lock PONTIAC SOLSTICE 2007 User Guide

At times you may notice a decrease in operating
range. This is normal for any RKE system. If
the transmitter does not work or if you have to
stand closer to your vehicle for the transmitter to
work, try this:
Check the distance. You may be too far from
your vehicle. You may need to stand closer
during rainy or snowy weather.
Check the location. Other vehicles or objects
may be blocking the signal. Take a few steps
to the left or right, hold the transmitter
higher, and try again.
Check to determine if battery replacement is
necessary. See “Battery Replacement”
underRemote Keyless Entry (RKE) System
Operation on page 62.
If you are still having trouble, see your dealer
or a qualied technician for service.
Remote Keyless Entry (RKE)
System Operation
The vehicle’s doors can
be locked and unlocked,
and the trunk can be
unlatched from
about 3 feet (1 m) up to
60 feet (18 m) away
with the Remote
Keyless Entry (RKE)
transmitter.
Q(Lock):Press the lock button to lock all the
doors. If enabled through the Driver Information
Center (DIC), the parking lamps may ash
once and the horn may chirp to indicate locking
has occurred. See “LOCK HORN” underDIC
Vehicle Personalization on page 152.
62

"(Unlock):Press the unlock button one time to
unlock the driver’s door. Press the unlock
button again within ve seconds to unlock the
other doors. The interior lamps will come on and
stay on for 20 seconds or until the ignition is turned
on. If enabled through the DIC, the parking
lamps will ash once to indicate unlocking has
occurred. See “UNLOCK HORN” underDIC
Vehicle Personalization on page 152.
V(Trunk Release):Press and hold this button
for approximately one second to release the
trunk lid. The trunk release will only work if the
ignition is off or the vehicle speed is less than
2 mph (3 km/h).
L(Vehicle Locator/Panic Alarm):Press and
release this button to help locate your vehicle.
The horn will sound three times and the hazard
lamps will ash three times. Press and hold
the button for three seconds to sound the panic
alarm. The horn will sound and the hazard
lamps will ash for 30 seconds. The ignition must
be off for the vehicle locator/remote alarm to
work. Press the vehicle locator/panic alarm button
again or turn the ignition to ACC or RUN to
turn off the alarm.The vehicle may have Remote Lock/Unlock
Conrmation. This feature provides feedback that
a command has been received by the vehicle.
The parking lamps will ash and the horn
may sound briey. See “LOCK HORN” and
“UNLOCK HORN” underDIC Vehicle
Personalization on page 152for programming
information.
Matching Transmitter(s) to Your
Vehicle
Each remote keyless entry transmitter is uniquely
coded to prevent another transmitter from
unlocking the vehicle. If a transmitter is lost or
stolen, a replacement can be purchased through
your dealer. Remember to bring any additional
transmitters so they can also be re-coded to match
the new transmitter. Once your dealer has
coded the new transmitter, the lost transmitter
cannot unlock the vehicle. The vehicle can have a
maximum of four transmitters coded to it.
63

Doors and Locks
Manual Door Locks
{CAUTION:
Unlocked doors can be dangerous.
Passengers, especially children, can
easily open the doors and fall out of a
moving vehicle. When a door is
locked, the handle will not open it.
You increase the chance of being
thrown out of the vehicle in a crash if
the doors are not locked. So, wear
safety belts properly and lock the
doors whenever you drive.
CAUTION: (Continued)
CAUTION: (Continued)

Young children who get into unlocked
vehicles may be unable to get out.
A child can be overcome by extreme
heat and can suffer permanent injuries
or even death from heat stroke.
Always lock your vehicle whenever
you leave it.
Outsiders can easily enter through an
unlocked door when you slow down
or stop your vehicle. Locking your
doors can help prevent this from
happening.
There are a couple of ways to lock and unlock
your vehicle manually.
65

From inside the vehicle,
use the manual door
lock knob. Pull up or
down on the knob to
unlock or lock the door.
To lock either door from the outside, turn the key
toward the rear of the vehicle. To unlock the
door, turn the key toward the front of the vehicle.
Power Door Locks
You can use the Remote Keyless Entry (RKE)
transmitter to lock and unlock the doors from inside
or outside the vehicle. SeeRemote Keyless
Entry (RKE) System Operation on page 62for
more information.
The power door lock switches are located on the
driver’s and passenger’s door.
Press the top of the switch to unlock all doors.
Press the bottom of the switch to lock all doors.
Delayed Locking
If your vehicle has power door locks, it will have
the delayed locking feature. This feature delays the
actual locking of the doors when the Remote
Keyless Entry (RKE) transmitter is used to lock
the vehicle.
If any door is open when locking the vehicle using
the RKE transmitter, three chimes will sound
signaling that the delayed locking feature is active.
Five seconds after the last door is closed, both
doors will lock and the parking lamps will ash.
To cancel the delay and lock the doors immediately,
press the lock button on the RKE a second time.
If the key is in the ignition, this feature will not lock
the doors.
Your vehicle is programmed from the factory with
this feature turned off. To turn the feature on,
you must go through the Driver Information
Center (DIC), if the vehicle has one. SeeDIC
Vehicle Personalization on page 152.
66

Automatic Door Lock
If your vehicle has power door locks, the doors will
automatically lock when the shift lever is moved
out of PARK (P) for a vehicle with an automatic
transmission. For a vehicle with a manual
transmission, the speed must be greater than
5 mph (8 km/h).
The automatic door locking feature cannot be
disabled.
Automatic Door Unlock
If your vehicle has an automatic transmission and
power door locks, the doors with automatically
unlock when the shift lever is moved into
PARK (P).
If your vehicle has a manual transmission and
power door locks, the doors will automatically
unlock when the key is removed from the ignition.
The automatic unlock feature can be disabled
or programmed in different ways if the vehicle has
an automatic transmission and a Driver
Information Center (DIC). SeeDIC Vehicle
Personalization on page 152for more information.
67

Remote Trunk Release
To open the trunk from inside the vehicle, press
the remote trunk release button located in the
glovebox.
The remote trunk release will only work when
either the ignition is off or in ACC, the parking
brake is engaged, or the vehicle speed is less than
2 mph (3 km/h).
Emergency Trunk Release Handle
Notice:Do not use the emergency trunk
release handle as a tie-down or anchor point
when securing items in the trunk as it
could damage the handle. The emergency
trunk release handle is only intended to aid a
person trapped in a latched trunk, enabling
them to open the trunk from the inside.
There is a glow-in-the-dark emergency trunk
release handle located inside the trunk on
the driver’s side. This handle will glow following
exposure to light. If someone is locked in the trunk,
they can pull the release handle and push the
trunk lid open from the inside to open the trunk.
69

Theft-Deterrent Systems
Vehicle theft is big business, especially in some
cities. Although your vehicle has a number of
theft-deterrent features, we know that nothing we
put on it can make it impossible to steal.
Content Theft-Deterrent
Your vehicle may have a content theft-deterrent
alarm system.
The security light,
located on the
instrument panel cluster,
will turn on to indicate
that arming has
been initiated.
Once the system is armed, the security light will
ash once every three seconds.
If the security light is ashing twice per second,
this means that a door is open.
Arming the System
While the ignition is off, press the remote keyless
entry transmitter lock button, to arm the system.
The system will arm after either of these
things occur:
Thirty seconds after all the doors are closed.
Sixty seconds with any door open.
If you press the lock button on the transmitter a
second time while all the doors are closed,
the system will arm immediately. The system arms
in 60 seconds if a door is open, or after the
open door is closed.
If you do not want to arm the system, lock the car
with the manual door lock knobs.
72

Disarming the System
You can disarm the system by doing any one of
the following:
Press the unlock button on the remote keyless
entry transmitter.
Turn the ignition on.
If the system is armed and the trunk is opened
using the trunk release button on the transmitter,
the system will temporarily disarm itself and re-arm
when the trunk has been closed. This allows you to
exit the vehicle, lock the doors using the transmitter,
or open the trunk using the transmitter without
having to disarm and re-arm the system.
Once the system is disarmed, the security light will
stop ashing.
How the System Alarm is Activated
If the system is armed, it can be activated by:
Opening the driver’s door or trunk. This causes
a ten second pre-alarm chirping noise followed
by the horn sounding and lights ashing for
30 seconds.
Opening a passenger’s door. This immediately
causes a full alarm of the horn sounding and
lights ashing for 30 seconds.
After the 30 second alarm ends, the system will
re-arm itself.
How to Turn Off the System Alarm
To turn off the system alarm, do one of the
following:
Press the lock button on the remote keyless
entry transmitter. The system will then
re-arm itself.
Press the unlock button on the remote keyless
entry transmitter. This will also disarm the
system.
Insert the key in the ignition and turn it on.
This will also disarm the system.
73

How to Detect a Tamper Condition
If you hear three chirps when you press the
unlock, lock, or trunk release buttons on the
remote keyless transmitter, it means that
the content theft security system alarm was
activated previously.
PASS-Key®III+
The PASS-Key®III+ system operates on a radio
frequency subject to Federal Communications
Commission (FCC) Rules and with Industry
Canada.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful
interference.
2. This device must accept any interference
received, including interference that may
cause undesired operation.This device complies with RSS-210 of Industry
Canada. Operation is subject to the following
two conditions:
1. This device may not cause interference.
2. This device must accept any interference
received, including interference that may
cause undesired operation of the device.
Changes or modications to this system by other
than an authorized service facility could void
authorization to use this equipment.
PASS-Key
®III+ uses a radio frequency
transponder in the key that matches a decoder in
your vehicle.
PASS-Key®III+ Operation
Your vehicle is equipped with PASS-Key®III+
(Personalized Automotive Security System)
theft-deterrent system. PASS-Key
®III+ is a
passive theft-deterrent system. This means you do
not have to do anything special to arm or disarm
the system. It works when you insert or remove the
key from the ignition.
74

When the PASS-Key®III+ system senses that
someone is using the wrong key, it prevents
the vehicle from starting. Anyone using a
trial-and-error method to start the vehicle will be
discouraged because of the high number of
electrical key codes.
When trying to start the vehicle if the engine does
not start and the security light on the instrument
panel cluster comes on, the key may have a
damaged transponder. Turn the ignition off and
try again.
If the engine still does not start, and the key
appears to be not damaged, try another ignition
key. At this time, you may also want to check the
fuse, seeFuses and Circuit Breakers on
page 326. If the engine still does not start with the
other key, your vehicle needs service. If your
vehicle does start, the rst key may be faulty. See
your dealer who can service the PASS-Key
®III+
to have a new key made. In an emergency,
contact Roadside Assistance. SeeRoadside
Assistance Program on page 368.It may be possible for the PASS-Key
®III+ decoder
to “learn” the transponder value of a new or
replacement key. Up to 10 keys may be
programmed for the vehicle. The following
procedure is for programming additional keys only.
If your vehicle was rst sold in Canada, or if all
the currently programmed keys are lost or do not
operate, you must see your dealer or a locksmith
who can service PASS-Key
®III+ to have keys
made and programmed to the system.
See your dealer or a locksmith who can service
PASS-Key
®III+ to get a new key blank that is cut
exactly as the ignition key that operates the
system.
To program the new key do the following:
1. Verify that the new key has a
1stamped on it.
2. Insert the already programmed key in the
ignition and start the engine. If the engine
will not start, see your dealer for service.
3. After the engine has started, turn the key to
LOCK, and remove the key.
75