light PEUGEOT 807 2002.5 User Guide

1 Rev counter.
2 Speedometer.
3 Fuel gauge.
4 Coolant temperature indicator.
5 Maximum coolant temperature
warning.
6 Low fuel level warning light.
7 Monochrome or colour screen.
INSTRUMENTS AND CONTROLS 27
Instrument panel with colour screen
PETROLDIESEL INSTRUMENT PANELS
Instrument panel with monochrome screen
18-11-2002

INSTRUMENTS AND CONTROLS
28
INSTRUMENTS AND CONTROLS
A warning light continuously lit, or flashing with the eng ine running, is an indication of a malfunction in the
relevant unit. Some warning lights may be linked to buzzer s and a message on the multi–function display. Do not
ignore this warning: contact a PEUGEOT dealer as quickly a s possible.
If the central STOP warning light comes on when you are d riving, stop immediately where it is safe to do so.
Central STOP warning light
This is linked to the "engine oil pressure", "coolant level low " and "brake fluid level" warning lights and the coolant
temperature gauge and puncture warnings, indicated by a message on the multifunction display.
It comes on each time the ignition is switched on.
Stop immediately .
Contact a PEUGEOT dealer.
Engine oil pressure warning light
This is linked to the central STOPwarning light.
If it comes on with the engine running, it is accompanied b y an audible signal and the message "Oil pressure low"
or "Top up engine oil" on the multifunction display.
Stop immediately .
In the case of a lack of oil in the lubricating circuit, top up the level.
Contact a PEUGEOT dealer without delay.
Low coolant level warning light
This is linked to the central STOPwarning light.
It comes on each time the ignition is switched on.
Illumination of this warning light, with the engine run ning, is accompanied by an audible signal and the message
"Top up coolant" on the multifunction display.
Stop immediately.
Warning: allow the engine to cool before topping up.
The cooling system is pressurised.
To prevent the risk of scalding, unscrew the cap by two turns to allow the pressure to drop.
Once the pressure has dropped, remove the cap and topup the le vel.
Contact a PEUGEOT dealer.
18-11-2002

Handbrake,low brake fluid level and electronic brake force distri bution warning light
This is linked to the central STOPwarning light.
It comes on each time the ignition is switched on.
This warning light is accompanied by an audible signal and a message on the multifunction display indicating the
cause of the warning:
– "Handbrake on" , if the handbrake is on or not released correctly while driving ,
– "Brake fluid low" in the event of an excessive drop in the brake fluid level (if the warning light remains lit even with the
handbrake released),
– "Braking fault" , displayed at the same time as the ABS warning light, indicat ing an electronic brake force distribution
system fault.
Stop immediately.
Contact a PEUGEOT dealer.
INSTRUMENTS AND CONTROLS 29
Dynamic stability control warning light (ESP/ASR)
This comes on each time the ignition is switched on.
If it remains on or comes on with the engine running and th e vehicle moving, it is accompanied by an audible
signal and the message "ESP/ASR not operational" on the multifunction display.
Contact a PEUGEOT dealer.
It flashes when the system is activated and is lit continuously when the system is switched off.
Antilock braking system (ABS) warning light
This comes on each time the ignition is switched on.
If it remains on or comes on above 8 mph (12 km/h), it indicates a
malfunction of the ABS.
However, the vehicle retains conventional servoassisted braking.
Illumination of this warning light is accompanied by an aud ible signal and the message "ABS fault" on the multifunction
display.
Contact a PEUGEOT dealer.
18-11-2002

INSTRUMENTS AND CONTROLS
30
Cruise control indicator light
This indicator light comes on when the function is activated.
Battery charge warning light
This comes on each time the ignition is switched on.
If it comes on with the engine running, it is accompanied b y an audible signal and the message "Low battery
charge" on the multifunction display.
It indicates faulty operation of the charging circuit (loose b attery terminals, a cut or slack alternator belt, an alternator f ault).
Contact a PEUGEOT dealer.
Engine diagnostics warning light
This comes on each time the ignition is switched on.
If it comes on with the engine running, accompanied by an a udible signal and the message "Emission control
system problem" on the multifunction display, it indicates a malfunction in the emission control sy stem.
If it flashes with the engine running, accompanied by an a udible signal and the message "Catalytic converter faulty"on
the multifunction display, it indicates a malfunction in th e injection or ignition sy stem. There is a risk of damage to t he
catalytic converter (petrol engines only).
Contact a PEUGEOT dealer without delay.
Note: following prolonged operation of the vehicle at very low sp eed or at idle, you may, in exceptional circumstances, notice
emissions of water vapour at the exhaust on acceleration. This d oes not have any effect on the vehicle's performance or on
the environment.
Diesel preheat indicator light
This comes on each time the ignition is switched on.
In cold weather, wait until it goes out before trying th e starter.
18-11-2002

INSTRUMENTS AND CONTROLS31
Passenger air bag disarming indicator light
This comes on for a few seconds each time the ignition is switch ed on.
Illumination of this indicator light is accompanied by an au dible signal and the message"Passenger air bag
disarmed" on the multifunction display.
If the passenger air bag is disarmed, the indicator light comes on when the ignition is switched on and remains on.
In all cases, if the indicator light flashes, contact a PEUGEOT dealer.
Front, side and curtain air bags warning light
This warning light comes on when the ignition is switched o n.
Illumination of this warning light, with the engine run ning, is accompanied by an audible signal and the message
"Air bag fault" on the multifunction display, indicating a front, side or cu rtain air bag fault.
Contact a PEUGEOT dealer.
Driver's seat belt warning light
With the engine running, this indicator light comes on, acco mpanied by an audible signal at a speed above 6 mph
(10 km/h) and the message "Seat belt not fastened" on the multifunction display, if the driver's seat belt is no t
fastened.
Low fuel level warning light
This light comes on each time the ignition is switched on.
When the warning light comes on, accompanied by the message "Fuel level low"on the multifunction display,
there is enough fuel remaining to drive approximately 30 miles (50 km). The tank capacity is approximately 80 litres.
This light flashes to indicate a malfunction of the fuel gauge or cuttingoff of the fuel supply, if it is accompanie d by the
message "Fuel circuit neutralised" on the multifunction display.
Restore the supply (refer to the "Practical Information § Fuel Su pply CutOff" section) or contact a PEUGEOT dealer,
depending on the circumstances.
Note: some functions can be configured by your PEUGEOT dealer.
18-11-2002

INSTRUMENTS AND CONTROLS
32
In zoneA,the temperature is correct.
In zone B, the temperature is too high. The central STOPwarning light and the
maximum coolant temperature warning light 1come on, accompanied by an
audible signal and the message "Coolant temp. too high"on the multifunction
display.
You must stop immediately.
Warning : wait for the engine to cool before topping up the le vel.
The cooling system is pressurised.
In the event of a breakdown and in order to avoid any risk of scalding, unscrew
the cap two turns to allow the pressure to drop.
When the pressure has dropped, remove the cap and top up the level.
Contact a PEUGEOT dealer.
Instrument panel with
monochrome screen
Instrument panel with colour
screen
Coolant temperature indicator light
18-11-2002

INSTRUMENTS AND CONTROLS33
"SNOW" indicator light
This comes on when the automatic gearbox "SNOW"operating programme is selected.
"Park"
"Reverse"
"Neutral"
"Drive"
"Manual" mode:
1st gear engaged
2nd gear engaged
3rd gear engaged
4th gear engaged
Automatic gearbox indicator
Automatic gearbox lever positions:
Automatic gearbox indicator light:
18-11-2002

Maximum
Minimum
Check the level with
the dipstick and top it
up.
The figure shown is
only correct if the vehicle has been
on stable, level ground, with the
engine stopped, for 10 minutes.
No oil
The message "Top
up the oil" appears
on the multifunction
display, accompa
nied by an audible signal.
It is essential to top up the oil to the
correct level, otherwise the engine
may be damaged.
Oil gauge fault
Flashing of the seg
ments indicates a
fault.
Check the level
using the dipstick.
Consult a PEUGEOT dealer. Control module display
After switching on the ignition, three
functions are shown in succession:
– service indicator (see correspond ing section),
– engine oil level indicator,
– total distance recorder (total and trip distances).
Note: the total and trip distances are
displayed for thirty seconds, when
the ignition is switched off, on open
ing the driver's door as well as on
locking and unlocking the vehicle.
It also displays the automatic gear
box positions and programmes
selected (see corresponding sec
tion).
Engine oil level
When the ignition is switched on, the
engine oil level is indicated for
approximately 10 seconds, after the
service information. Lighting rheostat
With the lights on,
press the button to
vary the intensity of
the lighting of the
control module, the
instrument panel, the
air conditioning dis
play and the multi–function display.
When the lighting reaches the mini
mum (or maximum) setting, release
it then press again to increase (or
reduce) the brightness.
As soon as the lighting is of the
brightness required, release the
button.
Trip recorder
zero reset
With the ignition on,
press the button.
INSTRUMENTS AND CONTROLS
34
18-11-2002

YOUR 807 IN DETAIL
64
TELEPHONE MODE
This function is a GSM dualband telephone (800 and 1 800 MHz) incorporated in the RT3 audio system.
It is a ''hands free'' telephone. This function is provided by a microphone located next to the front courtesy light, the
speakers and a steering column control which allows access to most of the functions (because the audio/telephone control
panel buttons allow access to all the functions).
Display of the principal ''mobile'' type functions, as well as consultation of the indexes, is pro vided by the multi–function
display.
This function is active whatever position the ignition key is in.
Note: when the key is in the accessories position (1st notch), this funct ion will be interrupted after thirty minutes, when the
message ''Economy mode active'' appears on the multi–function display. If you are using the telephone at that time, you
will be able to finish your call.
Using the menus
Press the ''MENU'' button to display the general menu. Select thetelematicsapplication, validiate Telephone functions
to access the principal telephone functions, then the various menus, in order to reach the one required.
This menu allows you to access the following functions:
Network: allows you to select the network search mode and to see the ne tworks
available.
Duration of calls: allows you to consult the duration recorder of calls made and ze ro
reset.
SIM card security: allows you to use or modify the PIN code and to erase the list of
calls and minimessages (SMS).
Telephone options: allows you to configure the calls with entering of my number,
automatic answering after X rings and specification of ring opt ions.
Within each menu:
Move around and select a function by turning knob Gthen validate by pressing the knob.
Cancel an operation by means of the ''ESC''button.
18-11-2002

YOUR 807 IN DETAIL
70
Services* Press button Eto display the "Services"menu and select one of the following services:
• "Customer Contact Centre" which enables you to contact the PEUGEOT Customer Contact Centre direct
ly and access the services offered (this type of call is suspended if an energency or breakown call is made).
• "Peugeot Assistance" which enables you to contact the call centre which controls the PEUGEOT breakdown
service directly and receive rapid assistance (you have 6 seconds within which to cancel the call when it is
made). During the breakdown call phase it is not possible to make any other calls with the exception of
emergency calls.
• "Operator services" which gives access to the list of services specific to the operator (e .g.: customer service,
consumption monitoring, news, stock market, weather, travel, games, etc) if they are available.
Note: during connection to a service, it is not possible to receive cal ls or SMS mini messages; they will be diverted to your
voice message service. Contrarily, it is possible to send a call wh ich results in automatic disconnection.
Emergency call*
In an emergency, press button Vuntil a signal is heard and a call validation / deletion screen is displayed (delay
of 6 seconds) or enter 11 2directly.
Note: in this case, a green diode flashes on the RT3 audio/tele phone panel when the emergency call procedure begins, then
lights permanently when the call is taken by the emergency services.
In the absence of a specific service contract, the parameters of th e SOS button are set so that a call is made to 11 2 unique
number made available by the worldwide GSM network, reserved for e mergency calls.
Before making a call of this kind, the audio/telephone must detect a cellular network. No security mode is required and,
depending on the network, you do not need to insert your SI M card or enter your PIN.
If you have signed the specific contract, refer to its general co nditions.
* If option and service available.
18-11-2002