Peugeot RCZ 2011 Workshop Manual
Page 51 of 276
1/
INSTRUMENTS AND CONTROLS
When the screen is open, you can adjust it precisely in different ways:
)
press the corresponding part of control B
to move the screen
towards you or towards the windscreen,
or
)
push or pull the screen gently by hand.
Adjusting the position of the screen
Storing the position of the screen
The system has four pre-set positions in its memory.
Each time the screen is closed, the system stores the last position of
the screen.
Each time the screen is re-opened, the system returns the screen to
the pre-set position closest to that stored.
Page 52 of 276
50
REMOTE CONTROL KEY
System which permits central unlocking or locking of the vehicle using
the lock or from a distance. It is also used to locate and start the
vehicle, as well as providing protection against theft.
UNLOCKING THE VEHICLE
Unfolding the key
)
First press this button to unfold the key.
Complete unlocking using the remote control
)
Press the open padlock to unlock the vehicle.
Selective unlocking using the remote control
)
Press the open padlock once to unlock the driver's door
and the fuel fi ller fl ap only.
)
Press the open padlock again to unlock the passenger's door and
the boot.
Selective unlocking using the key
)
Turn the key to the left in the driver's door lock once to unlock the
driver's door and the fuel fi ller fl ap only.
)
Turn the key to the left in the driver's door lock again to unlock the
passenger's door and the boot.
The complete or selective unlocking parameter is set via
the vehicle confi guration menu.
Complete unlocking is activated by default.
Complete unlocking using the key
)
Turn the key to the left in the driver's door lock to unlock
the vehicle.
Unlocking and partial opening of the boot
)
Press this button for more than two seconds to unlock
the boot. The boot opens slightly.
This action also unlocks the doors and the fuel fi ller fl ap.
Unlocking is confi rmed by rapid fl ashing of the direction indicators for
approximately two seconds.
According to version, the door mirrors unfold at the same time.
Each unlocking is confi rmed by rapid fl ashing of the direction indicators
for approximately two seconds.
According to version, the door mirrors unfold at the same time as the
fi rst unlocking action.
Page 53 of 276
2/
ACCESS
If one of the doors or the boot is still open, the central locking does
not take place; the vehicle lock and then immediately unlocks,
witnessed by the sound of the locks rebounding.
When the vehicle is locked, if it is unlocked inadvertently, it will
relock automatically after thirty seconds unless a door is opened.
The folding and unfolding of the door mirrors using the remote
control can be deactivated by a PEUGEOT dealer or a qualifi ed
workshop.
LOCKING THE VEHICLE
Normal locking using the remote control
)
Press the closed padlock to lock the vehicle completely.
Normal locking using the key
)
Turn the key to the right in the driver's door lock to lock the vehicle
completely.
Deadlocking using the remote control
)
Press the closed padlock to lock the vehicle completely.
)
Press the closed padlock again within fi ve seconds to
deadlock the vehicle.
Deadlocking using the key
Deadlocking renders the exterior and interior door controls
inoperative.
It also deactivates the manual central control button.
Therefore, never leave anyone inside the vehicle when it is
deadlocked. Locking is confi rmed by fi xed lighting of the direction indicators for
approximately two seconds.
According to version, the door mirrors fold at the same time.
Deadlocking is confi rmed by fi xed lighting of the direction indicators for
approximately two seconds.
According to version, the door mirrors fold at the same time.
)
Turn the key to the right in the driver's door lock to lock the vehicle
completely.
)
Turn the key to the right again within fi ve seconds to deadlock
the vehicle.
Page 54 of 276
52
Folding the key
)
First press this button to fold the key.
LOCATING YOUR VEHICLE
REMOTE CONTROL PROBLEM
Following disconnection of the vehicle battery, replacement of the
remote control battery or in the event of a remote control malfunction,
you can no longer unlock, lock or locate your vehicle.
)
First of all, use the key in the lock to unlock or lock your vehicle.
)
Then, reinitialise the remote control.
If the problem persists, contact a PEUGEOT dealer as soon as
possible.
Reinitialisation
)
Switch off the ignition.
)
Turn the key to position 2 (Ignition on)
.
)
Press the closed padlock immediately for a few seconds.
)
Switch off the ignition and remove the key from the ignition switch.
The remote control is fully operational again.
Changing the battery
Battery ref.: CR1620/3 volts.
If the battery is fl at, you are informed by illumination of this
warning lamp, accompanied by an audible signal and an alert
message in the screen.
)
Unclip the casing using a coin at the notch.
)
Slide the fl at battery out of its location.
)
Slide the new battery into its location observing the original
direction.
)
Clip the casing.
)
Reinitialise the remote control.
This function allows you to identify your vehicle from a
distance, particularly in poor light. Your vehicle must be
locked.
)
Press the closed padlock on the remote control.
This will switch on the courtesy lamps and the direction indicators will
fl ash for a few seconds.
Page 55 of 276
2/
ACCESS
LOST KEYS
Visit a PEUGEOT dealer with the vehicle's V5 registration
document and your personal identifi cation documents.
The PEUGEOT dealer will be able to retrieve the key code and
the transponder code required to order a replacement key.
LOCKING THE VEHICLE
Driving with the doors locked may make access to the passenger
compartment by the emergency services more diffi cult in an emergency.
As a safety precaution (with children on board), remove the key from the
ignition when you leave the vehicle, even for a short time.
REMOTE CONTROL
The high frequency remote control is a sensitive system; do not
operate it while it is in your pocket as there is a possibility that it
may unlock the vehicle, without you being aware of it.
Do not repeatedly press the buttons of your remote control out of
range and out of sight of your vehicle. You run the risk of stopping it
from working and the remote control would have to be reinitialised.
The remote control does not operate when the key is in the
ignition, even when the ignition is switched off, except for
reinitialisation.
ANTI-THEFT PROTECTION
Do not make any modifi cations to the electronic engine
immobiliser system; this could cause malfunctions.
Do not throw the remote control batteries away, they contain
metals which are harmful to the environment.
Take them to an approved collection point.
WHEN PURCHASING A SECOND-HAND
VEHICLE
Have the key codes memorised by a PEUGEOT dealer, to ensure
that the keys in your possession are the only ones which can start
the vehicle.
Page 56 of 276
54
ALARM *
System which protects and provides a deterrent against theft and break-
ins. It provides the following types of monitoring.
- Exterior perimeter
The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a door, the boot, the
bonnet...
- Interior volumetric
The system checks for any variation in the volume in the passenger
compartment.
The alarm is triggered if anyone breaks a window, enters the passenger
compartment or moves inside the vehicle.
- Tilt
The system checks for any change in the attitude of the vehicle.
The alarm is triggered if the vehicle is lifted, moved or knocked.
For all work on the alarm system, contact a PEUGEOT dealer or a
qualifi ed workshop.
LOCKING THE VEHICLE WITH FULL ALARM
SYSTEM
Activation
)
Switch off the ignition and get out of the vehicle.
)
Press the locking button on the remote control.
The monitoring system is active: the indicator lamp in the button fl ashes
once per second.
After the locking button on the remote control is pressed, the exterior
perimeter monitoring is activated after a delay of 5 seconds and the
interior volumetric and anti-tilt monitoring after a delay of 45 seconds.
Deactivation
)
Press the unlocking button on the remote control.
The alarm system is deactivated: the indicator lamp in the button goes off.
Self-protection function
The system checks for the putting out of service of its
components.
The alarm is triggered if the battery, the central control or the siren
wiring are put out of service or damaged.
*
According to country. If an opening (door, boot...) is not closed fully, the vehicle is not
locked but the exterior perimeter monitoring will be activated after
a delay of 45 seconds at the same time as the interior volumetric
and anti-tilt monitoring.
Page 57 of 276
2/
ACCESS
LOCKING THE VEHICLE WITH EXTERIOR
PERIMETER MONITORING ONLY
Deactivation of the interior volumetric and anti-tilt monitoring
)
Switch off the ignition.
)
Within ten seconds, press the button until the indicator lamp is on
continuously.
)
Get out of the vehicle.
)
Press the locking button on the remote control immediately.
The exterior perimeter monitoring alone is activated: the indicator lamp
in the button fl ashes once per second.
Reactivation of the interior volumetric and anti-tilt monitoring
)
Press the unlocking button on the remote control to deactivate the
exterior perimeter monitoring.
)
Press the locking button on the remote control to activate all the
monitoring functions.
The indicator lamp in the button again fl ashes once per second.
Deactivate the interior volumetric and anti-tilt monitoring to avoid
unwanted triggering of the alarm in certain cases such as:
- leaving a pet in the vehicle,
- leaving a window partially open,
- washing your vehicle,
- changing a wheel,
- having your vehicle towed,
- transport by sea. To be effective, this deactivation must be carried out each time the
ignition is switched off.
Page 58 of 276
56
OPERATING FAULT
AUTOMATIC ACTIVATION *
LOCKING THE VEHICLE WITHOUT ACTIVATING
THE ALARM
)
Lock or deadlock the vehicle using the key in the driver's door lock.
When the ignition is switched on, fi xed illumination of the indicator lamp
in the button indicates a fault with the system.
Have it checked by a PEUGEOT dealer or a qualifi ed workshop.
2 minutes after the last door or the boot is closed, the system is
activated automatically.
)
To avoid triggering the alarm on entering the vehicle, fi rst press the
unlocking button on the remote control.
* According to country.
FAILURE OF THE REMOTE CONTROL
To deactivate the monitoring functions:
)
Unlock the vehicle using the key in the driver's door lock.
)
Open the door; the alarm is triggered.
)
Switch on the ignition; the alarm stops. The indicator lamp in the
button goes off.
TRIGGERING OF THE ALARM
The monitoring functions remain active until the alarm has been
triggered eleven times in succession.
When the vehicle is unlocked using the remote control, rapid
fl ashing of the indicator lamp in the button informs you that the
alarm was triggered during your absence. When the ignition is
switched on, this fl ashing stops immediately.
This is indicated by sounding of the siren and fl ashing of the direction
indicators for thirty seconds.
Page 59 of 276
2/
ACCESS
ELECTRIC WINDOWS
Fitted with a safety anti-pinch system.
A.
Left-hand electric window control switch.
B.
Right-hand electric window control switch.
ONE-TOUCH ELECTRIC WINDOWS
There are two options:
- manual mode
)
Press or pull the switch gently. The window stops when the
switch is released.
- automatic mode
)
Press or pull the switch fi rmly. The window opens or closes fully
when the switch is released.
)
Pressing the switch again stops the movement of the window.
The electric window switches remain operational for approximately
45 seconds after the ignition is switched off or until the vehicle is
locked after a door is opened.
If the passenger's window cannot be operated from the driver's
door control panel, carry out the operation from the control panel
of the passenger door.
After approximately ten consecutive complete opening/closing
movements of the window, a protection function is activated which
only authorises closing of the windows, so as to prevent damage
to the electric window motor.
Once the window is closed, the switches will become operational
again after approximately 40 minutes.
Safety anti-pinch
When the window rises and meets an obstacle, it stops and partially
lowers again.
If the window cannot be closed (for example, in the presence of ice),
immediately after the movement is reversed:
)
press and hold the switch until the window opens fully,
)
then pull the switch immediately and hold it until the window
closes,
)
continue to hold the switch for approximately one second after
the window has closed.
The safety anti-pinch function is not operational during these
operations.
Page 60 of 276
58
Reinitialisation
If a window does not rise automatically, its operation must be
reinitialised:
)
pull the switch until the window stops,
)
release the switch and pull it again until the window closes fully,
)
continue to hold the switch for approximately one second after the
window has closed,
)
press the switch to lower the window automatically to the low
position,
)
when the window has reached the low position, press the switch
again for approximately one second.
The safety anti-pinch function is not operational during these
operations.
Always remove the key from the ignition when leaving the vehicle,
even for a short time.
If an obstacle is encountered during operation of the electric
windows, you must reverse the movement of the window. To do
this, press the switch concerned.
When the driver operates the switch for the passenger's electric
window, they must ensure that no one is preventing correct
closing of the windows.
The driver must ensure that the passengers use the electric
windows correctly.
Be aware of children when operating the windows.