Peugeot Expert 2006 User Guide

16 -
OPENING THE BONNET
From inside: pull the control located
on the right, under the fascia.
From outside: lift the catch, raise
the bonnet and secure the strut to
hold the bonnet open.
CRUISE CONTROL
Cruise control enables the vehicle to
maintain a steady speed programed
by the driver, regardless of the road
characteristics and without the driver
having to touch the accelerator or
brake pedals.
To be stored, the vehicle speed must
be higher than approximately 25 mph
(40 km/h) or 40 mph (60 km/h) (ac-
cording to engine), with at least fourth
gear engaged.
When the warning light
comes on you have
enough fuel left to drive
approximately 30 miles
(50 km).
 65  54 FILLING THE FUEL TANK
The tank must be filled with the
engine off
.
 Insert the key, then turn it to the
left.
 Remove the cap.
A label indicates the type of fuel to
be used.
The capacity of the tank is
approximately 80 litres.
Low fuel level warning light
 55
Operation

Press switch A. The indicator light
comes on.
You can store a speed.
 Press switch A again to switch the
system off. The indicator light is
switched off.
Do not use the cruise control on
slippery roads or in heavy traffic.
Familiarisation

12 -
HEATING/AIR CONDITIONING
 36
Air distribution Air conditioning
on/off
Rear screen and/or mirrors demisting
Air recirculation
Air flow Temperature
Familiarisation

14 -
PressFunction
1 Increase volume.
2 Decrease volume.
3 Selection of the previous stored station (radio) - Selection of t he previous CD (CD changer).
4 Selection of the next stored station (radio) - Selection of the next CD (CD changer).
5 Automatic search of lower frequencies (radio) - Selection of the pre vious track (CD/CD changer).
6 Automatic search of higher frequencies (radio) - Selection of the n ext track (CD/CD changer).
7 Change of source (radio/CD/CD changer).
8 Mute; restoring of the sound by pressing any button.
AUDIO RD1
Familiarisation

15
-
ButtonFunction
A ON/VOL Press: audio equipment on/off. Rotation: volume adjustment.
B
 Ejection of the CD.
C RDS RDS function on/off.
Press for more than 2 seconds: regional following mode on/off.
D TA Traffic information priority on/off.
Press for more than 2 seconds: PTY function on/off.
E AUDIO Selection of adjustment of the bass, treble, loudness and sou nd distribution.
F Increase the setting of the functions associated with button
E .
G Decrease the setting of the functions associated with button
E .
H Automatic search of higher frequencies.
Selection of the next CD track.
I MAN Manual/automatic operation of button H and J.
J Automatic search of lower frequencies.
Selection of the previous CD track.
K Selection of the radio. Selection of the FM1, FM2, FM3, AM wa
vebands.
Press for more than 2 seconds: automatic storing of the stations (au tostore).
L Selection of the CD changer.
Press for more than 2 seconds: random play.
M Selection of the CD.
Press for more than 2 seconds: random play.
1 to 6 1 2 3 4 5 6 Selection of the stored station.
Press for more than 2 seconds: storing of a station.
Selection of a disc in the CD changer.

24
Familiarisation

18 -Instruments and controls
PETROL-DIESEL MANUAL GEARBOX INSTRUMENT PANELS
1 - Front fog lamps indicator light.
2 - Rear fog lamp indicator light.
3 - Clock.
4 - Left direction indicator.
5 - Engine oil pressure and
temperature warning light.
6 - Central STOP warning light.
7 - Handbrake, low brake fluid
level and electronic brake force
distribution warning light. 8 -
Right direction indicator.
9 - Speedometer*.
10 - Main beam headlamps indicator
light.
11 - Dipped beam headlamps
indicator light.
12 - Coolant temperature indicator.
13 - Coolant maximum temperature
warning light.
14 - Service indicator and total/trip
distance recorder. 15 -
Trip recorder zero reset and
total/trip distance recorder
display button.
16 - Low coolant level warning light.
17 - Engine autodiagnostics warning
light.
18 - Seat belt not fastened warning
light**.
19 - Front and side air bags warning
light.
20 - Water in diesel filter warning
light**.
21 - Anti-lock brake system (ABS)
warning light.
22- Front brake pad wear warning
light.
23 - Diesel engine pre-heat warning
light.
24 - Battery charge warning light.
25 - Clock adjustment button.
26 - Fuel level indicator.
27 - Low fuel level warning light.
* Version indicating kilometres, according to country.
** According to country.

19
-Instruments and controls
INSTRUMENTS AND
CONTROLS
A permanently lit warning light
or one flashing, with the engine
running, indicates an operating
fault of the unit concerned. The
illumination of certain warning
lights may be accompanied by
an audible signal. Do not ignore
this warning: consult a PEUGEOT
dealer as soon as possible.
If the central STOP warning light
comes on when you are driving,
stop your vehicle immediately,
where it is safe to do so.
Central STOP warning
light
Linked to the "engine oil
pressure", "coolant tem-
perature and low level",
"handbrake", "low brake fluid level"
and "electronic braking system fault"
warning lights.
You must stop if the light flashes
with the engine running.
Consult a PEUGEOT dealer. Engine oil pressure and
temperature warning
light
Linked to the central
STOP
warning light.
You must stop.
This warning light indicates one of
the following:
- insufficient oil pressure,
- a lack of oil in the lubrication circuit. Top up the level.
- an oil temperature which is too high. The warning light is accompa-
nied by an audible signal. To lower
the oil temperature, reduce your
speed.
Consult a PEUGEOT dealer.
Low coolant level
warning light
Linked to the central STOP
warning light.
You must stop.
Wait for the engine to cool before
topping up the level.
The cooling circuit is pressurised.
In the event of breakdown and to
prevent any risk of burns , unscrew
the cap to the first notch to allow the
pressure to drop.
When the pressure has dropped, re-
move the cap and top up the level.
Consult a PEUGEOT dealer. Battery charge warning
light
This indicates one of the
following:
- faulty operation of the charging cir- cuit,
- slack battery or starter terminals,
- a cut or slack alternator belt,
- an alternator failure.
Consult a PEUGEOT dealer. Handbrake, low brake
fluid level and Electronic
Brake Force Distribution
fault warning light
Linked to the central
STOP
warning light.
This indicates one of the following:
- that the handbrake is applied or not fully released,
- an excessive drop in brake fluid level (if the warning light remains
on even when the handbrake is re-
leased),
- a fault in the Electronic Brake Force Distribution, if lit at the same time
as the ABS warning light.
You must stop.
Consult a PEUGEOT dealer.

20 -Instruments and controls
Front brake pad wear
warning light
For your safety, have the
four front brake pads re-
placed as soon as the
warning light comes on.
Anti-lock braking system
(ABS) warning light
This comes on for 3 sec-
onds each time the ignition
is switched on.
If the warning light remains on or
comes on above 8 mph (12 km/h),
this indicates an ABS malfunction.
However, the vehicle retains conven-
tional servo-assisted braking.
Lighting of this warning light is
accompanied by an audible signal.
Consult a PEUGEOT dealer.
Engine diagnostics
warning light
This comes on each time
the ignition is switched on.
If it comes on with the engine running,
this indicates incorrect operation of
the injection, ignition or emission
control system. There is a risk of
damage to the catalytic converter
(petrol engine only).
Consult a PEUGEOT dealer. Seat belt not fastened
warning light*
When the ignition is
switched on, this indicator
light comes on if the driver
has not fastened his seat belt. Diesel engine pre-heat
warning light
Wait until the warning light
goes out before starting the
engine.
If the temperature is high enough,
the warning light comes on for less
than one second. You can start the
engine without waiting. Front and side* air bags
warning light
The light will come on for a
few seconds when the igni-
tion is switched on.
With the engine running, illumination
of this warning light indicates a fault
in the air bags.
Consult a PEUGEOT dealer.
Low fuel level
warning light
When this light first
comes on, you have
enough fuel left to drive
approximately 30 miles (50 km)
(The tank capacity is approximately
80 litres).
Water in diesel filter
indicator light*
Lighting of this warning light
indicates the presence of
water in the diesel filter.
For the indirect injection Diesel en-
gine, bleed the circuit at the filter.
For the direct injection Diesel en-
gines, consult a PEUGEOT dealer
as soon as possible.
There is a risk of damage to the in-
jection system.
* According to country. Fuel gauge
Each time the engine is started, the
warning light comes on for a few sec-
onds and the needle moves to test
the operation of the gauge.

21
-Instruments and controls
Coolant temperature indicator
- needle in zone
(A), the temperature
is correct,
- needle in zone (B), the tempera-
ture is too high. The central STOP
warning light flashes.
You must stop.
Consult a PEUGEOT dealer.
Instrument panel display
After switching on the ignition, two func-
tions are shown in succession:
- service indicator (see correspond- ing section),
- total distance recorder (see corre- sponding section).
Note: it displays the total and trip dis-
tances for 30 seconds when the igni-
tion is switched off, on opening the
driver's door, as well as on locking
and unlocking the vehicle.

22 -Instruments and controls
Service indicator
This is a visual reminder of when the
next service is due. This service is to
be carried out according to the man-
ufacturer's servicing schedule.
Operation
As soon as the ignition is switched
on and for 5 seconds, the spanner
symbolising ''service operation'' is lit.
The trip recorder display shows the
distance remaining (in round figures)
before the next service.
Example: 4,800 miles/km remain be-
fore the next service is due. When the
ignition comes on and for 5 seconds
the display indicates:
5 seconds after the ignition is
switched on, the total distance re-
corder resumes normal operation
and the display shows the total or trip
distances. The distance remaining before the
next service is less than 500 miles
(1,000 km).
Example:
400 miles (900 km) remain
before the next service is due.
When switching on the ignition and
for 5 seconds, the display shows:
5 seconds after the ignition is
switched on, the total distance re-
corder resumes normal operation
and the symbol remains lit.
This indicates that a service should
be carried out shortly. The display
shows the total or trip distances. 5 seconds after the ignition is
switched on, the total distance
recorder resumes normal operation
and the symbol remains lit. The
display shows the total or trip
distances.
The service is overdue*.
Each time the ignition is switched on
and for 5 seconds, the symbol and
the excess distance flash.
Example:
the service is overdue by
300 miles/km. The service should be
carried out very shortly.
When the ignition is switched on and
for 5 seconds, the display shows:
* Whichever comes first: the service spanner lights if the two-year inter-
val has been exceeded.

23
-Instruments and controls
Resetting the service
indicator
Your PEUGEOT dealer carries out
this operation after each service.
The reset procedure is as follows:
- Switch off the ignition.
- Press and hold button
1.
- Switch on the ignition.
The display begins a 10 second
countdown.
- Keep button 1 pressed for 10 seconds.The display shows [= 0] and the
service symbol disappears.
Total distance recorder
Briefly pressing button 1 alternates
between the total and trip distance
displays.
To reset the trip recorder to zero,
when it is displayed press button 1
until zeros appear.
LIGHTING RHEOSTAT
With the lights on, turn the knob to
vary the intensity of the lighting of the
instruments and controls.
CLOCK
Rapid adjustment
Press and hold button A to turn the
hands quickly to the required time.
Accurate adjustment
Press button A briefly to turn the
hands slowly to the required time.
Note: if you have gone past the re-
quired time, you must repeat a cycle
of 12 hours.