battery Peugeot RCZ 2012.5 Owner's Manual - RHD (UK, Australia)

CONTENTS
Steering lock - Starting 127Parking brake 128Hill start assist 129Manual gearbox 130
Gear shift indicator 131Automatic gearbox 132Speed limiter 136Cruise control 139
Parking sensors 142
Fuel tank 146Bonnet 148Petrol engines 149
Diesel engine 150Running out of fuel (Diesel) 151Checking levels 152
Checks 154
Temporary puncture repair kit 156Changing a wheel 163Snow chains 168Changing a wiper blade 169
Energy economy mode 170Battery 171Changing a bulb 173Changing a fuse 180Towing a vehicle 187
Towing a trailer 189Cleaning and maintenance 191Accessories 193
6/DRIVING 127-144
7/CHECKS 145-155
8/PRACTICAL INFORMATION 156-194
ALPHABETICAL INDEX 321-325
VISUAL SEARCH 326-332
Petrol engines 195Weights (petrol) 196Diesel engine 197Weights (Diesel) 198Dimensions 199Identification markings 200
9/TECHNICAL DATA 195-200
Emergency or assistance 201Peugeot Connect Media Navigation (NG4 3D) 205Peugeot Connect Navigation (RT6) 249Peugeot Connect Sound (RD5) 303
10/AUDIO EQUIPMENT and TELEMATICS 201-320

28


Engine
autodiagnosis
system


fl ashing. The engine management system
has a fault. Risk of destruction of the catalytic converter.
Have it checked by a PEUGEOT dealer or a qualifi ed
workshop.

fi xed. The emission control system has
a fault. The warning lamp should go off when the engine is started.
If it does not go off, contact a PEUGEOT dealer or qualifi ed
workshop without delay.




Low fuel level


fi xed with the
needle in the
red zone,
accompanied by
an audible signal
and a message. When it fi rst comes on there
remains approximately 5 litres
of
fuel in the tank.
At this point, you begin to use the
fuel reserve. Refuel as soon as possible to avoid running out of fuel.
Until suffi cient fuel has been added, this warning lamp
will come on every time the ignition is switched on,
accompanied by an audible signal and a message.
The audible signal and message are repeated with
increasing frequency as the fuel level drops towards "0"
.
Fuel tank capacity: approximately 55 litres
.
Never continue to drive until you run out of fuel, as this
could damage the emission control and injection systems.

Warning lamp



is on



Cause



Action / Observations






Service


temporarily,
accompanied by
a message. Minor faults have occurred for
which there is no specifi c warning
lamp. Identify the fault by reading the message displayed in the
screen, such as:


- doors, boot or bonnet open,

- low engine oil level,

- low screenwash/headlamp wash reservoir level,

- remote control battery fl at,

- low tyre pressures,

- saturation of the particle emission fi lter on Diesel
vehicles (see "Checks" - "Checking levels / Particle
emissions fi lter" section).
For any other faults, contact a PEUGEOT dealer or a
qualifi ed workshop.

fi xed,
accompanied by
a message and
an audible signal. Major faults have occurred for
which there is no specifi c warning
lamp. Identify the fault by reading the message shown in the
screen and you must then contact
a PEUGEOT dealer or
a qualifi ed workshop.

36

Service overdue

For 7 seconds after the ignition is switched on, the spanner fl ashes
to
indicate that the service must be carried out as soon as possible.

Example:
the service is overdue by 300 miles.
For 7 seconds after the ignition is switched on, the central screen indicates:

The spanner remains
on
in the small screen
to indicate that a service should have been
carried out.
The distance remaining may be weighted by the time factor,
depending on the driver's driving habits.
Therefore, the spanner may also come on if you have exceeded
the one year service interval.









Service indicator zero reset

Retrieving the service information

You can access the service information at any time.
This information appears when running through the manual check
procedure.


)
Briefl y press the "CHECK/000"
button.
The service information is displayed for a few seconds on the
instrument panel central screen, then disappears.

Following this operation, if you wish to disconnect the battery, lock
the vehicle and wait at least fi ve minutes for the zero reset to be
registered. After each service, the service indicator must be reset to zero.
The procedure for resetting to zero is as follows:


)
switch off the ignition,

)
press and hold the "CHECK/000"
button,

)
switch on the ignition; the distance recorder display begins a
countdown,

)
when the instrument panel central screen indicates "=0"
, release
the button; the spanner disappears from the small screen.

54


Folding the key



)
First press this button to fold the key.









LOCATING YOUR VEHICLE















REMOTE CONTROL PROBLEM

Following disconnection of the vehicle battery, replacement of the
remote control battery or in the event of a remote control malfunction,
you can no longer unlock, lock or locate your vehicle.


)
First of all, use the key in the lock to unlock or lock your vehicle.

)
Then, reinitialise the remote control.
If the problem persists, contact a PEUGEOT dealer as soon as
possible.

Reinitialisation



)
Switch off the ignition.

)
Turn the key to position 2 (Ignition on)
.

)
Press the closed padlock immediately for a few seconds.

)
Switch off the ignition and remove the key from the ignition switch.
The remote control is fully operational again.


Changing the battery

Battery ref.: CR1620 / 3 volts.
If the battery is fl at, you are informed by illumination of this
warning lamp, accompanied by an audible signal and an alert
message in the screen.


)
Unclip the casing using a coin at the notch.

)
Slide the fl at battery out of its location.

)
Slide the new battery into its location observing the original
direction.

)
Clip the casing.

)
Reinitialise the remote control.

This function allows you to identify your vehicle from a
distance, particularly in poor light. Your vehicle must be
locked.


)
Press the closed padlock on the remote control.
This will switch on the courtesy lamps and the direction indicators will
fl ash for a few seconds.

56
ALARM *
System which protects and provides a deterrent against theft and
break-ins. It provides the following types of monitoring.


- exterior perimeter

The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a door, the boot, the
bonnet...




- interior volumetric

The system checks for any variation in the volume in the passenger compartment.

The alarm is triggered if anyone breaks a window, enters the passenger
compartment or moves inside the vehicle.




- tilt

The system checks for any change in the attitude of the vehicle.
The alarm is triggered if the vehicle is lifted, moved or knocked.


For all work on the alarm system, contact a PEUGEOT dealer or a
qualifi ed workshop.


LOCKING THE VEHICLE WITH FULL ALARM
SYSTEM

Activation



)
Switch off the ignition and get out of the vehicle.

)
Press the locking button on the remote control.
The monitoring system is active: the indicator lamp in the button fl ashes
once per second.
After the locking button on the remote control is pressed, the exterior
perimeter monitoring is activated after a delay of 5 seconds and the
interior volumetric and anti-tilt monitoring after a delay of 45 seconds.

Deactivation



)
Press the unlocking button on the remote control.
The alarm system is deactivated: the indicator lamp in the button goes off.



Self-protection function

The system checks for the putting out of service of its
components.
The alarm is triggered if the battery, the central control or the siren
wiring are put out of service or damaged.

* According to country. If an opening (door, boot...) is not closed fully, the vehicle is not
locked but the exterior perimeter monitoring will be activated after
a delay of 45 seconds at the same time as the interior volumetric
and anti-tilt monitoring.

2/
ACCESS

Pressing the central locking control unlocks the vehicle.
Opening a door from the inside, when stationary, also unlocks
the vehicle, but the vehicle will be locked again when the speed
exceeds 6 mph (10 km/h).


Activation / Deactivation

You can activate or deactivate this function.


)
With the ignition on, press the button for more than two seconds.
A confi rmation message appears in the screen.

In the event of a serious impact with deployment of an airbag, the
vehicle's doors unlock automatically to allow the occupants to leave the
vehicle.











EMERGENCY LOCKING

To lock or unlock the doors mechanically in the event of a central
locking system failure or fl at battery.


Locking the driver's door



)
Insert the key in the lock, then turn it to the right.



Unlocking the driver's door



)
Insert the key in the lock, then turn it to the left.



Locking the passenger door



)
Using the key, remove the black cap on the edge of the door.

)
Insert the key in the cavity without forcing, then without turning it,
move the the latch sideways towards the interior of the door.

)
Remove the key and refi t the cap.



Unlocking the passenger door



)
Pull the interior door opening control.




ANTI-INTRUSION SECURITY

This function permits automatic and simultaneous locking of the doors,
boot lid and fuel fi ller fl ap as soon as the vehicle speed exceeds 6 mph
(10 km/h).

Operation

If one of the doors is open, the automatic central locking does not take
place.
If the boot lid is open, the automatic central locking of the doors is
active.

64
BOOT

OPENING



)
Press this button for more than two seconds to unlock
the boot lid. The boot lid opens slightly.

)
Lift the boot lid.
This action also unlocks the doors and the fuel fi ller fl ap.




Using the manual control; vehicle unlocked



)
Press the opening control above the number plate.

)
Lift the boot lid.




CLOSING



)
Lower the boot lid using one of the interior grab handles.

)
If necessary, press the top of the boot lid to close it fully.
If the boot lid is not closed correctly:


- when the engine is running
, this warning lamp comes on,
accompanied by a message in the screen for a few seconds,
When selective unlocking is activated, the boot can also be
opened by a second press on the open padlock on the remote
control.

Using the remote control

Emergency locking

If the central locking system fails (fl at battery), you are advised to
disconnect the battery.

- when the vehicle is moving
(speed above 6 mph (10 km/h)), this
warning lamp comes on, accompanied by an audible signal and a
message in the screen for a few seconds.

68
STORING DRIVING POSITIONS
System which takes into account the electrical settings of the driver's
seat and the door mirrors. It enables you to store two positions using
the buttons on the side of the driver's seat.

STORING A POSITION


Using buttons M / 1 / 2



)
Switch on the ignition.

)
Adjust your seat and your door mirrors.

)
Press button M
, then press button 1
or 2
within four seconds.
An audible signal is heard indicating that the settings have
been stored.


RECALLING A STORED POSITION

Storing a new position cancels the previous position.



Using button 1 or 2



)
Press and hold button 1
or 2
until the audible signal is heard
indicating the end of the adjustment.
When the ignition is off, after a few consecutive position recalls,
the function will be deactivated until the engine is started, to
prevent discharging of the battery.

92






C.
Foglamp selection ring.
The foglamp operates with the dipped and main beam headlamps.


Rear foglamp.


)
Turn the ring C
forwards and release to switch on the rear foglamp.
When the lighting is switched off automatically (with AUTO model)
or when the dipped beam headlamps are switched off manually, the
foglamp and the sidelamps will remain on.


)
Turn the ring C
rearwards and release to switch off all the lamps.






In good or rainy weather, both day and night, use of the rear
foglamp is prohibited. In these situations, the power of its beam
may dazzle other drivers. It should only be used in fog or snow.
In these weather conditions, it is your responsibility to switch
on the foglamp and dipped beam headlamps manually as the
sunshine sensor may detect suffi cient light.
Do not forget to switch off the rear foglamp when it is no longer
needed.


Switching off the lamps when the ignition is switched off

On switching off the ignition, all of the lamps turn off immediately,
except for dipped beam if guide-me-home lighting is activated.


Switching on the lamps after the ignition is switched off

To reactivate the lighting control, rotate ring A
to the "0"
position -
lamps off, then to the desired position.
On opening the driver's door a temporary audible signal warns the
driver that the lighting is on.
The lamps, with the exception of the sidelamps, switch off
automatically after a maximum duration of thirty minutes to
prevent discharging of the battery.

6/
DRIVING
It is only possible to change from one gear to another if the vehicle
speed and engine speed permit; otherwise, the gearbox will operate
temporarily in automatic mode.

M
and the gears engaged manually appear in succession in
the instrument panel.
If the engine speed is too low or too high, the gear selected
fl ashes for a few seconds, then the actual gear engaged is
displayed.
It is possible to change from position D
(automatic) to position M

(manual) at any time.
When the vehicle is stationary or moving very slowly, the gearbox
selects gear M1
automatically.
The sport and snow programmes do not operate in manual mode.


Invalid value during manual operation

This symbol is displayed if a gear is not engaged correctly
(selector between two positions).



STOPPING THE VEHICLE

Before switching off the engine, you can engage position P
or N
to
place the gearbox in neutral.
In both cases, apply the parking brake to immobilise the vehicle. If the lever is not in position P
, when the driver's door is opened or
approximately 45 seconds after the ignition is switched off, there is
an audible signal is heard accompanied by a message.


)
Return the lever to position P
; the audible signal stops and the
message disappears.



OPERATING FAULT

When the ignition is on, the illumination of this warning lamp,
accompanied by an audible signal and a message in the
screen, indicates a gearbox malfunction.
In this case, the gearbox switches to emergency mode and is locked in
3rd gear. You may feel a substantial knock when changing from P
to R

and from N
to R
. This will not cause any damage to the gearbox.
Do not exceed a speed of 60 mph (100 km/h), local speed restrictions
permitting.
Have it checked by a PEUGEOT dealer or a qualifi ed workshop.
This warning lamp may also come on if a door is opened.

There is a risk of damage to the gearbox:


- if you press the accelerator and brake pedals at the same
time,

- if you force the lever from position P
to another position when
the battery is fl at.
To reduce fuel consumption during a long period stationary with
the engine running (traffi c jam, etc.), place the gear lever in
position N
and apply the parking brake.