PEUGEOT 607 2005.5 Owner's Guide

30 -Instruments and controls
01-06-2005
31
-Instruments and controls
01-06-2005
The distance remaining before
the next service is less than
500 miles (1,000 km).
Each time the ignition is switched on
and for 7 seconds, the service span-
ner and the distance lash.
Example:
400 miles (900 km) remain
before the next service is due.
When switching on the ignition and
for 7 seconds, the display shows:
7 seconds after the ignition is switched
on, the total distance recorder resumes
normal operation and the service
spanner remains lit.
This indicates that a service should
be carried out shortly. The display
shows the total and trip distances. 7 seconds after the ignition is switched
on, the total distance recorder resumes
normal operation and the symbol
remains lit. The display shows the total
and trip distances.
Note:
the service spanner may also
be lit if the two-year interval has been
exceeded. Service indicator zero re-set
Your PEUGEOT dealer carries out this
operation after each service.
However, if you carry out the service
yourself, the re-set procedure is as
follows:
F
Switch off the ignition,
F Press and hold the trip recorder
re-set button,
F Switch on the ignition.
The display begins a countdown.
When the display shows "=0" and the
service symbol disappears, release
the button.
Important: after this operation, if you
wish to disconnect the battery, lock
the vehicle and wait for at least ive
minutes, otherwise the zero re-set
will not be registered.
The service is overdue.
Each time the ignition is switched on
and for 7 seconds, the symbol and
the excess distance lash.
Example:
the service is overdue by
300 miles/km. The service should be
carried out very shortly.
When the ignition is switched on and
for 7 seconds, the display shows:

30 -Instruments and controls
01-06-2005
31
-Instruments and controls
01-06-2005
The distance remaining before
the next service is less than
500 miles (1,000 km).
Each time the ignition is switched on
and for 7 seconds, the service span-
ner and the distance lash.
Example:
400 miles (900 km) remain
before the next service is due.
When switching on the ignition and
for 7 seconds, the display shows:
7 seconds after the ignition is switched
on, the total distance recorder resumes
normal operation and the service
spanner remains lit.
This indicates that a service should
be carried out shortly. The display
shows the total and trip distances. 7 seconds after the ignition is switched
on, the total distance recorder resumes
normal operation and the symbol
remains lit. The display shows the total
and trip distances.
Note:
the service spanner may also
be lit if the two-year interval has been
exceeded. Service indicator zero re-set
Your PEUGEOT dealer carries out this
operation after each service.
However, if you carry out the service
yourself, the re-set procedure is as
follows:
F
Switch off the ignition,
F Press and hold the trip recorder
re-set button,
F Switch on the ignition.
The display begins a countdown.
When the display shows "=0" and the
service symbol disappears, release
the button.
Important: after this operation, if you
wish to disconnect the battery, lock
the vehicle and wait for at least ive
minutes, otherwise the zero re-set
will not be registered.
The service is overdue.
Each time the ignition is switched on
and for 7 seconds, the symbol and
the excess distance lash.
Example:
the service is overdue by
300 miles/km. The service should be
carried out very shortly.
When the ignition is switched on and
for 7 seconds, the display shows:

32 -Instruments and controls
01-06-2005
33
-Instruments and controls
01-06-2005
TRIP COMPUTER
Each press on the button, located at
the end of the
wipers stalk, displays
different trip computer data in suc-
cession, depending on the multifunc-
tion display: - the
"vehicle" tab with:
• the range, the current consumption and the distance remaining to be
travelled,
- tab "1" (route 1) with:
• the average speed, the average consumption and the distance trav-
elled calculated over route "1",
- tab "2" (route 2) with the same
characteristics for a second route.
Colour screen C Colour and map screen DT
- the "Current info" with:
• the range, the current consumption and the distance remaining to be
travelled,
- "Route 1" with:
• the distance travelled, the aver- age consumption and the average
speed calculated over route "1",
- "Route 2" with the same charac-
teristics for a second route.

34 -Instruments and controls
01-06-2005
35
-Instruments and controls
01-06-2005
Range (km or miles)
This shows the distance that can still
be covered with the fuel remaining in
the tank in accordance with the aver-
age consumption over the last few
miles (kilometres).
This igure may increase if there is a
change in the style of driving or the
road surface, producing a signiicant
drop in current consumption.
When the range is less than 30 miles
(50 km), four dashes are displayed.
After illing with fuel, the range is
displayed when it exceeds 62 miles
(100 km).
If dashes are displayed for long
periods instead of digits, contact a
PEUGEOT dealer.
Current consumption
(l/100 or km/l or mpg)
This is the average quantity of fuel con-
sumed during the last few seconds.
This function is displayed only when
the vehicle is travelling at a speed
greater than 20 mph (30 km/h).
Average consumption
(l/100 or km/l or mpg)
This is the average fuel consump-
tion since the computer was last set
to zero.
Distance travelled
(km or miles)
This indicates the distance travelled
since the computer was last set to
zero.
Distance remaining to be
travelled (km or miles)
This is the distance remaining to be
travelled to the inal destination. It is
either calculated by the navigation
system if guidance is activated or
entered by the user.
If the distance is not entered, dashes
are displayed in place of the digits.
Average speed (km/h or mph)
This is the average speed calculated
since the computer was last set to
zero (with the ignition on). The routes
"1" and "2" are independ-
ent but have identical application.
Route "1" for example allows you
to make daily calculations and route
"2" monthly calculations.
The routes
Zero reset
When the required route is displayed,
press the end of the wipers stalk for
more than two seconds.

34 -Instruments and controls
01-06-2005
35
-Instruments and controls
01-06-2005
Warnings log
This summarises the active warning
messages, displaying them on the
multifunction display in succession.
Status of the functions
This summarises the active or inac-
tive status of the functions present on
the vehicle.
Inputting the distance remaining
to be travelled
When guidance is not activated, this
enables you to enter an approximate
distance to the inal destination.Access via the general menu
C screen
DT screen
"TRIP" menu
Press the "MENU" or "TRIP" button
to gain access to the general menu.
Select the "Trip computer" ap-
plication using the navigator, then
conirm.
The "Trip computer" menu offers
various options:
- Inputting of the distance to be trav- elled,
- Warnings log,
- Status of the functions. The different trip computer data also
appears on the instrument panel dis-
play at the same time.
Indication on the instrument
panel display

36 -Multifunction displays
01-06-2005
37
-Multifunction displays
01-06-2005
COLOUR SCREEN C
This displays the following informa-
tion, via the RD4 audio equipment
control pad:
- the time,
- the date,
- the exterior temperature (the value
displayed lashes if there is a risk of
ice),
- the accesses check,
- the vehicle functions warning or status messages, displayed tem-
porarily,
- the audio sources displays,
- the trip computer displays,
- the personalisation and conigura- tion displays,
- the hands-free kit displays. Management of the displays
Example: "TRIP"
General menu
Press the
"MENU" button to gain ac-
cess to the general menu and select
one of the following functions:
- "Audio functions",
- "Trip computer",
- "Personalisation-Coniguration",
- "Telephone". "Personalisation-Coniguration"
menu
This provides access to successive
conirmation windows.
Deining the vehicle parameters
This enables you to activate or de-
activate certain driving and comfort
elements:
- "Automatic switching on of the
lights",
- "Follow-me-home lighting" and "Duration",
- "Remote control action",
- "Permanent locking of the boot".
The
"AUDIO" , "TRIP" and "TEL"
buttons on the RD4 audio equipment
control pad permit displaying in the
main window.
Example: "Audio functions" Example: "Automatic switching on of
the lights"

36 -Multifunction displays
01-06-2005
37
-Multifunction displays
01-06-2005
Selection of the language
German, Spanish, French, English,
Italian, Dutch, Portuguese and
Brazilian Portuguese.
Coniguration of the display
- "Setting the brightness-video".
- "Setting the date and time".
- "Selection of the units":
• temperature (°C or °F),
• fuel consumption (l/100, mpg or km/l).
- "Selection of the colours". Changing the date and time
From the
general menu , select the
" P e r s o n a l i s a t i o n - C o n f i g u r a t i o n "
icon using the navigator, then conirm.
From the list displayed, select "Con-
iguration of the display" , then
conirm.
From the list displayed, select
"Setting the date and time" , then
conirm. Set the parameters one by one:
- the zone selected is displayed on
the screen,
- use the navigator to move from one zone to another,
- your new parameters are con- irmed one by one, by pressing the
navigator button,
- all of the changes are saved, if you click on "OK" on the screen, or
cancelled, if you press the "ESC"
button on the control pad.
For safety reasons, con-
iguration of the multifunc-
tion displays by the driver
must be carried out while
stationary.

38 -Multifunction displays
01-06-2005
39
-Multifunction displays
01-06-2005
DT COLOUR AND MAP
SCREEN
This displays the following infor-
mation, via the RT3 GPS audio/
telephone control pad:
- the time,
- the date,
- the exterior temperature (the value
displayed lashes if there is a risk of
ice),
- the accesses check,
- the vehicle functions warning or status messages, displayed tem-
porarily,
- the audio sources displays,
- the telematic systems displays (telephone, services, ...),
- the trip computer displays,
- the personalisation and conigura- tion displays,
- the satellite navigation system displays. General menu
Press the
"MENU" button to gain
access to the general menu and
select one of the following functions:
- "Navigation - Guidance",
- "Audio functions",
- "Trip computer",
- "Personalisation-Coniguration",
- "Directory",
- "Telematics",
- "Map",
- "Video". "Personalisation-Coniguration"
menu
This provides access to successive
conirmation windows.

38 -Multifunction displays
01-06-2005
39
-Multifunction displays
01-06-2005
Coniguration of the display
- "Selection of the colours": selec-
tion of the colours available for the
display.
- "Brightness and brilliance".
- "Sound": selection of the sound ambience, setting of the voice
synthesiser and of the voice com-
mands.
- "International parameters": • setting of the date and time,
• selection of the units: tempera- ture (°C or °F) and fuel con-
sumption (l/100, mpg or km/l).
- "Selection of the language": German, Spanish, French, English, Italian,
Dutch, Portuguese and Brazilian
Portuguese.
"Video" menu
Deining the vehicle parameters
This enables you to activate or de-
activate certain driving and comfort
elements:
- "Automatic switching on of the
lights",
- "Follow-me-home lighting" and "Duration",
- "Remote control action",
- "Permanent locking of the boot".
You can connect video equipment
(camcorder, digital camera, DVD
player, ...) to the three video sockets
located in the glove box.
Video display is only possible
when stationary.
Select the "Video" menu from the
general menu :
- "Activate video mode" to activate/ deactivate the video,
- "Video parameters" to set the display format, the brightness, the
contrast and the colours.
Pressing the "DARK" button discon-
nects the video display.
Successive presses of the
"SOURCE" button permit the selec-
tion of an audio source other than
that of the video.
For safety reasons, con-
iguration of the multifunc-
tion displays by the driver
must be carried out while
stationary.
Example: "Automatic switching on of
the lights"

40 -Comfort
01-06-2005
41
-Comfort
01-06-2005