Peugeot Boxer Dag 2005 User Guide

12
01-01-2005
13QUICK REFERENCE GUIDE

12
01-01-2005
13
INTERIOR FITTINGS
1. STORAGE COMPARTMENTS IN THE DOORS
A. Armrest.
B. Bottle holder.
C. Storage compartment.
2. GRAB HANDLE
This is positioned for the centre front
passenger.
3. SUN VISORS
The sun visors have pockets for stor-
ing documents.
4. WRITING TABLE (Folding)
The table is in the centre of the fascia
panel.
Lift the table D at the clip F to open it.
The clip F can be used to secure
documents.
To fold the table D, press the centre
of bar E and fold the table.
Note: the writing table is ixed if your
vehicle is itted with a passenger air
bag. 10. TABLE (2
-seat bench seat)
The table is in the seat back of the
2-seat bench seat.
Pull the handle at the top of the seat
back to fold the table.
It has:
- a document clip,
- a pen holder,
- two can holders.
5. GLOVE BOX
This has a lock.
To open the glove box, lift the handle.
6. LIGHTER
7. ASHTRAY
Pull the cover to open the ashtray.
To empty it, after opening, remove it
by pulling upwards.
8. 12 VOLT ACCESSORIES
SOCKET
This is at the bottom of the centre
console.
9. STORAGE TRAY UNDER THE DRIVER AND PASSENGER
SEAT
67
QUICK REFERENCE GUIDE
01-01-2005

16TELEMATICS
If your vehicle is equipped with on-
board telematics, please refer to the
special manual, located in the glove
box.
QUICK REFERENCE GUIDE
01-01-2005

1
01-01-200 5
MULTI-FUNCTION DISPLAYS
These two multi-function displays
are an integral part of the audio/
telephone/GPS . Therefore, they are
controlled by its control keypad and
by its steering wheel stalk.
They enable you to obtain the follow-
ing information:
- displaying of the audio sources (radio, CD),
- displaying of the telematic sys- tems (telephone, services, ... ),
- displaying of the satellite naviga- tion system (see corresponding
section),
- displaying of the trip computer (see corresponding section),
- the warning messages (e.g. "Warning, maximum speed ex-
ceeded") or information mes-
sages (e.g. "SIM card absent")
displayed temporarily. Superimposed display
In certain cases, when a function
(radio, telephone, trip computer, ...)
changes status while another func-
tion is displayed, a window opens
to inform you of the change, then
disappears.
Monochrome display
Colour display

2
02-08-2004
3
MAIN SCREENPULL-DOWN MENU
This is the menu associated with the
application in use at the base of the
display.
Press the "MAIN/DARK" button to
display the main screen , display
the information relating to the active
source (radio, CD, telephone or navi-
gation) and gain access to the follow-
ing functions:
- Voice memory,
- Setup.
The "Voice Memory" function per-
mits management of the recorded
voice messages. You can listen to
them again or delete them.
The messages are played in se-
quence, from the oldest to the most
recent.
Deleting deletes all of the mes-
sages.
The "Setup" function permits modii-
cation of the general system parame-
ters (see § "General parameters"). When the menu consists of several
pages, access to the next page is by
selecting the
"Other menus" func-
tion. - Following selection of a function
from the menu, the sub-menu
appears on the right-hand side
of the display .
- The values corresponding to each of the functions of the sub-menu
appear opposite on the left-hand
side of the display .
01-01 -200 5

45
02-08-2004
The "Commands & Setup" menu
provides access to the following gen-
eral parameters:
- "Setup": choice of day/night brightness, display colours, voice/
text message language and dis-
tance unit,
- "Fleet Management": conigura- tion of the automatic vehicle loca-
tion SMS messages,
- "Speed Limit Warning": setting, activation and display of exceed-
ing of the permitted speed,
- "Modem": activation/deactivation of the communication between
the system's modem and the lap-
top.
GENERAL PARAMETERS
The "Day brightness" and "Night
brightness" functions enable you to
set day and night brightness values
independently.
The "Colours" function controls dis-
playing on the day or night setting or
changes the setting automatically in
relation to the light in the passenger
compartment or switching on of the
lights.
The "Voice language" and "Text
language" functions enable you to
choose the language for voice rec-
ognition and SMS messages (Italian,
German, English, Spanish, French,
Portuguese, Dutch).
The "Distance unit" function ena-
bles you to choose the distance unit
for the trip computer calculations (km
or miles).
Note: to choose the language and
the distance unit, insert the conigu-
ration CD-Rom.
Setup
The "Fleet Management" function
permits locating of the vehicle by
means of the automatic transmis-
sion of SMS messages to a control
centre.
To have the SMS messages sent,
you must:
- activate the "Sending mode" func- tion,
- select a type of interval in the "Event mode" function,
- set the duration of the interval in the "Data frequency send" func-
tion,
- enter the registration number in the "Vehicle ID" function,
- enter the telephone number of the control centre in the "Telephone
number" function,
- insert the SIM card.
Fleet Management
01
-01 -200 5

4
02-08-2004
5
The "Speed Limit Warning" func-
tion enables you to monitor the
speed of the vehicle.
To enable the system to detect an
excessive speed and warn you of
this, you must:
- activate the "Alarm" function,
- set the permitted speed in the "Speed Limit" function,
- activate the "Buzzer" function.
Speed Limit Warning
The "Modem" function permits an
exchange of data between the sys-
tem and a laptop.
To permit an exchange of data, you
must:
- connect the computer to the sys- tem using its cable located in the
centre of the fascia panel under
the storage compartment,
- conigure the serial port of the computer to 9600 bits/s; 8 data
bits; no parity; 1 stop bit; lux Xon/
Xoff check,
- install the modem on the compu- ter,
- activate the "modem" function,
- insert the SIM card.
Modem
01
-01 -200 5

23
02-08-2004
CONTROL BUTTONS
Rotation:
Selection of functions from a menu
or a screen.
Selection of audio settings - Modii-
cation of the value of a setting.
Increase or decrease of the map
zoom factor.
Adjustment of the display brightness
for the video camera.
Press:
Displaying of the "MAIN" or "NAV"
context menu depending on the ac-
tive source.
Conirmation of the functons selected
or of the values changed."ESC" button:
Cancellation of the cur-
rent operation.
Exit from the page se-
lected and return to the
previous page.
Deletion of a character.
Pressing for more than 2 seconds:
deletion of an entire line.
"MAIN/DARK" button:
Displaying of the main
menu . Switching on of
the display.
Pressing for more than
2 seconds: switches the
display to standby.
"AUDIO/OFF" button:
Displaying of the audio
sources menu. Switching
on of the radio and CD.
Pressing for more than
2 seconds: switches off the radio
and CD. "TEL/OFF" button:
Displaying of the
telephone
source menu. Switching on
of the telephone.
Pressing for more than 2
seconds: switches the telephone off.
"NAV/MUTE" button:
Displaying of the naviga-
tion source menu.
Pressing for more than
2 seconds: cuts off/ restores
the voice information.
"TRIP" button
Displaying of the trip
computer source menu.
For safety reasons, the
driver must conigure the
multi-function displays
while stationary.
"SEL" knob:
01
-01 -200 5

67
02-08-2004
TRIP COMPUTER
- the distance remaining or dis-
tance to the destination. This
is calculated at any time by the
navigation system if guidance is
activated, or entered by the user
minus the distance travelled since
the data was entered;
- the time of arrival or the approxi-
mate time of arrival at the destina-
tion. This is obtained by adding
30% to the remaining duration of
the journey, calculated from the
average speed and added to the
current time.
Each time the
TRIP button on the
audio/telephone control panel is
pressed, the following sequence of
data is displayed:
- the average speed calculated
since the last trip computer zero
reset (ignition on);
- the distance travelled since the
last trip computer zero reset;
- the duration of the journey or
time elapsed since the last trip
computer zero reset, indicated in
"hours and minutes";
01 -01 -200 5

6
02-08-2004
7
AUDIO/TELEPHONE/GPS
Action Function
1 - Press Volume increase.
2 - Press Volume decrease.
3 - Press Activation / Deactivation of voice
commands.
Pressing for more than 1 second:
recording of a voice description.
4 - Press Sound cut-off (MUTE) -
Restoration of sound.
5 - Press Selection of the next stored station
(radio).
Selection of the next track (CD).
6 - Press Selection of the previous stored
station (radio).
Selection of the previous track
(CD).
7 - Press Pick up (Incoming call / Not in
communication) - Hang up (In
communication) - Redial.
Pressing for more than 1 second:
Hang up (Incoming call).
8 - Press Change of audio source
(FM1 / FM2 / FM3 / LW / MW /
CD).
01
-01 -200 5