Peugeot Partner VU 2001 Owners Manual

70 A
60 A
50 A
40 A
20 A
30 A
25 A
20 A
15 A
10 A
5 A
FuseAmperageSupply type Functions protected
F5 20 A Battery +BSI
F6 30 A Battery +Free
F7 20 A Battery +Additional heating burner
F14 SHUNTBattery +Injection double relay
F18 10 A Front right hand main beam
F19 10 AFront left hand main beam
F20 10 A
Ignition onABS ECU
F21 5 A Battery + Additional heating relay
F22 20/30 A Battery +Diesel heating relay
F23 15 A Ignition onDiesel heater
F24 5 A Ignition onFree
F25 15 A Ignition onFuel pump
F26 SHUNTBattery +Double injection relay
F27 30 A Battery + Free
F28 5/10 A Ignition onThrottle housing heater (petrol)/
Injection pump (diesel)
F29 30 A Battery + Free
F30 10 A Battery +Front left hand fog lamp
F31 10 A Battery +Front right hand fog lamp
F32 5/10 AIgnition onInjection ECU
F33 15 A Ignition on Reverse lamps Ð Coolant level
Preheater unit Ð Cooling fan unit
F34 5 A Ignition on Exhaust sensor
Engine compartment fuses
Unclip the cover. The unnumbered fuses are spares. After repairs, reposition the cover
very carefully.
93
VI-1TABLE OF FUSES
(According to specification or country)
FUSE COLOUR CHART
Maxi-fuses Fuses

95
VI-3BULB CHART
Headlamps H4 Halogen 60/55 W
Side lamps W 5 W
Direction indicators PY 21 W - Orange bulb Direction indicator side repeaters W 5 W FRONT
REAR
Brake and side lamps P 21 / 5 W Direction indicators PY 21 W - Orange bulbReversing lamps P 21 W Rear fog lamp P 21 W
Number plate lamps W 5 W
Additional brake lamp (Third brake lamp) W 5 W
INTERIOR
Courtesy lamps W 5 W

Headlamps Removal :
- Disconnect the connector and release the rubber protector.
- Unclip the two retaining clips.
- Remove the bulb. Refitting :
Proceed in the reverse order.
96VI-4CHANGING BULBS
The headlamps should be switched off for a few minutes before the halogen bulbs are changed. Do not touch the bulb directly with your fingers,use a lint-free cloth.
Advice
At the end of each operation, check that the lights are working properly.

97
Front direction indicators and side lamps Open the bonnet, press the tab and push the lamp unit outwards. Turn the bulb base one quarterturn and change the bulb. Replace the lamp unit, engaging the two upper and lower guides.Push the lamp unit into position.Direction indicator siderepeaters Push the unit forwards to unclip it and pull it towards you.
Turn the bulb holder one quarterturn.
VI-4CHANGING BULBS

1
2
3
4
A
98
Rear lamps Note the position of the faulty bulb. Bulbs : 1 Fog lamp
2 Direction indicator lamp
3 Reversing lamp
4 Brake lamp - Side lamp Open the rear door to 180¡ on the side of the faulty bulb (see ÒOPEN-
ING THE DOORSÓ). Unscrew the butterfly nut
A.
Gently push the lamp unit towards the inside of the vehicle to releasethe two side retaining lugs. Remove and disconnect the lamp unit. Unclip the bulb holder as indicatedby the arrows. Change the faultybulb.When refitting, ensure that thegrommet is properly seated andclose the rear doors in the correct
sequence (see ÒOPENING THEDOORSÓ).VI-4CHANGING BULBS

99
Front courtesy lamps Unclip the cover to gain access to the bulb. Rear courtesy lamp Unclip the cover to gain access to the bulb.Brake lamp (tailgate) Open the tailgate, unscrew the two nuts.Unclip the support to gain accessto the bulbs.
VI-4CHANGING BULBS

100
Number plate lamp Unscrew the translucent cover to gain access to the bulb. Additional brake lamp* (Third brake lamp) Remove the cover by pressing on the tab (round section) at the endof the lamp (in the direction of thearrows).
Pull the cover towards the rear.Remove the bulb holder by squee- zing the two tabs. Pull out the faulty bulb and change it.
To refit, proceed in the reverse
order. * Option depending on version.VI-4CHANGING BULBS

99
Front courtesy lamps Unclip the cover to gain access to the bulb. Rear courtesy lamp Unclip the cover to gain access to the bulb.Brake lamp (tailgate) Open the tailgate, unscrew the two nuts.Unclip the support to gain accessto the bulbs.
VI-4CHANGING BULBS

Roof bars
¥ The design of your vehicle is such that only roof bars tested and approved by the manufacturer should be used,to ensure your safety and to avoid damaging your vehicle.
¥ Spread the load evenly, avoid overloading one side.
Keep to the prescribed load capacity. Maximum load, distributed over the roof bars or roof rack: 220 lbs (100 kg) in total. ¥ Place the heaviest load as close as possible to the roof.¥ Fasten the load securely and flag any overhanging load.
¥ Drive smoothly. The effect of side winds will be increased, affecting the stability of your vehicle.¥ Remove the roof bars or roof rack when no longer needed.
107VI-7SAFETY ADVICE

1
2
3
Tools The tools are stowed behind the driver's seat.
101
VI-5CHANGING A WHEEL
1 Chock,
2 Jack,
3 Wheel brace.
The jack is specific to your vehicle, do not use it for other applications.