Time Peugeot 508 2011 User Guide

2
47
!
Access


















Lost keys, remote control, electronic key

Visit a PEUGEOT dealer with the vehicle's V5 registration document and your personal identification documents.
The PEUGEOT dealer will be able to retrieve the key code and the transponder code required to order a replacement.


Remote control

The high frequency remote control is a sensitive system; do not operate it while it is in your pocket as there is a possibility that it may unlock the
vehicle, without you being aware of it.
Do not repeatedly press the buttons of your remote control out of range and out of sight of your vehicle. You run the risk of stopping it from
working and the remote control would have to be reinitialised.
The remote control does not operate when the key is in the ignition, even when the ignition is switched off.


Locking the vehicle

Driving with the doors locked may make access to the passenger compar tment by the emergency ser vices more difficult in an emergency.
As a safety precaution (with children on board), remove the key from the ignition or take the electronic key when you leave the vehicle, even for
a shor t time.


Electrical interference

The Keyless Entry and Star ting electronic key may not operate if close to cer tain electronic devices: telephone, laptop computer, s t r o n g
magnetic fields, ...


Anti-theft protection

Do not make any modifications to the electronic engine immobiliser system; this could cause malfunctions.
Don't forget to turn the steering to engage the steering lock.


When purchasing a second-hand vehicle

Have the key codes memorised by a PEUGEOT dealer, to ensure that the keys in your possession are the only ones which can star t the vehicle.

48
!
Access
System which protects and provides a deterrent
against theft and break-ins. It provides the
following types of monitoring:






Alarm


- Exterior perimeter

The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a
door, the boot or the bonnet...




- Interior volumetric

The system checks for any variation in the
volume in the passenger compartment.
The alarm is triggered if anyone breaks a
window, enters the passenger compar tment or
moves inside the vehicle.




- Tilt

The system checks for any change in the
attitude of the vehicle.
The alarm is triggered if the vehicle is lifted,
moved or knocked.




Self-protection function

The system checks for the putting out of
ser vice of its components.
The alarm is triggered if the battery, the
central control unit or the wires of the
siren are put out of ser vice or damaged.
For all work on the alarm system,
contact a PEUGEOT dealer or a
qualified workshop.


Locking the vehicle with full
alarm system

Activation



)
Switch off the ignition and get out of the vehicle.


)
Press the locking button on the
remote control or lock the vehicle
using the Keyless Entry and
Star ting system. The monitoring system is active: the indicator
lamp on the button flashes once per second.
After the locking button on the remote control
is pressed or the vehicle locked using the
Keyless Entry and Star ting system, the exterior
perimeter monitoring is activated after a delay
of 5 seconds and the interior volumetric and
anti-tilt monitoring after a delay of 45 seconds.
If an opening (door, boot...) is not closed
fully, the vehicle is not locked but the exterior
perimeter monitoring will be activated after a
delay of 45 seconds at the same time as the
interior volumetric and anti-tilt monitoring.


)
Press the unlocking button on
the remote control or unlock the
vehicle using the Keyless Entry
and Star ting system.


Deactivation of the volumetric
monitoring
The volumetric protection system is
deactivated: the indicator lamp in the
button goes off.

2
49
Access

Locking the vehicle
with exterior perimeter
monitoring only
Deactivate the interior volumetric and anti-lift
monitoring to avoid unwanted triggering of the
alarm in cer tain cases such as:


- leaving a window par tially open,

- washing your vehicle,

- changing a wheel,

- having your vehicle towed,

- transpor tation by sea.


Deactivation of the interior
volumetric and anti-tilt monitoring


)
Switch of the ignition and within
ten seconds, press this button
until the indicator lamp is on
continuously.

)
Get out of the vehicle.

)
Press the locking button on
the remote control immediately
or lock the vehicle using the
Keyless Entry and Star ting
system.
The exterior perimeter monitoring alone is
activated: the indicator lamp in the button
flashes once per second.
To be effective, this deactivation must be carried
out each time the ignition is switched off.


Reactivation of the interior
volumetric and anti-tilt monitoring

Tr i g g e r i n g o f t h e a l a r m


This is indicated by sounding of the siren and
flashing of the direction indicators for thirty seconds.
The monitoring functions remain active until
the alarm has been triggered eleven times in
succession.

)
Press the unlocking button on
the remote control or unlock the
vehicle using the Keyless Entry
and Starting system to deactivate
the exterior perimeter monitoring.

)
Press the locking button on the
remote control or lock the vehicle
using the Keyless Entry and
Starting system to activate all the
monitoring functions.
The indicator lamp in the button
again flashes once per second.

When the vehicle is unlocked using
the remote control or unlocked
using the Keyless Entry and Star ting
system, rapid flashing of the indicator
lamp in the button informs you that the alarm
was triggered during your absence. When
the ignition is switched on, this flashing stops
immediately.



Failure of the remote control

To deactivate the monitoring functions:



)
Unlock the vehicle using the key in the
driver's door lock.

)
Open the door; the alarm is triggered.

)
Switch on the ignition; the alarm stops. The
indicator lamp in the button switches off.




Locking the vehicle without
activating the alarm



)
Lock or deadlock the vehicle using the key
in the driver's door lock.




Operating fault


When the ignition is switched on, fixed
illumination of the indicator lamp in the button
indicates a fault in the system.
Have it checked by a PEUGEOT dealer or a
qualified workshop.


*
According to country.


Automatic activation *


2 minutes after the last door or the boot is
closed, the system is activated automatically.


)
To avoid triggering the alarm on entering
the vehicle, first press the unlocking button
on the remote control or unlock the vehicle
using the Keyless Entry and Star ting
system.

50
Access
Electric windows



1.
Left hand front electric window switch.


2.
Right hand front electric window
switch.


3.
Right hand rear electric window switch.


4.
Left hand rear electric window switch.


5.
Deactivating the rear electric window
switches,

locking the rear doors

(child lock).


Manual operation

To open or close the window, press or pull the
switch gently. The window stops as soon as the
switch is released.

Automatic operation

(depending on version)

To open or close the window, press or pull
switch fully: the window opens or closes
completely when the switch is released.
Pressing the switch again stops the movement
of the window.
The electric window switches remain
operational for approximately one minute after
the key has been removed from the ignition.
Once this time has elapsed, the electric
windows will not operate. To reactivate them,
switch the ignition on again.


Safety anti-pinch

When the window rises and meets an obstacle,
it stops and immediately partially lowers again.
In the event of unwanted opening of the
window on closing, press the switch until the
window opens completely, then pull the switch
immediately until the window closes. Continue
to hold the switch for approximately one second
after the window has closed.
The safety anti-pinch function is not active
during this operation.


Deactivating the rear window
controls
For the safety of your children, press switch 5

to prevent operation of the rear windows
irrespective of their position.
The interior controls for the rear doors are also
deactivated.
When the button is pressed down, the switches
are deactivated. When the button is raised, the
switches are active.

2
51
!
Access

Reinitialisation of the
electric windows

Always remove the key from the ignition
when leaving the vehicle, even for a
shor t time.
In the event of contact during operation
of the windows, you must reverse the
movement of the window. To do this,
press the switch concerned.
When operating the passenger electric
window switches, the driver must
ensure that no one is preventing correct
closing of the windows.
The driver must ensure that the
passengers use the electric windows
correctly.
Be aware of children when operating
the windows.
Following reconnection of the battery, the
safety anti-pinch function must be reinitialised.
The safety anti-pinch function is not active
during these operations:


- lower the window completely, then raise
it, it will rise in steps of a few centimetres
each time the switch is pressed. Repeat
the operation until the window closes
completely,

- continue to press the switch for at least one
second after reaching this position, window
closed.

54
!
Access

Closing




)
Press this button C
to close the
tailgate electrically.
Do not hinder closing of the tailgate: any
obstacle to closing causes the tailgate to stop
and rise a few centimetres automatically.
To close the tailgate manually: move the
tailgate slightly up then down to disengage it
from its drive then lower it until closed.


To

avoid the risk of injur y

, ensure
that no



one is close to the rear of the
vehicle

when

opening or closing the
tailgate

.





Adjusting the opening height

During motorised opening, if clearance above
the vehicle is limited, or to make it easier to
reach the tailgate grip, stop it manually at
the desired height. The height is stored and
confirmed by an audible signal.
To change the height: during motorised
opening, lift the tailgate to the desired height.

While electric opening or closing of the tailgate
is in progress, you can stop its movement at
any time:


)
press the interior button or button A
on
the remote control or button B
or C
on the
tailgate.




Stopping the opening or
closing

3
61
Comfort

















Front seats


Manual adjustments


1.
Adjustments to the height and angle of
the head restraint

To raise it, pull upwards.
To lower it, hold the button in and press on
the head restraint (pushing to go past the
stiff point of the button).

2.
Adjustment of the backrest angle

Operate the control lever and adjust the
position of the backrest to the front or to the
rear.

3.
Adjustment of the seat height

Raise or lower the control lever the number
of times required to obtain the desired
position.

4.
Adjustment of the lumbar suppor t

This system allows the height and depth of
the lumbar suppor t to be adjusted separately.


)
For wards or backwards to increase or
decrease the lumbar suppor t.

)
Upwards or downwards to raise or lower
the lumbar contact zone.

5.
Forwards-backwards adjustment of the
seat position

Lift the control bar and slide the seat
for wards or backwards.




6. Adjusting the cushion

Pull the handle to adjust the length of the
cushion.

3
65
Comfort






Massage function

This function provides the driver with a back
massage. It only operates when the engine is
running as well as in STOP mode of the Stop &
Star t system.

Activation



)
Press this button.
The warning lamp comes on and the massage
function is activated for a period of 1 hour.
During this time, massage is per formed in
cycles of 6 minutes (4 minutes of massage
followed by 2 minutes break). In total, the
system will per form 10 cycles.
After one hour, the function is deactivated, the
warning lamp goes off.


Deactivation

You can deactivate the massage
function at any time by pressing this
button.

72
!
Comfort








Mats
Removable carpet protection.
When fitting the mat for the first time, on the
driver's side use only the fixings provided in the
wallet attached.
The other mats are simply placed on the
carpet.


Fitting

Removal

To remove the mat on the driver's side:


)
move the seat as far back as possible,

)
unclip the fixings,

)
remove the mat.



Refitting

To refit the mat on the driver's side:


)
position the mat correctly,

)
refit the fixings by pressing,

)
check that the mat is secured correctly.

To avoid any risk of jamming of the
pedals:


- only use mats which are suited to
the fixings already present in the
vehicle; these fixings must be used,

- never fit one mat on top of another.
The use of mats not approved by
PEUGEOT may inter fere with access to
the pedals and hinder the operation of
the cruise control/speed limiter.


)
Lower the rear armrest for a more
comfortable position.
It has cup holders and also gives access to the
ski flap.








Rear armrest

3
81
i
Comfort
In order for these systems to be fully effective, follow the operation and maintenance
guidelines below:


)
If the interior temperature remains very high after the vehicle has been parked in the sun
for a considerable time, first ventilate the passenger compartment for a few minutes.
Place the air flow control at a sufficient level to provide an adequate renewal of air in the
passenger compartment.

)
To obtain an even air distribution, take care not to obstruct the exterior air intake grilles
located at the base of the windscreen, the nozzles, the vents and the air outlets, as well
as the air extractor located in the boot.

)
Use in preference the intake of exterior air as prolonged use of the air recirculation may
cause misting of the windows and side windows.

)
Do not cover the sunshine sensor, located on the dashboard; this is used for regulation
of the automatic air conditioning system.

)
Operate the air conditioning system for 5 to 10 minutes, once or twice a month to keep it
in good working order.

)
Ensure that the passenger compartment filter is in good condition and have the filter
elements replaced regularly (refer to the "Checks" section).
We recommend the use of a combined passenger compartment filter. Thanks to its second special
active filter, it contributes to the purification of the air breathed by the occupants and the cleanliness
of the passenger compartment (reduction of allergic symptoms, bad odours and greasy deposits).

)
The air conditioning uses power from the engine while operating. This results in an
increase in the vehicle's fuel consumption.

When towing at or near maximum capacity or on steep slopes in high ambient temperatures,
switching off the air conditioning saves engine power and so improves towing capacity.
Condensation created by the air conditioning results in a discharge of water under the
vehicle when stationary, which is per fectly normal.

)
To ensure correct operation of the air conditioning system, you are also advised to have
it checked regularly.

)
If the system does not produce cold air, do not use it and contact a PEUGEOT dealer or
a qualified workshop.












Recommendations for ventilation and air conditioning


The air conditioning system does not
contain chlorine and does not present
any danger to the ozone layer.