heating PEUGEOT 807 2008 Owners Manual

Instruments and controls
READY TO SET OFF
2
33
Warning light is indicates Solution - actionESP/ASR lashing. wheel skid avoided.
The system optimises drive and permits
improvement of the directional stability of the
vehicle. Chapter 5, "Driving safety" section.
remaining on.
system malfunction.
E.g.: under-inlation of the tyres.Check the pressure of the tyres.
Call a PEUGEOT dealer.
remaining on with
the button (below
the steering
wheel on the left)
pressed.
deactivation of the system. Operation of the system is deactivated.

Chapter 5, "Driving safety" section.
Diesel
pre-heating lit.climatic conditions requiring
pre-heating. Wait until the warning light is switched off before
operating the starter.
Dipped
headlamps/
Daytime lights litmanual selection or
automatic lighting.
Rotate the ring on the lights stalk to the second
position.
lighting of the dipped headlamps
from the time the ignition is switched
on - daytime lights. Depending on the
country in which the vehicle is sold.
Chapter 3, "Steering wheel controls" section.
Main beam
headlamps pulling of the stalk towards
you.
Pull the stalk to return to dipped headlamps.
and with an
audible signal,
ignition off. opening of the driver’s door
with the lights still on.
Rotate the ring on the lights stalk to position 0.
Direction
indicators lashing with
buzzer.change of direction via the
lights stalk, to the left of the
steering wheel. To the Right: control to be pushed upwards.

To the Left: control to be pushed downwards.

READY TO SET OFF
2
43
Starting and stopping
STARTING AND STOPPING
STOP position: steering lock.
The ignition is off.
Good practice when startingHandbrake
On the version with rotating front seat,
the handbrake can be disengaged.
Pulling the handbrake to immobilise
the vehicle then lowering the lever
does not release the brake, it permits
rotation of the driver’s seat.
Pull the button placed at the end of the
handbrake forwards.
The handbrake lever lowers.
You can now rotate the seat.
To return to normal operation, pull the
lever up until it clicks.
If the handbrake is on or has
not been released fully, this is
indicated by:
- a warning light which comes on on the instrument panel,
- an audible signal,
- a message on the display.
Good practice when stopping
Running and accessories position.
Certain accessories can be used.
Starting position.
The starter is operated. Diesel pre-heating warning
light
Turn the key to the Running
position.
In cold weather, wait for this warning
light to switch off then operate the
starter (Starting position) until the
engine starts.
If the temperature is high enough, the
warning light comes on for less than one
second, you can start without waiting.
Minimise engine and gearbox
wear
When switching off the ignition, let the
engine run for a few seconds to allow
the turbocharger to return to idle.
Do not press the accelerator when
switching off the ignition.
There is no need to engage a gear
after parking the vehicle.
Good practice on long journeys
When travelling far from home, take
the conidential card with you just as
you would take your personal papers.
In other circumstances, keep this
conidential card in a safe place, never
in the vehicle.
Make a note of the coded number on
the label attached to the key and of the
code etched on the head of the
anti-theft socket (if your vehicle is itted
with alloy wheels).

66
Seats
Memorising seat positions
Two driving positions can be
memorised, using buttons M/1 and
M/2 .
These are located on the side of the
seat: 4 Place the ignition key in the
"running" position (2nd notch),
4 Adjust your seat,
4 Press button M, then button 1 for
a irst driving position within four
seconds.
Repeat the same actions on buttons M
and 2 to store another driving position.
An audible signal conirms that a
position has been memorised.
Memorising a new position cancels the
previous one. Activating a memorised driving
position
Front heated seat controls
When the engine is running, the front
seats can be heated separately.
Use the adjustment controls located on
the side of each front seat to switch on
and select the self-regulated level of
heating:
1:
Low.
2: Medium.
3: High.
0: Off.
After recalling a memorised
position ive times in succession,
the function will be cancelled until
the engine is started.
Engine running 4 Keep button 1 or 2 pressed down
until the end of setting of the
corresponding memorised position.
Engine off 4
Briely press button 1 or 2 to recall
the corresponding memorised
position.