dashboard Peugeot iOn 2018 User Guide

16
Lighting dimmer
System that allows the brightness of the
instruments and controls to be adjusted
manually to suit the ambient light level.
With the headlamps on or off, press button A to
select the function, then hold it down to adjust
the brightness of the instruments and controls
lighting to "day" or "night".
The brightness of the lighting increases every
time you press button A.
When the lighting reaches the maximum
setting, press again to move to the minimum
setting.
Release button A as soon as the lighting
reaches the desired brightness.
The setting is registered as soon as you
release button A and is stored when the ignition
switch is turned to OFF.
Service indicator
System which informs the driver when the
next ser vice is due, in accordance with the
manufacturer's servicing schedule.
This due date is calculated from the last reset
of the service indicator.
There are two different ways to indicate when
the next ser vice is due:
-

r
emaining distance (in kilometres or miles),
-

t
ime (in months) left before the next
service.
Once the ignition is switched on, press
button
A successively until the ser vice indicator
is displayed in the desired units.
Operation
1. The display shows the distance or time
remaining before the next service.
2. The display shows that the ser vice is due.
Each time the ignition is switched on, the
ser vice spanner is displayed for a few
seconds to notify you that the ser vice
must be carried out very soon.
3. Once the ser vice has been completed,
the distance or the time remaining before
the next ser vice is displayed.
Dashboard instruments

17
Resetting the service indicator
After each service, the service indicator must
be reset to zero.
The procedure for resetting to zero is as
follows:
F
T
urn off the ignition (switch to LOCK or
ACC position).
F

P
ress the reset button A in succession until
the service indicator is displayed.
F

P
ress and hold the reset button down for a
few seconds to make the spanner flash .
F

P
ress the reset button whilst the spanner
is flashing to move the display " ---" to
" CLEAR ".
The distance (or the time) remaining before
the next ser vice is displayed. The distance "
---" indicating that the
ser vice is now due is reset automatically
after a certain time and a certain distance
travelled. The display will then indicate the
remaining time before the next service.
Under-inflation detection
You must reinitialise the under-inflation
detection system after adjusting one or more
tyre pressures and after changing one or more
wheels.
The procedure for this is as follows.
F

P
ress button A to select the system.
F

P
ress and hold button A down for at least
three seconds .
An audible signal sounds and the under-
inflation warning lamp flashes slowly until
reinitialisation has been completed.
1
Dashboard instruments

18
Choice of set of tyres fitted
If you have registered a second set of tyres
with sensor, after every change, select the
corresponding set in the instrument panel
display screen.
The procedure for this is as follows.
F
P
ress button A to select the system.
F

P
ress and hold button A for more than ten
seconds to move from tyre set 1 to tyre
set
2 in succession or vice versa.
Range indicator
This function provides you with an estimated
range that your vehicle can still travel, taking
into account your recent conditions of use
(driving style, use of heating, air conditioning,
e t c .) .When the remaining range is too low, " ---"
is displayed in the instrument panel.
The remaining range can be displayed in
miles or kilometres.
For more information on the distance
recorder , and the unit change in
particular, refer to the corresponding
section.
Dashboard instruments

23
Always remove the key from the ignition
when leaving the vehicle, even for a short
time.
In the event of contact during operation of
the electric windows, you must reverse the
movement of the window. To do this, press
the corresponding control.
When operating the passenger electric
window switches, the driver must ensure
that no-one is preventing correct closing
of the windows.
The driver must ensure that the
passengers use the electric windows
c o r r e c t l y.
Be aware of children when operating the
windows.
Charging flaps
Normal charging
F Pull control A in the lower part of the dashboard, driver's side, to unlock the
access flap.
F

O
pen the access flap on the right-hand
side of the vehicle.
F

P
ress on latch B to open the socket cover.
Fast charging
(Depending on equipment.) F
P
ull control C under the driver's seat, near
the door, to unlock the access flap.
F
O
pen the access flap on the left-hand side
of the vehicle.
F
P
ress on latch D to open the socket cover.
For more information on Recharging the
main battery , refer to the corresponding
section.
2
Access

24
Front seats
Manual adjustments
1.Adjusting the height of the head restraint.
2. Adjusting the seat backrest angle.
Operate the control lever and adjust the
position of the backrest for wards or
backwards.
3. Adjusting the height of the driver's seat
cushion.
Raise or lower the control lever the
number of times required to obtain the
desired position.
4. Seat forwards-backwards adjustment.
Raise the control bar and slide the seat
forwards or backwards.
Adjusting the height of the head
restraintNever drive with the head restraints
removed and in the vehicle, they may
become projectiles in severe braking
situations - they must always be in place
and properly adjusted.
After installing the head restraint, make
sure that the height adjustment button has
properly locked in place.
The adjustment is correct when the top of
the head restraint is aligned with the top of
the head of the person seated.
Heated seat control
Press the switch on the dashboard to turn on
the driver's seat heating.
The indicator lamp in the switch comes on.
The temperature is controlled automatically.
Pressing a second time stops operation.
F

T

o raise it, pull it upwards.
F

T

o lower it, push it down while pressing the
height adjustment button.
F

T

o remove it, move it to the high position,
then remove it while pressing the height
adjustment button.
F

T

o replace it, engage the head restraint
rods in the holes while pressing the height
adjustment button.
Ease of use and comfort

54
Airbags
The airbags do not operate when the
ignition is switched off.
This equipment will only deploy once. If a
second impact occurs (during the same or
a subsequent accident), the airbag will not
be deployed again.
Impact detection zones
A.Front impact zone.
B. Side impact zone.
Airbag deployment generates slight
smoke emissions and a noise, due to the
activation of the pyrotechnic cartridge
incorporated in the system.
This smoke is not harmful, but sensitive
individuals may experience slight irritation.
The detonation noise associated with the
deployment of an air bag may result in a
slight loss of hearing for a short time.
The airbags are designed to help enhance the
safety of occupants in the event of a serious
collision. They complement the action of the
safety belts equipped with force limiters.
If a collision occurs, the electronic detectors
record and analyse the front and side impacts
sustained in the impact detection zones:
-

i

f there is a violent impact, the airbags
deploy instantly and help better protect
occupants of the vehicle; immediately after
the impact, the airbags deflate rapidly
in order not to hinder the visibility or the
possible exit of the occupants.
-

i

n the case of a minor or rear impact or in
certain roll-over conditions, the airbags
may not be deployed; the seat belt
alone contributes towards ensuring your
protection in these situations.
Front airbags
This system protects the driver and front
passenger from the risk of injury to the head
and chest in the event of a severe frontal
impact.
The driver's airbag is fitted in the centre of the
steering wheel; the front passenger's airbag is
fitted in the dashboard above the glove box.
Activation
The airbags are deployed (except the
passenger's front airbag if it is deactivated) in
the event of a severe frontal impact to all or part
of the frontal impact zone A , in the longitudinal
centreline of the vehicle on a horizontal plane
and directed from the front to the rear of the
vehicle.
The front airbag inflates between the front
occupant of the vehicle and the dashboard, to
cushion their forward movement.
Safety

56
Advice
For the airbags to be fully effective,
observe the safety recommendations
below.
Adopt a normal and upright sitting position.
Wear a correctly adjusted seat belt.
Do not leave anything between the occupants
and the airbags (a child, pet, object, etc.), nor
fix or attach anything close to or in the way of
the airbag release trajectory; this could cause
injuries during their deployment.
Never modify the original definition of your
vehicle, particularly in the area directly
around the airbags.
After an accident or if the vehicle has been
stolen, have the airbag systems checked.
All work on the airbag systems must be
carried out by a PEUGEOT dealer or a
qualified workshop.
Even if all of the precautions mentioned
are obser ved, a risk of injury or of minor
burns to the head, chest or arms when an
airbag is deployed cannot be ruled out. The
bag inflates almost instantly (within a few
milliseconds) then deflates within the same
time discharging the hot gas via openings
provided for this purpose.Front airbags
Do not drive holding the steering wheel by its
spokes or resting your hands on the centre
part of the wheel.
Passengers must not place their feet on the
dashboard.
Do not smoke as deployment of the airbags
can cause burns or the risk of injury from a
cigarette or pipe.
Never remove or pierce the steering wheel or
hit it violently.
Do not fit or attach anything to the steering
wheel or dashboard, this could cause injuries
in case of airbag deployment.
Lateral airbags
Use only approved covers on the seats,
compatible with the deployment of the lateral
airbags. For information on the range of seat
covers suitable for your vehicle, contact a
PEUGEOT


dealer.
Do not attach anything to or hang anything
from the seat backrests (clothes, etc.) as
this could cause injuries to the thorax or arm
when the lateral airbag is deployed.
Do not sit with the upper part of the body any
nearer to the door than necessary. Curtain airbags
Do not attach anything or hang anything to
the roof, as this could cause head injuries
when the curtain airbag is deployed.
If fitted to your vehicle, do not remove the
grab handles installed on the roof, they play a
part in securing the curtain airbags.
Safety

75
Recharging the main
battery
Two types of charging are available: normal or
fast.
Normal charging is the preferred procedure; it
is carried out via a domestic electricity network.
Fast charging is carried out via a compatible
fast charging point.
Normal charging
* (e.g. for France: Standard NF C 15 -100)During charging
, if you have a
pacemaker or another electric
medical device, you must not
stay inside or close to the
vehicle, the charging cable,
the charging unit or just the
charging point, even for a short
time.
It is crucial to speak to your
doctor and find out about the
precautions to take, and to
respect them. Before making any connection, check that
the electrical installation that you want to
use meets standards* and is compatible
with the amperage of your control unit.
In case of doubt, contact a professional
installer.
There are power points available that are
designed specifically for charging electric
vehicles.
For power points dedicated to charging an
electric vehicle, refer to the corresponding
installation recommendations.
In all cases, it is recommended that
you first have an initial check and then
regular checks on your installation
carried out by a qualified electrician.
In most European countries, PEUGEOT
has established a partnership with a
specialist company that can offer a
check and update of your electrical
installation. For more information, contact
a PEUGEOT dealer.
Use only the original PEUGEOT charging
cable.
F
A
pply the parking brake and place the drive
selector in position P .
F
S
witch off the electrical consumers and turn
the ignition switch to position " LOCK".
In the event of damage to the charging
cable or control unit, stop use immediately.
For replacements, or in case of doubt,
contact a PEUGEOT dealer.
F
P
ull lever 1 on the lower part of the
dashboard, driver's side, to open the access
flap to the normal charging socket (right-
hand side of the vehicle).
7
Practical information

101
Changing a fuse
Access to the tools
The extraction tweezers are fitted to the back
of the dashboard fusebox cover.
To access them:
F
U
nclip the protective cover and remove it
completely by pulling it towards you.
F

P
ull out the tweezers.
Changing a fuse
Good Failed
Tw e e z e r s
Before changing a fuse, the cause of the fault
must be found and rectified.
F

M

ake sure that the ignition switch is set to
the " LOCK " position.
F

I

dentify the failed fuse by checking the
condition of its filament.
F

U

se the special tweezers to extract the fuse
from its housing.
F

A

lways replace the faulty fuse with a fuse of
the same rating.
F

C

heck that the number marked on the
fusebox, the rating marked on the fuse and
the following tables all agree. Your vehicle's electrical system is
designed to operate with standard or
optional equipment.
Before installing other electrical
equipment or accessories on your vehicle,
contact a PEUGEOT dealer or a qualified
workshop.
PEUGEOT accepts no responsibility for
the cost incurred in repairing your vehicle
or for rectifying malfunctions resulting
from the installation of accessories
not supplied and not recommended by
PEUGEOT and not installed in accordance
with its specifications, in particular when
the combined power consumption of all
of the additional equipment connected
exceeds 10
mil

liamperes.
F

T

urn the bulb holder and remove it.
F

R

emove the bulb and replace it.
To refit, carry out these operations in reverse
o r d e r.
8
In the event of a breakdown

102
Fuses in the dashboard
The fusebox is located in the lower dashboard.
Access to the fuses
F
U
nclip the protective cover and remove it
completely by pulling it towards you. Fuse No.
Rating Functions
1 7. 5 AFront and rear left sidelamps.
2 15 AAccessory socket.
3 -Not used.
4 7. 5 AStarter motor.
5 20 AAudio system.
6 -Not used.
7 7. 5 ADashboard consumers, front and rear right sidelamps.
8 7. 5 AElectric door mirrors.
9 7. 5 ASupervisor.
10 7. 5 AAir conditioning.
11 10 ARear foglamp.
12 15 ADoor locks.
13 10 ACourtesy lamp.
In the event of a breakdown