battery PEUGEOT RCZ 2012 User Guide

Page 151 of 336

7/
CHECKS
PETROL ENGINES
The various caps and covers allow access for checking the levels of the various fl uids and for replacing certain components.


1.
Power steering reservoir.

2.
Screenwash and headlamp wash reservoir.

3.
Coolant reservoir.

4.
Brake fl uid reservoir.

5.
Battery / Fuses.
6.
Fusebox.

7.
Air fi lter.

8.
Engine oil dipstick.

9.
Engine oil fi ller cap.

Page 152 of 336

150
DIESEL ENGINE
The various caps and covers allow access for checking the levels of the various fl uids, for replacing certain components and for priming the fuel system.


1.
Power steering reservoir.

2.
Screenwash and headlamp wash reservoir.

3.
Coolant reservoir.

4.
Brake fl uid reservoir.

5.
Battery / Fuses.

6.
Fusebox.
7.
Air fi lter.

8.
Engine oil dipstick.

9.
Engine oil fi ller cap.

10.
Priming pump.

11 .
Bleed screw.

Page 156 of 336

154





CHECKS













BATTERY









PARTICLE EMISSION FILTER (DIESEL)


On a new vehicle, the fi rst particle fi lter regeneration operations
may be accompanied by a "burning" smell, which is perfectly
normal.
Following prolonged operation of the vehicle at very low speed or
at idle, you may, in exceptional circumstances, notice the emission
of water vapour at the exhaust on acceleration. This does not
affect the behaviour of the vehicle or the environment.

The battery does not require any maintenance.
However, check that the terminals are clean and correctly
tightened, particularly in summer and winter.
When carrying out work on the battery, refer to the "Battery"
section for details of the precautions to be taken before disconnecting
the battery and following its reconnection.

The start of saturation of the particle emissions fi lter is
indicated by the temporary illumination of this warning lamp,
accompanied by an audible signal and a message on the risk
of blockage of the particle emissions fi lter.
As soon as the traffi c conditions permit, regenerate the fi lter by driving
at a speed of at least 40 mph (60 km/h) until the warning lamp goes off.
If the warning lamp stays on, refer to the "Additive level" section.
Unless otherwise indicated, check these components in accordance
with the servicing and warranty booklet and according to your engine.
Otherwise, have them checked by a PEUGEOT dealer or a qualifi ed
workshop.





















AIR FILTER AND PASSENGER COMPARTMENT FILTER


Refer to the servicing and warranty booklet for details of
the replacement intervals for these components.
Depending on the environment (e.g. dusty atmosphere)
and the use of the vehicle (e.g. city driving), replace them
twice as often if necessary
.
A clogged passenger compartment fi lter may have an adverse effect
on the performance of the air conditioning system and generate
undesirable odours.
Replace the oil fi lter each time the engine oil is changed.
Refer to the servicing and warranty booklet for details of the
replacement interval for this component.














OIL FILTER

Page 172 of 336

170
ENERGY ECONOMY MODE
System which manages the duration of use of certain functions to
conserve a suffi cient level of charge in the battery.
After the engine has stopped, you can still use functions such as
the audio and telematic system, windscreen wipers, dipped beam
headlamps, courtesy lamp, etc. for a maximum combined duration of
thirty minutes.
This period may be greatly reduced if the battery is not fully charged.


SWITCHING TO ECONOMY MODE

Once this time has elapsed, a message appears in the screen indicating
that the vehicle has switched to economy mode and the active functions
are put on standby.
If the telephone is being used at this time:


- it will be maintained for 5 minutes with the Bluetooth system
of your Peugeot Connect Sound (RD5),

- it will still be possible to fi nish the call with the Peugeot Connect
Navigation (RT6) or Peugeot Connect Media (NG4 3D).



EXITING ECONOMY MODE

These functions are reactivated automatically next time the vehicle is
driven.
To restore operation of these functions immediately, start the engine
and let it run for at least 5 minutes.
Let the engine run for the period specifi ed to ensure that the battery
charge is suffi cient.
Do not repeatedly and continuously restart the engine in order to charge
the battery.
A fl at battery prevents the engine from starting (refer to the
"Battery" section).
LOAD REDUCTION MODE

System which manages the use of certain functions according to the
level of charge remaining in the battery.
When the vehicle is being driven, the load reduction function temporarily
deactivates certain functions, such as the air conditioning, the heated
rear screen...
The deactivated functions are reactivated automatically as soon as
conditions permit.

Page 173 of 336

8/
PRACTICAL INFORMATION
BATTERY
The battery is located under the bonnet.
For access to it:


)
open the bonnet using the interior release lever, then the exterior
safety catch,

)
remove the plastic cover for access to the two terminals,

)
wait 2 minutes after switching off the ignition before disconnecting
the battery,

)
unclip the fusebox to remove the battery, if necessary.



STARTING USING ANOTHER BATTERY



)
Connect the red cable to the positive terminal (+) of the fl at
battery A
, then to the positive terminal (+) of the slave battery B
.

)
Connect one end of the green or black cable to the negative
terminal (-) of the slave battery B
.

)
Connect the other end of the green or black cable to the earth
point C
on the broken down vehicle.

)
Operate the starter, let the engine run.

)
Wait until the engine returns to idle and disconnect the cables.



ACCESS TO THE BATTERY


The batteries contain harmful substances such as sulphuric
acid and lead. They must be disposed of in accordance with
regulations and must not, in any circumstances, be discarded with
household waste.
Take used remote control batteries and vehicle batteries to a
special collection point.

Page 174 of 336

172

DISCONNECTING / RECONNECTING THE
CABLES

To avoid discharging the battery, do not leave the vehicle lighting
on repeatedly with the ignition off (refer to the "Energy economy
mode" paragraph).
It is advisable to disconnect the battery if the vehicle is to be left
unused for more than one month.

Do not disconnect the terminals while the engine is running.
Do not charge the batteries without disconnecting the terminals
fi rst.


Before disconnecting the battery

Wait 2 minutes after switching off the ignition before disconnecting
the battery.
Retract the active spoiler then close the windows and the doors
before disconnecting the battery.


Following reconnection of the battery

Following reconnection of the battery, switch on the ignition
and wait 1 minute before starting to permit initialisation of the
electronic systems. However, if slight problems remain following
this operation, contact a PEUGEOT dealer or a qualifi ed
workshop.
Referring to the corresponding section, you must yourself
reinitialise:


- the remote control key,

- the electric windows and the automatic partial opening of the
door windows,

- the GPS satellite navigation system.



)
Raise the locking tab D
fully.

)
Position the open clip E
of the cable on the positive terminal (+) of
the battery.

)
Press vertically on the clip E
to position it correctly against the
battery.

)
Lock the clip by lowering the tab D
.


CHARGING THE BATTERY USING A BATTERY
CHARGER


)
Disconnect the battery from the vehicle.

)

Follow the instructions for use provided by the manufacturer of the charger.


)
Reconnect starting with the negative terminal (-).

)
Check that the terminals and connectors are clean. If they are
covered with sulphate (whitish or greenish deposit), remove them
and clean them.

Do not force the tab as locking will not be possible if the clip is not
positioned correctly.
Start the procedure again.

Page 186 of 336

184

ENGINE COMPARTMENT FUSES

The fusebox is placed in the engine compartment near the battery (left-
hand side).

Access to the fuses



)
Unclip the cover.

)
Change the fuse (see corresponding paragraph).

)
When you have fi nished, close the cover carefully to assure the
sealing of the fusebox.



Fuse table



Fuse N°



Rating


Functions



F1



20 A

Engine control unit supply, injection
pump and EGR electrovalves (Diesel),
injectors (Diesel).


F2



15 A

Horn.


F3



10 A

Front wash-wipe.


F4



20 A

Daytime running lamps.


F5



15 A

Air fl ow sensor, coolant pump, oil pump,
thermostat, blow-by heater (petrol),
by-pass and EGR electrovalves (Diesel),
diesel heater (Diesel).


F6



10 A

Steering wheel angle sensor, ABS/ESC
control unit, ESC sensor.


F7



10 A

Power steering control unit, automatic
gearbox, engine coolant level detector,
dual function brake switch.


F8



25 A

Starter motor control.


F9



10 A

Diagnostic socket, directional
headlamps, particle emission fi lter pump
(Diesel).


F10



30 A

Engine control unit actuators (petrol:
ignition coils, electrovalves, injectors,
fuel pump (Diesel: electrovalves,
heaters).


F11



40 A

Air conditioning blower.

Page 188 of 336

186

Table of fuses over the battery



Fuse N°



Rating


Functions



F1



-

Not used.


F2



5 A

Dual function brake switch.


F3



5 A

Battery charge unit.


F4



25 A

ABS/ESC electrovalves.


F5



-

Not used.


F6



15 A

Automatic gearbox. All work on the other types of fuses (midi-fuses and maxi-fuses)
must only be done by a PEUGEOT dealer or a qualifi ed workshop.

Page 204 of 336

202
EMERGENCY OR ASSISTANCE CALL
In an emergency, press this button for more than2 seconds. Flashing of the green LED and a voice
message confi rm that the call has been made to the
PEUGEOT CONNECT SOS call centre * .
The
green LED remains on (without fl ashing) when communication is established. It goes off at the end of communication.

When the ignition is switched on, the green
LED comes on for 3 seconds indicating that
the system is operating correctly. Pressin
g this button again immediately cancels the request.
The cancellation is confi rmed b
y a voice message.
Press this button for more than 2 seconds to request
assistance if the vehicle breaks down.
A voice message confi rms that the call has been made **
.


OPERATION OF THE SYSTEM Pressing this button again immediately cancels the request. The green LED goes off. Cancellation is confi rmed by a voice message.
To cancel a call, tell the PEUGE
OT CONNECT SOS call centre that thecall was a mistake.
PEUGE
OT CONNECT SOS immediately locates your vehicle, starts communication with you in your language ** , and where necessary sends
the appropriate public emergency services ** . In countries where theservice is not available, or when the locating service has been expresslydeclined, the call sent directly to the emergency services (11 2) without the
vehicle location.

If an impact is detected b
y the airbag control unit, and
independently of the deployment of any airbags, an emergency call
is made automatically.
*
Sub
ject to the general conditions for the service available from dealersand to technological and technical limitations.
**

Depending on the geographical cover of PEUGEOT CONNECT SOS,
PEUGEOT CONNECT ASSISTA NCE and the offi cial national language selected by the owner of the vehicle.
Th
e list of countries covered and PEUGEOT CONNECT services are available from dealers or at www.peugeot.co.uk.
If the oran
ge LED fl ashes: there is a system
fault.
If the oran
ge LED is on continuously: the backup battery must be replaced.
In either case, contact a PEU
GEOT dealer.

I
f you purchased your vehicle outside the PEUGEOT dealer network,
we invite you to have a dealer check the confi guration of these services
and, if desired, modifi ed to suit your wishes. In a multi-lingual country,confi guration is possible in the offi cial national language of your choice.

For technical reasons and in particular to improve the qualit
y of PEUGEOT CONNECT services to customers, the manufacturer reserves
the right to carry out updates to the vehicle's on-board telematic system.

Page 207 of 336

205

The system is protected in such a way that it will onlyoperate in your vehicle.
Peugeot Connect Media Navigation (NG4 3D)


For safety reasons, the driver must only carry out
operations which require prolonged attention while the
vehicle is stationary.
When the en
gine is switched off and to prevent
discharging of the battery, the system switches off
following the activation of the energy economy mode.



01 First steps

02 Voice commands and
steerin
g mounted controls

03 General operation

04 Navi
gation - Guidance

05 Traffic information

06 Radio

07 Music media pla
yers

08 Usin
g the telephone

09 Screen menu map

Frequentl
y asked questions
p.
p.
p.
p.
p.
p.
p.
p.
p.
p. 2
06
208
211
216
225
227
228
233
238
243

CONTENTS
MULTIMEDIA AUDIO SYSTEM / BLUETOOTH TELEPHONE
GPS EUROPE

Page:   < prev 1-10 11-20 21-30 next >