Peugeot Partner VP 2007 Manual PDF

Visibility68 -
Windscreen wipers
2 Fast wipe (heavy rain).
1 Normal wipe (moderate rain).
l Intermittent wipe.
0 Off.
 Single wipe (press downwards).
WINDSCREEN WIPER STALKWindscreen and headlamp wash
Pull the windscreen wiper stalk to-
wards you. The windscreen wash
then the windscreen wipers operate
for a fixed period.
The headlamp wash is also activa-
ted, if the headlamps are on .Rear windscreen wash
Turn ring
A past the first
notch: the windscreen wash
then the windscreen wiper
operate for a fixed time.
Rear windscreen wiper
Turn ring A to the first notch.
The wiping speed is inverse-
ly proportional to the speed
of the vehicle.
In winter, in the event of
a considerable amount of
snow or ice, switch on the
rear screen demister. Once
de-icing is complete, remove the
snow or ice which has accumulated
on the rear wiper blade. You can now
operate the rear windscreen wiper.
Operation
In position
1 or 2, when the vehicle
stops, the windscreen wiper chang-
es to a lower wiping speed, then
resumes its initial speed when the
vehicle starts again.
In the Intermittent position, the wiping
speed is proportional to the speed of
the vehicle. Automatic rear windscreen
wiping

place the front wipers stalk in a
position other than 0.
 engage reverse gear.
 the rear wiper operates with inter-
mittent wiping.
Note: if a bicycle carrier is used, con-
tact a PEUGEOT dealer to have this
function disarmed.

69Visibility-
On vehicles fitted with this stalk, in
the AUTO position, the wipers op-
erate automatically and adapt their
speed to the intensity of the rain-
fall .
For the other positions, when not in
AUTO mode, refer to the operation of
the windscreen wipers.
The command must be reactiva-
ted whenever the ignition has
been switched off for more than
one minute:
- move the stalk to any position,
- then move it back to the required position.
Operating check
Activation
Activation of the function is accom-
panied by a message on the multi-
function display.
In the event of malfunction , the driv-
er is informed by an audible signal.
In the AUTO position, the wind-
screen wiper will operate in intermit-
tent mode.
Contact a PEUGEOT dealer to have
the system checked.
Do not cover the rain sensor
located on the windscreen
behind the interior mirror.
When using an automatic
car wash, switch off the ignition or
check that the wiper stalk is not in the
AUTO position.
In winter, it is advisable to wait for the
windscreen to completely clear of ice
before operating the automatic wipe.
Vehicles fitted with an
automatic wipers stalk

Visibility70 -
TRIP COMPUTER
Pressing the button on the end of the
wash/wipe stalk enables the follow-
ing data to be displayed:
Screen B
- the range
- the distance travelled
- the average consumption
- the current consumption
- the average speed
- return to the date display
Zero reset
Press the stalk for more than two
seconds. Range
This shows the distance that can still
be covered with the fuel remaining in
the tank.
Note:
this figure may increase if there
is a change in the style of driving or
the road surface, producing a signifi-
cant drop in current consumption.
When the range is less than 20 miles
(30 km), three segments are dis-
played. After filling with fuel, the
range is displayed when it exceeds
60 miles (100 km).
If horizontal segments are displayed
for long periods instead of digits,
contact a PEUGEOT dealer. Current consumption
This is the average quantity of
fuel consumed during the last few
seconds.
This function is displayed only when
the vehicle is travelling at a speed
greater than 20 mph (30 km/h).
Average consumption
This is the average fuel consumption
since the computer was last set to
zero.Distance travelled
This indicates the distance travelled
since the computer was last set to
zero.
Average speed
This is the average speed calculated
since the computer was last set to
zero (with the ignition on).

71Visibility-
ELECTRIC WINDOWS
1. Driver’s electric window switch
2. Passenger electric window switch
You have two options:
- Manual operation:
Press switch 1. The window stops
as soon as the switch is released.
- Automatic operation (driver):
Press and hold switch 1. One touch
completely opens or closes the
window.
Automatic closing only operates
when the engine is running. Always remove the ignition
key when leaving the vehi-
cle, even for a short time.
If an obstacle is encountered
while the electric windows are in use,
you must reverse the movement of
the window. To do this, press the
switch concerned.
When the driver operates the pas-
senger electric window switches, he
must ensure that no one is prevent-
ing correct closing of the windows.
The driver must ensure that passen-
gers use the electric windows cor-
rectly.
Be aware of children when operating
the windows.
REAR WINDOWS
To partially open the rear windows,
tilt the lever and push it fully to lock
the windows in the open position.

Visibility72 -
Manual exterior mirrors
Move the lever in all four directions
to adjust.
When the vehicle is parked, the ex-
terior mirrors can be folded back
manually.
Passenger side exterior
mirror electric control
From the driver’s seat, move the con-
trol 1 in all four directions to adjust.
Manual interior mirror
The interior mirror has two positions:
- day (normal),
- night (anti-dazzle).
To change from one to the other,
push or pull the lever on the lower
edge of the mirror.

73Comfort and safety-
HEADLAMP
ADJUSTMENT
Depending on the load in your vehi-
cle, it is recommended that the head-
lamp beam is adjusted.
0. 1 or 2 people in the front seats.
-. 3 people.
1. 5 people.
2. 5 people + maximum authorised
load.
3. Driver + maximum authorised
load.
Initial setting is position 0.
STEERING WHEEL HEIGHT
ADJUSTMENT
When stationary, lower the handle to
unlock the steering wheel.
Adjust to the desired height and
lift the handle to lock the steering
wheel.
HORN
HAZARD WARNING LIGHTS
Press the button, the direction indica-
tors flash.
They can operate with the ignition off. Press one of the spokes or
the centre of the steering
wheel.

Comfort and safety74 -

75Comfort and safety-
FRONT FITTINGS
1. Storage in the doors
A. Bottle holder.
B. Can holder.
C. Storage compartment.
2. Overhead storage
Maximum load: 5 kg.
Map reading lights
Turn the dial to the right or to the left to switch them on.
Place the dial in the centre to switch them off. 3. Courtesy lights 4. Sun visors
5. Glove box
6. Lighter
7. Removable ashtray
Pull the cover to open the ash-
tray.
To empty, after opening, remove it by pulling upwards.
8. 12 V accessories socket
This is located at the bottom of the centre console.
It permits the connection of a telephone charger, a baby’s bot-
tle warmer, ...
9. Storage drawer
To open the drawer, lift it slightly and pull it forwards.
Permanently off.
On entering the vehicle:
- they come on when the ve-
hicle is unlocked or when a
door is opened,
- they switch off after approximately 30 seconds with the doors closed,
or when the ignition is switched on.
On leaving the vehicle:
- they come on when the key is re- moved from the ignition (timing of
approximately 30 seconds) or when
a door is opened,
- they switch off after approximately 30 seconds with all of the doors
closed, or immediately when the
vehicle is locked.
In this position, the courtesy light
may flash while driving if a door is not
closed correctly.
If a door is open, it will switch off auto-
matically after approximately 10 minutes
or when the ignition is switched on.
Permanently on when the
key is in the accessories po-
sition or the ignition is on.

Comfort and safety76 -

77Comfort and safety-
REAR LAYOUT
1. Trays between the front and rear seats
2. Load-space cover
To install it:
- position the front ends of the load space cover on its support and
press gently to put it in place,
- unfold the load space cover fully,
- position the rear ends of the load space cover on its support and
press gently to put it in place.
To remove it:
- unclip the rear ends,
- fold the load space cover fully,
- unclip the front ends and remove the load space cover.
To store it, fold it like an accordion. Do not roll it.
3. Stowing rings 4. High load retaining net
The high load retaining net can be fit-
ted behind the front or rear seats.
Open the covers
A of the correspond-
ing upper fastenings.
Fit the ends of the metal bar in these
fastenings.
Secure the two net strap hooks be-
hind the front seats, with the rear
seat folded, or in the stowing rings B
on the floor.
The rings are located directly below
the corresponding upper fastenings.
Pull the two straps C taut.
5. Side door storage compartments
6. Seat back storage pockets
7. Storage net