check engine light Peugeot Partner VU Dag 2004 Owner's Manual

PEUGEOT SERVICING25
22-12-2003
A AND C SERVICE LEVELS AND THE INTERMEDIATE VISIT
Level
Operations Description of operation 1st service
A C Intermediate
DRAIN/REFILLÐ Engine oilÐ Bleed fuel filter (diesel)Ð Oil filterÐ Petrol filter (according to engine)REPLACEÐ Diesel filter or element (according to engine)Ð Air filter elementÐ Spark plugs (petrol)Ð Engine oil (check + top-up) Ð Manual gearbox oil (check + top-up) Ð Battery (check + top-up) if cap is removableLEVELÐ Screen wash (check + top-up)Ð Coolant (check + top-up)Ð Brake fluid (check + top-up)Ð Power steering fluid (check + top up according to specification)Ð Operation of lights and indicatorsÐ Condition of glass, headlamp and light lenses and mirrorsÐ HornÐ Windscreen washer jetsÐ Condition of wiper bladesÐ Condition and tension of the ancillary drive beltsÐ HandbrakeÐ Condition of hydraulic circuits (hoses and covers)CHECKÐ Condition of rubber boots and gaitersÐ Brake pads Ð Play in hubs, link rods, ball joints, flexible mountingsÐ Shock absorbersÐ Rear drum brake lining wearÐ Condition and pressure of tyres (including spare wheel)Ð Emission control check as per current legislation (petrol)Ð Smoke opacity (diesel)Ð Passenger compartment filter (according to specification) Ð Visual check of the whole vehicle
SERVICE*Ð Courtesy vehicle
ROAD TEST
: All driving conditions. : Arduous conditions. * According to destination.

PRACTICAL INFORMATION
100
22-12-2003
BATTERY
To charge the battery using a battery charger:
Ð Disconnect the battery,
Ð Follow the instructions for use given by the battery charger manufacturer,
Ð Reconnect starting with the negative (Ð) terminal,
Ð Check that the terminals and connectors are clean. If they are covered with
sulphate (white or greenish deposit), disconnect them and clean them.
To start the vehicle from another battery:
Ð Connect the red cable to the positive (+) terminals of the two batteries,
Ð Connect one end of the green or black cable to the negative (Ð) terminal of the slave battery,
Ð Connect the other end of the green or black cable to an earth point on the broken down vehicle as far as possible from the battery.
Operate the starter, let the engine run.
Wait for the engine to return to idle, then disconnect the cables.
Ð Never disconnect a terminal when the engine is running.
Ð Never charge a battery without first disconnecting the terminals.
Ð After every reconnection of the battery, switch on the ignition and wait 1 minute before starting to allow the electronic systems to be initialised. If slight difficulties are experienced after this, please
contact a PEUGEOT dealer. A flat battery will preventthe engine from starting.
It is advisable to disconnect the battery if the vehicle is not to be used
for a period of more than one month.
ECONOMY MODE FUNCTION After the engine has stopped, with the key in the accessories position,
certain functions (windscreen wiper,electric windows, courtesy lights,audio equipment etc.) can only beused for thirty minutes, to prevent
discharging the battery.
Once the thirty minutes are over, the message "Eco mode active"
appears on the multifunction displayand the active functions are put on
standby.

PRACTICAL INFORMATION103
22-12-2003
TOWING A TRAILER,
CARAVAN, BOAT etc.
Only use original PEUGEOT tow bars that have been tested andapproved from the design stage ofyour vehicle. The tow bar must be fitted by a
PEUGEOT dealer.
Your vehicle is basically designed for transporting people and luggage but it
may also be used for towing a trailer. Driving with a trailer subjects the towing vehicle to more significantstress and its driver must be particu-larly careful. Air density decreases with altitude, thus reducing engine performance.
Above 1 000 metres, the maximum
towing load must be reduced by 10 %
and so on for every 1 000 metres ofaltitude.Driving advice Distribution of loads:
Distribute the
load in the trailer so that the heaviest items are as close as possible to theaxle and the nose weight approachesthe maximum permitted withoutexceeding it. Cooling: Towing a trailer on a slope
increases the temperature of the coolant. As the fan is electrically controlled, its cooling capacity is not dependenton the engine speed.
On the contrary, use a high gear to lower the engine speed, and reduceyour speed. The maximum towing load on a long slope depends on the gradient andthe outside temperature. In all cases, pay attention to the coolant temperature. If the warning light comes on, stop
the vehicle and switch off the engineas soon as possible. Tyres:
Check the tyre pressures
of the towing vehicle and of the
trailer, observing the recommendedpressures. Braking: Towing increases the braking
distance. Lights: Check the electrical signalling
on the trailer. Side wind: Take into acount the
increased sensitivity to side wind.