service indicator Peugeot 407 C 2010.5 Owner's Manual

1
26
Electronically controlled
suspension indicator lamps
This comes on when the
SPORT function is activated.
Automatic illumination of
headlamps on indicator
This comes on when the
AUTO function is activated.
Automatic illumination of
headlamps off indicator
This comes on when the AUTO
function is deactivated.
Automatic rain sensitive
wipers on indicator
This comes on when the
AUTO function is activated.
Automatic rain sensitive
wipers off indicator
This comes on when the
AUTO function is deactivated.
Service warning lamp
This is displayed to indicate
an engine management sys-
tem fault.
Contact a PEUGEOT dealer as soon
as possible.
Electronically controlled
suspension fault warning
lamp
This indicates an electroni-
cally controlled suspension
malfunction.
Select automatic operation and con-
tact a PEUGEOT dealer as soon as
possible.
Parking sensor system
warning lamp
In forward and/or reverse
gear, this indicates a parking
sensor system fault.
Consult a PEUGEOT dealer. This comes on when the
SPORT function is deacti-
vated.
Particle emission fi lter
saturation warning lamp
(Diesel engine)
With the engine running, this
indicates that the particle
emission fi lter is starting to become
saturated (exceptionally prolonged ur-
ban driving type conditions: low speed,
long traffi c jams...) or a low Diesel ad-
ditive reservoir level.
In order to regenerate the fi lter, you are
advised to drive, as soon as possible
when the traffi c conditions permit, at a
speed of 40 mph (60 km/h) or above
for at least fi ve minutes (until the warn-
ing lamp goes off).
If the warning lamp remains on, con-
tact a PEUGEOT dealer.
Following prolonged use of the vehi-
cle at very low speeds or at idle, you
may, exceptionally, notice an emission
of water vapour at the exhaust dur-
ing acceleration. This does not affect
the performance of the vehicle or the
environment. Water in Diesel fi lter
warning lamp
This indicates the presence
of water in the Diesel fi lter.
There is a risk of damage to
the injection system.
Contact a PEUGEOT dealer as soon
as possible.

1
28
SERVICE INDICATOR
This is a visual reminder of when the
next service is due. This service is to
be carried out according to the manu-
facturer's servicing schedule.
Once an engine oil level indication has been displayed, the display indicates
the total and trip distances.
If the service is overdue , each time
the ignition is switched on and for
5 seconds, the distance and the span-
ner fl ash.

Example : when the ignition is switched on and for 5 seconds, the display in-
dicates that the service is overdue by
300 miles/km. The service should be
carried out very shortly.
Once the servicing and oil level infor-
mation has been displayed, the total
distance recorder resumes normal op-
eration and the spanner remains on.
The point at which a service is due is
calculated using two parameters:
- the total distance travelled,
- the time elapsed since the last
service.
The distance remaining may be
weighted by the time factor, depend-
ing on the user's driving conditions.
Engine oil temperature indicator
When the ignition is switched on or
while the vehicle is moving, this indi-
cates the engine oil temperature.
When the needle is in zone C , the
temperature is correct.
When the needle is in zone D , the
temperature is too high.
Reduce your speed to lower the tem-
perature. Operation
As soon as the ignition is switched on
and for 5 seconds, the spanner sym-
bolising the service operations is on.
The trip recorder display shows the
distance remaining (in round fi gures)
before the next service.

Example : when switching on the ig-
nition and for 5 seconds, the display
shows that 400 miles/900 km remain
before the next service is due.

1
28
SERVICE INDICATOR
This is a visual reminder of when the
next service is due. This service is to
be carried out according to the manu-
facturer's servicing schedule.
Once an engine oil level indication has been displayed, the display indicates
the total and trip distances.
If the service is overdue , each time
the ignition is switched on and for
5 seconds, the distance and the span-
ner fl ash.

Example : when the ignition is switched on and for 5 seconds, the display in-
dicates that the service is overdue by
300 miles/km. The service should be
carried out very shortly.
Once the servicing and oil level infor-
mation has been displayed, the total
distance recorder resumes normal op-
eration and the spanner remains on.
The point at which a service is due is
calculated using two parameters:
- the total distance travelled,
- the time elapsed since the last
service.
The distance remaining may be
weighted by the time factor, depend-
ing on the user's driving conditions.
Engine oil temperature indicator
When the ignition is switched on or
while the vehicle is moving, this indi-
cates the engine oil temperature.
When the needle is in zone C , the
temperature is correct.
When the needle is in zone D , the
temperature is too high.
Reduce your speed to lower the tem-
perature. Operation
As soon as the ignition is switched on
and for 5 seconds, the spanner sym-
bolising the service operations is on.
The trip recorder display shows the
distance remaining (in round fi gures)
before the next service.

Example : when switching on the ig-
nition and for 5 seconds, the display
shows that 400 miles/900 km remain
before the next service is due.

1
Service indicator zero re-set
Your PEUGEOT dealer carries out this
operation after each service.
However, if you carry out the service
yourself, the re-set procedure is as
follows:

 Switch off the ignition,

 Press and hold the trip recorder re-
set button,

 Switch on the ignition.
The display begins a countdown.
When the display shows "=0" , release
the button; the spanner disappears.
Engine oil level indicator
When the ignition is switched on, the
engine oil level is indicated for approx-
imately 5 seconds, after the service
information.
Dipstick
There are 2 level marks on
the dipstick: never exceed
level A .
In position B , top up the
level via the oil fi ller cap,
using the type of oil suited
to your engine.

A = max.

B = min.
Oil level correct
Oil level too low
Flashing indicates that the oil level is
too low, which may damage the en-
gine.
If the low oil level is confi rmed by
checking with the dipstick, the level
must be topped up. Oil level indicator fault
(fl ashing segments)
Check the oil level using the dipstick.
If the level is correct, the fl ashing indi-
cates an engine oil level gauge mal-
function.
Consult a PEUGEOT dealer.
The level observed on the dipstick is
only valid if the vehicle is parked on
level ground and the engine has been
off for more than 15 minutes.
After this operation, if you wish
to disconnect the battery, lock
the vehicle and wait for at least
fi ve minutes, otherwise the zero
re-set will not be registered.

1
Service indicator zero re-set
Your PEUGEOT dealer carries out this
operation after each service.
However, if you carry out the service
yourself, the re-set procedure is as
follows:

 Switch off the ignition,

 Press and hold the trip recorder re-
set button,

 Switch on the ignition.
The display begins a countdown.
When the display shows "=0" , release
the button; the spanner disappears.
Engine oil level indicator
When the ignition is switched on, the
engine oil level is indicated for approx-
imately 5 seconds, after the service
information.
Dipstick
There are 2 level marks on
the dipstick: never exceed
level A .
In position B , top up the
level via the oil fi ller cap,
using the type of oil suited
to your engine.

A = max.

B = min.
Oil level correct
Oil level too low
Flashing indicates that the oil level is
too low, which may damage the en-
gine.
If the low oil level is confi rmed by
checking with the dipstick, the level
must be topped up. Oil level indicator fault
(fl ashing segments)
Check the oil level using the dipstick.
If the level is correct, the fl ashing indi-
cates an engine oil level gauge mal-
function.
Consult a PEUGEOT dealer.
The level observed on the dipstick is
only valid if the vehicle is parked on
level ground and the engine has been
off for more than 15 minutes.
After this operation, if you wish
to disconnect the battery, lock
the vehicle and wait for at least
fi ve minutes, otherwise the zero
re-set will not be registered.