PEUGEOT 807 2004 Manual PDF

74
26-04-2004
75
26-04-2004
YOUR 807 IN DETAIL
To remove it, set it in the high posi-
tion, lift the tab using a coin and pull
upwards and forwards at the same
time.
To re-install, engage the head re-
straint rods in the holes, making sure
they are aligned with the seat back.6 - Rotating of seats
Place the seat back in the upright
position.
Place the seat in the highest interme-
diate longitudinal position.
On the driver's side, push the steering
wheel, apply the handbrake, then re-
lease, pulling on the end.
Pull the control upwards and rotate
the seat inwards.
Never drive with the head
restraints removed; they
must be in place and cor-
rectly adjusted. This pivoting operation
must be carried out with
the engine switched off.
The passenger must not be facing
the rear when the vehicle is being
driven.

76
26-04-2004
77
26-04-2004
YOUR 807 IN DETAILFront seats with electrical
adjustment
A - Forwards-backwards adjustment
Push the control forwards or back-
wards to slide the seat.
B - Driver's seat height adjustment
Push the rear part of the control up-
wards or downwards to obtain the
required height.
C - Seat back angle adjustment
Tilt the control to the front or the rear
to obtain the correct angle.
Note: the electrical functions of the
seats are cancelled one minute after
the ignition has been switched off.
D - Driver's seat lumbar adjustment (mechanical)
Raise or lower the lever to obtain the
correct position.

76
26-04-2004
77
26-04-2004
YOUR 807 IN DETAIL
The setting is correct when
the upper edge of the head
restraint is level with the top of
the head.
To remove the head restraint, place it
in the high position, lift the tab using
a coin and pull upwards and forwards
at the same time.
To re-install, engage the head re-
straint rods in the holes, making sure
they are aligned with the seat back.Never drive with the head
restraints removed; they
must be in place and cor-
rectly adjusted. This pivoting operation
must be carried out with
the engine switched off.
The passenger must not be
facing the rear when the vehicle is
being driven.
F - Rotating of seats (mechanical)
Place the seat back in the upright
position.
Place the seat in the highest interme-
diate longitudinal position.
On the driver's side, push the steer-
ing wheel, apply the handbrake, then
release, pulling on the end.
Pull the control upwards and rotate
the seat inwards.
E - Head restraint height and
angle adjustment
To raise or lower the head restraint,
pull it forwards, then slide it.

78
26-04-2004
79
26-04-2004
Memorising seat and mirror
positions
Four driving positions can be memo-
rised:
- two, using two remote control
keys (two users) ,
- two, using buttons M/1 and M/2 .
Driving positions memorised by
the remote control key
When locking the doors, the remote
control key memorises the position of
the driver's seat and exterior mirrors.
When unlocking the doors, the driv-
er's seat and the exterior mirrors
resume the position memorised by
the remote control key if this has
changed in the meantime.
Each remote control key can
memorise a speciic setting.
YOUR 807 IN DETAIL
Memorising using the buttons
M, 1 and 2
To memorise using the buttons
located on the side of the seat:
F Place the ignition key in the 'running'
position (2nd notch),
F Adjust your seat and mirrors,
F Press button M, then button 1 (irst
driving position) or button 2 (sec-
ond driving position) within four
seconds.
An audible signal conirms that a posi-
tion has been memorised.
Memorising a new position cancels
the previous one.
Recalling a memorised position
Engine off F Briely press button 1 or 2 to re-
call the corresponding memorised
position.
Note: after recalling a memorised
position ive times in succession, the
function will be cancelled until the
engine is started.
Engine running F Keep button 1 or 2 pressed down
until the end of setting of the cor-
responding memorised position. Front heated seat controls
The front seats can be heated sepa-
rately.
Use the adjustment controls located
on the side of each seat to select the
level of heating required:
0:
Off.
1: Low.
2: Medium.
3: High.
The seat temperature is controlled
automatically.
Note: the heated seats only operate
with the engine running.

78
26-04-2004
79
26-04-2004
YOUR 807 IN DETAIL
FRONT SEAT LAYOUT
1 - Storage drawers
There is a storage drawer under
each front seat.
- To open it, lift and pull.
- To take it out, open it to its full extent, lift the two tabs on either
side of the drawer, then remove it
completely.
Note: under the front seat on the
passenger side, if the vehicle has an
ampliier, the storage drawer will be
locked. 2 - Elastic retaining straps
There is an elastic retaining strap on
each front seat, on the centre side.
- In the side position (elastic strap
on its own seat), this can be used
as a magazine holder.
- In the transverse position (elastic straps A hooked between the two
seats), they can hold a bag.
3 - 'Aircraft' type table
You have an 'aircraft' type table,
equipped with a can holder, itted to
the rear of each front seat.
Do not forget to fold this before
pivoting the seat.
Note: each front seat also has a stor-
age pocket on the seat back. 4 - 12 V socket
You have a 12 V accessory socket at
the foot of the driver's seat, which is
accessible to passengers in the 2nd
row.
5 - Front and rear armrests
To place the armrest in its rest
position: -
Lift the armrest until it is aligned
with the seat back.
To place the armrest in the
position in which it is used: - Push it towards the rear.
- Fold it down completely.
- Raise it slowly to the required position.
- If you lift it past the required posi- tion, restart the above operations.
To remove it occasionally:
- Lift the armrest, going past the idle position.
- Press its securing pin irmly and tilt it fully.
- Pull towards you to remove it from its ixing.
To put it back in place:
- Place it in its removal position.
- Push as far as the ixing allows.

80
26-04-2004
81
26-04-2004
THE REAR SEATS
Forwards/backwards adjustment
Lift bar A and slide the seat towards
the front or the rear.
From the third row you can pull on
strap B and slide the seat towards
the front.
This makes it easier for passengers
to exit the 3rd row of seats, when
folding down the second row seat.
Adjusting the angle of the seat
back
Push lever C upwards and adjust the
angle as required.
Release the lever to lock.
YOUR 807 IN DETAIL
Folding a side seat
Access to the third row:
Place the head restraint in the low
position.
Push control C upwards as far as
possible.
Tilt the seat back towards the front
until the rear anchorages are un-
locked.
Fold the seat back onto the seat
cushion.
Place the seat in the closed position.
Exiting the third row:
Place the head restraint in the low
position.
Push control D upwards as far as
possible.
Tilt the seat back towards the front
until the rear anchorages are un-
locked.
Fold the seat back onto the seat
cushion.
Place the seat in the closed position. Table position of a side seat
Fold the corresponding seat.
Tilt the folded seat rearwards, until
the rear anchorages lock.
You now have a shelf with two cup
holders.
Folding a side seat from the table
position
Lift the seat back.
Fold as described opposite.

80
26-04-2004
81
26-04-2004
Table position of the centre seat
Place the head restraint in the low
position.
Push control E upwards.
Tilt the seat back forwards.
You now have a table with two cup
holders.
Folding the centre seat
Place the seat in the table position.
Lift control F.
Place the seat in the closed position. Removing a seat
Fold the corresponding seat.
Grasp the two bars
G under the seat
and tighten them securely.
The front anchorages unlock.
Lift the seat and carry it using the
carrying handle H.
Reitting a seat
Check that there is no obstacle
obstructing the slides or prevent-
ing correct locking of the seat.
Locate the front anchorages in the
slides (if necessary tighten the two
bars G securely).
Tilt the folded seat towards the rear.
The rear anchorages lock.
Lift the seat back (for the centre seat,
move control E).
YOUR 807 IN DETAIL
This turning operation
must be carried out with
the engine switched off.
It is prohibited to sit facing
the rear when the vehicle
is being driven.
Never use the adjusting straps to
remove, reit or transport a seat.
When the vehicle is being driven,
it is prohibited to place a side seat
in the closed position, when a pas-
senger is sitting in the 3rd row.
Turning a seat round
The rear seats can be placed in the
'rearwards facing' position.
For this, after the seat has been
folded, carry out the removal and
replacing operations for the seat and
turn it round.

82
26-04-2004
83
26-04-2004
YOUR 807 IN DETAIL
THE REAR SEAT
Forwards/backwards adjustment
Lift bar A and slide the seat towards
the front or the rear.
Note:
to make it easier to load the
vehicle through the tailgate, you can
pull on strap B and slide the seat
forwards. Rear parcel shelf position
Place the head restraints in the low
position.
Pull the strap
C upwards, from the
tailgate.
Tilt the seat back on the seat cushion. Removing the seat
Fold down the seat.
Grasp the two bars
E underneath
the seat.
The front anchorages unlock.
Note: for removal and reitting, pass
the rear seat, in the "folded" position,
through the sliding side doors.
Reitting the seat
Check that there is nothing block-
ing the runners which could pre-
vent corrrect locking of the seat
anchorages.
Position the front anchorages at the
front stop of the runners.
Tilt the folded seat rearwards.
The rear anchorages then lock.
Unlock the seat back and lift it using
the strap C.
Never use the adjustment
straps to remove, reit or
transport the seat. Folding the seat
Place the head restraints in the low
position.
Pull the strap
C upwards, from the
tailgate.
Fold the seat back onto the seat
cushion.
Pull the lever D to unlock the rear
anchorages.
Place the seat in the "folded" position.
When driving, attach the retaining
straps to the handles.

82
26-04-2004
83
26-04-2004
REAR HEAD RESTRAINTS
The rear head restraints can be removed
and have two positions;
- high, position for use
- low, storage position.
To raise or lower a head restraint, pull it
forwards sliding it at the same time.
To remove it, place it in the high position,
push the lug and pull it forwards and
upwards.
To reit it, engage the head restraint
rods in the holes taking care to remain
in the centreline of the seat back.Never drive with the head
restraints removed, they
must be in place and cor-
rectly adjusted.
YOUR 807 IN DETAIL

84
26-04-2004
85
26-04-2004
GENERAL POINTS RELATING
TO CHILD SEATS
Although one of PEUGEOT's main
criteria when designing your vehicle,
the safety of your children also de-
pends on you.
For maximum safety, please follow these
precautions:
- Since 1992, all children under the
age of 10 must travel in approved
child seats* suited to their weight ,
on seats itted with a seat belt or
ISOFIX mountings.
-
A child weighing less than 9 kg
must travel in the rearwards facing
position both in the front and in
the rear. PEUGEOT recommends
that children should travel in the
"rearwards facing" position up to
the age of two.
- Statistically, the safest seats in
your vehicle for the transporta-
tion of children are the rear seats.
PEUGEOT recommends that chil-
dren travel in the rear even when
a "rearwards facing" child seat is
used.
- If a child is travelling on a booster seat, check that the lap section of
the seat belt passes over the child's
thighs correctly. The chest section of
the seat belt must be positioned on
the child's shoulder without touching
the neck. PEUGEOT recommends
that you use a booster seat with a
back, itted with a seat belt guide at
shoulder level.
- Remember to fasten the seat belt or the child seat harness keeping
the slack in relation to the child's
body to a minimum , even for short
journeys. Special points relating to the
transportation of children
on the front passenger seat*
Children under the age of 10 must not
travel in the forwards facing position,
unless the rear seats are already oc-
cupied by other children or the rear
seats cannot be used (absent or
folded). In this case, adjust the front
passenger seat to the intermediate
longitudinal position and leave the
passenger air bag armed.
The transportation of children in the
rearwards facing position is permit-
ted. In this position, it is essential to
disarm the passenger air bag. Other-
wise, the child would risk being killed
or seriously injured if the air bag were
to inlate.
* According to current legislation in
the country.
YOUR 807 IN DETAIL