Peugeot Partner VP 2005 Owner's Guide

32 -
01-02-2005
33
-
01-02-2005
RDS
Using the RDS (Radio Data
System) function on FM
Radio Data System allows you to
continue listening to the same sta-
tion, whatever frequency it is using
for the region you are going through. Trafic information programme Regional following mode (REG)
RDS station following
The display indicates the name of the
station selected. The radio is contin-
ually searching for the station which
has the best reception and which is
transmitting the same programme. Press the
"TA" button
to switch the function
on or off.
The multi-function dis-
play will show:
- "TA" if the function is selected,
- "(TA)" if the function is selected but
not available.
Any trafic information lash will be
given priority, whatever source you
are listening to (radio, cassette, CD
or CD changer).
If you wish to interrupt a message,
press the "TA" button; this switches
the function off.
Note: the volume of trafic infor-
mation announcements is inde-
pendent of the volume of normal
radio listening. You can adjust
it using the volume button. The
setting will be stored and will be
used when the next messages are
broadcast.
Briely press the
"RDS"
button to switch
the function on or off.
The multi-function display will show:
- "RDS" if the function is selected.
- "(RDS)" if the function is selected
but not available. When they are part
of a network, certain
stations broadcast re-
gional programmes in
the various areas they
serve. With regional following mode
you can keep listening to the same
programme.
Press the "RDS" button for more
than two seconds to switch the REG
function on or off.
Audio equipment

34 -
01-02-2005
35
-
01-02-2005
CASSETTE: AUDIO RB3
Selecting cassette mode Recommendations for using
casssettes
- Use good quality cassettes.
- Avoid the use of cassettes which
play for longer than 90 minutes.
- Never expose the cassettes to heat or the direct rays of the sun.
- Re-tighten the tape if necessary before inserting the cassette in the
player.
- Clean the playing head regularly with a damp type cleaning cas-
sette.
When a cassette is
inserted, the cassette
player will start auto-
matically.
If a cassette is already inserted,
press button "SRC" several times to
select cassette mode.
Note: before inserting the cassette,
ensure that the tape is taut.
Ejecting the cassette Direction of play
The player will play sides 1 and 2 of
the cassette alternately, by automati-
cally reversing the direction of play at
the end of a side.
To manually reverse the direction of
play, press the 2 buttons
F and G
half way.
Fully press buttons F
and G to eject the cas-
sette from the player. Fast forward/rewind
Fully press button
F or G to fast for-
ward or rewind the cassette. At the
end of the fast forward/rewind, the
set plays the current side.
Audio equipment

36 -
01-02-2005
37
-
01-02-2005
Accelerated play
Keep button L or N pressed for for-
wards or backwards accelerated
play.
Accelerated play stops as soon as
the button is released.
Audio RB3: press the
"SRC" button several
times in succession.CD CHANGER
Selecting CD changer mode
The use of copied compact
discs may cause faults.
Insert circular compact discs
only.
Selecting a disc
Press buttons
"1" to "6" of the radio
to select the corresponding disc.
Press button L to select the next
track.
Press button N to return to the start
of the current track or to select the
previous track.
Audio RD3:
press
button P. Selecting a track
Shufle (RDM)
When the CD changer is selected:
- audio RB3: keep the "SRC" but-
ton pressed for two seconds;
- audio RD3: keep button P pressed
for two seconds.
The tracks will be played in random
sequence. Pressing the button again
for two seconds returns you to nor-
mal play.
Audio equipment

28 -
01-02-2005
29
-
01-02-2005
AUDIO RD3
Stalk movement Function
1 - Press (behind) Increase volume
2 - Press (behind) Decrease volume
1+2 - Simultaneous press Sound cut-off (mute); restoring of the sound by pressing any button
3 - Press Automatic search of higher frequencies (radio) - Selection of th e next track (CD)
4 - Press Automatic search of lower frequencies (radio) - Selection of the previous track (CD)
5 - Press the end Change of source (radio/CD/CD changer)
6 - Rotation
(clockwise) Selection of next station stored in memory (radio) - Selection of f
ollowing CD
7 - Rotation
(anti-clockwise) Selection of previous station stored in memory (radio) - Selection of
previous CD
Audio equipment

28 -
01-02-2005
29
-
01-02-2005
Button Function
A Radio on/off
B - Decrease volume
C + Increase volume
D RDS RDS function on/off
Press for more than 2 seconds: regional following mode on/off
E TA Trafic information priority on/off
Press for more than 2 seconds: PTY function on/off
H
¯Selection of bass, treble, loudness, sound distribution and automatic volume correction
I
5Increase the setting of the functions associated with button H
J
6Decrease the setting of the functions associated with button H
L
8Manual and automatic search of higher frequency
Selection of next CD track and PTY (radio)
M MAN Manual/automatic operation of buttons L and N
N
7Manual and automatic search of lower frequency
Selection of previous CD track and PTY (radio)
P CH.CD Selection of CD changer
Press for more than 2 seconds: shufle
Q CD Selection of CD
Press for more than 2 seconds: shufle
R Radio Selection of radio. Selection of FM1, FM2, FMAST, AM wavebands
Press for more than 2 seconds: automatic storing of stations in memory
(autostore)
S
5Ejection of CD
1 to 6 1 2 3 4 5 6 Selection of station stored in memory - Selection of a CD change
r disc
Press for more than 2 seconds: storing of a station in memory
Audio equipment

30 -
01-02-2005
31
-
01-02-2005
RADIO
Notes on radio reception
Your car radio is subject to pheno-
mena which do not affect domestic
radio sets. Both AM (MW/LW) and
FM reception are subject to various
forms of interference. This is no re-
lection on the quality of the equip-
ment, but is due to the nature of the
signals and the way in which they are
transmitted.
On MW/LW, interference may be
noticed when passing under high
voltage power lines or bridges, or in
tunnels.
On FM, interference may be the result
of increasing distance from the trans-
mitter, delection of the signals by
obstacles (mountains, hills, buildings,
etc.), or of being in an area which is
not covered by a transmitter. Selecting a waveband
Adjusting the front/rear sound
distribution (Fader)
When
"FAD" is displayed, press
button I or J.
Button I increases the volume in the
front.
Button J increases the volume in the
rear.
Adjusting the right/left sound
distribution (Balance)
When "BAL" is displayed, press
button I or J.
Button I increases the volume on the
right-hand side.
Button J increases the volume on the
left-hand side.
Automatic volume correction
This function enables the volume to
be automatically adjusted depending
on the level of noise produced by the
speed of the vehicle.
Press buttons I or J to switch the
function on or off. Audio RB3:
press the
"SRC" button several
times in succession.
Selecting radio mode
Audio RD3: press
button R.
Audio RB3: briely
press the "BND/AST"
button to select the
FM1, FM2, FMast and
AM wavebands.
Audio RD3: briely
press button R to
select the FM1, FM2,
FMast and AM wave-
bands.
Audio equipment

32 -
01-02-2005
33
-
01-02-2005
Briely press button L or N to search
for the station immediately above or
below. By continuing to press the
button in the direction selected, you
will obtain continuous scrolling of the
frequency.
The scrolling stops at the irst sta-
tion found as soon as the button is
released.
If the TA trafic information pro-
gramme is selected, only stations
broadcasting this type of programme
are selected.
Searching for a station occurs irst
in "LO" sensitivity (selection of the
most powerful transmitters) during
scanning of the waveband, then in
"DX" sensitivity (selection of the
weakest and most distant transmit-
ters).
To make a direct search in "DX" sen-
sitivity, press button L or N twice. Manual station search
Press the
"MAN" button.
Briely press button L or N to in-
crease or decrease the frequency
displayed.
By continuing to press the button
in the direction selected, you will
obtain continuous scrolling of the
frequency.
The scrolling stops as soon as the
button is released.
Pressing the "MAN" button again
returns you to automatic station
search.
Manual storing of stations in
the memory
Select the station required.
Press one of the buttons "1" to "6"
for more than two seconds.
The sound stops then becomes audi-
ble again, conirming that the station
has been stored in the memory.
Automatic station search
Automatic storing of FM stations
in the memory (autostore)
Audio RB3: press
and hold the "BND/
AST" button for more
than two seconds.
Audio RD3: press and
hold button R for more
than two seconds.
Your radio automatically stores the
6 stations with the strongest signal in
FM . These stations are stored in the
FMast waveband.
If it is not possible to ind 6 stations,
the remaining memories are empty.
Recalling stations stored in
the memory
For each waveband, briely press
buttons "1" to "6" to recall the cor-
responding station.
Audio equipment

32 -
01-02-2005
33
-
01-02-2005
RDS
Using the RDS (Radio Data
System) function on FM
Radio Data System allows you to
continue listening to the same sta-
tion, whatever frequency it is using
for the region you are going through. Trafic information programme Regional following mode (REG)
RDS station following
The display indicates the name of the
station selected. The radio is contin-
ually searching for the station which
has the best reception and which is
transmitting the same programme. Press the
"TA" button
to switch the function
on or off.
The multi-function dis-
play will show:
- "TA" if the function is selected,
- "(TA)" if the function is selected but
not available.
Any trafic information lash will be
given priority, whatever source you
are listening to (radio, cassette, CD
or CD changer).
If you wish to interrupt a message,
press the "TA" button; this switches
the function off.
Note: the volume of trafic infor-
mation announcements is inde-
pendent of the volume of normal
radio listening. You can adjust
it using the volume button. The
setting will be stored and will be
used when the next messages are
broadcast.
Briely press the
"RDS"
button to switch
the function on or off.
The multi-function display will show:
- "RDS" if the function is selected.
- "(RDS)" if the function is selected
but not available. When they are part
of a network, certain
stations broadcast re-
gional programmes in
the various areas they
serve. With regional following mode
you can keep listening to the same
programme.
Press the "RDS" button for more
than two seconds to switch the REG
function on or off.
Audio equipment

34 -
01-02-2005
35
-
01-02-2005
EON system: Audio RD3
This connects stations which are part
of the same network. It enables the
broadcast of trafic information, by a
station that is part of the same net-
work as the station to which you are
listening.
This service is available when you
have selected the TA trafic informa-
tion programme or the PTY function.
PTY function: Audio RD3
This allows you to listen to stations
broadcasting a speciic type of pro-
gramme (news, culture, sport, rock,
etc.).
To search for a
PTY programme:
With FM selected,
press the "TA" but-
ton for more than two
seconds to switch the
function on or off. - select the
PTY function,
- briely press button L or N to scroll
down the list of the various types of
programmes offered,
- when the programme of your choice is displayed, keep button L or N
pressed for more than two seconds
to carry out an automatic search
(after an automatic search the PTY
function is switched off).
In PTY mode the different types of
programmes can be stored in the
memory. To do this, press the prese-
lection buttons "1" to "6" for more
than two seconds. Briely press the
corresponding button to recall the
type of programme stored in the
memory.
Audio equipment

36 -
01-02-2005
37
-
01-02-2005
Ejection of a disc Shufle (RDM)
When the CD player is selected,
keep button
Q pressed for two sec-
onds. The tracks will be played in
random sequence. Pressing the
button again for two seconds returns
you to normal play.
Shufle mode is de-activated each
time the audio system is switched
off.
After insertion of a
disc, printed face
upwards, the player
starts automatically.
If a disc is already inserted, press
button Q.
COMPACT DISC: AUDIO RD3
Selecting CD mode
The use of copied compact
discs may cause faults.
Insert circular compact discs
only.
Selecting a track
Press button
L to select the next
track.
Press button N to return to the start
of the current track or to select the
previous track.
Press button S to
eject the disc from the
player. Accelerated play
Keep button
L or N pressed for for-
wards or backwards accelerated
play.
Accelerated play stops as soon as
the button is released.
Audio equipment