PEUGEOT 807 2007.5 Owner's Manual

23
2
INSTRUMENT PANELS
With monochrome displayWith colour display
1. Rev counter.
2. Speedometer*.
3. Fuel level and coolant temperature.
4. Display.
* Version in kilometres, according to country.Instruments and controls
READY TO SET OFF

Instruments and controls
24WARNING LIGHTS
Each time the vehicle is started: a series of warning lights come on applying a check auto-test. They switch off almost immediately.
Engine running: the warning light becomes a warning if it remains on continuously or flashes. This initial warning may be accompanied by an
audible signal and a message on the display. "Do no t ignore these warnings."
Warning light
is indicates Solution - action
STOPlit, associated
with another
warning light and
accompanied by
a message on the
display.major faults linked with the "Brake
fluid level", "Engine oil pressure",
"Coolant temperature", "Electronic
brake force distribution", "Power
steering" and "Punctured wheel"
warning lights.
You must stop, park, switch off the ignition and ca
ll a
PEUGEOT dealer.
Handbrake/Brake
fluid level/EBFD lit.
handbrake applied or not released
correctly.
lit.
remaining on,
even though the
level is correct and
associated with the
ABS warning light. failure of the electronic brake force
distribution. Releasing the handbrake switches off the warning li
ght.
Chapter 2, "Starting and stopping" section.
Top up using a fluid recommended by PEUGEOT.
You must stop, park, switch off the ignition and ca ll a
PEUGEOT dealer.
low brake fluid level.
Engine oil
pressure lit while driving.
remaining on, even
though the level is
correct.
major fault. Park, switch off the ignition and allow to cool. Vi
sually check
the level. Chapter 7, "Levels" section.
Call a PEUGEOT dealer.
insufficient pressure.

25
2
Warning light is indicates Solution - action
Coolant
temperature and
levellit. abnormal increase in temperature.
Park and switch off the ignition then allow to cool
. Visually
check the level. Chapter 2, "Instruments and contro ls" section.
Service lit temporarily. minor faults or warnings.
remaining on. Consult the warnings log on the display or on the s
creen. See
chapter 4, "RD4/RT4 - Trip computer" section, depen ding on
the seriousness of the fault, contact a PEUGEOT dea ler.
In the case of a low diesel additive level, see cha pter 7,
"Levels" section.
major faults.
Row 1 seat belt
not fastened lit.
flashing, accompanied
by an audible signal of
increasing volume.the vehicle is moving with the driver
or front passenger seat belt not
fastened. Pull the strap then insert the tongue in the buckle
.
Check that the seat belt is fastened by pulling the strap.
Chapter 5, "Seat belts" section.
the driver or a front passenger has
not fastened his seat belt.
flashing. drop in coolant level. Chapter 7, "Levels"
section. Contact a PEUGEOT dealer.
Front/side/curtain
air bag flashing or
remaining on.
failure of an air bag. Have the system checked by a PEUGEOT dealer without
delay.
Chapter 5, "Air bags" section.
Front passenger
air bag disarmed lit.intentional disarming of this air bag
in the presence of a rear facing child
seat. Chapter 5, "Air bags-children on board" section.
Instruments and controls
READY TO SET OFF

26
Warning light is indicates Solution - action
Low fuel levellit.
flashing.
malfunction of the gauge or cutting
off of the supply following a serious
impact. Fill up with fuel without delay. The evaluation of
the fuel
reserve is a parameter which is sensitive to the st yle of driving,
the profile of the road, the time elapsed and the d istance
travelled from the time the warning light comes on.
Restore the supply. Chapter 7, "Fuel" section.
fuel reserve being used.
EOBD emission
control system flashing or
remaining on.failure of the injection, ignition
(risk of destruction of the catalytic
converter in the case of a petrol
engine) or emission control system. Have the system checked by a PEUGEOT dealer as soon
as
possible.
Battery charge lit. fault in the charging circuit. Check the battery
terminals, … Chapter 8, "Battery" section.
flashing. placing of the active functions on
standby (economy mode). Chapter 8, "Battery" section.
remaining on, in
spite of the checks. faulty circuit, injection or ignition
malfunction.
Call a PEUGEOT dealer.
ABS remaining on or
coming on above
7 mph (12 km/h).failure of the anti-lock braking
system.
The vehicle retains conventional braking without as
sistance but
you are advised to stop. Call a PEUGEOT dealer.
Instruments and controls

27
2
Warning light is indicates Solution - action
ESP/ASRflashing. wheel skid avoided.
The system optimises drive and permits improvement
of the
directional stability of the vehicle.
Chapter 5, "Driving safety" section.
remaining on. system malfunction.
E.g.: under-inflation of the tyres. Check the pressure of the tyres. Call a PEUGEOT dea
ler.
remaining on with
the button (below
the steering wheel
on the left) pressed. deactivation of the system.
Operation of the system is deactivated.
Chapter 5, "Driving safety" section.
Diesel pre-heating lit.climatic conditions requiring pre-
heating. Wait until the warning light is switched off before
operating the
starter.
Dipped
headlamps/
Daytime lights litmanual selection or automatic
lighting.
Rotate the ring on the lights stalk to the second p
osition.
lighting of the dipped headlamps from
the time the ignition is switched on
- daytime lights. Depending on the
country in which the vehicle is sold. Chapter 3, "Steering wheel controls" section.
Main beam
headlamps pulling of the stalk towards you. Pull the stalk to
return to dipped headlamps.
Direction
indicators flashing with
buzzer.change of direction via the lights
stalk, to the left of the steering
wheel. To the Right: control to be pushed upwards.
To the Left: control to be pushed downwards.
opening of the driver ’s door with the
lights still on.
Rotate the ring on the lights stalk to position 0.
and with an audible
signal, ignition off.
Instruments and controls
READY TO SET OFF

28
Warning light is indicates Solution - action
Rear fog lampslit. manual selection. The fog lamps only operate if the side lights or dipped he
adlamps
are on. In conditions of normal visibility, take care to switch them
off on penalty of being booked. "This light is a dazzling red".
Cruise control lit. cruise control selected. Manual selection. Chapt er 3, "Steering wheel controls" section.
Speed limiter lit. speed limiter selected. Manual selection. Chapte r 3, "Steering wheel controls" section.
Service spanner lit. service due shortly. Refer to the list of checks in the servicing bookle
t.
Have the service carried out by a PEUGEOT dealer.
Automatic
gearbox displayed. gear lever position selected. Chapter 2, "
Instruments and controls" section.
Display is indicates Solution - action
Particle emission
filter saturation
warningdisplayed and
associated with
the service warning
light.malfunction of the particle emission
filter (diesel additive level, risk of
clogging, ...).
Have the filter checked by a PEUGEOT dealer.
Chapter 7, "Levels" section.
Front fog lamps
lit. manual selection. The fog lamps only operate if the side lights or di
pped
headlamps are on.
Instruments and controls

29
2
Wait for the engine to cool before
topping up the level.
The cooling system is pressurised.
In the event of a breakdown and in order to
avoid any risk of scalding, unscrew the cap
two turns to allow the pressure to drop.
When the pressure has dropped, remove the
cap and top up the level.
Contact a PEUGEOT dealer.
COOLANT TEMPERATURE INDICATOR
In zone A , the temperature is correct.
In zone B, the temperature is too high. The
central STOP warning light and the
maximum coolant temperature warning light
1 come on, accompanied by an audible
signal and the message "Engine coolant
temp. too high" on the display.
You must stop immediately.
With monochrome screen With colour screen
INSTRUMENT PANEL DISPLAY
After switching on the ignition, three
functions are shown in succession:
- service indicator,
- engine oil level indicator (see corresponding section),
- total distance recorder (total and trip distances).
It also displays the automatic gearbox
positions and programmes selected
(see opposite).
The total and trip distances are displayed
for thirty seconds, when the ignition is
switched off, on opening the driver’s door as
well as on locking and unlocking the vehicle.
Instruments and controls
READY TO SET OFF

Instruments and controls
30Service indicator
The display, located in the control block,
informs you when the next service will be
due in accordance with the "Manufacturer ’s"
servicing schedule indicated in the servicing
booklet. This information is determined in
relation to the distance travelled since the
previous service.
Refer to the list of checks in the
servicing booklet which was given to
you on delivery of the vehicle. If necessary,
refer to the site:
http://public.infotec.peugeot.com .
Operation
A few moments after the ignition has been
switched on, the spanner indicating a service
operation lights up; the display for the total
distance recorder tells you (in round figures)
the distance remaining before the next
service.
The points at which a service is due are
calculated from the last indicator zero reset.
The point at which a service is due is
determined by the distance travelled. A few seconds after the ignition is switched
on, the oil level is displayed, then the total
distance recorder resumes normal operation
showing the total and trip distances.
The distance remaining before the next
service is less than 500 miles/1 000 km
Each time the ignition is switched on and
for a few seconds, the spanner flashes and
the number of miles/kilometres remaining is
displayed:A few seconds after the ignition is switched
on, the oil level is displayed, then the total
distance recorder resumes normal operation
and the spanner remains lit. This indicates
that a service should be carried out shortly.
The service is overdue
Each time the ignition is switched on and for
a few seconds, the spanner flashes and the
excess distance is displayed.
With the engine running the spanner
remains lit until the service has been
carried out.
The distance remaining may be weighted
by the time factor, depending on the user ’s
driving habits.
The spanner may also light when the two
year time limit has been exceeded.
Example: 4 800 miles/km remain before
the next service is due. When the ignition
is switched on and for a few seconds, the
display shows:

31
2
Zero re-set
Your PEUGEOT dealer carries out this
operation after each service.
However, if you carry out the service
yourself, the re-set procedure is as follows:Switch off the ignition,
 Press and hold the trip recorder re-set
button,
 Switch on the ignition.
The display begins a countdown.
When the display shows "=0", release the
button; the spanner disappears.
Engine oil level indicator
When the ignition is switched on, the engine
oil level is indicated for a few seconds, after
the service information. Oil level correct
Lack of oil
Flashing of
"OIL", linked
with the service warning
light, accompanied by
an audible signal and a
message on the display, indicates a lack of
oil which could damage the engine.
If the lack of oil is confirmed by a check
using the dipstick, it is essential that the
level is topped up.
Oil level gauge fault
Flashing of "OIL --"
indicates a malfunction
of the engine oil level
gauge.
Contact a PEUGEOT dealer. Dipstick
A =
maximum, never exceed
this level as a surplus of oil may
damage the engine.
Contact a PEUGEOT dealer
without delay.
B = minimum, top up the level via
the oil filler cap, using the type of
oil suited to your engine.
Trip recorder zero reset
button
With the ignition on, press the
button until the zeros appear.
Lighting rheostat
With the lights on, press the
button to vary the intensity of
the lighting of the instruments
and controls. When the lighting
reaches the minimum (or maximum) setting,
release the button then press it again to
increase (or reduce) the brightness.
As soon as the lighting is of the required
brightness, release the button.
The level read will only be correct if
the vehicle is on level ground and the
engine has been off for more than
15 minutes.
After this operation, if you wish to
disconnect the battery, lock the vehicle
and wait for at least five minutes, otherwise
the zero re-set will not be registered.
Instruments and controls
READY TO SET OFF

32
GEARBOXES AND STEERING WHEELPark: position of the lever when
parked.
To immobilise the vehicle or start
the engine.
Drive: position of the lever while
driving.
To move the vehicle forwards in
automatic mode.
Reverse: position of the lever in
reverse gear.
To reverse the vehicle.
Neutral: position of the lever in
neutral.
To park the vehicle (handbrake
on) and start the engine.
Manual 1, 2, 3, 4: selection of the
gears by pressing the gear lever.
To move the vehicle forwards in
manual mode.
AUTOMATIC GEARBOX
The four-speed "Porshe Tiptronic-system"
automatic gearbox offers a choice between:
- the comfort of integral automatic operation ,
enhanced by a snow programme,
- or the pleasure of manual gear changing .Gear selection gate

Move the lever in the gate to select
a position.
Once the position is selected, the corresponding indicator light appears on
the instrument panel display.
Gearboxes and steering wheel