steering wheel PEUGEOT 807 2008.5 Owners Manual

Page 5 of 252

Interior
10

5. Control block.

6. Steering wheel audio equipment
controls.

7. Wipers/wash-wipe/trip computer
controls.

8. Gear lever.

9. Ignition.

1. Interior protection alarm
deactivation button.

2. Speed limiter/cruise control
switches.

3. Lights and direction indicators
controls.

4. Driver's air bag.
Horn.
10. Headlamp height adjustment.

11. a - Dynamic stability control button
(ESP/ASR).
b - Parking assistance button.

12. Steering wheel adjustment control.
INSTRUMENTS AND CONTROLS

Page 9 of 252

53
3
3
Interior
14
173 48
Repositioning
SIT COMFORTABLY
SEE CLEARLY
Adjust the height
and depth of the
steering wheel.
Electric exterior mirrors.
Selection Seat belts
Height adjustment.
Fastening. Lights off
Side lights
Main beam headlamps (blue)
Dipped headlamps (green)
Wipers stalk 45

2 fast.
1 normal.
I intermittent.
0 off.

 single wipe.
AUTO, press the stalk down.

AUTO, automatic switching
on of the lights
Adjustment
86

Page 29 of 252

Instruments and controls
READY TO SET OFF
2
33
Warning light is indicates Solution - action
ESP/ASR fl ashing.
wheel skid avoided. The system optimises the traction and improves
the directional stability of the vehicle. Chapter 5,
"Driving safety" section.
remaining on. a malfunction of the system.
E.g.: under-infl ation of the
tyres. Check the pressure of the tyres. Call a PEUGEOT
dealer .
remaining on
with the button
(below the
steering wheel
on the left)
pressed. deactivation of the system.
The operation of the system has been
deactivated.
Chapter 5, "Driving safety" section.

Diesel
pre-heating lit. climatic conditions requiring
pre-heating. Wait until the warning light is switched off before
operating the starter.

Dipped
headlamps/
Daytime
lights lit. manual selection or
automatic lighting.
Rotate the ring on the lights stalk to the second
position.
lighting of the dipped headlamps
from the time the ignition is
switched on - daytime lights.
Depending on the country in
which the vehicle is sold.
Chapter 3, "Steering wheel controls" section.

Main beam
headlamps
pulling of the stalk towards you. Pull the stalk to return to dipped headlamps.
and with an
audible signal,
ignition off. opening of the driver's door
with the lights still on.
Rotate the ring on the lights stalk to position 0.

Direction
indicators fl ashing with
buzzer. change of direction via the
lights stalk, to the left of the
steering wheel. To the Right: control to be pushed upwards.
To the Left: control to be pushed downwards.

Page 30 of 252

Instruments and controls
34
Warning light is indicates Solution - action
Front fog
lamps lit. manual selection. The fog lamps only operate if the side lights or
dipped headlamps are on.

Rear fog
lamps lit. manual selection. The fog lamps only operate if the side lights or
dipped headlamps are on. In conditions of normal
visibility, take care to switch them off on penalty of
being booked. "This light is a dazzling red."
Display is indicates Solution - action
Cruise control lit. cruise control selected. Manual selection. Chapter 3, "Steering wheel
controls" section.

Speed limiter lit. speed limiter selected. Manual selection. Chapter 3, "Steering wheel
controls" section.

Service
spanner lit. service due shortly. Refer to the list of checks in the servicing booklet.
Have the service carried out by a PEUGEOT
dealer .

Automatic
gearbox displayed. gear lever position selected. Chapter 2, "Instrume
nts and controls" section.

Particle
emission fi lter
saturation
warning displayed and
associated with
the service
warning light. malfunction of the particle
emission fi lter (diesel
additive level, risk of
clogging, ...).
Have the fi lter checked by a PEUGEOT dealer .
Chapter 7, "Levels" section.

Page 34 of 252

Gearboxes and steering wheel
38
GEARBOXES AND STEERING WHEEL
Park: position of the lever
when parked.
To immobilise the vehicle or
start the engine.
To park the vehicle
(handbrake on) and start the
engine.

Drive: position of the lever
while driving.
Reverse:
position of the lever
in reverse gear.
To reverse the vehicle.
Neutral: position of the lever
in neutral.
To move the vehicle forwards
in automatic mode.

Manual: selection of the gears
by pressing the gear lever:
- 1 to 4: petrol engine,
- 1 to 6: Diesel engine.
To move the vehicle forwards in
manual mode.
AUTOMATIC GEARBOX
The four-speed (petrol engine) or
six-speed (Diesel engine) "Porsche
Tiptronic-system" automatic gearbox
offers a choice between:
- the comfort of integral automatic
operation , enhanced by a snow
programme,
- or the pleasure of manual gear
changing . Gear selection gate
- Move the lever in the gate to select
a position. Once the position
is selected, the corresponding
indicator light appears on the
instrument panel display.

Page 35 of 252

Gearboxes and steering wheel
2
39
READY TO SET OFF
Automatic changing of the four or
six gears .
Moving off
- It is essential to press the brake pedal to exit
position P,
- select position R or D ,
You can also move off from position N .
- gradually release the
pressure on the brake
pedal; the vehicle moves
off immediately.
- With your foot on the brake, release
the handbrake,
- select position R , D or M ,
- gradually release the pressure on the brake
pedal; the vehicle moves
off immediately. The gearbox always selects the most
suitable gear according to the following
parameters:
- the style of driving,
- the road profi le,
- the vehicle load.
The gearbox is then operating in auto-
adaptive mode, without any action on
your part. For immediate maximum
acceleration without touching the
gear lever, press the accelerator
pedal down as far as it will go to the
end of its travel passing the point of
resistance (kickdown). The gearbox will
automatically change down or maintain
the gear selected until maximum
engine speed is reached.
With the engine running, to move off
from position
P .
Automatic mode On a descent, the gearbox will
automatically change down in order to
provide effi cient engine braking and
good re-acceleration.
If you take your foot off the accelerator
suddenly, the gearbox will not change
to a higher gear for reasons of safety.
6-speed gearbox (Diesel engine):
when stationary with the gear lever in
position
D (drive), a vibration limiting
device is activated by pressing the
brake pedal.
- Select position D .

Page 36 of 252

Gearboxes and steering wheel
40
- press the lever to the + sign
to change to a higher gear,
from 1 to 4 or from 1 to 6,
- conversely, press the lever to the - sign to
change to a lower gear. You can change from position
D
(automatic mode) to position M
(manual mode) at any time.
Stopping the vehicle, starting
the engine
Reverse gear
- Select position R , with the
vehicle stationary and the
engine at idle.
If the battery is fl at and the lever is
in position P , it will be impossible
to change to another position. - Select position
P to

immobilise the vehicle or
to start the engine , with
the handbrake on or off.
- You can also select position N to park or to

start the engine , with the
handbrake on.
If position N is engaged
inadvertently while driving, allow
the engine to return to idle before
engaging position D to accelerate.
Manual mode
Manual changing of the gears by
pressing.
- Select lever position M , In manual mode, it is only possible to
change from one gear to another if
the vehicle speed and engine speed
permit. If they do not, the vehicle will
operate temporarily in automatic mode.
When the vehicle is stationary or
moving very slowly, the gearbox
automatically selects gear 1.
The
 (snow) programme does not
operate in manual mode.

Page 37 of 252

Gearboxes and steering wheel
2
41
READY TO SET OFF
Good practice
Never select position N when the
vehicle is moving.
Never select positions P or R unless
the vehicle is stationary.
Never change between positions to
optimise braking on a slippery surface.
When the engine is at idle, brakes
not applied, if position R , D or M is
selected the vehicle moves even
without the accelerator being pressed.
For this reason, do not leave children
unsupervised inside the vehicle,
with the engine running .
Operating abnormality
Any operating abnormality is indicated
by an audible signal, accompanied by
the message
"Automatic gear fault"
on the display and fl ashing of the Snow
snowfl ake on the instrument panel.
In this situation the gearbox operates
in downgrade mode (locked in 3rd
gear). You may feel a substantial knock
when changing from P to R and from N
to R (this will not cause any damage to
the gearbox).
Do not exceed 60 mph (100 km/h),
keeping within the limit of local speed
restrictions.
Contact a PEUGEOT dealer as soon
as possible.
You can return to the automatic
programme at any time.
- Press button
 again to switch off
the programme you are in.
Snow programme
In addition to the automatic
programme, there is a special
Snow programme.
This improves starting
and drive when traction is poor. The
snowfl ake appears on the instrument
panel display.
- Press button
 once the
vehicle has been started
and position D selected.
The gearbox adapts to driving
on slippery roads.

Page 38 of 252

Gearboxes and steering wheel
42
STEERING WHEEL HEIGHT AND
DEPTH ADJUSTMENT
When the vehicle is stationary, unlock
the steering wheel by lowering the
lever.
Adjust the height and depth of the
steering wheel, then lock by pushing
the lever fully upwards.
MANUAL GEARBOX
5-speed gearbox 6-speed gearbox
To change gear easily, always press
the clutch pedal fully.
To prevent the mat from becoming
caught under the pedal:
- ensure that the mat is positioned correctly,
- never fi t one mat on top of another.
When driving, avoid leaving your hand
on the gear knob as the force exerted,
even if slight, may wear the internal
components of the gearbox over time. Reverse gear (6-speed)
Raise the collar under the gear knob to
engage reverse gear.
Never engage reverse gear before the
vehicle is completely stationary.
The lever should be moved slowly to
reduce the noise on engaging reverse
gear.

Page 40 of 252

Steering wheel controls
ERGONOMICS and COMFORT
3
45
Automatic lights
If your vehicle is fi tted
with a brightness
sensor.
Lights off
Dipped beam (green)
Main beam (blue)
DIRECTION INDICATORS
(green flashing)
STEERING WHEEL CONTROLS
Checking by means of the
indicator lights on the instrument
panel is described in the
"Instruments and controls" section of
chapter 2. Side lights
LIGHTING CONTROL

Left: downwards.

Right: upwards. Front and rear lights
Selection is by turning ring
A .

Page:   1-10 11-20 21-30 31-40 40 next >