run flat Peugeot RCZ 2012.5 Owner's Manual - RHD (UK, Australia)

160

2. Inflation




)
Turn the selector A
to the "air" position.

)
Uncoil the black pipe H
fully.

)
Connect the black pipe to the valve of the wheel.


As soon as possible, go to a PEUGEOT dealer or a qualifi ed
workshop.
You must inform the technician that you have used this kit. After
inspection, the technician will advise you on whether the tyre can
be repaired or if it must be replaced.


)
Connect the compressor's electric plug to the vehicle's 12 V socket.

)
Start the vehicle again and leave the engine running.



)
Adjust the pressure using the compressor (to infl ate: switch B

in position "I"
; to defl ate: switch B
in position "O"
and press
button C
), in accordance with the vehicle's tyre pressure label
(located on the left hand door aperture).
A loss of pressure indicates that the puncture has not been fully
plugged; contact a PEUGEOT dealer or qualifi ed workshop for
assistance.

)
Remove and stow the kit.

)
Drive at reduced speed (50 mph [80 km/h] max) limiting the
distance travelled to approximately 120 miles (200 km).

162

CHECKING TYRE PRESSURES / INFLATING
ACCESSORIES

You can also use the compressor, without injecting any product, to:


- check or adjust the pressure of your tyres,

- infl ate other accessories (balls, bicycle tyres...).




)
Turn the selector A
to the "Air" position.

)
Uncoil the black pipe H
fully.

)
Connect the black pipe to the valve of the wheel or
accessory.
If necessary, fi t one of the adaptors supplied with the kit fi rst.



)
Connect the compressor's electrical connector to the vehicle's 12 V
socket.

)
Start the vehicle and let the engine run.

)
Adjust the pressure using the compressor (to infl ate: switch B

in position "I"
; to defl ate: switch B
in position "O"
and press
button C
), according to the vehicle's tyre pressure label or the
accessory's pressure label.

)
Remove the kit then stow it.