check engine Peugeot RCZ 2013 Owner's Guide

7/
CHECKS






2 LITRE HDI ENGINE



)
Fill the fuel tank with at least fi ve litres of Diesel.

)
Open the bonnet.

)
If necessary, unclip the style cover for access to the priming pump.

)
Slacken the bleed screw.

)
Squeeze and release the priming pump repeatedly until fuel
appears in the transparent pipe.

)
Tighten the bleed screw.

)
Operate the starter until the engine starts (if the engine fails to start
at the fi rst attempt, wait around 15 seconds before trying again).

)
If the engine fails to start after a few attempts, operate the priming
pump again, then the starter.

)
Put the style cover back in position and clip it in place, ensuring that
it has clipped correctly.

)
Close the bonnet.

RUNNING OUT OF FUEL (DIESEL)

If the engine does not start fi rst time, don't keep trying.
Operate the priming pump again, then the starter motor. On vehicle fi tted with HDi engines, the fuel system must be primed
if you run out of fuel; refer to the engine compartment view on the
"Diesel engine" page.

152





CHECKING LEVELS



















OIL LEVEL


The check is carried out either when the ignition is switched
on using the oil level indicator in the instrument panel, or using
the dipstick.
It will only be correct if the vehicle is on level ground and the engine
has been off for more than 30 minutes.
Take care when working under the bonnet, as certain areas of the engine may be extremely hot (risk of burns) and the cooling fan could start
at any time (even with the ignition off).



If a level drops signifi cantly, have the corresponding system checked by a PEUGEOT dealer or a qualifi ed workshop.
Check all of these levels regularly, in line with the servicing booklet and the requirements of the warranties. Top them up if necessary, unless otherwise indicated.


Engine oil change

Refer to the servicing and warranty booklet for details of the interval
for this operation.
In order to maintain the reliability of the engine and emission control
system, the use of additives in the engine oil is prohibited. It is normal to top up the oil level between two services (or oil
changes). PEUGEOT recommends that you check the level, and
top up if necessary, every 3 000 miles (5 000 kms).
After topping up the oil, the check when switching on the ignition with
the oil level indicator in the instrument panel is not valid during the
30 minutes after topping up.


Oil specification

The oil must be the correct grade for your engine and conform to the
manufacturer's recommendations.












BRAKE FLUID LEVEL

The brake fl uid level should be close to the "MAX" mark.
If it is not, check the brake pad wear.

Changing the fluid

Refer to the servicing and warranty booklet for details of the interval
for this operation.


Fluid specification

The brake fl uid must conform to the manufacturer's recommendations
and meet the DOT3 or DOT4 standard.












POWER STEERING FLUID LEVEL

The power steering fl uid level should be close to the "MAX"
mark. With the engine cold, unscrew the cap to check the level.

7/
F0
CHECKS









ADDITIVE LEVEL (DIESEL WITH PARTICLE
EMISSIONS FILTER)
The additive reservoir low level is indicated by fi xed
illumination of this warning lamp, accompanied by an audible
signal and a message that the particle emissions fi lter additive
level is too low.

Topping up

The reservoir must be topped up without delay by a PEUGEOT dealer
or a qualifi ed workshop.









USED PRODUCTS

Avoid prolonged contact of used oil or fl uids with the skin.
Most of these fl uids are harmful to health or indeed very corrosive.
Do not discard used oil or fl uids into sewers or onto the ground.
Take used oil to a PEUGEOT dealer or a qualifi ed workshop
(France) or to an authorised waste disposal site.











COOLANT LEVEL


The coolant level should be close to the "MAX" mark but
should never exceed it.
When the engine is warm, the temperature of the coolant is regulated
by the fan.
In addition, as the cooling system is pressurised, wait at least one hour
after switching off the engine before carrying out any work.
To avoid any risk of scalding, unscrew the cap by two turns to allow the
pressure to drop. When the pressure has dropped, remove the cap and
top up the level.





The cooling fan may start after switching off the engine: take
care with articles and clothing that might become caught by the
fan blades.




Changing the coolant

The coolant does not have to be changed.


Fluid specification

The coolant must conform to the manufacturer's recommendations.























SCREENWASH AND HEADLAMP
WASH FLUID

In the case of vehicles fi tted with headlamp washers, the low
fl uid level is indicated by an audible signal and a message in
the instrument panel screen.
Top up the reservoir when you next stop the vehicle.


Fluid specification

For optimum cleaning and to avoid freezing, this fl uid must not be
topped up with or replaced with plain water.

154





CHECKS













BATTERY









PARTICLE EMISSION FILTER (DIESEL)


On a new vehicle, the fi rst particle fi lter regeneration operations
may be accompanied by a "burning" smell, which is perfectly
normal.
Following prolonged operation of the vehicle at very low speed or
at idle, you may, in exceptional circumstances, notice the emission
of water vapour at the exhaust on acceleration. This does not
affect the behaviour of the vehicle or the environment.

The battery does not require any maintenance.
However, check that the terminals are clean and correctly
tightened, particularly in summer and winter.
When carrying out work on the battery, refer to the "Battery"
section for details of the precautions to be taken before disconnecting
the battery and following its reconnection.

The start of saturation of the particle emissions fi lter is
indicated by the temporary illumination of this warning lamp,
accompanied by an audible signal and a message on the risk
of blockage of the particle emissions fi lter.
As soon as the traffi c conditions permit, regenerate the fi lter by driving
at a speed of at least 40 mph (60 km/h) until the warning lamp goes off.
If the warning lamp stays on, refer to the "Additive level" section.
Unless otherwise indicated, check these components in accordance
with the servicing and warranty booklet and according to your engine.
Otherwise, have them checked by a PEUGEOT dealer or a qualifi ed
workshop.





















AIR FILTER AND PASSENGER COMPARTMENT FILTER


Refer to the servicing and warranty booklet for details of
the replacement intervals for these components.
Depending on the environment (e.g. dusty atmosphere)
and the use of the vehicle (e.g. city driving), replace them
twice as often if necessary
.
A clogged passenger compartment fi lter may have an adverse effect
on the performance of the air conditioning system and generate
undesirable odours.
Replace the oil fi lter each time the engine oil is changed.
Refer to the servicing and warranty booklet for details of the
replacement interval for this component.














OIL FILTER

7/
CHECKS






MANUAL GEARBOX






AUTOMATIC GEARBOX















BRAKE PADS
BRAKE DISC WEAR

The gearbox does not require any maintenance (no oil change).
Refer to the servicing and warranty booklet for the details of
the level checking interval for this component.
The gearbox does not require any maintenance (no oil change).
Refer to the servicing and warranty booklet for details of the
level checking interval for this component.
Brake wear depends on the style of driving, particularly in
the case of vehicles used in town, over short distances.
It may be necessary to have the condition of the brakes
checked, even between vehicle services.
Unless there is a leak in the circuit, a drop in the brake fl uid level
indicates that the brake pads are worn. For information on checking brake disc wear, contact a
PEUGEOT dealer or a qualifi ed workshop.
















Only use products recommended by PEUGEOT or products of
equivalent quality and specifi cation.
In order to optimise the operation of units as important as the
braking system, PEUGEOT selects and offers very specifi c
products.
To avoid damaging the electrical units, the use of a high pressure
washer in the engine compartment is strictly prohibited
.























PARKING BRAKE


If excessive travel or a loss of effectiveness of this system
is noticed, the parking brake must be checked, even
between two services.

Checking this system must be done by a PEUGEOT dealer
or a qualifi ed workshop.

158

Take care, this product is harmful (e.g. ethylene-glycol,
colophony...) if swallowed and causes irritation to the eyes.
Keep this product out of the reach of children.


REPAIR PROCEDURE


1. Sealing




)
Switch off the ignition.



)
Uncoil the white pipe G
fully.

)
Unscrew the cap from the white pipe.

)
Connect the white pipe to the valve of the tyre to be repaired.




)
Connect the compressor's electric plug to the vehicle's 12 V socket.

)
Start the vehicle and leave the engine running.

Avoid removing any foreign bodies which have penetrated into the
tyre.


)
Turn the selector A
to the "sealant" position.

)
Check that the switch B
is in position "O"
.

162

CHECKING TYRE PRESSURES / INFLATING
ACCESSORIES

You can also use the compressor, without injecting any product, to:


- check or adjust the pressure of your tyres,

- infl ate other accessories (balls, bicycle tyres...).




)
Turn the selector A
to the "Air" position.

)
Uncoil the black pipe H
fully.

)
Connect the black pipe to the valve of the wheel or
accessory.
If necessary, fi t one of the adaptors supplied with the kit fi rst.



)
Connect the compressor's electrical connector to the vehicle's 12 V
socket.

)
Start the vehicle and let the engine run.

)
Adjust the pressure using the compressor (to infl ate: switch B

in position "I"
; to defl ate: switch B
in position "O"
and press
button C
), according to the vehicle's tyre pressure label or the
accessory's pressure label.

)
Remove the kit then stow it.

172

DISCONNECTING / RECONNECTING THE
CABLES

To avoid discharging the battery, do not leave the vehicle lighting
on repeatedly with the ignition off (refer to the "Energy economy
mode" paragraph).
It is advisable to disconnect the battery if the vehicle is to be left
unused for more than one month.

Do not disconnect the terminals while the engine is running.
Do not charge the batteries without disconnecting the terminals
fi rst.


Before disconnecting the battery

Wait 2 minutes after switching off the ignition before disconnecting
the battery.
Retract the active spoiler then close the windows and the doors
before disconnecting the battery.


Following reconnection of the battery

Following reconnection of the battery, switch on the ignition
and wait 1 minute before starting to permit initialisation of the
electronic systems. However, if slight problems remain following
this operation, contact a PEUGEOT dealer or a qualifi ed
workshop.
Referring to the corresponding section, you must yourself
reinitialise:


- the remote control key,

- the electric windows and the automatic partial opening of the
door windows,

- the GPS satellite navigation system.



)
Raise the locking tab D
fully.

)
Position the open clip E
of the cable on the positive terminal (+) of
the battery.

)
Press vertically on the clip E
to position it correctly against the
battery.

)
Lock the clip by lowering the tab D
.


CHARGING THE BATTERY USING A BATTERY
CHARGER


)
Disconnect the battery from the vehicle.

)

Follow the instructions for use provided by the manufacturer of the charger.


)
Reconnect starting with the negative terminal (-).

)
Check that the terminals and connectors are clean. If they are
covered with sulphate (whitish or greenish deposit), remove them
and clean them.

Do not force the tab as locking will not be possible if the clip is not
positioned correctly.
Start the procedure again.

190

Cooling

Towing a trailer on a slope increases the temperature of the coolant.
As the fan is electrically controlled, its cooling capacity is not dependent
on the engine speed.


)
To lower the engine speed, reduce your speed.
The maximum towing load on a long slope depends on the gradient and
the ambient temperature.
In all cases, pay attention to the coolant temperature.


Braking

Towing a trailer increases the braking distance.


Tyres



)
Check the tyre pressures of the towing vehicle and of the trailer,
observing the recommended pressures.



Lighting



)
Check the electrical signalling on the trailer.

)
If the warning lamp and the STOP
warning lamp come
on, stop the vehicle and switch off the engine as soon as
possible.
The rear parking sensors will be deactivated automatically if a
genuine PEUGEOT towbar is used.


When not towing a trailer, remove the quickly-detachable tow ball
before driving, so as to avoid masking the central rear lamp.

244
QUESTIONANSWERSOLUTION
The stored stations donot function (no sound, 87.5 Mhz is displayed…).

An incorrect waveband is selected.
Press RADIO, select Radio Menu then"Waveband" to return to the waveband on which the stations are stored.

The quality of receptionof the radio station listened to graduallydeteriorates or the stored stations do not function(no sound, 87.5 Mhz is displayed…).
The vehicle is too far from the transmitter used by the station listenedto or there is no transmitter in the geographical area through which the vehicle is travelling.
Activate the "RDS" function by means of theshort-cut menu to enable the system to check whether there is a more powerful transmitter in thegeographical area.
The environment (hills, buildings, tunnels, basement car parks…) block reception, including in RDS mode.
This phenomenon is normal and does not indicate a failure of the audio equipment.
The aerial is absent or has been damaged (for example when goingthrough a car wash or into an underground car park).
Have the aerial checked by a PEUGEOT dealer.
Sound cut-outs of 1 to2 seconds in radio mode.During this brief sound cut-out, the RDS searches for any frequency permitting better reception of the station.
Deactivate the "RDS" function by means of the short-cut menu if the phenomenon is too frequentand always on the same route.

With the engine off, the system switches off after a few minutes of use.
When the engine is switched off, the system's operating time depends on the battery charge.
The switch-off is normal: the system switches to economy mode and switches off to prevent discharging of the vehicle's battery.

Start the vehicle's engine to increase the batterycharge.