Peugeot 407 Dag 2005 Service Manual

34 -
14-02-2005
35
-
14-02-2005
This indicates an automatic
gearbox program fault.
Automatic gearbox lever
postion indicator lights
This indicates an automatic
gearbox malfunction.
4 or 6 speed automatic gearbox
"Manual" indicator lights
"Park" indicator
lights
"Reverse"
indicator lights
"Neutral"
indicator lights
"Drive"
indicator lights
The letter S or the symbol T asso-
ciated with the gate lever position
indicator lights, corresponds to the
Sport or Snow program selected in-
tentionally. These correspond to the manual
control of the gearbox, four or six
speed.
When the engine speed is too low
or too high in relation to the gear
engaged, the gear selected lashes
for a few seconds, then the actual
gear is displayed, the auto-adaptive
program having taken control tem-
porarily.
Engine oil temperature
indicator
When the ignition is switched on or
while the vehicle is moving, this indi-
cates the engine oil temperature.
When the needle is in zone
C, the
temperature is correct.
When the needle is in zone D, the
temperature is too high.
Reduce your speed to lower the tem-
perature.
Instruments and controls

36 -
14-02-2005
37
-
14-02-2005
SERVICE INDICATOR
This is a visual reminder of when the
next service is due. This service is to
be carried out according to the man-
ufacturer's servicing schedule.
Operation
As soon as the ignition is switched
on and for 5 seconds, the spanner
symbolising ''service operation'' is lit.
The trip recorder display shows the
distance remaining (in round igures)
before the next service.
Example:
when switching on the
ignition and for 5 seconds, the
display shows that 900 miles/km
remain before the next service is
due. Service indicator zero re-set
Your PEUGEOT dealer carries out
this operation after each service.
However, if you carry out the service
yourself, the re-set procedure is as
follows:
F
Switch off the ignition,
F Press and hold the trip recorder
re-set button,
F Switch on the ignition.
The display begins a countdown.
When the display shows "= 0" and
the service symbol disappears, re-
lease the button.
Important: after this operation, if you
wish to disconnect the battery, lock
the vehicle and wait for at least ive
minutes, otherwise the zero re-set
will not be registered.
Once an engine oil level indication
has been displayed, the display indi-
cates the total and trip distances. If the service is overdue
, each
time the ignition is switched on and
for 5 seconds, the distance and the
service spanner lash.
Example: when the ignition is
switched on and for 5 seconds, the
display indicates that the service
is overdue by 300 miles/km. The
service should be carried out very
shortly.
Once the servicing and oil level infor-
mation has been displayed, the total
distance recorder resumes normal
operation and the symbol remains lit.
The point at which a service is due is
calculated using two parameters:
- the total distance travelled,
- the time elapsed since the last service.
The distance remaining may be
weighted by the time factor, depend-
ing on the user's driving habits.
Instruments and controls

36 -
14-02-2005
37
-
14-02-2005
Engine oil level indicator
When the ignition is switched on,
the engine oil level is indicated for
approximately 5 seconds, after the
service information.
Dipstick
There are 2 level marks
on the dipstick: never ex-
ceed level A.
In position B, top up the
level via the oil reservoir
cap, using the type of oil
suited to your engine.
A = max.
B = min.

Trip recorder zero reset
With the trip distance displayed, press
the button for a few seconds.
Oil level correct
Lack of oil
Flashing indicates a lack of oil which
may damage the engine.
If the lack of oil is conirmed by
checking using the dipstick, it is im-
perative that the level is topped up. Oil level gauge fault
(lashing segments)
Check the oil level using the dip-
stick.
If the level is correct, the lashing
indicates an engine oil level gauge
malfunction.
Contact a PEUGEOT dealer.
The level observed on the dipstick
is only valid if the vehicle is parked
on level ground and the engine has
been off for more than
15 minutes.
The total distance is displayed in
zone A of the display and the trip
distance in zone B.
Distance recorder
Instruments and controls

38 -
14-02-2005
39
-
14-02-2005
TRIP COMPUTER
or
TRIP: access to the
trip computer displays.
Each successive press on the but-
ton located at the end of the wipers
stalk displays different information.
- the "vehicle" tab with:
• the range and the current con- sumption,
- tab "1" (route 1) with:
• the average consumption, the dis- tance travelled and the average
speed calculated over route "1",
- tab "2" (route 2) with the same
characteristics for a second route.
Zero reset
When the required route is displayed,
press the control for more than two
seconds.
Range
This shows the distance that can still
be covered with the fuel remaining in
the tank in accordance with the aver-
age consumption over the last few
miles (kilometres).
This igure may increase if there is a
change in the style of driving or the
road surface, producing a signiicant
drop in current consumption.
When the range is less than 20 miles
(30 km), four segments are dis-
played. After illing with fuel, the
range is displayed when it exceeds
62 miles (100 km).
If horizontal segments are displayed
for long periods instead of digits,
contact a PEUGEOT dealer.
Distance remaining to be
travelled
This is the distance remaining to the
destination, either calculated at any
time by the navigation if guidance
is activated or entered by the user,
minus the distance covered since the
distance was entered.
If digits are missing, dashes are dis-
played in their place.
Current consumption
This is the average quantity of fuel con-
sumed during the last few seconds.
This function is displayed only when
the vehicle is travelling at a speed
greater than 20 mph (30 km/h).
The routes
The routes "1" and ''2'' are independ-
ent but have identical application.
Route "1" for example allows you
to make daily calculations and route
"2" monthly calculations.
Instruments and controls

38 -
14-02-2005
39
-
14-02-2005
Average speed
This is the average speed calculated
since the computer was last set to
zero (with the ignition on).
Access via the general menu"TRIP" menu
Press the
"MENU" button to gain ac-
cess to the general menu.
Select the "Trip computer" ap-
plication using the navigator, then
conirm.
The "Trip computer" menu offers
various options:
- Warnings log,
- Status of the functions,
- Inputting of the distance to be trav- elled.
Average consumption
This is the average fuel consump-
tion since the computer was last set
to zero.
Distance travelled
This indicates the distance travelled
since the computer was last set to
zero. C screen.
CT screen.
DT screen.Warnings log
This summarises the active warning
messages, displaying them on the
multifunction display in succession.
Status of the functions
This summarises the active or inac-
tive status of the functions present on
the vehicle.
Distance remaining
When guidance is not activated, this
enables you to enter an approximate
distance to be travelled value.
Instruments and controls

40 -
14-02-2005
41
-
14-02-2005
FRONT SEATS
Manual mode
Longitudinal adjustment
Lift the control bar and slide the seat
forwards or backwards. Driver's seat cushion height and
angle adjustment
Pump up or down to the required
position.
Seat back angle adjustment
Operate the lever for your comfort.
407 saloon and 407 SW comfort

40 -
14-02-2005
41
-
14-02-2005
Electric mode
The electrical functions of the driver's
seat are deactivated one minute after
the ignition is switched off.
To reactivate them, open the door or
switch on the ignition.
Longitudinal adjustment
Push the control fowards or back-
wards to slide the seat. Driver's seat cushion height and
angle adjustment
Height:
tilt the rear of the control up
or down.
Tilt: tilt the front of the control up or
down. Seat back angle adjustment
Tilt the control forwards or backwards
for your comfort.
407 saloon and 407 SW comfort

42 -
14-02-2005
43
-
14-02-2005
Head restraint height and angle
adjustment
To raise or lower the head restraint,
pull it forwards then slide it.
To tilt the head restraint, tilt the lower
part forwards or backwards.
To remove the head restraint, move it
almost to the highest position, lift the
tab using a coin and pull it forwards
and upwards at the same time.
To reit the head restraint, engage
the stalks in the holes keeping in line
with the seat back.
Never drive with the head restraints
removed and stored in the vehicle.
This is dangerous and they may be
thrown in the event of sharp braking.
They must be in place and adjusted
correctly.
The adjustment is correct when the
top of the head restraint is aligned
with the top of the head of the occu-
pant of the seat. Front seat active head restraint
This system prevents "whiplash".
In the event of a rear impact, the
action of the body on the seat back
moves the head restraint forwards
and upwards preventing the head
from being thrown back.
Front armrest
To change the position of the armrest:
F
Lift the handle 1.
The armrest folds forwards and
upwards.
To return to the initial position, push
the armrest backwards and press it
to engage.
Driver's seat lumbar adjustment
Operate the lever to obtain the cor-
rect position.
Heated seats adjustment
With the engine running, turn the
dial. The temperature of the seat is
regulated automatically.
0:
Off.
1: Low. 2:
Medium.
3: High.
407 saloon and 407 SW comfort

42 -
14-02-2005
43
-
14-02-2005
GENERAL POINTS RELATING
TO CHILD SEATS
Although one of PEUGEOT's main
criteria when designing your vehicle,
the safety of your children also de-
pends on you.
For maximum safety, please follow
these precautions:
- Since 1992,
all children under
the age of 12 must travel in ap-
proved child seats* suited to
their weight , on seats itted with a
seat belt or ISOFIX mountings**.
- A child weighing less than 9 kg
must travel in the rearwards
facing position both in the front
and in the rear. PEUGEOT recom-
mends that children should travel
in the "rearwards facing" position
up to the age of two. -
Statistically, the safest seats in
your vehicle for the transpor-
tation of children are the rear
seats. PEUGEOT recommends
that children travel in the rear
even when a "rearwards facing"
child seat is used.
- If a child is travelling on a booster seat, check that the lap section of
the seat belt passes over the child's
thighs correctly. The chest section of
the seat belt must be positioned on
the child's shoulder without touching
the neck. PEUGEOT recommends
that you use a booster seat with a
back, itted with a seat belt guide at
shoulder level.
- Remember to fasten the seat belt or the child seat harness keeping
the slack in relation to the child's
body to a minimum , even for short
journeys. Special points relating to the
transportation of children on the
front passenger seat*
Children under the age of 10 must not
travel in the forwards facing position,
unless the rear seats are already oc-
cupied by other children or the rear
seats cannot be used (absent or
folded). In this case, adjust the front
passenger seat to the intermediate
longitudinal position and leave the
passenger air bag armed**.
The transportation of children in the
rearwards facing position is permit-
ted. In this position, it is essential
to disarm the passenger air bag**.
Otherwise, the child would risk be-
ing killed or seriously injured if the air
bag were to inlate.
* According to current legislation in
the country.
** According to model.
407 saloon and 407 SW comfort

44 -
14-02-2005
45
-
14-02-2005
"ISOFIX" MOUNTINGS
Available on:
- the two rear side seats,
- the front passenger seat (407 SW).
These seats are itted with
ISOFIX
mountings .
These are two rings, located between
the seat back and the seat cushion.
The ISOFIX child seats are itted
with two locks which are secured
easily on these lower rings.
Incorrect installation of a child seat
in a vehicle compromises the pro-
tection of the child in the event of a
collision.
The ISOFIX securing system guar-
antees reliable, safe and fast itting
of the child seat in your vehicle.
You can only it the ISOFIX child
seats approved by PEUGEOT and
presented below on your vehicle's
ISOFIX mountings. The ISOFIX KIDDY child seat
It can be itted in the "rear facing"
position from birth to 13 kg and in
the "forwards facing" position from 9
and 18 kg.
In the rear:

- in the "forwards facing" position, the front seat must be in the com-
pulsory mid-way position, seat
back upright.
- in the "rear facing" position, the body of the child seat must be in
contact with the back of the corre-
sponding front seat. In the front
(407 SW):
- in the "forwards facing" position, the front passenger seat must be
in the mid-way position, seat back
upright and seat cushion in the low-
est position.
- in the "rear facing" position, the front passenger seat must be in
the fully forward position so that the
body of the child seat is in contact
with or as close as possible to the
fascia. The angle of the seat cush-
ion* must be in the lowest position.
When the ISOFIX KIDDY seat is
installed in the "rear facing" posi-
tion on the front passenger seat,
it is imperative that the passenger
air bag is disarmed.
Otherwise, the child would risk be-
ing killed or seriously injured if the
air bag were to inlate.
Follow the instructions for installing
the child seat indicated in the seat
manufacturer's installation guide.
* According to version.
407 saloon and 407 SW comfort