coolant Peugeot 407 C 2010.5 Owner's Manual

Page 21 of 243

1
24
Under-infl ation tyre
warning lamp
This indicates that the tyre
pressure is too low.
A message in the multifunction screen
indicates the wheel(s) concerned.
Refer to the information label affi xed
to the central pillar of the driver's door.
For your safety, check the tyre pres-
sures as soon as possible.
Electronic stability control system
(ESP) warning lamps
Activation warning lamp
Operation warning lamp
Deactivation warning lamp
Fault warning lamp
Parking brake warning
lamp
This indicates that the parking
brake is still applied or has not
been released correctly.
It is linked with the braking system
warning lamp.
Low screenwash and
headlamp wash fl uid level
warning lamp
When the wipers are switched
on, this indicates that the fl uid
level is too low.
Fill the screenwash and headlamp
wash fl uid reservoir. Battery charge warning
lamp
When the engine is running,
this indicates a charging cir-
cuit fault (battery terminals,
alternator belt).
Consult a PEUGEOT dealer. Engine oil level warning
lamp
This indicates a low engine
oil level.

Stop as soon as it is safe to do so.
Consult a PEUGEOT dealer.
INSTRUMENT PANEL SCREEN WARNING LAMPS
STOP warning lamp
It comes on linked with the
warning lamps for engine
oil pressure, coolant tem-
perature, power steering,
braking system or punctured tyre.

Stop as soon as it is safe to do so.
Consult a PEUGEOT dealer.
Low coolant level warning
lamp (according to
version)
This warning lamp indicates
that cooling system level is
too low.

Stop as soon as it is safe to do so.
Consult a PEUGEOT dealer.
Warning: the cooling system is pres-
surised, wait for the engine to cool
down before topping up the level.
When topping up, and in order
to prevent any risk of scalding,
unscrew the cap by two turns
to allow the pressure to drop.
When the pressure has
dropped, remove the cap and top up
the level with coolant. Power steering warning
lamp
This indicates a power stee-
ring fault.
It is linked with the STOP warning lamp.
Consult a PEUGEOT dealer.

Page 24 of 243

1
27
Coolant temperature indicator
When the needle is in zone A , the
temperature is correct.
When the needle is in zone B , the
temperature is too high.
If the coolant temperature
warning lamp comes on
(linked with the STOP warn-
ing lamp), stop as soon as it
safe to do so.
Wait for the engine to cool down be-
fore topping up the level, if necessary.
As the cooling circuit is pres-
surised, in order to prevent
any risk of scalding, unscrew
the cap by two turns to allow
the pressure to drop.
When the pressure has dropped, re-
move the cap and top up the level with
coolant, if necessary.
Consult a PEUGEOT dealer.
This indicates an automatic
gearbox programme fault.
Automatic gearbox lever position indicators
Automatic gearbox fault
warning lamp
This indicates an automatic
gearbox fault.
The gearbox will operate in
down-grade mode, locked in
3rd gear.
Never force the gear lever.
Consult a PEUGEOT dealer.
6 speed automatic gearbox
"Park" indicator
"Reverse" indicator
"Neutral" indicator
"Drive" indicator
The letter S or the symbol , associ-
ated with the gear lever position indica-
tors, corresponds to the Sport or Snow
programme selected intentionally.
"Manual" indicators
These correspond to the manual con-
trol of the gearbox.
When the engine speed is too low or too
high in relation to the gear engaged, the
gear selected fl ashes for a few seconds,
then the actual gear is displayed, the
auto-adaptive programme having taken
control temporarily.