Peugeot Partner VP 2007 Service Manual

42 -
AIR CONDITIONING
The air conditioning does not op-
erate while the air flow adjustment
control is in the minimum position.
Note: to optimise the operation of
the air conditioning, leave the vents
open.
Press the switch to activate
the air conditioning. The indi-
cator light comes on. 2. Air flow adjustment and air
intake control
Turn the control from posi-
tion 1 to position 4 to obtain
an air flow sufficient to en-
sure your comfort.
1. Air conditioning control
The air conditioning is designed to op-
erate in all seasons. In summer, it en-
ables the temperature to be lowered
and in winter, above 0 °C, it increases
the effectiveness of the demisting.
Ventilation

43Ventilation-
This position prevents exterior odours
and smoke entering the passenger
compartment.
Used simultaneously with the air con-
ditioning, recirculation enables both
heating and cooling performance to
be improved.
Used without the air conditioning,
recirculation may result in misting of
the windows.
As soon as possible, position the
control in the exterior air intake posi-
tion.To quickly de-ice or demist the wind-
screen and side windows:
- turn the temperature and air flow
controls to maximum,
- close the centre vents,
- position the air intake control in the "Outside Air" position,
- start the air conditioning.
Intake of exterior air.
4. Air distribution adjustment
Windscreen and side windows
(de-icing/demisting).
This is the normal operating position.
Recirculation of interior air.
3. Temperature adjustment
To be adjusted to your requirements.
From blue (cold when the air condi-
tioning is on) to red (hot). Windscreen, side windows
and footwells.
Footwells.
These settings are recommended for
cold climates. Centre and side vents.
This setting is recommended for high
temperatures. Additional heater
Vehicles which are fitted with an HDI
engine may be fitted with automatic
additional heating to improve your
comfort.
When the engine is idling or the vehi-
cle is stationary, it is quite normal to
notice a high-pitched whistling noise
and a slight emission of smoke and
odour.

Seats and bench seats44 -
FRONT SEATS
1. Head restraint height adjustment
To raise or lower the restraint, slide
it.
The adjustment is correct when
the upper edge of the head
restraint is level with the top of
the head.
To remove the head restraint, place it
in the top position, press the tabs and
pull it upwards.
To put it back in position, locate the
stems of the restraint in the holes,
taking care to keep them in line with
the seat back.
2. Armrests
These can be folded back.
3. Seat back angle adjustment
A. Turn the knob.
B. Pull the lever (version with one
sliding side door only).

45Seats and bench seats-
4. Forwards-backwards
adjustment
Lift the control and slide the seat for-
wards or backwards.
5. Storage drawer (version with passenger air bag)
There is a storage drawer under the
front passenger seat.
To open it, lift it and pull. 7. Heated seats switch
(according to model)
Press the switch. The temperature is
controlled automatically.
Pressing the switch again stops op-
eration.
Note: the command for activation of
heating of the seat(s) remains mem-
orised for two minutes after the igni-
tion has been switched off.
No person or object must
prevent the seat from return-
ing to its initial position; re-
turn to this position is neces-
sary for the seat to lock in place. Never drive with the head re-
straints removed; they must
be in place and correctly ad-
justed.
Do not place heavy objects in the
drawers.
6. Access to rear seats
(version with one sliding
side door only)
Lift the control to fold the seat back
and move the seat forwards.
On repositioning, the seat returns to
its initial position (driver’s side).

Seats and bench seats46 -
REAR SEAT
To fold the rear seat:
- lower the head restraint,
- press control 1 to unlock the seat
back 2, - fold the seat back
2 onto the seat,
- place the seat in the "folded" position.When repositioning:
- tilt the folded seat rearwards,
- lift the seat back,
- check that the seat is locked correctly.
Take care not to trap the seat
belts.

Seats and bench seats48 -
GENERAL POINTS RELATING
TO CHILD SEATS
Although one of PEUGEOT’s main
criteria when designing your vehicle,
the safety of your children also de-
pends on you.
For maximum safety, please follow
these precautions:
- in accordance with Directive 2003/20, all children under the age of
12 or less than one metre fifty
tall must travel in approved child
seats suited to their weight , on
seats fitted with a seat belt or ISO-
FIX mountings*.
- statistically, the safest seats in
your vehicle for the transpor-
tation of children are the rear
seats,
- a child weighing less than 9 kg
must travel in the "rearwards-
facing" position both in the front
and in the rear.
PEUGEOT recommends that chil-
dren should travel in the rear seats
of your vehicle:
- "rearwards-facing" up to the age
of 2,
- "forwards-facing" over the age of
2.
INSTALLING A CHILD SEAT
USING A THREE POINT SEAT
BELT
"Rearwards-facing"
When a "rearwards-facing" child seat
is installed on the front passenger
seat , it is essential that the passen-
ger air bag** is disarmed. Otherwise,
the child would risk being seri-
ously injured or killed if the air bag
were to inflate . "Forwards-facing"
When a "forwards-facing" child seat
is installed on the
front passenger
seat , adjust the vehicle’s seat to the
intermediate longitudinal position
with the seat back upright and leave
the passenger air bag armed**.
* The rules for transporting children are specific to each country. Con-
sult the current legislation in your
country.
** According to model. Intermediate longitudinal position

49Seats and bench seats-
Passenger air bag OFF**
CHILD SEATS RECOMMENDED BY PEUGEOT
PEUGEOT offers a complete range of recommended child seats which
are secured using a three point seat belt :
Group 0: from birth to 10 kg
Group 0+: from birth to 13 kg
L1
"BRITAX
Babysure"
(E11 0344117) Installed in the rear-facing position. L2

"ROMER
Baby-Safe Plus" (E1 03301146) Installed in the rear-facing position.
Groups 1, 2 and 3: from 9 to 36 kg
L3
"KIDDY Life"
(E1 03301135)
For the safety of young children (from 9 to 18 kg), PEUGEOT recommends use of the restraining cushion.
Groups 2 and 3: from 15 to 36 kg
L4
"RECARO Start’’ (E1 03301108). L5
"KLIPPAN Optima" (E17 030007) From the age of 6 years
(approximately
22 kg), the booster is used on its own.
** According to version.

Seats and bench seats50 -
INSTALLING CHILD SEATS SECURED USING THE SEAT BELT
In accordance with the European regulation (Directive 2000/3), this table indicates the options for the installation of child
seats secured using the seat belt and universally approved (a), in accordance with the weight of the child and the seat in the
vehicle:
(a) Universal child seat: child seat which can be installed in all
vehicles using the seat belt.
(b) Group 0: from birth to 10 kg. Seat
Weight of the child and indicative age
Below 13 kg
(groups 0 (b) and 0+)
Up to 1 year approx
From 9 to 18 kg
(group 1)
From 1 to 3 years approx From 15 to 25 kg
(group 2)
From 3 to 6 years approx From 22 to 36 kg
(group 3)
From 6 to 10 years
approx
Front passenger
seat (c) U U U U
Rear side seat U U U U
Rear centre seat U U U U
(c) Consult the legislation in force in your country before installing
your child on this seat. U
Seat suitable for the installation
of a child seat secured using
a seat belt and universally
approved, "rear facing" and/or
"forward facing".

51Seats and bench seats-
ADVICE ON CHILD
SEATS
The incorrect installation of a child
seat in a vehicle compromises the
child’s protection in the event of an
accident.
Remember to fasten the seat belts
or the child seat harnesses keeping
the slack in relation to the child’s
body to a minimum , even for short
journeys.
For optimum installation of the "for-
ward facing" child seat, ensure that
the back of the child seat is in contact
with the back of the vehicle’s seat
and that the head restraint does not
cause any discomfort.
If the head restraint has to be re-
moved, ensure that it is stored or at-
tached securely to prevent it from be-
ing thrown around the vehicle in the
event of sharp braking. Children under the age of 10 must not
travel in the "forward facing" position
on the front passenger seat, unless
the rear seats are already occupied
by other children, cannot be used or
are absent.
Disarm the passenger air bag* when
a "rear facing" child seat is installed
on the front seat. Otherwise, the child
would risk being seriously injured or
killed if the air bag were to inflate.
As a safety precaution, do not leave:
- one or more children alone and un-
supervised in a vehicle,
- a child or an animal in a vehicle which is exposed to the sun, with
the windows closed,
- the keys within reach of children in- side the vehicle.
To prevent accidental opening of the
doors, use the "Child lock"*.
Take care not to open the rear win-
dows by more than one third*.
To protect young children from the
rays of the sun, fit side blinds on the
rear windows.
* According to version.
Installing a booster seat
The chest part of the seat belt must
be positioned on the child’s shoulder
without touching the neck.
Ensure that the lap part of the seat
belt passes correctly over the child’s
thighs.
PEUGEOT recommends the use of
a booster seat which has a back, fit-
ted with a seat belt guide at shoulder
level.

Seats and bench seats52 -
"ISOFIX" MOUNTINGS
Your vehicle has been approved in ac-
cordance with the ISOFIX regulation.
The seats*, represented below, are fit-
ted with regulation ISOFIX mountings: These are two rings located between
the seat back and the seat cushion.
This ISOFIX mounting system guar-
antees reliable, safe and fast fitting of
the child seat in your vehicle.
The
ISOFIX child seats are fitted
with two locks which are secured
easily on these rings.
* According to version.