check engine PEUGEOT 607 2007 User Guide

Page 119 of 187

9CHECKS
102
CHECKS Handbrake
Where the handbrake travel is
too great or there is a reduc-
tion in the performance of the system,
the handbrake should be adjusted.
Have the system checked by a PEUGEOT
dealer.
Only use products recom-
mended by PEUGEOT or
products of equivalent quality
and specii cation.
To ensure best performance
from components as important as the
power steering and the braking sys-
tem, PEUGEOT selects and offers
specii c products.
To prevent damage to the electrical
units, high pressure washing of the
engine compartment is strictly prohibited .

In order to check the main levels
and certain components, in ac-
cordance with the manufacturer’s
servicing schedule, refer to the
pages of the servicing booklet
which correspond to your vehi-
cle’s engine.
Battery
At the start of winter, have
your battery checked by a
PEUGEOT dealer.
Air filter and passenger
compartment filter
Have the i lter elements re-
placed regularly. If you drive
in dusty conditions, change them
twice as often .
Particulate emission filter -
Additive reservoir (Diesel)
Maintenance of the particulate emis-
sion i lter and i lling of the additive
reservoir must be carried out by a
PEUGEOT dealer, according to the
manufacturer’s servicing schedule.
Brake pads
Brake pad wear depends on
the style of driving, in particu-
lar for vehicles which are used in town,
over short distances. Manual gearbox
This does not need an oil change.
Have the level checked, according to
the manufacturer’s servicing schedule.
Automatic gearbox
This does not need an oil change.
Have the level checked by a PEUGEOT
dealer, according to the manufactur-
er’s servicing schedule.
Oil filter
Change the i lter regularly, in accord-
ance with the servicing schedule.
It may be necessary to check
the thickness of the pads,
even between services. Disc wear condition
For any information relating to check-
ing of the disc wear condition, contact
a PEUGEOT dealer.

Page 175 of 187

165
QUESTIONSOLUTION
RESPONSE
The stored stations do
not function (no sound,
87.5 Mhz is displayed...) An incorrect waveband is selected.
Press the BAND AST button to return to the
waveband (AM, FM1, FM2, FMAST) on which the
stations are stored.
The trafic announcement
(TA) is displayed. I do
not receive any trafic
information. Tune to a radio station which broadcasts trafic
information.
The radio station is not part of the regional trafi
c information network.
The quality of reception
of the radio station
listened to gradually
deteriorates or the
stored stations do
not function (no
sound, 87.5 Mhz is
displayed...). The vehicle is too far from the transmitter used by
the station listened to or
there is no transmitter in the geographical area th rough which the vehicle
is travelling.
The environment (hills, buildings, tunnels, basemen t car parks...) block
reception, including in RDS mode.
The aerial is absent or has been damaged (for examp le when going
through a car wash or into an underground car park) .Activate the RDS function to enable the system
to check whether there is a more powerful
transmitter in the geographical area.
This phenomenon is normal and does not
indicate a failure of the audio equipment.
Have the aerial checked by a PEUGEOT dealer.
Sound cut-outs of 1
to 2 seconds in radio
mode. During this brief sound cut-out, the RDS searches f
or any frequency
permitting better reception of the station. Deactivate the RDS function if the phenomenon
is too frequent and always on the same route.
With the engine off,
the audio equipment
switches off after a few
minutes of use. When the engine is switched off, the audio equipmen
t operating time
depends on the battery charge.
The switch-off is normal: the audio equipment switc hes to economy mode
and switches off to prevent discharging of the vehi cle’s battery.Start the vehicle’s engine to increase the battery
charge.
The message "the audio
system is overheated"
appears on the display. Switch the audio system off for a few minutes to
allow the system to cool.
In order to protect the installation if the surroun
ding temperature is too
high, the audio equipment switches to an automatic thermal protection
mode leading to a reduction of the volume or stoppi ng of the playing of the
CD.

Page:   < prev 1-10 11-20