ESP PEUGEOT 407 C 2010 Owners Manual

 20 With the ignition on, the orange and red
warning lamps come on.
With the engine running, these warning
lamps should go off.
If a warning lamp remains on, refer to
the page concerned.
Lighting of the indicator lamp indicates
the status of the corresponding function.

A. With the ignition on, the fuel gauge
needle should rise.

B.
With the engine running, the associated
low level warning lamp should go off.

C. With the ignition on, the oil level in-
dicator should display "OIL OK" for
a few seconds.
If the levels are not correct, top up the
level which is low.
Warning lamps

 22
Switch panel Instrument panel

 102

A. Deactivation of the front
and/or rear parking sen-
sors.

B. Central locking.

C. Deactivation of the inte-
rior protection alarm.

D. Hazard warning lamps.

E. Selection of the electroni-
cally controlled suspen-
sion.

F. Deactivation of the elec-
tronic stability programme
ESP.
 70

 68

 84

 96

 85

1
24
Under-infl ation tyre
warning lamp
This indicates that the tyre
pressure is too low.
A message in the multifunction screen
indicates the wheel(s) concerned.
Refer to the information label affi xed
to the central pillar of the driver's door.
For your safety, check the tyre pres-
sures as soon as possible.
Electronic stability control system
(ESP) warning lamps
Activation warning lamp
Operation warning lamp
Deactivation warning lamp
Fault warning lamp
Parking brake warning
lamp
This indicates that the parking
brake is still applied or has not
been released correctly.
It is linked with the braking system
warning lamp.
Low screenwash and
headlamp wash fl uid level
warning lamp
When the wipers are switched
on, this indicates that the fl uid
level is too low.
Fill the screenwash and headlamp
wash fl uid reservoir. Battery charge warning
lamp
When the engine is running,
this indicates a charging cir-
cuit fault (battery terminals,
alternator belt).
Consult a PEUGEOT dealer. Engine oil level warning
lamp
This indicates a low engine
oil level.

Stop as soon as it is safe to do so.
Consult a PEUGEOT dealer.
INSTRUMENT PANEL SCREEN WARNING LAMPS
STOP warning lamp
It comes on linked with the
warning lamps for engine
oil pressure, coolant tem-
perature, power steering,
braking system or punctured tyre.

Stop as soon as it is safe to do so.
Consult a PEUGEOT dealer.
Low coolant level warning
lamp (according to
version)
This warning lamp indicates
that cooling system level is
too low.

Stop as soon as it is safe to do so.
Consult a PEUGEOT dealer.
Warning: the cooling system is pres-
surised, wait for the engine to cool
down before topping up the level.
When topping up, and in order
to prevent any risk of scalding,
unscrew the cap by two turns
to allow the pressure to drop.
When the pressure has
dropped, remove the cap and top up
the level with coolant. Power steering warning
lamp
This indicates a power stee-
ring fault.
It is linked with the STOP warning lamp.
Consult a PEUGEOT dealer.

7
85
ELECTRONIC STABILITY PROGRAMME (ESP)
The electronic stability programme (ESP)
incorporates the following systems:
- anti-lock braking system (ABS) and the braking system (EBFD),
- emergency braking assistance system,
- anti-slip regulation (ASR), also known as traction control
- dynamic stability control (DSC).
Anti-slip regulation (ASR) -
Traction control
The ASR system optimises traction in
order to avoid wheel slip by acting on
the brakes of the driving wheels and
on the engine. It also improves the
directional stability of the vehicle on
acceleration.
Dynamic stability control (DSC)
If there is a difference between the
path followed by the vehicle and that
required by the driver, the DSC moni-
tors each wheel and automatically acts
on the brake of one or more wheels
and on the engine to return the vehicle
to the required path, within the limits of
the laws of physics.
Operating modes
Definitions
Emergency braking assistance
system
In an emergency, this system enables
you to reach the optimum braking
pressure more quickly and therefore
reduce the stopping distance.
It is triggered in relation to the speed
at which the brake pedal is pressed.
This is felt by a reduction in the resis-
tance of the pedal and an increase in
the effectiveness of the braking. When this warning lamp
comes on, accompanied by
an audible signal and a mes-
sage, it indicates that there
is an ABS fault, which could
cause a loss of control of the vehicle
when braking.
When this warning lamp
comes on, connected to the

STOP and ABS warning
lamps, accompanied by an
audible signal and a mes-
sage, it indicates that there is an elec-
tronic brake force distribution fault,
which could cause a loss of control of
the vehicle when braking.

Stop
as soon as it is safe to do so
.
In both cases, consult a PEUGEOT
dealer.
Anti-lock braking system (ABS)
and braking system (EBFD)
This system improves the stability and
manoeuvrability of your vehicle when
braking and offers improved control,
in particular on poor or slippery road
surfaces.
The ABS prevents wheel lock in the
event of emergency braking.
The EBFD provides complete man-
agement of the braking pressure
wheel by wheel. Anti-lock braking system (ABS)
and electronic brake force
distribution (EBFD) braking system

7
Dynamic stability control (DSC)
When changing wheels (tyres
and rims), ensure that only
approved tyres and rims are
used.
Normal operation of the ABS may
make itself felt by slight vibrations of
the brake pedal.

In emergency braking, press
very fi rmly without relea sing
the pressure.
Operating fault
When a system malfunction occurs,
the warning lamp comes on accompa-
nied by an audible signal and a mes-
sage in the multifunction screen.
Contact a PEUGEOT dealer to have
the system checked.
The DSC offers improved
safety during normal driving
but should not encourage the
driver to take extra risks (late
braking) or drive at very high speeds.
Operation of the system is guaranteed
on condition that the manufacturer's in-
structions regarding the wheels (tyres
and rims), the braking components,
the electronic components and the as-
sembly and repair procedures used by
PEUGEOT dealers are observed.
Following an impact, have the system
checked by a PEUGEOT dealer.
Warning lamp in the instrument panel.
The indicator lamp comes on.
Deactivation
In exceptional conditions (starting the
vehicle when it is stuck in mud, immo-
bilised in snow, on unstable ground…),
it may prove useful to deactivate the
DSC.

 Press the "ESP OFF" switch, lo-
cated on the centre console.
The switch lamp and the warning lamp
come on: the DSC no longer acts on
the operation of the engine.
Warning lamp in the instru-
ment panel.
Reactivation

 Automatic when the ignition is
switched off,

 Automatic from 30 mph (50 km/h),

 Manual by pressing the switch
again.
Operation of the DSC

1010
117
Engine compartment fuses
To access the fuses located in the
engine compartment (next to the bat-
tery), remove the battery cover and
unclip the fusebox cover.
Close the fusebox cover carefully and
refi t the battery cover when you have
fi nished.
Fuse N°
Rating

A
Functions

1 20 Engine control unit, fan assembly relay supply.

2 15 Horn.

3 10 Screenwash pump.

4 20 Headlamp wash pump.

5 15 Fuel pump, engine management actuators
(air fl ow sensor, electrovalves, ...).

6 10 ESP control unit.

7 10 Automatic headlamp adjustment.

8 20 Starter coil.

9 10 Directional headlamps control unit, additional
heating switching and protection control unit,
clutch switch.

10 30 Engine management actuators (ignition coil,
injectors, thermostats, electrovalves, oxygen
sensors), Diesel additive pump, fuel pump,
engine control unit, blow-by heater.

11 40 Air conditioning fan.

12 30 Windscreen wipers.

13 40 Built-in systems interface supply
(ignition positive).

14 30 Not used.

205
Avoid ferries
Recalculate
Settings
Navi volume
POI categories on Map
Set parameters for risk areas
Display on map
Visual alert
Sound alert
3
2
4
3
3
3
4
4
4
Dial from address book
"Phone" Menu
Search phone
Call lists
Connect phone
Select ring tone
Phone/Ring tone volume
Phones connected
Enter mailbox number
Settings
Disconnect phone
Rename phone
Delete pairing
Delete all pairings
Show details
"SETUP" menu
System language *
English
Español
Deutsch
Italiano
Français
Nederlands
Polski
Portuguese
Date & Time *
Set date & time
Date format
Time format
1
2
2
2
2
3
3
4
4
4
4
4
2
3
3
3
1
2
3
3
3
3
3
3
3
3
3
3
3
2
Avoid motorways
Route dynamics
Traffi c independent
Semi-dynamic
Avoidance criteria
Avoid toll roads
Optimized route
3
3
4
4
4
4
4
* Available according to model.