ignition PEUGEOT 607 2007 Owners Manual

FAMILIARISATION

8.
Fascia fuse box.

9. Manual headlamp adjustment.
Deactivation of the interior alarm.
Deactivation of the ESP/ASR system.

10.
Adjustable and closing side vent.

11. Driver's side window de-icing and
demisting vent.

12.
Driver's seat electric controls.

13.
Driver's heated seat control.

14.
Bonnet release.

15.
Deactivation of the parking
assistance.
SPORT suspension control.
Sunroof control.
Rear blind control.

16.
Armrest with storage compartment.

17.
Rear ashtray.

18.
Rear lighter (100 W max.).

19.
Rear heated seat controls.

1.
Audio equipment steering wheel
control.

2. Steering lock and ignition.

3. Wipers/wash-wipe and trip
computer controls.

4. Instrument panel.
5. Driver's air bag.
Horn.

6.
Gear lever.

7.
Driver's footwell air outlet.

FAMILIARISATION
The position is indicated on the instrument
panel by the corresponding indicator light.
Ring A Lights off
Side lights
Dipped headlamps/Main
beam headlamps Ring B
Front fog lamps
Front fog lamps and rear
fog lamps
2. Fast wipe.

1. Normal wipe.

I. Intermittent wipe.

0. Park.

AUTO. Automatic wipe or single wipe.

A. Wash-wipe.

The windscreen wiping must be
reactivated if the ignition has been
switched off for more than one minute.
Lights
Wipers

 72
 73
Your vehicle is i tted with a parking lights, automatic fol
low-me-home
lighting and automatic switching on of the lights system.
To activate or deactivate these functions, refer to the correspo nding
sections.
If your lights are switched on manually, return the ring to position 0 , lights off.

 71

1
21
OPERATION WARNING LIGHTS
Anti-lock braking system
(ABS) warning light
This should go out after a
few seconds.
If the warning light remains on
or comes on above 8 mph (12 km/h),
accompanied by an audible signal and
a message on the multifunction display,
this indicates a malfunction of the ABS.
However, the vehicle retains conven-
tional servo-assisted braking.
It is linked with the corresponding
warning light on the instrument panel
display.
Contact a PEUGEOT dealer.
Emission control system
warning light
This should go out a few sec-
onds after the engine starts.
With the engine running, if
the warning light l ashes or comes on
permanently, this indicates a malfunc-
tion of the emission control system.
Contact a PEUGEOT dealer as soon
as possible. Passenger air bag
disarmed warning light *
This should go out after a
few seconds.
The lighting of this warning light is ac-
companied by a message on the mul-
tifunction display.
If the passenger air bag is disarmed,
the warning light comes on when the
ignition is switched on and remains on
throughout the duration of disarming.
In all cases, if the warning light l ash-
es, contact a PEUGEOT dealer.

Low fuel level
warning light
This should go out af-
ter a few seconds.
The lighting of this
warning light is accompanied by an
audible signal and a message on the
multifunction display.
It is linked with the corresponding
warning light on the instrument panel
display.
When the warning light comes on, you
have enough fuel left to drive approxi-
mately 30 miles (50 km) (the capacity of
the fuel tank is approximately 80 litres).
Handbrake, low brake
l uid level and electronic
brake force distribution
warning light
This light should go out after
a few seconds.
If the warning light remains on, or if it
comes on when the engine is running,
it indicates:
- an excessive drop in the brake l u- id level, if linked with the low brake
l uid level warning light on the in-
strument panel display,
- a malfunction of the electronic brake force distribution, if linked
with the STOP warning light on the
instrument panel display,
- an applied or incorrectly released handbrake, when the vehicle is
moving, if linked with the hand-
brake warning light on the instru-
ment panel display.

In the i rst two cases, stop immedi-
ately. Contact a PEUGEOT dealer.
* According to country.
With the ignition on, initially, the
following warning lights illuminate
on the instrument panel:

1
22
Seat belt not fastened/
unfastened warning light
With the vehicle stationary,
when the ignition is switched
on, the warning light comes
on if the driver and/or the front
passenger has not fastened his seat belt.
From approximately 12 mph (20 km/h)
and for two minutes, the warning light
l ashes accompanied by an increas-
ingly loud audible signal. Once these
two minutes have elapsed, the warn-
ing light remains on until the driver or
front passenger fastens his seat belt.
When the vehicle is moving, the warn-
ing light comes on if the driver or one
of the front or rear passengers unfas-
tens his seat belt.
Diesel engine pre-heating
warning light
If the temperature is sufi -
cient, the warning light does
not come on and you can
start without waiting.
If the warning light comes on, wait
until it goes out before operating the
starter.
If no malfunction has been
detected: the CHECK OK
indicator light comes on af-
ter two seconds (following a
black screen), in the absence
of indicator lights showing the status
of vehicle functions. If these indicator
lights are present, the CHECK OK in-
dicator light will come on after these.

You may start your vehicle.

If a "minor" malfunction has been
detected: the warning light for the
faulty function comes on. Certain in-
dicator lights showing the status of
vehicle functions may also come on,
followed by the CHECK OK indicator
light.

You can start your vehicle; however,
contact a PEUGEOT dealer as soon
as possible.

If a "major" malfunction has been
detected: the corresponding warning
light comes on. Certain indicator lights
showing the status of vehicle functions
may also come on. The CHECK OK
indicator light does not come on.

Do not start your vehicle.
Contact a PEUGEOT dealer. Following this, the following
information appears on the
instrument panel display:
The engine oil level appears for ap-
proximately 7 seconds; at the same
time, the service indicator appears on
the display located in the speedometer
dial for approximately 7 seconds.
Then, the status of the tyre pressures is
indicated for approximately 5 seconds.
With the ignition on, the vehicle
carries out an automatic
test which appears on the
instrument panel display:

1
32
INSTRUMENT PANEL DISPLAY SERVICE INDICATOR
This is a visual reminder of when the
next service is due. This service is to
be carried out according to the manu-
facturer's servicing schedule.
The point at which the service is due is
calculated from the last indicator zero re-
set. It is determined by two parameters:
- the distance travelled,
- the time elapsed since the last service.

Note: the distance remaining before
the next service is due may be weight-
ed by the time factor.
The service information appears on
the display, located in the speedo-me-
ter dial, at the same time as the en-
gine oil level on the instrument panel
display. Operation
As soon as the ignition is switched on
and for 7 seconds, the spanner sym-
bolising the servicing operations is lit.
The trip recorder display shows the
distance remaining (in round i gures)
before the next service.

Example: 4,800 miles/km remain be-
fore the next service is due. When the
ignition comes on and for 7 seconds
the display indicates:
7 seconds after the ignition is switched
on, the total distance recorder resumes
normal operation and the display
shows the total and trip distances.
After switching on the ignition, two
functions are shown in succession:
- service indicator,
- total distance recorder (total and
trip distances).

Note: the total and trip distances are
displayed for 30 seconds when the
ignition is switched off, on opening the
driver’s door, as well as on locking and
unlocking the vehicle.

1
32
INSTRUMENT PANEL DISPLAY SERVICE INDICATOR
This is a visual reminder of when the
next service is due. This service is to
be carried out according to the manu-
facturer's servicing schedule.
The point at which the service is due is
calculated from the last indicator zero re-
set. It is determined by two parameters:
- the distance travelled,
- the time elapsed since the last service.

Note: the distance remaining before
the next service is due may be weight-
ed by the time factor.
The service information appears on
the display, located in the speedo-me-
ter dial, at the same time as the en-
gine oil level on the instrument panel
display. Operation
As soon as the ignition is switched on
and for 7 seconds, the spanner sym-
bolising the servicing operations is lit.
The trip recorder display shows the
distance remaining (in round i gures)
before the next service.

Example: 4,800 miles/km remain be-
fore the next service is due. When the
ignition comes on and for 7 seconds
the display indicates:
7 seconds after the ignition is switched
on, the total distance recorder resumes
normal operation and the display
shows the total and trip distances.
After switching on the ignition, two
functions are shown in succession:
- service indicator,
- total distance recorder (total and
trip distances).

Note: the total and trip distances are
displayed for 30 seconds when the
ignition is switched off, on opening the
driver’s door, as well as on locking and
unlocking the vehicle.

3COMFORT
FRONT SEATS
B - Seat cushion angle adjustment C - Seat height adjustment
A - Forwards-backwards
adjustment
Push the control forwards or back-
wards to slide the seat. Tilt the front of the control upwards
or downwards to obtain the required
angle. Tilt the rear part of the control upwards
or downwards to obtain the required
height.
Electric front seats
The electric functions of the
driver’s seat are deactivated
one minute after the ignition is
switched off.
The operation of the electric
seats will be deactivated tem-
porarily if the energy economy
mode is activated.

3COMFORT
52
Memorising driving and mirror
positions
Memorising using the controls on
the driver’s door
To memorise:

 Place the key in the ignition on po-
sition,

 Adjust your seat and mirrors,

 Press button M , then button 1 "i rst
driving position" or button 2 "sec-
ond driving position" within four
seconds.
An audible signal coni rms that a posi-
tion has been memorised.
Memorising a new position cancels
the previous one. Recalling a memorised driving
position
Ignition on, vehicle stationary

 Briel y press button 1 or 2 to recall
the corresponding memorised
position. The end of the setting is
indicated by a bleep.
After recalling a memorised position
a few times in succession, the func-
tion will be cancelled until the engine
is started.
G - Heated seats adjustment
With the engine running, use the cor-
responding adjustment dial to select
the required degree of heating:
0:
Off.
1: Low.

2: Medium.
3: High. The electrical adjustments of the seat
and exterior mirrors are memorised.
Two driving positions can be memo-
rised using buttons
M/1 and M/2 . Vehicle moving

 Keep button 1 or 2 pressed down
until the bleep indicates that setting
of the corresponding memorised
position is complete.

3COMFORT
52
Memorising driving and mirror
positions
Memorising using the controls on
the driver’s door
To memorise:

 Place the key in the ignition on po-
sition,

 Adjust your seat and mirrors,

 Press button M , then button 1 "i rst
driving position" or button 2 "sec-
ond driving position" within four
seconds.
An audible signal coni rms that a posi-
tion has been memorised.
Memorising a new position cancels
the previous one. Recalling a memorised driving
position
Ignition on, vehicle stationary

 Briel y press button 1 or 2 to recall
the corresponding memorised
position. The end of the setting is
indicated by a bleep.
After recalling a memorised position
a few times in succession, the func-
tion will be cancelled until the engine
is started.
G - Heated seats adjustment
With the engine running, use the cor-
responding adjustment dial to select
the required degree of heating:
0:
Off.
1: Low.

2: Medium.
3: High. The electrical adjustments of the seat
and exterior mirrors are memorised.
Two driving positions can be memo-
rised using buttons
M/1 and M/2 . Vehicle moving

 Keep button 1 or 2 pressed down
until the bleep indicates that setting
of the corresponding memorised
position is complete.

3COMFORT
53
REAR SEATS
Folding down the seat back Rear heated seats controls
The seat back in the rear is folded
down in two 1/3-2/3 parts.
Before folding down the seat back:

 check that the seat belt strap on
the side of the seat back (1/3 or
2/3) is positioned correctly,

 release the lap belt strap by press-
ing the black button of the lock
(2/3).
 Press the switch. The temperature
is regulated automatically.

 Press it again to stop operation.

Note: the command to activate heating
of the seat(s) remains in the memory
for one minute after the ignition is
switched off.
The unlocking controls are located in
the boot.
To unlock from the boot:

 pull the control A corresponding to
the part of the seat back that you
wish to fold down.
To unlock from inside the vehicle:

 lower the armrest and open the ski
l ap,

 pull the button B located on the un-
locking housing corresponding to
the part of the seat back that you
wish to fold down.
Rear seat
When returning the seat back
to its original position, en-
sure that the seat belt is not
trapped. When putting the seat back to
its original position, for your
safety make sure that it is cor-
rectly locked.