, instrument panel, airbags and pre-tensi
oners control unit,
air conditioning control panel, steering wheel adjustment sw itch, hands-free kit.

F15 30 Locking and deadlocking.

F16 - PARC shunt.

1010
117
Engine compartment fuses
To access the fuses located in the
engine compartment (next to the bat-
tery), remove the battery cover and
unclip the fusebox cover.
Close the fusebox cover carefully and
refi t the battery cover when you have
fi nished.
Fuse N°
Rating

A
Functions

1 20 Engine control unit, fan assembly relay supply.

2 15 Horn.

3 10 Screenwash pump.

4 20 Headlamp wash pump.

5 15 Fuel pump, engine management actuators
(air fl ow sensor, electrovalves, ...).

6 10 ESP control unit.

7 10 Automatic headlamp adjustment.

8 20 Starter coil.

9 10 Directional headlamps control unit, additional
heating switching and protection control unit,
clutch switch.

10 30 Engine management actuators (ignition coil,
injectors, thermostats, electrovalves, oxygen
sensors), Diesel additive pump, fuel pump,
engine control unit, blow-by heater.

11 40 Air conditioning fan.

12 30 Windscreen wipers.

13 40 Built-in systems interface supply
(ignition positive).

14 30 Not used.

1010
118
The electrical system of your
vehicle is designed to oper-
ate with standard or optional
equipment.
Before installing other electrical equip-
ment or accessories on your vehicle,
contact a PEUGEOT dealer. PEUGEOT will not accept responsi-
bility for the cost incurred in repairing
your vehicle or for rectifying the mal-
functions resulting from the installation
of accessories not supplied and not
recommended by PEUGEOT and not
installed in accordance with its instruc-
tions, in particular where the equip-
ment in question consumes more than
10 milliamperes. The maxi-fuses provide additional
protection for the electrical systems.
All work must be carried out by a
PEUGEOT dealer.

1010
119
CHANGING A WINDSCREEN WIPER BLADE
ECONOMY MODE FUNCTION
After the engine has stopped, certain
electrical functions can be used for a
maximum duration of approximately
one hour, to prevent discharging of the
battery.
LOAD REDUCTION FUNCTION
When driving, certain functions (air
conditioning, heated rear screen,
heating system for passenger com-
partment of Diesel vehicles, etc.) may
be switched off temporarily, depending
on the level of battery charge.
Reactivation of these functions is au-
tomatic, once the battery charge is
suffi cient.
Note: at the risk of discharg-
ing the battery, the functions
that have been switched off
may be reactivated manually.

Note : if the telephone is being
used when economy mode
starts, it will still be possible to
fi nish the call.
A fl at battery prevents the en-
gine from starting.
Replacing a blade

 Lift the arm, then unclip the blade
and remove it.

 Fit the new blade and fold down
the arm.
To reposition the blades, switch on the
ignition and operate the windscreen
wiper stalk. Once the hour is over, a switching to
economy mode message appears in
the multifunction scren and the active
functions are put on standby.
These functions are reactivated au-
tomatically next time the vehicle is
driven.
In order to resume the use of these
functions immediately, the engine
must be started and left to run for a
few minutes.
The time available to you will then be
approximately double the duration
for which the engine is left running.
However, this period will always be
between fi ve and thirty minutes.
This time may be signifi cantly
reduced if the battery charge
is low.
Placing the wiper blades in the
maintenance position

 Less than one minute after switching
off the ignition, press the windscreen
wiper stalk down once to position the
blades vertically on the windscreen
(maintenance position).

1010
120
Disconnecting/Reconnecting
the cables

1. Raise the locking plate A .

2. Position the open clip of the cable
on the positive (+) terminal of the
battery.

3. Press until the position checking
system B tilts.

4. Lock the clip by lowering the lock-
ing plate while pressing on the clip. To start the vehicle from another
battery:
-
Connect the red cable to the positive (+)
terminals of the two batteries,
- Connect one end of the green or
black cable to the negative (-) ter-
minal of the slave battery,
- Connect the other end of the green or black cable to an earth point on
the broken down vehicle as far as
possible from the battery,
-
Operate the starter, let the engine run,
- Wait for the engine to return to idle, then disconnect the cables.
ENGINE COMPARTMENT)
To charge the battery using a
battery charger:
- Disconnect the battery,
-
Follow the instructions for use given by
the manufacturer the battery charger,
- Reconnect starting with the nega-tive (-) terminal,
- Check that the terminals and connec- tors are clean. If they are covered with
sulphate (white or greenish deposit),
disconnect them and clean them.
It is advisable to disconnect
the battery if the vehicle is not
to be used for a period of more
than one month.
Do not force the plate as locking
is not possible if the clip is not
positioned correctly.
Start the procedure again.

1010
Before disconnecting the bat-
tery, you must wait for 2 minu tes
after switching off the ignition.
Never disconnect a terminal
when the engine is running.
Never charge a battery without fi rst
disconnecting the terminals.
Open the windows and close the sun-
roof before disconnecting the battery.
If they do not operate normally follow-
ing reconnection of the battery, they
must be reinitialised (see paragraphs
"Reinitialisation of the electric windows"
and "Sunroof").
After every reconnection of the bat-
tery, switch on the ignition and wait
1 minute before starting to allow the
electronic systems to be initialised.
However, if slight diffi culties are ex-
perienced after this, please contact a
PEUGEOT dealer.

On the 2.7 litre 24V HDI engine, if
there is no battery in the boot, do
not connect a slave battery to the
positive (+) and negative (-) termi-
nals under the bonnet as a short
circuit may occur.
The batteries contain harmful
substances such as sulphuric
acid and lead. They must be
disposed of in accordance
with regulations and must never be
discarded with household waste.
Take used batteries to an approved
collection point.

 open the bonnet,

 use the two additional positive (+)
and negative (-) terminals located
under the bonnet,

 open the red cover of the positive (+)
terminal,


connect the red cable between the
positive (+) terminal and the positive (+)
terminal of the slave battery,

 connect the green or black cable
between the negative (-) terminal
and the negative (-) terminal of the
slave battery,


operate the starter, let the engine run,

 wait for the engine to return to idle,
then disconnect the cables,


close the red cover of the positive (+)
terminal,

 refi t the left side cover,

 close the bonnet.
IN THE BOOT) *
* Vehicles fi tted with the 3 litre HDI V6
24V engine.
The battery is behind the left hand
boot trim.

To charge the battery using a battery
charger (boot open):

 fold down the panel to gain access
to the battery,

 disconnect the battery,

 follow the instructions for use given
by the battery charger manufacturer,

 reconnect starting with the nega-
tive (-) terminal,

 raise the panel and close it.
To start the vehicle from another
battery:

1010
122
TOWING THE VEHICLE
From the rear:

 Unclip the cover, pulling the upper
rib towards you,

 Screw in the towing eye as far as it
will go.
Special requirements with an automatic gearbox
Lifting (2 wheels only on the ground)
It is preferable to raise the vehicle with
professional lifting equipment.
When towing with the engine
switched off, there is no braking
or steering assistance.
From the front:

 Unclip the left part of the cover,

 Screw in the towing eye as far as it
will go. Towing a vehicle with an auto-
matic gearbox in reverse gear
is
prohibited (the gearbox is
not lubricated).
When being towed with all four wheels
on the ground, it is imperative that the
following rules are obeyed:
- gear lever in position N ,
- the vehicle must be towed at a speed of less than 30 mph (50 km/h) over
a maximum distance of 30 miles
(50 km),
- do not add oil to the gearbox.
Without lifting(4 wheels on the ground)
You must always use a towing bar.
The removable towing eye is inside
the spare wheel.

1010
123
In all cases, pay attention to the coolant
temperature.
Brakes: towing increases the braking
distance. Drive at a moderate speed,
change down early and brake gradually.

Side wind: sensitivity to side wind is
increased. Drive smoothly and at a
moderate speed. TOWING A TRAILER, CARAVAN, BOAT, ETC...
We recommend the use of genuine
PEUGEOT towbars which have been
tested and approved from the design
stage of your vehicle, and that the tow-
bar is fi tted by a PEUGEOT dealer.
Driving advice

Distribution of loads: distribute the
load in the trailer so that the heavi-
est loads are as close as possible to
the axle and the nose weight is close
to the maximum authorised without,
however, exceeding it.

Cooling: towing a trailer on a slope in-
creases the coolant temperature.
As the fan is electrically controlled, its
cooling capacity is not dependent on
the engine speed.
Note: in certain cases of par-
ticularly arduous use (towing
the maximum load in high
temperatures), the engine au-
tomatically limits its power and selects
the appropriate automatic gearbox
gear in manual mode. In this case,
switching off the air conditioning saves
engine power and so increases towing
capacity.
If the coolant temperature
warning lamp comes on, stop
the vehicle and switch off the
engine as soon as possible.

Tyres: check the tyre pressures of the
towing vehicle (label on the central
door pillar on the driver's side) and of
the trailer, observing the recommend-
ed pressures.

1010
124
ACCESSORIES
A wide range of accessories recom-
mended by PEUGEOT and genuine
replacement parts are offered by the
dealer network.
They all benefi t from PEUGEOT's rec-
ommendation.
These accessories and parts, having
been tested and approved for reliabil-
ity and safety, are all adapted to your
PEUGEOT vehicle.

"Style": 19 inch alloy wheels, spoiler,
chrome door mirror shells...

Note :
To prevent the mat from becoming
caught under the pedals:
- ensure that the mat is positioned and secured correctly,
- never fi t one mat on top of another. The fi tting of electrical equip-
ment or accessories which
are not recommended by
PEUGEOT may result in a fail-
ure of your vehicle's electronic system.
Please note this specifi c warning. You
are advised to contact a representa-
tive of the Marque to be shown the
range of recommended equipment
and accessories.
The NINETEEN inch alloy wheels which
are available as accessories require the
fi tting of tyres of specifi c dimensions
(235/40ZR19 96 Y), with a maximum
section of 236 mm. Consult a PEUGEOT
dealer.

"Safety and security": winter equip-
ment, range of child seats, alarm,
security bolts for alloy wheels, high
visibility vest, warning triangle, breath-
alyzer...

"Protection": Rear mud fl aps, anti-skid
covers, ...

"Multimedia": 230V socket, Wi-Fi on
board, mapping updates for built in
satellite navigation, hands-free kit, por-
table satellite navigation systems...

"Comfort": Coat hanger, insulated
modules, child booster cushion...

"Transport solutions": boot liner,
towbar with quickly detachable ball,
towbar-mounted bicycle carrier, boot
spacers... Depending on the country in
which the vehicle is sold, it
is compulsory to have a high
visibility vest, warning triangle
and spare bulbs available in
the vehicle.

11
125
TECHNICAL DATA
* Draining by gravity with oil fi ller cap open.
ENGINE AND GEARBOX: PETROL

Model codes: 6J.. .
XFVJ

Engine
3 litre V6 24V
Cubic capacity (cc) 2 946
Bore x stroke (mm) 87 x 82.6
EU standard maximum power (kW)/(hp) 155/211
Maximum power engine speed (rpm) 6 000
EU standard maximum torque (Nm) 290
Maximum torque engine speed (rpm) 3 750
Fuel Unleaded
Catalytic converter Yes

Gearbox - Gears Automatic - 6

Oil capacity (in litres)

Engine (with fi lter replacement) * 5.25