heating PEUGEOT 607 2007.5 Owners Manual

1
22
Seat belt not fastened/
unfastened warning light
With the vehicle stationary,
when the ignition is switched
on, the warning light comes
on if the driver and/or the front
passenger has not fastened his seat belt.
From approximately 12 mph (20 km/h)
and for two minutes, the warning light
l ashes accompanied by an increas-
ingly loud audible signal. Once these
two minutes have elapsed, the warn-
ing light remains on until the driver or
front passenger fastens his seat belt.
When the vehicle is moving, the warn-
ing light comes on if the driver or one
of the front or rear passengers unfas-
tens his seat belt.
Diesel engine pre-heating
warning light
If the temperature is sufi -
cient, the warning light does
not come on and you can
start without waiting.
If the warning light comes on, wait
until it goes out before operating the
starter.
If no malfunction has been
detected: the CHECK OK
indicator light comes on af-
ter two seconds (following a
black screen), in the absence
of indicator lights showing the status
of vehicle functions. If these indicator
lights are present, the CHECK OK in-
dicator light will come on after these.

You may start your vehicle.

If a "minor" malfunction has been
detected: the warning light for the
faulty function comes on. Certain in-
dicator lights showing the status of
vehicle functions may also come on,
followed by the CHECK OK indicator
light.

You can start your vehicle; however,
contact a PEUGEOT dealer as soon
as possible.

If a "major" malfunction has been
detected: the corresponding warning
light comes on. Certain indicator lights
showing the status of vehicle functions
may also come on. The CHECK OK
indicator light does not come on.

Do not start your vehicle.
Contact a PEUGEOT dealer. Following this, the following
information appears on the
instrument panel display:
The engine oil level appears for ap-
proximately 7 seconds; at the same
time, the service indicator appears on
the display located in the speedometer
dial for approximately 7 seconds.
Then, the status of the tyre pressures is
indicated for approximately 5 seconds.
With the ignition on, the vehicle
carries out an automatic
test which appears on the
instrument panel display: