door Ram 1500 2013 Owners Manual
Page 521 of 734
To switch from the max load inflation pressure (cold) low
pressure warning threshold to the light load inflation
pressure (cold) low pressure warning threshold, begin by
placing the ignition switch in the RUN position. Next,
lower all four road tire pressures to the Light Load
Inflation Pressure values as listed on the SupplementalTire Pressure Information label. The Supplemental Tire
Pressure Information label is located on the rear face of
the driver door opening. Use an accurate tire gauge to
check the tire pressures when lowering all four tire
pressures. The vehicle may need to be driven above
15 mph (25 km/h) to receive this updated pressure
information. After all four tire pressures have been
lowered to the Light Load inflation pressures, press the
tire light load inflation switch. If the tire light load
inflation switch’s amber colored LED turns ON, the
TPMS is using the light load inflation pressure (cold) low
pressure warning thresholds. A text message
Tire Pres-
sure System - Light Load Setting will also be displayed
in the EVIC.
If the tire light load inflation switch amber colored LED
flashes on and off for 10 seconds, after all four tire
pressures have been lowered to the Light Load inflation
pressures, the pressure in any one of the four tires may
not be at the light load inflation pressure (cold) values as
Example Supplemental Tire Pressure Label
5
STARTING AND OPERATING 519
Page 522 of 734
indicated for the Light Load condition as defined on the
Supplemental Tire Pressure Information label located on
the rear face of the driver door. A text messageCannot
Enter Light Load Setting - Please Adjust Tire Pressure
text message will also be displayed in the EVIC. Using an
accurate tire pressure gauge, re-check the tire pressures
for the light load inflation pressure (cold) value.
WARNING!
It is the driver ’s responsibility to change to the max
load inflation pressure (cold) low pressure warning
threshold condition when not driving in the light
load condition as defined as two occupants (150 lbs
[68 kg] each) plus 200 pounds (91 kg) of cargo. The
vehicle “Light Load Definition” is found in the
Supplemental Tire Pressure Information label lo-
cated on the rear face of the driver door. Failure to do
so may cause you to lose control resulting in an
accident, causing serious or fatal injury. To switch back to the max load inflation pressure (cold)
low pressure warning threshold, press the tire light load
inflation switch. It is not necessary to first fill the tires to
the max load inflation pressure (cold) values to switch
the TPMS system to the max load inflation pressure
(cold) low pressure warning threshold. If after pressing
the tire light load inflation switch, and tire pressures are
below the max load inflation pressure (cold) low pressure
warning thresholds, the “Tire Pressure Monitoring Tell-
tale Light” (located in the instrument cluster) will turn
ON and a chime will sound. An
inflate to XXmessage
will also be displayed. The tire pressures are now re-
quired to be inflated to the max load inflation pressure
(cold) values described on the Tire and Loading Informa-
tion label. The Tire and Loading Information label is
located on the drivers side B-pillar. If the tire light load
inflation switch LED turns OFF, the TPMS has been reset
and the TPMS is using the max load inflation pressure
520 STARTING AND OPERATING
Page 528 of 734
FLEXIBLE FUEL (3.6L/4.7L ENGINES ONLY) — IF
EQUIPPED
E-85 General Information
The information in this section is for Flexible Fuel ve-
hicles only. These vehicles can be identified by a unique
fuel filler door label that statesEthanol (E-85) or Un-
leaded Gasoline Only. This section only covers those
subjects that are unique to these vehicles. Please refer to
the other sections of this manual for information on
features that are common between Flexible Fuel and
gasoline-only powered vehicles.
CAUTION!
Only vehicles with the E-85 fuel filler door label can
operate on E-85.
E-85 Fuel Cap
526 STARTING AND OPERATING
Page 532 of 734
ADDING FUEL
The fuel filler cap (gas cap) is located behind the fuel
filler door, on the left side of the vehicle. Open the fuel
door and remove the fuel cap by turning it counter-
clockwise.NOTE:
When removing the fuel filler cap, lay the cap
tether in the hook, located on the fuel filler door.
CAUTION!
• Damage to the fuel system or emissions control
system could result from using an improper fuel
tank filler tube cap (gas cap).
• A poorly fitting gas cap could let impurities into
the fuel system.
• A poorly fitting gas cap may cause the “Malfunc-
tion Indicator Light (MIL)” to turn on.
• To avoid fuel spillage and overfilling, do not “top
off” the fuel tank after filling. When the fuel
nozzle “clicks” or shuts off, the fuel tank is full.
Fuel Filler Cap
530 STARTING AND OPERATING
Page 534 of 734
VEHICLE LOADING
Certification Label
As required by National Highway Traffic Safety Admin-
istration regulations, your vehicle has a certification label
affixed to the driver’s side door or pillar.
This label contains the month and year of manufacture,
Gross Vehicle Weight Rating (GVWR), Gross Axle Weight
Rating (GAWR) front and rear, and Vehicle Identification
Number (VIN). A Month-Day-Hour (MDH) number is
included on this label and indicates the Month, Day and
Hour of manufacture. The bar code that appears on the
bottom of the label is your VIN.
Gross Vehicle Weight Rating (GVWR)
The GVWR is the total permissible weight of your vehicle
including driver, passengers, vehicle, options and cargo.
The label also specifies maximum capacities of front andrear axle systems (GAWR). Total load must be limited so
GVWR and front and rear GAWR are not exceeded.
Payload
The payload of a vehicle is defined as the allowable load
weight a truck can carry, including the weight of the
driver, all passengers, options and cargo.
Gross Axle Weight Rating (GAWR)
The GAWR is the maximum permissible load on the front
and rear axles. The load must be distributed in the cargo
area so that the GAWR of each axle is not exceeded.
Each axle GAWR is determined by the components in the
system with the lowest load carrying capacity (axle,
springs, tires or wheels). Heavier axles or suspension
components sometimes specified by purchasers for in-
creased durability does not necessarily increase the vehi-
cle’s GVWR.
532 STARTING AND OPERATING
Page 542 of 734
Trailer Towing Weights (Maximum Trailer Weight Ratings)
The rear bumper is intended to tow trailers up to a 5,000 lbs (2 268 kg) without added equipment or alterations to
the standard equipment.
Ram 1500 4x2
STSLT/OutdoorsmanSport/Laramie
3.6L V-6
8–Speed
Automatic
Transmission Standard Towing: 5,000 lbs
(2 268 kg)
Max Towing: 6,500 lbs (2 948 kg)
Max Payload: 1,910 lbs (866 kg) Standard Towing: 5,000 lbs
(2 268 kg)
Max Towing: 6,500 lbs (2 948 kg)
Max Payload: 1,890 lbs (857 kg) –
4.7L V-8
6–Speed
Automatic
Transmission Standard Towing: 5,000 lbs
(2 268 kg)
Max Towing: 7,700 lbs (3 492 kg)
Max Payload: 1,750 lbs (793 kg) Standard Towing: 5,000 lbs
(2 268 kg)
Max Towing: 7,700 lbs (3 492 kg)
Max Payload: 1,720 lbs (780 kg) –
540 STARTING AND OPERATING
Page 543 of 734
STSLT/OutdoorsmanSport/Laramie
5.7L HEMI®
V-8 6–Speed
Automatic
Transmission Standard Towing: 5,000 lbs
(2 268 kg)
Max Towing: 10,450 lbs
(4 740 kg)
Max Payload: 1,710 lbs (775 kg) Standard Towing: 5,000 lbs
(2 268 kg)
Max Towing: 10,450 lbs
(4 740 kg)
Max Payload: 1,690 lbs (766 kg)Standard Towing:
5,000 lbs (2 268 kg)
Max Towing: 10,300 lbs
(4 672 kg)
Max Payload: 1,550 lbs
(703 kg)
Ram 1500 4x4
ST
SLT/OutdoorsmanSport/Laramie
3.6L V-6
8–Speed
Automatic
Transmission Standard Towing:
5,000 lbs (2 268 kg)
Max Towing: 6,300 lbs
(2 857 kg)
Max Payload: 1,930 lbs (875 kg) Standard Towing:
5,000 lbs (2 268 kg)
Max Towing: 6,250 lbs
(2 834 kg)
Max Payload: 1,900 lbs (861 kg) –5
STARTING AND OPERATING 541
Page 544 of 734
STSLT/OutdoorsmanSport/Laramie
4.7L V-8
6–Speed
Automatic
Transmission Standard Towing:
5,000 lbs (2 268 kg)
Max Towing: 7,500 lbs
(3 401 kg)
Max Payload: 1,570 lbs (712 kg) Standard Towing:
5,000 lbs (2 268 kg)
Max Towing: 7,450 lbs
(3 379 kg)
Max Payload: 1,530 lbs (694 kg) –
5.7L HEMI® V-8 6–Speed Automatic
Transmission Standard Towing: 5,000 lbs
(2 268 kg)
Max Towing: 10,350 lbs (4 694 kg)
Max Payload: 1,480 lbs (671 kg) Standard Towing: 5,000 lbs
(2 268 kg)
Max Towing: 10,300 lbs (4 672 kg)
Max Payload: 1,450 lbs (657 kg) Standard Towing:
5,000 lbs (2 268 kg)
Max Towing: 10,050 lbs (4 558 kg)
Max Payload: 1,380 lbs (625 kg)
542 STARTING AND OPERATING
Page 545 of 734
Ram 2500 And 3500
STSLT/Outdoorsman/Sport Laramie
5.7L HEMI®
V-8 6–Speed
Automatic
Transmission Max Towing: 10,100 lbs
(4 581 kg)
Max Payload: 1,780 lbs (807 kg)
Max Towing: 12,300 lbs
(5 579 kg)
Max Payload: 3,120 lbs
(1 415 kg) –
NOTE: For additional trailer towing information (maxi-
mum trailer weight ratings) refer to the following website
addresses:
• http://www.ramtrucks.com
• http://www.ramtruck.ca (Canada)
5
STARTING AND OPERATING 543
Page 561 of 734
•Check the runners and cutting edge for excessive wear.
The cutting edge should be 1/4 to 1/2 in (6 cm to 1.2
cm) above ground in snow plowing position.
• Check that snowplow lighting is connected and func-
tioning properly.
Snowplow Prep Package Model Availability
For Information about snowplow applications visit
www.ramtrucks.com or refer to the current Body Build-
ers Guide.
1. The maximum number of occupants in the truck should not exceed two.
2. The total GVWR or the Front GAWR or the Rear GAWR should never be exceeded.
3. Cargo capacity will be reduced by the addition of options or passengers, etc.
The loaded vehicle weight, including the snowplow system,
all aftermarket accessories, driver, passengers, options, and
cargo, must not exceed either the Gross Vehicle Weight
(GVWR) or Gross Axle Weight (GAWR) ratings. These
weights are specified on the Safety Compliance Certifica-
tion Label on the driver’s side door opening.
NOTE: Detach the snowplow when transporting pas-
sengers.
Vehicle front end wheel alignment was set to specifica-
tions at the factory without consideration for the weight
of the plow. Front end toe-in should be checked and reset
if necessary at the beginning and end of the snowplow
season. This will help prevent uneven tire wear.
The blade should be lowered whenever the vehicle is
parked.
5
STARTING AND OPERATING 559